• Electrical & Electronic Materials
• /
• v.9 no.7
• /
• pp.708-718
• /
• 1996

The microstructure and electrical properties of the nonlinear ZnO varistor with A1$_{2}$ $O_{3}$ additions is investigated. The variation of nonlinear behavior with A1$_{2}$ $O_{3}$ additions is indicated from J-E and C-V measurement to be a result of the change of the interface defects density $N_{t}$ at the grain boundaries and the donor concentration $N_{d}$ in the ZnO grains. The optimum composition which has the nonlinear coefficients of -57 was observed in the sample with 0.005wt% A1$_{2}$ $O_{3}$ additions. The conduction mechanism at the pre-breakdown region is consistent with a Schottky thermal emission process obeying a relation given by $J^{\var}$exp[-(.psi.-.betha. $E^{1}$2/)kT] and the conduction process at the breakdown region follows a Fowler-Nordheim tunneling mechanism of the form $J^{\var}$exp(-.gamma./E).

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.11
• /
• pp.980-986
• /
• 2009

In a triple-layered structure of ITO/N,N'-diph enyl-N,N'bis(3-methylphenyl)-1,1' - biphenyl-4,4'-diamine(TPD)/tris(8-hydroxyquinoline)aluminum($Alq_3$)/(2,9-Dimethyl-4,7-diphenyl-1,10-phenanthroline(BCP)/Al device, we have studied the electrical and optical characteristics of organic light-emitting diodes(OLEDs) depending on the deposition condition of BCP layer. Several different sizes of holes on boat and several different deposition rates were employed in evaporating the organic materials. And then, electrical properties of the organic light-emitting diodes were measured and the performance of the devices was analyzed. It was found that the hole-size of crucible boat and the evaporation rate affect on the surface roughness of BCP layer as well as the performance of the device. When the hole-size of crucible boat and the deposition rate of BCP are 1.2 mm and $1.0\;{\AA}/s$, respectively, average surface roughness of BCP layer is lower and the efficiency of the device is higher than the ones made with other conditions. From the analysis of current density-luminance-voltage characteristics of a triple layered device, we divided the conductive mechanism by four region according to applied voltage. So we have obtained a coefficient of ${\beta}_{ST}$ in schottky region is $3.85{\times}10^{-24}$, a coefficient of ${\beta}_{PF}$ in Poole-Frenkel region is $7.35{\times}10^{-24}$, and a potential barrier of ${\phi}_{FN}$ in Fower-Nordheim region is 0.39 eV.

• Korean Journal of Materials Research
• /
• v.2 no.4
• /
• pp.285-292
• /
• 1992

Ultrathin(8nm) oxynitride (SiOxNy) film have been formed on Si(100) by rapid thermal processing(RTP) in $O_2$and $N_2$O as reactants. Compared with conventional furnace $O_2$ oxide, the oxynitride dielectrics shows better characteristics of I-V and TDDB, and less flat-band voltage shift. The oxynitride has a behavior of Fowler-Nordheim tunneling in the region of V 〉${\varphi}_0$ simialr to pure Si$O_2$oxide. The relative dielectric constant of oxynitride is higher than that of conventional pure oxide. Excellent diffusion harrier property to dopant(B$F_2$) is also observed. Nitrogen depth profiles by SIMS, AES, and XPS show nitrogen pile - up at Si$O_2$/Si interface, which can explain the improved properties of oxynitride dielectrics.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.729-732
• /
• 2001

In this study, the effect of oxygen partial pressure on the electrical properties of vanadium oxide(VO$_{x}$) thin films were investigated. The thin films were prepared by r.f. magnetron sputtering from V$_2$O$_{5}$ target in a gas mixture of argon and oxygen. The oxygen partial pressure ratio is changed from 0% to 8%. I-V characteristics were distinguished between linear and nonlinear region. In the low field region the conduction is due to Schottky emission, while at high fields it changes to Fowler-Nordheim tunneling type conduction. The conductivity measurements have shown an Arrhenius dependence of the conductivity on the temperature.ure.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.11a
• /
• pp.435-438
• /
• 2003

The effects of oxygen partial pressure and vacuum annealing on the electrical properties of sputtered vanadium oxide($VO_x$) thin films were investigated. The thin films were prepared by r.f. magnetron sputtering from $V_2O_5$ target in a gas mixture of argon and oxygen. The oxygen/(oxygen+argon) partial pressure ratio of 0% and 8% is adopted. Electrical properties of films sputter-deposited under different oxygen gas pressures and in situ annealed in vacuum at $400^{\circ}C$ for 1h and 4h are characterized through electrical conductivity measurements. I-V characteristics were distinguished between linear and nonlinear region. In the low field region the conduction is due to Schottky emission, while at high fields it changes to Fowler-Nordheim tunneling type conduction. The conductivity measurements have shown an Arrhenius dependence of the conductivity on the temperature.

