• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2017.11a
• /
• pp.232-233
• /
• 2017

In this research, tunnel stern was applied on the asymmetric high-speed catamaran to evaluate vessel's hydrodynamic performance by numerical method, and the tunnel stern types are distinguished by angle of inclination of tunnel exit region into 3cases ($0^{\circ}$, $3^{\circ}$ and $6^{\circ}$). Consequently, it is confirmed that the total resistances of tunnel stern which have $0^{\circ}$ of inclination are lower about 4.8-17.9% than the bare hull in the wide speed range, but those of $3^{\circ}$ and $6^{\circ}$ of inclination tunnel stern are higher than bare hull about 5-14% and 5-29%, respectively. On the other hand, trim angles of $0^{\circ}$ of inclination tunnel stern show similar trend with those of bare hull in whole ranges of FnV but those of $3^{\circ}$ and $6^{\circ}$ of inclination tunnel stern are stabilized and declined respectively after FnV=1.54. These phenomena indicated that increasing angle of inclination of tunnel exit region had negative influence on resistance performance, however, it could make vessel's operation performance better than bare hull.

• Asian-Australasian Journal of Animal Sciences
• /
• v.33 no.5
• /
• pp.704-711
• /
• 2020

Objective: Muscle fiber types, numbers and area are crucial aspects associated with meat production and quality. However, there are few studies of pig muscle fibre traits in terms of the detection power, false discovery rate and confidence interval precision of whole-genome quantitative trait loci (QTL). We had previously performed genome scanning for muscle fibre traits using 183 microsatellites and detected 8 significant QTLs in a White Duroc×Erhualian F₂ population. The confidence intervals of these QTLs ranged between 11 and 127 centimorgan (cM), which contained hundreds of genes and hampered the identification of QTLs. A whole-genome sequence imputation of the population was used for fine mapping in this study. Methods: A whole-genome sequences association study was performed in the F₂ population. Genotyping was performed for 1,020 individuals (19 F₀, 68 F₁, and 933 F₂). The whole-genome variants were imputed and 21,624,800 single nucleotide polymorphisms (SNPs) were identified and examined for associations to 11 longissimus dorsi muscle fiber traits. Results: A total of 3,201 significant SNPs comprising 7 novel QTLs showing associations with the relative area of fiber type I (I_RA), the fiber number per square centimeter (FN) and the total fiber number (TFN). Moreover, one QTL on pig chromosome 14 was found to affect both FN and TFN. Furthermore, four plausible candidate genes associated with FN (kinase non-catalytic C-lobe domain containing [KNDC1]), TFN (KNDC1), and I_RA (solute carrier family 36 member 4, contactin associated protein like 5, and glutamate metabotropic receptor 8) were identified. Conclusion: An efficient and powerful imputation-based association approach was utilized to identify genes potentially associated with muscle fiber traits. These identified genes and SNPs could be explored to improve meat production and quality via marker-assisted selection in pigs.

• Journal of Korean Neurosurgical Society
• /
• v.51 no.5
• /
• pp.253-261
• /
• 2012

Objective : This study was performed to determine the anatomical landmarks and optimal dissection points of the facial nerve (FN) and the hypoglossal nerve (HGN) in the submandibular region to provide guidance for hypoglossal-facial nerve anastomosis (HFNA). Methods : Twenty-nine specimens were obtained from 15 formalin-fixed adult cadavers. Distances were measured based on the mastoid process tip (MPT), common carotid artery bifurcation (CCAB), and the digastric muscle posterior belly (DMPB). Results : The shortest distance from the MPT to the stylomastoid foramen was $14.1{\pm}2.9$ mm. The distance from the MPT to the FN origin was $8.6{\pm}2.8$ mm anteriorly and $5.9{\pm}2.8$ mm superiorly. The distance from the CCAB to the crossing point of the HGN and the internal carotid artery was $18.5{\pm}6.7$ mm, and that to the crossing point of the HGN and the external carotid artery was $15.1{\pm}5.7$ mm. The distance from the CCAB to the HGN bifurcation was $26.6{\pm}7.5$ mm. The distance from the digastric groove to the HGN, which was found under the DMPB, was about $35.8{\pm}5.7$ mm. The distance from the digastric groove to the HGN, which was found under the DMPB, corresponded to about 65.5% of the whole length of the DMPB. Conclusion : This study provides useful information regarding the morphometric anatomy of the submandibular region, and the presented morphological data on the nerves and surrounding structures will aid in understanding the anatomical structures more accurately to prevent complications of HFNA.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.34 no.1
• /
• pp.14-26
• /
• 2010

