• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.7
• /
• pp.37-43
• /
• 2008

In this paper, the dependence of electrical characteristics of Silicon-$Al_2O_3$-Nitride-Oxide-Silicon (SANOS) memory cell transistors and program/erase (P/E) speed, reliability of memory device on interface trap between Si substrate and tunneling oxide and bulk trap in nitride layer were investigated using charge pumping method which has advantage of simple and versatile technique. We analyzed different SANOS memory devices that were fabricated by the identical processing in a single lot except the deposition method of the charge trapping layer, nitride. In the case of P/E speed, it was shown that P/E speed is slower in the SANOS cell transistors with larger capture cross section and interface trap density by charge blocking effect, which is confirmed by simulation results. However, the data retention characteristics show much less dependence on interface trap. The data retention was deteriorated as increasing P/E cycling number but not coincides with interface trap increasing tendency. This result once again confirmed that interface trap independence on data retention. And the result on different program method shows that HCI program method more degraded by locally trapping. So, we know as a result of experiment that analysis the SANOS Flash memory characteristic using charge pumping method reflect the device performance related to interface and bulk trap.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.46 no.1
• /
• pp.76-81
• /
• 2009

A novel design method of time-interleaved subranging ADC is presented. We use the bisection method to let only half of comparators in typical subranging ADC working in every clock cycle. Thus, we are able to reduce the number of comparators by half. It is possible to reduce the die size. An example of 8-bit time-interleaved subranging ADC operates at 40MHz sampling rate and 1.8V supply voltage is demonstrated. The power consumption of the proposed circuit is only 10mV with SPECTRE simulation. Compared with the typical subranging ADC, our bisection method is able to reduce up to 40% in die size.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.4
• /
• pp.325-336
• /
• 2013

FlashLinQ, one of the typical D2D communication systems developed by Qualcomm, considers a single-tone communication based distributed channel-aware link scheduling method to realize the link scheduling process with low control overheads. However, considering the frequency selective fading effect of practical multi-path channel, the single-tone based SIR estimation causes a critical scheduling error problem because the received single-tone signal has quite different channel gain at each sub-carrier location. In order to overcome this problem, we propose a novel link scheduling method based on CAZAC (Constant Amplitude Zero Auto-Correlation) sequence for D2D communication system. In the proposed method, each link has a unique offset value set for the generation of CAZAC sequences. CAZAC sequences with the cyclic offsets are transmitted using multiple sub-blocks in the entire bandwidth, and then each device can obtain nearly full-band SIR using a good cyclic cross-correlation property of CAZAC sequence.

• Journal of Internet of Things and Convergence
• /
• v.10 no.2
• /
• pp.109-114
• /
• 2024

Enterprise storage systems that require high data reliability are applying RAID (Redundant Array of Independent Disks) systems to recover from data loss and failure. In particular, RAID 5 ensures space efficiency and reliability by distributing parity across multiple storage devices. However, when storage devices have different capacities, RAID is built based on the smallest capacity storage device, resulting in wasted storage space. Therefore, research is needed to solve this resource management problem. In this paper, we propose a method for RAID grouping of each independent NAND flash memory block in a RAID consisting of SSD (Solid State Disk) with external SSDs as well as internal SSDs. This method is divided into a policy for delivering block information inside SSDs to the RAID system and a policy for RAID grouping of physical addresses delivered from the RAID system. This method allows us to maintain a RAID that does not waste resources when SSDs of different capacities are grouped into RAID5. Finally, we demonstrate the effectiveness of the proposed method through experiments.

• Journal of Korea Water Resources Association
• /
• v.44 no.11
• /
• pp.875-887
• /
• 2011

The objective of this study is to develop and evaluate a Korean threshold runoff computation method. The selected study area is the Han-River basin and the stream channels in the study area are divided into 3 parts; natural channel and artificial manmade channel for small mountainous catchments, and main channel for master stream. The threshold runoff criteria for small streams is decided to 0.5 m water level increase from the channel bottom, which is the level that mountain climbers and campers successfully escape from natural flood damage. Threshold runoff values in natural channel of small mountainous area are computed by the results from the regional regression analysis between parameters of basin and stream channel, while those in artificial channel of small mountainous area are obtained from the data of basin and channel characteristics parameter. On the other hand, the threshold runoff values for master channel are used the warning flood level that is useful information for escaping guideline for riverside users. For verification of the threshold runoff computation method proposed in this study, three flash flood cases are selected and compared with observed values, which is obtained from SCS effective rainfall computation. The 1, 3, 6-hour effective rainfall values are greater than the corresponding threshold runoff values represents that the proposed computation results are reasonable.

