• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.28 no.2
• /
• pp.133-142
• /
• 2004

In this article, the constitutive relations of three types of piezoelectric benders, which are a unimorph bender, a bimorph bender and a triple-layer bender, are derived based on the beam theory under the quasi-static equilibrium condition. The relation coefficients are described as the geometry and material properties of the benders. More general constitutive relations involving fixed-free, fixed-roll, and fixed-simply supported boundary conditions under the inconsistent length condition between the piezoelectric layer and the nonpiezoelectric one are discussed. The complicated constitutive relations can be easily calculated and checked by using the symbolic function in ‘Mathematica’. The relation coefficients for the benders are plotted in three dimensional graph using the developed program.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.20 no.1
• /
• pp.47-52
• /
• 2007

Organic field-effect transistors (OFETS) are of interest for use in widely area electronic applications. We fabricated a copper phthalocyanine (CuPc) based field-effect transistor with varying channel length. The CuPc FET device was made a top-contact type and the channel length was a $100\;{\mu}m,\;50\;{\mu}m,\;40\;{\mu}m,\;and\;30\;{\mu}m$ and the channel width was a fixed at 3 mm. We observed a typical current-voltage (I-V) characteristics in CuPc FET with varying channel length (L) and we calculated the effective mobility. Also, we measured a capacitance-voltage (C-V) by applied bias voltage with varying frequency at 43, 100, 1000 Hz.

• Journal of the Korean Graphic Arts Communication Society
• /
• v.28 no.1
• /
• pp.43-50
• /
• 2010

The 200mesh screen was tensioned and fixed on a frame. When applied tension to 5N and 10N per unit area, a side length of opening of the screen was 163.223${\mu}m$ and 168.224${\mu}m$, respective. But side length not tensioned was 158.879${\mu}m$. We knew that a side length of opening of the screen rarely changes with tension applied to the screen. The appearances that a side length of opening of the screen expand little are due to a decreasing diameter of thread by means of tension. In a thickness measurement of screen, While the high density mesh screen that had a lot of knots that crossed a line of latitude and longitude per unit area appeared a higher numerical value, the low density mesh screen that had a few knots appeared a low numerical value.

• Structural Engineering and Mechanics
• /
• v.5 no.5
• /
• pp.529-539
• /
• 1997

This paper deals with the bending problem of a variable-are-length elastica under moment gradient. The variable are-length arises from the fact that one end of the elastica is hinged while the other end portion is allowed to slide on a frictionless support that is fixed at a given horizontal distance from the hinged end. Based on the elastica theory, exact closed-form solution in the form of elliptic integrals are derived. The bending results show that there exists a maximum or a critical moment for given moment gradient parameters; whereby if the applied moment is less than this critical value, two equilibrium configurations are possible. One of them is stable while the other is unstable because a small disturbance will lead to beam motion.

• Journal of Astronomy and Space Sciences
• /
• v.30 no.1
• /
• pp.33-41
• /
• 2013

Various features of the existing perturbations in the Earth's spin rotation are investigated for the recent and most reliable data by spectral analysis, filtering, and comparison with idealized model. First, theory of Earth's spin rotational perturbation is briefly re-derived in the Earth-fixed coordinate frame. By spectral windowings, different periodic components of the length of day perturbation are separated, and their characters and excitations are discussed. Different periodic components of polar motion are acquired similarly and described with further discussion of their excitations. Causes of the long time trends of both the length of day and polar motion are discussed. Three possible causes are considered for the newly discovered 490-day period component in the polar motion.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.19 no.6
• /
• pp.560-568
• /
• 2009

Modal vibration characteristics of a thin annular disk containing narrow radial slots are studied numerically and experimentally. Existing analytical solution is examined based on these results revealing that it can not precisely predict eigenvalues of the disk with slots since it does not accurately consider change in the vibration modes and change in strain energy density distributions due to the slots. Parametric study on slot length found that distortions in the mode shape as well as changes in the corresponding natural frequencies are proportional to the slot length. Consequently, errors in the calculated eigenvalues are also proportional to the slot length and accurate data can not be obtained with existing analytical solution above a certain level of slot length. Same phenomena can be observed in both free-free disk and fixed-free disk.

• Electrical & Electronic Materials
• /
• v.8 no.2
• /
• pp.129-135
• /
• 1995

SiO thin films are deposited by evaporator the refractive index of wave length, photon energy and the absorptive rate of these films are measured by spectroscopic ellipsometer. It is derived the absorptive rate and permitivity of SiO thin films from the equations that calculating the refractive index. And the result show good agreement with the calculated values and experimental values. As a result, the wave length of light is increased in the condition that the angle of incidence is fixed on SiO thin film, the basic absorption and the absorption impurities are found in the low wave length (below 450 nm in this study) and the reflective absorption and conductive absorption is increased by the form of exponential function over the low wavelength. The absorptive rate is increased by increased the angle of incidence and thickness of SiO film for the insulating layer. As the thickness of SiO film is increased, the value of complex permitivity is decreasing and as wave length of incidence is increased., the value of dielectric is linearly increasing.

• Proceedings of the IEEK Conference
• /
• 2002.06d
• /
• pp.109-112
• /
• 2002

In this paper, we propose the efficient digital watermarking scheme to transmit effectively the compressed medical image that embedded with watermarking data in mobile Internet access channel. The wireless channel error based on multiple access interference (MAI) is closely related to the length of spreading sequence in CDMA system. Also, the fixed length coded medical image with watermark bit stream can be classified by significance of source image. In the simulation, we compare the peak signal to noise ratio (PSNR) performance when the watermarked image with a simple symbol and when the watermarked image with a text file is transmitted using variable length of spreading sequences in case of limited length of spread sequence.

• Journal of the Korean Society for Precision Engineering
• /
• v.25 no.5
• /
• pp.60-68
• /
• 2008

The tool overhang length affects tool deflection and chatter that should be reduced for machined surface quality, productivity and long tool lift. The shortest tool setting algorithm that uses a safe space is proposed and applied with simulation software in NC machining. The safe space in the coordinate fixed in the tool is computed by the virtual machining system that simulates NC machining by stock model, tool model and NC code. The optimal tool assembly that has largest diameter and shortest length is possible using the safe space. This algorithm has been applied over fifty companies for safe and rigid tool setting. The collision accident between holder and stock was reduced from 3 to 0 a year and the productivity was incensed about 15% by using faster feed rate acceptable for shorten tool length.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.44 no.1
• /
• pp.33-40
• /
• 2007

Processor pipelines have been growing deeper and issue widths wider over the years. If this trend continues, the branch misprediction penalty will become very high. Branch misprediction is the single most significant performance limiter for improving processor performance using deeper pipelining. Therefore, more accurate branch predictor becomes an essential part of modern processors. Several branch predictors combine a part of the branch address with a fixed amount of global branch history to make a prediction. These predictors cannot perform uniformly well across all programs because the best amount of branch history to be used depends on the program and branches in the program. Therefore, predictors that use a fixed history length are unable to perform up to their potential performance. In this paper, we propose a branch prediction mechanism, using variable length history, which predicts using a bank having higher prediction accuracy among predictions from five banks. Bank 0 is a bimodal predictor which is indexed with the 12 least significant bits of the branch address. Banks 1, 2, 3 and 4 are predictors which are indexed with different global history bits and the branch PC. In simulation results, the proposed mechanism outperforms gshare predictors using fixed history length of 12 and 13 , up to 6.34% in prediction accuracy. Furthermore, the proposed mechanism outperforms gshare predictors using best history lengths for benchmarks, up to 2.3% in prediction accuracy.