This study investigates the effectiveness of fashion coordination presentation formats when people buy apparel products online. This study conducted an online survey with 595 females who shopped online at the simulated website by a single apparel plan picture (n=189), coordination plane picture (n=187), and 3-D coordination image (n=216). For data analysis, factor analysis, Cronbach's alpha, MANCOVA, ANOVA, Duncan test, correlation analysis, and chi-square are used. The results of this study are: First, the hedonic shopping value was significantly the highest when respondents shopped at a 3-D coordination image shopping mall, the next highest-scored presentation type was the coordination plane picture, and the case of presenting only the single apparel picture was significantly the lowest. The utilitarian shopping value and information shopping value were higher in the coordination plane picture and the 3-D coordination image shopping mall than the single apparel picture. Second, transactions satisfaction was high when respondents shopped at a 3-D coordination image, coordination plane image, and single apparel image in decreasing order.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.5
• /
• pp.601-608
• /
• 2014

In this paper, we have characterized the electrical properties related to gate leakage current in AlGaN/GaN MISHFETs with varying the thickness (0 to 10 nm) of $Al_2O_3$ gate insulator which also serves as a surface protection layer during high-temperature RTP. The sheet resistance of the unprotected TLM pattern after RTP was rapidly increased to $1323{\Omega}/{\square}$ from the value of $400{\Omega}/{\square}$ of the as-grown sample due to thermal damage during high temperature RTP. On the other hand, the sheet resistances of the TLM pattern protected with thin $Al_2O_3$ layer (when its thickness is larger than 5 nm) were slightly decreased after high-temperature RTP since the deposited $Al_2O_3$ layer effectively neutralizes the acceptor-like states on the surface of AlGaN layer which in turn increases the 2DEG density. AlGaN/GaN MISHFET with 8 nm-thick $Al_2O_3$ gate insulator exhibited extremely low gate leakage current of $10^{-9}A/mm$, which led to superior device performances such as a very low subthreshold swing (SS) of 80 mV/dec and high $I_{on}/I_{off}$ ratio of ${\sim}10^{10}$. The PF emission and FN tunneling models were used to characterize the gate leakage currents of the devices. The device with 5 nm-thick $Al_2O_3$ layer exhibited both PF emission and FN tunneling at relatively lower gate voltages compared to that with 8 nm-thick $Al_2O_3$ layer due to thinner $Al_2O_3$ layer, as expected. The device with 10 nm-thick $Al_2O_3$ layer, however, showed very high gate leakage current of $5.5{\times}10^{-4}A/mm$ due to poly-crystallization of the $Al_2O_3$ layer during the high-temperature RTP, which led to very poor performances.

• The Korean Journal of Mycology
• /
• v.41 no.1
• /
• pp.38-41
• /
• 2013

In 2010 and 2011, gray mold was found on common fig (Ficus carica) fruit grown at the research field of Jeollabuk-do Agricultural Research and Extension Services, Korea. Gray mold symptoms on common fig fruit mainly occurred after harvest season until December. The typical symptom included brown water-soaked rot and fruit decay. The diseased fruit was covered by gray to brown colored conidiophore and conidia. The conidiophores were tree shape and measured $15-33{\times}2{\mu}m$. Conidia on conidiophore were ellipsoidal or lemon shape, colorless, single cell, and measured $7.3-14.6{\times}6.8-11.1{\mu}m$. The nucleotide sequences of the rDNA ITS region obtained from the pure culture of the gray mold on common fig were 100% similar to the sequences of the GenBank accession number HQ171052, EU519210, HQ171053, FN812726, HM849615, and EU563120 of B. cinerea isolates. In phylogenetic tree, the representative isolate was placed within same clade of B. cinerea. Based on the morphological characteristics and analysis of rDNA ITS sequence data, the fungus was identified as B. cinerea.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.24 no.7
• /
• pp.945-952
• /
• 2018

