• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.7
• /
• pp.662-669
• /
• 2017

Military rotary aircraft are heavily exposed to projectile environments due to their mission characteristics, and fires caused by fuel leaks after shooting are linked directly to the loss of human life. To improve the survivability of pilots and crews, the fuel tank in rotary aircraft must have gunfire resistance and anti-explosion characteristics. Gunfire resistance can be satisfied by applying a self-sealing cell to a fuel tank. Anti-explosion can be satisfied by reducing the oxygen concentration in an explosive area and suppressing the generation of combustible fuel vapor by minimizing the evaporation rate of the fuel by heat. A Korean utility helicopter applies anon-board inert gas generation system to meet the anti-explosion requirements for ballistic impact. The generator fills the fuel tank with an inert gas and reduces the oxygen concentration. This paper describes the overall development process of the OBIGGS developed in accordance with the localization process of weapon components. OBIGGS was developed/manufactured through domestic technology, and the performance was found to be equal to or better than that of the existing products through single performance tests and aircraft mounting tests.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.12
• /
• pp.55-63
• /
• 2015

Recently, terroristic threats using a radio controlled improvised explosive device (RCIED) that is remotely controlled and exploded have been increased around the world. In order to prevent the explosion of an RCIED, jamming techniques that interrupt an RCIED receiver can be used, so that the receiver can not demodulate the trigger code. Conventional jamming technique is a type of active barrage jamming that always emits the noise jamming signal for all the frequency band. However, it needs large power consumption and thus is limited in operation time for a vehicle. In order to overcome the shortage of the active barrage jamming, reactive jamming technique has drawn attention. In reactive jamming, all the frequency band is firstly scanned, and then if any trigger signal exists, one emits the jamming signal to the corresponding frequency band. Therefore, the reactive jamming is superior to the active barrage jamming in terms of power efficiency. However, a reactive jammer emits a jamming signal only after the trigger signal is intercepted, which means that the jamming signal may be late for interrupting an RCIED receiver. In this sense, it is needed to evaluate a delay in an RCIED receiver. To achieve this, we analyze the reaction time and present the simulation result for jamming performance of reactive jamming against an RCIED using mobile devices.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.1C
• /
• pp.1-10
• /
• 2002

With the explosive growth of the number of Internet users and Internet-related services, the research on construction of broadband Optical Internet by using WDM technologies is actively is actively progressed. In this paper, we design the offset time decision (OTD) algorithm for supporting the QoS in optical networks based on optical burst switching (OBS), which is the new switching paradigm, and evaluate the performance of it. The proposed algorithm determines a reasonable offset time considering traffic load of network and the number of wavelengths to guarantee the burst loss rate (BLR) of high priority Internet traffic as a QoS parameter. In order to design the proposed OTD algorithm, firstly we make the new burst loss formula, which includes the effect of offset time. The decision of offset time corresponding to the requested BLR, however, should use the reverse formula of proposed one, thus we are not able to use it without any changes. In this paper, we define the heuristic loss formula (HLF) that can be changed into reversed formula by using the proposed formula and proportional equation considering its characteristics. Finally we show the OTD algorithm to decide the offset time by using HLF. We show that the requested BLR is guaranteed under various traffic load with the determinded offset time by using the proposed OTD algorithm.

• Journal of KIISE:Information Networking
• /
• v.30 no.5
• /
• pp.581-594
• /
• 2003

Recently, a location management is being more important in mobile communication systems due to an explosive increase of mobile users. Current systems have used a concept of location area. Based on this concept, a mobile user performs a location update whenever it moves into a new location area. However, this scheme can not avoid unnecessary location updates when a mobile user moves around with high movement rate as compared to call arrival rate. That results in tremendous location management cost. To overcome this drawback, our proposal divides service areas into two sets: One is a set of areas that mobile users move with high speed and another is a set of areas that they move with low speed. After establishing these two sets, this paper employs different location tracking schemes for each sets. Generally, most mobile users with high speed have a low CMR and a regular direction until they arrive at their destination. Using such the moving behavior, systems can predict a mobile user's next location area in advance. When the mobile user moves into the predicted location, our proposal does not perform a location update. Thus, it can reduce overall location management cost. The Markov model is used to analyze the performance of our proposal. Using the model, this paper compares our proposal with IS-41 and TLA. The analytic results show that as CMR grows lower, an overall cost of our proposal becomes less, particularly if a mobile user frequently moves into the specific location are predicted by mobile systems. Also, our proposal has a better performance than other two schemes when the communication cost between HLR and VLR is high.

• Analytical Science and Technology
• /
• v.22 no.5
• /
• pp.386-394
• /
• 2009

Formaldehyde is used in lether manufacture, a dry plate and an explosive. It is by-product of ozonizing process in filtration plant. The effects of exposure are eye pruritus, tickle, runing nose, blocking nasal passages and headache. It also makes a dried throat and causes inflammation. It is classified as B1 group for inhalation by US. EPA, which can cause cancer in human. For analysis of formaldehyde, formaldehydes-DNPH derivative was extracted with solid cartridge and was analyzed by High Performance Liquid Chromatography/Diode Array Detector (HPLC/DAD). The detection limit was $3{\mu}g/L$ and the recoveries were 72.3~109.1% (RSD 2.9~11.5%). Water samples were collected in four Korean rivers, four times per year seasonally for 10 years from 1998 to 2007. The monitoring results were 48.8% (630/1291), $5.15{\sim}101.9{\mu}g/L$ in purified water. Because of non-carcinogen in drinking water, hazard index is calculated with RfD. Results of excess cnacer risk was below 1 and was considered as safe value.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38B no.11
• /
• pp.879-894
• /
• 2013

