• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2004.11a
• /
• pp.337-340
• /
• 2004

Stabilizing systems with Gyroscope are extensively used in various tracking devices for attaining the system's objective. Because of putting performance first in importance of system and focusing on specification of parts, designers are sometimes passing over the dynamic characteristics of system in vibrating condition. In this paper, we were dealing with unstable stabilizing control due to coincidence of stabilization platform natural frequency and that of Gyroscope used for sensing rate. For solving this problem, statics and dynamic test of silicon rubber with 3 different hardness were performed and similar stabilizing system was adopted to prove reasonability of rubber choice and static pre-strain.

• Korean Journal of Remote Sensing
• /
• v.23 no.5
• /
• pp.421-430
• /
• 2007

This paper presents the results of the ocean surface current velocity estimation using 6 Radarsat-1 SAR images acquired in west coastal area near Incheon. We extracted the surface velocity from SAR images based on the Doppler shift approach in which the azimuth frequency shift is related to the motion of surface target in the radar direction. The Doppler shift was measured by the difference between the Doppler centroid estimated in the range-compressed, azimuth-frequency domain and the nominal Doppler centroid used during the SAR focusing process. The extracted SAR current velocities were statistically compared with the current velocities from the high frequency(HF) radar in terms of averages, standard deviations, and root mean square errors. The problem of the unreliable nominal Doppler centroid for the estimation of the SAR current velocity was corrected by subtracting the difference of averages between SAR and HF-radar current velocities from the SAR current velocity. The corrected SAR current velocity inherits the average of HF-radar data while maintaining high-resolution nature of the original SAR data.

• Journal of Korean Home Economics Education Association
• /
• v.7 no.2
• /
• pp.91-101
• /
• 1995

The purposes of the study were to: (1) develop instructional method for consumer education of home economics in the middle school. (2) test the effectiveness of the developing instructional method focusing on the problem solving. In the method of the research, literature review related to the consumer education. models of teaching and characteristics of problem solving method were studied. Also, on the basis of theoretical evidence. the teaching plan focusing on problem solving method was developed. In addition, experimental research was done to find out the learning effectiveness on the developing instructional method of the study. This experimental research were made in the six classes of the three middle school in Seoul. For the statistical analysis of the study, frequency, mean and two way ANOVA(factorial design) were used. The results of this study were summarized as follows; (1) The developed instructional method of the study was more effective than the traditional lecture method. (2) The effects of the teaching-learning method were depended on the sex. The learning effects on the female students were higher than the male students. (3) The learning effects on the students were influenced by the sex and teaching method.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.4
• /
• pp.285-289
• /
• 2018

In this paper, we demonstrate electromagnetic wave focusing and rectification based on time reversal as a smart method for far-field wireless power transfer. Time reversal in a complex propagation environment allows for transmission of high peak power pulses by focusing the electromagnetic waves selectively regardless of the receiver position. We demonstrate wave focusing and radio frequency (RF) to direct current (DC) rectification via numerical simulation of a complex propagation environment. The results reveal that time reversal can ensure peak power up to 12 dB greater compared to a narrowband continuous wave signal, thereby enhancing the rectified DC voltage with better efficiency.

• Proceedings of the KSME Conference
• /
• 2004.04a
• /
• pp.1643-1648
• /
• 2004

When a shock wave propagates into a Helmholtz resonator, very complicated wave phenomena are formed both inside and outside the resonator tube. Shock wave reflection, shock focusing phenomena and shock-vortex interactions cause strong pressure fluctuations inside the resonator, consequently leading to powerful sound emission. In the present study, the wave phenomena inside and outside the Helmholtz resonator are, in detail, investigated with a help of CFD. The Mach number of the incident shock wave is varied below 2.0 and several types of resonators are tested to investigate the influence of resonator geometry on the wave phenomena. A TVD scheme is employed to solve the axisymmetric, compressible, Euler equations. The results obtained show that the configuration of the Helmholtz resonator significantly affects the peak pressure of shock wave focusing, its location, the amplitude of the discharged wave and resonance frequency.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.11a
• /
• pp.744-749
• /
• 2005