• Korean Journal of Materials Research
• /
• v.4 no.1
• /
• pp.63-74
• /
• 1994

The ultrathin oxide films less than 100$\AA$ were grown by thermal oxidation in $N_2O$ ambient to improve the controllability of thickness, thickness uniformity, process reproducibility and their electrical properties. Oxidation rate was reduced significantly at very thin region due to the formation of oxynitride layer in $N_2O$ ambient and moreover nitridation of the oxide layer was simultaneously accompanied during growth. The nitrogen incorporation in the grown oxide layer was characterized with the wet chemical etch-rate and ESCA analysis of the grown oxide layer. All the oxides thin films grown in $N_2O$, pure and dilute $O_2$ ambients show Fowler-Nordheim electrical conduction. The electrical characteristics of thin oxide films grown in $N_2O$ such as leakage current, electrical breakdown, interface trap density generation due to the injected electron and reliability were better than those in pure or dilute ambient. These improved properties can be explained by the fact that the weak Si-0 bond is reduced by stress relaxation during oxidation and replacement by strong Si-N bond, and thus the trap sites are reduced.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.11
• /
• pp.1699-1705
• /
• 1989

Nitridation of about 300\ulcornerSiO2 filmss thermally grown on Si was performed in NH3 plasm ambient (0.2-2 torr) at 900\ulcornerC-1100\ulcorner for 15-20 minutes. The peoperties of those films have been investigated by analyzing the AES and the SIMS data, and the results of the I-V and the C-V measurements. At the plasma ambient of less than 1.5 torr pressure, etching of the films have been shown. Above the 1.5 torr pressure, however, SiO2 films were nitrided as SiIxNy. Plasma thermal nitridation of SiO2 by addition of small amount (6%) of CF4 to the NH3 showed higher pile-up N concentration in the surface region of SiOxNy film. The higher the nitridation temperature is and the longer the nitridation time is the larger the dielectric constant is. The plasma thermal nitridation of silicon dioxide on silicon causes the flat-band voltage shift based on the formation of the positive charge. The conduction mechanism for SiOxNy films could be elucidated by Fowler-Nordheim tnneling model. By SIMS analysis, surface of the film nitrided in plasma process has less contamination than that of the film nitrided in open-tube process.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07a
• /
• pp.54-57
• /
• 2002

In this study, a new programming method, to minimize the generation of Si-SiO$_2$ interface traps of scaled SONOS flash memory as a function of number of program/erase cycles has been proposed. In the proposed programming method, power supply voltage is applied to the gate, forward biased program voltage is applied to the source and the drain, while the substrate is left open, so that the program is achieved by Modified Fowler-Nordheim (MFN) tunneling of electron through the tunnel oxide over source and drain region. For the channel erase, erase voltage is applied to the gate, power supply voltage is applied to the substrate, and the source and drain are open. A single power supply operation of 3 V and a high endurance of 1${\times}$10$\^$6/ prograss/erase cycles can be realized by the proposed programming method. The asymmetric mode in which the program voltage is higher than the erase voltage, is more efficient than symmetric mode in order to minimize the degradation characteristics of scaled SONOS devices because electrical stress applied to the Si-SiO$_2$ interface is reduced by short programming time.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.16 no.1
• /
• pp.5-10
• /
• 2003

In this study, a new programming method to minimize the generation of Si-SiO$_2$interface traps of SONOS nonvolatile memory device as a function of number of porgram/erase cycles was proposed. In the proposed programming method, power supply voltage is applied to the gate. forward biased program voltage is applied to the source and the drain, while the substrate is left open, so that the program is achieved by Modified Fowler-Nordheim(MFN) tunneling of electron through the tunnel oxide over source and drain region. For the channel erase, erase voltage is applied to the gate, power supply voltage is applied to the substrate, and the source and dram are left open. Also, the asymmetric mode in which the program voltage is higher than the erase voltage, is more efficient than symmetric mode in order to minimize the degradation characteristics or SONOS devices because electrical stress applied to the Si-SiO$_2$interface is reduced due to short program time.

• Korean Journal of Materials Research
• /
• v.29 no.8
• /
• pp.463-468
• /
• 2019

The electrical and interfacial properties of $HfO_2/Al_2O_3$ and $Al_2O_3/HfO_2$ dielectrics on AlN/p-Ge interface prepared by thermal atomic layer deposition are investigated by capacitance-voltage(C-V) and current-voltage(I-V) measurements. In the C-V measurements, humps related to mid-gap states are observed when the ac frequency is below 100 kHz, revealing lower mid-gap states for the $HfO_2/Al_2O_3$ sample. Higher frequency dispersion in the inversion region is observed for the $Al_2O_3/HfO_2$ sample, indicating the presence of slow interface states A higher interface trap density calculated from the high-low frequency method is observed for the $Al_2O_3/HfO_2$ sample. The parallel conductance method, applied to the accumulation region, shows border traps at 0.3~0.32 eV for the $Al_2O_3/HfO_2$ sample, which are not observed for the $Al_2O_3/HfO_2$ sample. I-V measurements show a reduction of leakage current of about three orders of magnitude for the $HfO_2/Al_2O_3$ sample. Using the Fowler-Nordheim emission, the barrier height is calculated and found to be about 1.08 eV for the $HfO_2/Al_2O_3$ sample. Based on these results, it is suggested that $HfO_2/Al_2O_3$ is a better dielectric stack than $Al_2O_3/HfO_2$ on AlN/p-Ge interface.