Recently, bass fishing has become a marine leisure sport in Korea. There are 4 major fishing associations in Korea, and each association holds 10-15 tournaments each year. However, supply of 17 ft bass boats, which are preferred in leagues, depends 100 % on imports. In this study, we have derived the main specifications to develop the initial hull forms of a 18.5ft bass boat through statistical analysis based on mothership data. In addition, CFD numerical analysis was carried out according to deadrise angle and longitudinal center of gravity, which strongly influenced the resistance and planing performance. For numerical analysis, design speed was set to $Fn=3.284 (Re=9.858{\times}10^7)$, the deadrise angle was set from 12 to $20^{\circ}$, and the longitudinal center of gravity was set in the range of 0 to $8%L_{wL}$ from the center of buoyancy to the stern. Based on the numerical results, we first set the range of these factors by resistance performance and immersion keel length. Furthermore, using a correlation graph of Savitsky's Drag-Lift ratio, we derived the deadrise angle ($14-16^{\circ}$) and longitudinal center of gravity ($4-6%L_{wL}$).

• Reproductive and Developmental Biology
• /
• v.29 no.4
• /
• pp.259-267
• /
• 2005

The present study was conducted to investigate gelatinolytic activities in HAM and to determine whether there are any changes in gelatinolytic activity profiles when the cells are cultured in hepatogenic medium. Placenta was obtained during caesarean section of the volunteers, with informed consent. HAM were isolated from amniotic membrane using collagenase type A HAM were cultured in hepatogenic medium for 3 weeks and the conditioned media were obtained at day 7, 14 and 21. The zymographic pattern of gelatinolytic activity of the HAM did not undergo a change during passages. When the HAM were cultured in a fibronectin-coated dishes in a hepatogenic medium, there was no significant difference of the gelatinase pattern between before and after culture. However, when bFGF was added to the culture, a dramatic increase of 62kDa and 59kDa gelatinases was observed. Interestingly, when ITS instead of FN was present, HAM-conditioned medium also showed a similar increase of both gelatinases. Immunoblotting analysis demonstrated that both 62kDa and 59kDa gelatinases were the active form of MMP-2 resulting from the turnover of MMP-2 proform. Futher study will be necessary to determine the relationship between bFGF and active MMP-2 during hepatogenesis of HAM.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.13 no.1
• /
• pp.858-876
• /
• 2021

Although widely used, the design of the bulbous bow for ships has been difficult due to the complex interference between the wave system generated by the bulb and the wave system of the ship hull. Until now, a bulbous bow has been often designed using Kracht charts, which were established based on model test data, but these charts apply only to ships with a block coefficient C_B = 0.56-0.82, Froude number Fn = 0.20-0.40, and the obtained bulb sizes are only close to optimal. This paper presents a new method for the optimal design of bulbous bow, starting from the design of an initial bulb using Kracht charts for ships with any block coefficient or Froude number, then resizing this initial bulb to define the optimal bulb sizes based on a multi-objective function of the required power reduction, and a combined solution of Computation Fluid Dynamics (CFD) analysis and surrogate models. This study was applied to a fishing vessel FAO 75, which has been model tested and used to design steel fishing vessels in Vietnam recently. The obtained quantitative results showed the same trend as the theory and practice, with a reduction of the ship's required power by about 14%.

• Journal of Life Science
• /
• v.19 no.8
• /
• pp.1093-1103
• /
• 2009

The purpose of this study was to analyze the effects of ballet program training at the Royal Academy of dance (RAD) on body composition (BC), physical fitness (PF) and bone mineral density (BMD) in college women. The subjects for this study were 14 females aged 19 to 22, who were divided into the Experimental group (n=7, EG) and the Control group (n=7, CG). The RAD ballet program training was done by 7 subjects (EG), 60 minutes per day, three times a week for 12 weeks. The TBF and %fat significantly decreased and LBM increased in the Experimental group, but all the variables of Body composition in the Control group did not significantly changed. The AMS, Sit ups, STF, SLJ CFB and 1,200 m R & W in the EG significantly increased, but 1,200 m R & W in the CG decreased. The lumbar vertebra (LV), femoral neck (FN), greater trochanter (GT) and ward's triangle (WT) did not significantly change in the EG, but LV, GT and WT in the CG decreased. There was no significant difference in osteopenia for EG, but there were increases in GT and WT for the CG. There was significant correlation between BMDs and body weight, TBF, LBM, %fat, BMI, AMS. There was significant correlation between LV and FN and LV and whole body. In conclusion, regular and continuous RAD training was effective in improving the body composition, physical fitness and bone mineral density. Consequently, RAD training will be effective for preventing osteopenia and osteoporosis, and for improving the health-related fitness for college and middle-aged women.