In this paper, a lens actuator for mobile devices is proposed using stack type piezoelectric materials. In general, the deformation of PZT actuators is not enough for lens motion when the allowed voltage is applied. The small stroke problem can be solved by accumulating a lot of small displacements in high frequency. In this paper, a new inch-worm type model for focusing actuator is suggested based on the interaction of inertial and frictional forces. Theoretical analysis and simulation using ANSYS are performed to verify the feasibility of the inch-worm PZT actuator model. Various types of clamps are considered to determine the effect of frictional force on the motion, and appropriate clamp-actuator models are proposed. The proposed models are experimentally verified and the experimental results show high correspondence with theoretical and simulated values. The inch-worm type focusing actuator enable a large stroke with 7.79 mm/sec with 10kHz and 10V.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.27 no.5
• /
• pp.558-566
• /
• 2024

This study proposes method for enhancing the performance of previously developed or produced weapon systems without developing new detection equipment by using Phase Gradient Metasurfaces(PGMS). Metasurface has been studied and utilized a lot to improve the detection performance of inorganic systems, but its utilization is low due to its narrow bandwidth and complex structure. To address some of these limitations, dual-band power focusing PGMS is proposed. Its frequency independent unit cell characteristic enables creating metasurface that concentrates signals in dual-band. The designed PGMS was validated through near-field and far-field measurement, confirming signal concentration at the specified focal length and improved gain in the dual bands.

• Journal of Positioning, Navigation, and Timing
• /
• v.3 no.1
• /
• pp.11-16
• /
• 2014

A Satellite Based Augmentation System (SBAS) is a representative differential GNSS system, which is used for the navigation performance improvement of Global Navigation Satellite System (GNSS) users. SBAS has been developed focusing on the securement of user integrity so that it can be used for the navigation in aviation fields. Accordingly, the development of SBAS has been completed, and it has been actively used in the United States, Europe, and Japan. As the new satellite of Global Positioning System (GPS) recently started to broadcast new civil signals (L5 frequency), the methods for improving user navigation performance in SBAS using this signal have also been studied. In Korea, to keep pace with these circumstances, full-scale SBAS development is expected to start in 2014, and studies on dual-frequency SBAS using L1/L5 frequencies will also be performed. In this study, before the full-scale development of dual-frequency SBAS in Korea, a simulation was performed to predict the performance and analyze the expected effects.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.49 no.10
• /
• pp.47-53
• /
• 2012

Time-reversal (TR) precoding focuses the energy of the effective channel in time and improves receive performance of a single tap receiver. Frequency-domain equal-gain-combining (FD-EGC) TR scheme, which works in linear block precoding fashion, has better temporal focusing performance than the traditional TR. Also, the FD-EGC improves receive performance of minimum mean square error receiver with distributed antenna systems (DAS). The detailed receive performance of the FD-EGC was analyzed in our previous work. In this paper, we focused on capacity analysis of the FD-EGC in DAS. We derived a scaling law which shows how the use of multiple antenna can increase the capacity of the FD-EGC precoding compared with that of no precoding. In addition, we analyze the secrecy rate of the FD-EGC which shows how high-rate messages can be transmitted towards an intended user without being decoded by the other users from the view point of information theoretic security.

• The Research Journal of the Costume Culture
• /
• v.27 no.4
• /
• pp.398-413
• /
• 2019

This study empirically analyzed the influence of fashion brands' marketing issues on actual sales and consumer preference-focusing on evaluation trends of brands over time by using the theoretical background and big data provided through literature. This study examined the influence of three fashion brands (Balenciaga, Vetements, and Off-White) that have recently seen a drastic increase in the number of searched volumes through social networks. To identify the consumer-brand evaluations and trends and the marketing issues, the time period was divided into Groups A and B, which are from 2014 to 2015 and from 2016 to 2017, respectively. This study analyzed the frequency of overlapping keywords by using the R program to graphically visualize the changes over the timeline. Specifically, this analysis extracted data mainly related to bags, wallets and accessories for 2014-2015, but in 2016-2017, all four brands saw a vast increase in the frequency of searching product keywords related to clothing and footwear, and newly extracted ones were the top keywords. When analyzing the big data with these keywords as indicators, I confirmed that the products related to bags, wallets, and accessories were shifted to those related to apparel and footwear. Consumers previously recognized luxury brands such as Balenciaga as accessories-oriented brands that were focused on handbags and sunglasses, but now they are gaining popularity and recognition among consumers as a fashion brand.