• KIEAE Journal
• /
• 제17권4호
• /
• pp.33-39
• /
• 2017

Purpose: The use of renewable energy system is essential for building energy independence and saving energy consumption in the building sector. Among renewable energy technologies, ground source heat pump(GSHP) system is more energy-efficient and environmental-friendly than other heat source systems due to utilize stable ground heat source. However, the GSHP system requires a high initial installation cost and installation space in limited urban area, so it is difficult to have superiority in the market of heat source system. Therefore, it is necessary to develop the installation method of low-cost and improve system performance. This paper aims to evaluate the performance of double u-tube ground heat exchanger(GHX) and verify system feasibility through real-scale experiment. Method: In this study, the real-scale experiment of vertical closed-type GSHP system was conducted using double u-tube GHX and high-efficiency grout. Through the verification experiment, heat source temperature, heat exchange rate(HER) and seasonal performance factor(SPF) were measured according to the long-term operation. In addition, the feasibility analysis was conducted comparing to the single u-tube system. Result: In the results of experiment, average HER was 136.27 W/m and average SPF was 5.41. Furthermore, compared to the single u-tube, the installation cost of the developed system could be reduced about 70% in the same heating load condition.

• 한국소음진동공학회논문집
• /
• 제16권9호
• /
• pp.964-970
• /
• 2006

Micro gas turbine(MGT) has received attention recently as small-scale distributed power sources. With characteristics such as their small size, lightweight, low maintenance cost and minimal vibrations during operation, they are expected to become widespread in a wide range of ' applications, including residential and small-scale industrial use. It is very easier to start-up and stop the MGT system which is the friendly environmental power system has just below the 9ppm NOx emmission and good quality of noise level. The exhaust heat emitted by the MGT is in the form of about $300^{\circ}C$ clean exhaust gas. The exhaust gas is suitable for absorption chiller/heater system. 1 has researched performance characteristics of the 60 kW class MGT-absorption chiller-heater system in the local condition. Variations of heat recovery from exhaust gas has measured according to micro gas turbine output of 15, 30, 45, 60kW. From those results, the performance of the MGT-absorption chiller/heater system has been evaluated.

• 한국디지털건축인테리어학회논문집
• /
• 제10권3호
• /
• pp.79-86
• /
• 2010

From the research which sees the building which uses a natural control method with ecological architecture, continuity tried to divide the building which uses a physical control method with sustainable architecture. Ecological architecture analyzes the microclimate of the area and applies mining and natural ventilation leads and that the interior environment controls, the condition of the site actively and there is a possibility of seeing. Also sustainable architecture which is possible to lead and recycling and reuse of the resources and energy cyclic process of the construction resources to lead and the interior environment to control. Therefore the case where the facility system and structural system become integrated design organically in natural circulating method is many. Specially the sunshade system and double skin system are combined and structural system of the building and there is a possibility of having the envelope which form is feature. Today the buildings lead and the system integration process where the integral parts are systematic is demanded the interior environment which and an external form and that, they make they are there is a possibility of seeing. the environmental building which hits joins in with natural control method and the structure and facility system are integrated and has the tendency which is developed and there is a possibility of saying that a meaning with the alternative construction will be able to reduce the resources and an energy.

• 한국수소및신에너지학회논문집
• /
• 제25권2호
• /
• pp.139-144
• /
• 2014

A Fuel Cell is one of the solving to reduce greenhouse gases. Despite the high efficiency and environmental friendly of Household Fuel Cell System it has hardly obtained popularity mainly due to its high prices. In order to encourage use of the system prices and operational expenses need to become economical. In this study, optimization through simulation was conducted to find out the optimal operational condition. As a result of simulation the system is operated with DSS operation from 5 O'clock until 19 O'clock for 13 hours at the constant output of 0.4kW to maximize reduction of energy rate. Furthermore, instead of the domestic system with the rated output of 1kW, rated output of the system should be reduced to 0.4 - 0.6kW which can promote installation of household Fuel Cell System.

• 펄프종이기술
• /
• 제44권1호
• /
• pp.65-73
• /
• 2012

Nowadays, the concern on the environmental load of bleaching process gave rise to the process of ECF(elemental chlorine free) and TCF(total clorine free). These sequences are based on oxygen-derived compounds such as oxygen, ozone, and hydrogen peroxide which is used as a typical eco-friendly bleaching agent. In this study, paper mulberry pulp was bleached with hydrogen peroxide and some bleaching process were accompanied with ultrasonication in order to increase the bleaching efficiency. The best bleaching efficiency of paper mulberry pulp was obtained in the condition of hydrogen peroxide and ultrasonication(20 kHz) bleaching system at $45^{\circ}C$ for 30 min. The brightness and kappa number of paper mulberry pulp were gained to 5.09% and 3.52 respectively. and yield was slightly loosed to 2%. Therefore, the efficiency of hydrogen peroxide and ultrasonication bleaching system of paper mulberry pulp was superior to the conventional hydrogen peroxide bleaching system. Magnesium sulfate acted as a bleaching stabilizer for the increasement of yield. As a result, the yield and viscosity were increased to 2.2% and 12% respectively.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2008년도 추계학술대회 논문집
• /
• pp.391-394
• /
• 2008