• Journal of radiological science and technology
• /
• v.26 no.3
• /
• pp.33-39
• /
• 2003

Purpose : Be aware of clinical possibilities on image quality by comparison of contrast-enhanced dynamic CT and MR imaging applied of MIP technique after the experimentally induced clonorchasis infection in dogs. Materials and Method : Twenty mongrel dogs prepared in zoo-laboratory were followed up with serial CT scans and MR imaging for 13 weeks after the experimental infection in liver. Two-phase helical CT was acquired in the supine position with the following scanning parameters. After the injection of contrast material, the arterial phase was initiated using a bolus-racking method. The portal phase scan was started 15 seconds after the arterial phase scan. CT protocol was determined after single level dynamic scans. MR imaging used the CP body coil and images get a 2D image using HASTE, FLASH, TSE pulse sequence. Bile duct MR imaging were obtained in three plans. Then each image was post processed by using target MIP algorithm. Two experimentation above, as a method of evaluation, one pathologist, three radiologist and five radiological technologist were analyzed visually for evaluation of following findings, enhancement of the bile duct wall, dilatation of bile duct tip, liver parenchyma, background suppression. Results : Five dogs was died of a disease after the infection, the rest one else shows the chronic dilatation of the intrahepatic bile duct with CT and MR imaging. Contrast administration of CT shows the contrast-enhanced of the bile duct walls with live parenchyma. MR imaging calculated of CNR and CR from pulse sequence for comparative evaluation and shows the pattern of the intrahepatic bile duct, dilatation of bile duct tip using MIP technique. CNR of the clonorchiasis, HASTE was $16{\pm}0.83$, TSE $7.06{\pm}3.0$, FLASH $1.19{\pm}0.2$ and CR, HASTE was 73.3%, TSE 62.3%, FLASH 6.4%. Conclusion : CT and MR imaging is very usefulness in diagnosis of dog clonorchiasis.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• v.y2005m4
• /
• pp.183-188
• /
• 2005

This study targets to investigate thermal wave transfer in a droplet strongly coupled with acoustic pressure and its effects on combustion response. The one-dimensional vaporization model uses SRK equation of state and flash calculation method to obtain more accurate thermophysical properties and compute vapor-liquid equilibrium. Calculations of an n-pentane droplet exposed into a perturbing nitrogen gas is carried out in terms of different ambient gas pressures and wave frequencies. The thermal wave is transferred more effectively at lower frequencies, which results in the decrease in the amplitude of the response.

• Journal of Korea Society of Industrial Information Systems
• /
• v.8 no.3
• /
• pp.42-50
• /
• 2003

E-Learning is a modern main teaching method starting from the concept of remote education. This research is aimed for proposing cyber lecture library system and designing a cyber lecture component that becomes a basis for e-Learning system Cyber lecture library is a storage system of cyber lectures that can supply high quality data to the needed developers. Component consists of 5 categories and those are text voice, image, animation, and flash. By using this system the developers can save the necessary time and effort in education development. This system also helps students. The students can access various lecture data on a given subject and select the best fit for them.

• Journal of Microbiology and Biotechnology
• /
• v.4 no.3
• /
• pp.215-221
• /
• 1994

Two strains of yeast (RA-74-2 and RA-912) showing superior fermenting ability at a high temperature were isolated from soils and wastewaters by an enrichment culture method. Based on the morphological and physiological charateristics, the two strains were identified as Saccharomyces cerevisiae and Kluyveromyces marxianus, respectively. RA-74-2 was able to grow upto $43^{\circ}C$ and sustain similar fermenting ability in the temperatures range from 30 to $40^{\circ}C$. In addition, the sugar- and ethanol-tolerance of RA-74-2 were 30% (w/v) glucose and 10% (v/v) ethanol, which appeared to be higher than those of nine other industrial yeast strains currently being used in the alcohol factories. The thermotolerant ethanol fermenting yeast RA-912 showed identical growth in the temperatures range from 35 to $45^{\circ}C$ and was resistant to various heavy metals. The quality and quantity of byproducts of the isolated yeast strains in fermentation broth after fermentation at $40^{\circ}C$ and $45^{\circ}C$ were similiar with those obtained at $30^{\circ}C$. These results show that RA-74-2 can be adopted for the ethanol fermentation process where the expenses for cooling system is significant, and suggest that RA-912 may be applied in either SSF(simultaneous saccharification and fermentation) or Flash-fermentation process and RA-912 may be used as a gene donor for the development of thermotolerant ethanol-fermenting yeasts.

• Journal of Microbiology and Biotechnology
• /
• v.12 no.3
• /
• pp.522-525
• /
• 2002

A very rapid and efficient separation technique for cellular rhizobial cyclosophoraoses was developed based on fractional precipitation and partition chromatography. Cyclosophoraoses are known to function in the osmotic regulation and root nodule formation of legumes during the nitrogen fixation process. Cyclosophoraoses are produced as unbranched cyclic (1longrightarrow12)-${\beta}$-D-glucans in Agrobacterium or Rhizobium species. Recent research has shown that cyclosophoraoses can form inclusion complexation with various unstable or insoluble guest chemicals, thereby implying great potential for industrial application. Typical separation of pure cellular cyclosophoraoses has been so far carried out by several time-consuming steps, including size exclusion, anion exchange, and desalting liquid chromatographies, with a relatively poor recovery. However, the proposed method demonstrated that the successive application of fractional ethanol precipitation and one step of silica gel-based flash column chromatography was enough to simultaneously purify neutral or anionic forms of cyclosophoraoses. This novel technique is very rapid and provides a high recovery.