Global warming and air pollution have increased the amount $CO_2$ in the atmosphere. In order to decrease the amount of $CO_2$, lots of researches are conducted toward using Hydrogen energy. Because of its high efficiency energy level and environmental friendly features, many companies have researched on developing hydrogen engine system and distributed generation system. Especially, the focus of this research provides the operation method of linear generator for hydrogen fuel combustion linear engine. During an ignition, linear generator is operated by motor to create the initial condition of engine combustion. Once the engine combustion is stabilized, the generator supplies electric power to grid. In order to stabilize the engine, linear generator is required to control mover frequency, direction, and force; Hence the PCS(Power Conversion System) place three H-bridge type inverter stacks in parallel to control phase current independently. As well, by using Back-to-Back method, it can receive electric power from both end.

• 한국수소및신에너지학회논문집
• /
• 제19권5호
• /
• pp.445-452
• /
• 2008

DME(Dimethyl ether) Dimethyl Ether (DME) is a new clean fuel and an environmental-benign energy resource. In comparison with other fuels, DME rapidly decomposes into carbon dioxide ($CO_2$) and water in the atmosphere without forming ozone. It can be manufactured from various energy sources including natural gas, coal, biomass and spent plastics. In addition to its environmentally friendly properties, DME is considered as one of the most promising candidates for the substitute of LPG and diesel fuel. In this work, we will be studied to find optimized condition for the catalyst of DME energy manufacture from hydrogen and carbon oxide and its chemical and physical characteristics.

• 한국식품영양과학회지
• /
• 제28권3호
• /
• pp.586-592
• /
• 1999

Microwave assisted extraction(MAE) is known as a more environmental friendly process with economic advantages in terms of less time, less solvent, less energy and less wastes than the current time consuming reflux method. It was applied to develop a rapid extraction method for soluble ginseng components that are major materials used for the processing of ginseng products. In a comparative study between pre established MAE(ethanol 60%, power 80 W, process time 4 min$\times$5) and current extraction method(ethanol 80%, temp. 85oC, time 8 hr$\times$5), MAE was more efficient than the current method to obtain an extract yield(soluble solid), but it was insufficient to extract individual ginsenosides, total phenols, reducing components and acidic polysaccharides. MAE with 80% ethanol by 5 times showed, however, that its extraction efficiency on soluble solid, crude saponin, major ginsenosides, and the other components was equal or superior to that of the current method, indicating that ethanol concentration is one of the critical parameters influencing the MAE process. The quality of ginseng extracts from MAE was assured by evaluating the corresponding standards and by comparing TLC and HPLC patterns with the control.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2013년도 춘계 학술논문 발표대회
• /
• pp.321-322
• /
• 2013

Recently, the exhaustion of resource and environmental damage is serious due to the global warming because of the CO₂ exhaust and each type the natural aggregate picking described below. meanwhile, The rest is the actual condition gone to the dumping ground that there is nearly no use which the waste glass can recycle and it is recycled. This research applied the waste glass as the cement substitute material the inorganic binder and coares aggregate substitute material. It utilizes the substitute material of the cement according to it and natural aggregate and tries to develop the environment-friendly artificial stone. The inorganic binder used the blast furnace slag, red mud, and fly ash. The straight type steel fiber, PVA fiber, PA fiber, and cellulosic fiber were used with a kind of fiber. As to the experimental item according to it, the compressive strength is the flexural strength and compressive strength.

• 한국산학기술학회논문지
• /
• 제9권6호
• /
• pp.1739-1744
• /
• 2008

본 연구에서는 현재 국내에서 다량 사용하고 있는 중금속 크롬($Cr^{6+}$)과 납(Pb)이 포함된 녹색안료를 대체하기 위하여 유동층기상증착(FB-VD) 공정을 사용한 무독성 유 무기 복합안료를 개발하였다. 안교제조를 위하여 카올린(Kaolin) 계열의 화합물과 탄산칼슘($CaCO_3$)을 담체로 사용하였으며, 담체들의 표면특성과 구성성분은 SEM과 EDXS를 사용하여 고찰하였다. 또한 안료의 성능을 극대화하기 위하여 다양한 종류의 계면활성제를 사용하고, 그 성능 차이를 고찰하였다. 녹색안료의 색상발현 실험을 한 결과 건조상태나 색상발현에서 녹색물실 배합농도에 차이를 보였으나, 음이온 계면활성제를 사용한 경우 건조와 색상발현에 가장 적합하였다.