Recently, due to a explosive growth in the mobile Internet traffic, the problem of excessive data traffic handling on core network and thus scalability problem have been magnified in 3GPP LTE/SAE networks. Current LTE/SAE network based on the central P-GW (PDN Gateway) used as mobility anchor cannot deal with such demand for exponentially increasing mobile Internet traffic. In this paper, we propose a new LTE/SAE network architecture supporting distributed P-GWs and corresponding distributed mobility management to solve these problems. For this, in addition to the deployment of such distributed P-GWs, we propose a dynamic and distributed mobility management by distributing MMEs (Mobility Management Entities) which dynamically manages the location information of a UE's PDN connection, and also propose a handover procedure of such PDN connections by using the proposed distributed P-GWs and MMEs. The performance of the proposed dynamic and distributed LTE/SAE network system is compared with the current LTE/SAE network system in terms of handover latency and network throughput.

• Explosives and Blasting
• /
• v.35 no.1
• /
• pp.43-52
• /
• 2017

Mountain and hill areas occupy by more than 70% in South Korea and Rock drilling should be applied in order to reduce noisy & vibration from massive civil engineering business such as road expansion, high-way construction, subway construction and construction of site renovation such as a newly-built & re-development of apartment, newly-built of high-rising building in downtown area. As Blasting noise & vibration such as vibration, noise, fly rock etc caused by blasting operation from large small scale construction occurs, neighboring residents who demand the compensation file a civil complaint so that the business reach a deadlock. As the excavation method for these areas, There are blasting of micro-vibration, mechanical excavation method(Rock splitter, Breaker etc), similar blasting method(plasma, gel fragmentation etc) to date. In this study, we are trying to find the feature & performance which get improved economic feasibility & construct ability through improving sympathetic detonation of New KINECKER-I used in blasting of micro-vibration & formulation and would provide convenience for use by introducing standard blasting pattern & construction method. Also, checked and confirmed all the blasting with connecting cap has been cleary detonated.

• Journal of Internet Computing and Services
• /
• v.13 no.1
• /
• pp.125-134
• /
• 2012

As the social networking service (SNS), Facebook, and Cyworld, is developing, the social network game and social business commerce based on this service is activated. Especially, the Social Network Game (SNG) is getting explosive interests and it becomes popular, because it is small scale and user can enjoy the game among close friends. The market for this game is getting larger every year, but still it has some limitations in developing the game. Especially, the current game engine is aiming for developing online or console game, and there is no exclusive game engine for developing SNG. Therefore, it takes lots of time for developing SNG with this game engine. In this paper, we described a design and development of the game engine optimized for developing SNG, which not only adapts the main characteristics of the previous game engine, but also considers the specific characteristics of the SNG. The engine also supports map for the simulation game that is the most popular game in SNG, and also provides modules and tools for developing character animation easily. The evaluation standard for the performance of the game engine is the output generation speed of image, text and character. And the results showed reasonable output speed for developing the SNG in generation of image, text, and character.

• Journal of the Korea Concrete Institute
• /
• v.29 no.3
• /
• pp.237-248
• /
• 2017

Frequent terror or military attack by explosion, impact, fire accidents have occurred recently. These attacks and incidents raised public concerns and anxiety of potential terrorist attacks on important infrastructures. However, structural behavioral researches on prestressed concrete (PSC) infrastructures such as Prestressed Concrete Containment Vessel (PCCV) and Liquefied Natural Gas (LNG) storage tanks under extreme loading are significantly lacking at this time. Also, researches on possible secondary fire scenarios after terror and bomb explosion has not been performed yet. Therefore, a study on PSC structural behavior from an blast-induced fire scenario was undertaken. To evaluate the blast-fire combined resistance capacity and its protective performance of bi-directional unbonded PSC member, blast-fire tests were carried out on $1,400mm{\times}1,000mm{\times}300mm$ PSC specimens. Blast loading tests were performed by the detonation of 25 kg ANFO explosive charge at 1.0 m standoff distance. Also, fire and blast-fire combined loading were tested using RABT fire loading curve. The test results are discussed in detail in the paper. The results can be used as basic research references for related research areas, which include protective design simulation under blast-fire combined loading.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.1A
• /
• pp.25-33
• /
• 2011

The impact damage behavior of steel-strengthened concrete panels exposed to explosive loading is investigated. Since real explosion experiments require the vast costs to facilities as well as the blast and impact damage mechanisms are too complicated, numerical analysis has lately become a subject of special attention. However, for engineering problems involving blast wave and fragment impact, there is no single numerical method that is appropriate to the various problems. In order to evaluate the retrofit performance of a steel-strengthened concrete panel subject to blast wave and fragment impact loading, an explicit analysis program, AUTODYN is used in this work. The multi-solver coupling methods such as Euler-Lagrange and SPH-Lagrange coupling method in order to improve efficiency and accuracy of numerical analysis is implemented. The simplified and idealized two dimensional and axisymmetric models are used in order to obtain a reasonable computation running time. As a result of the analysis, concrete panels subject to either blast wave or fragment impact loading without the steel plate are shown the scabbing and perforation. The perforation can be prevented by concrete panels reinforced with steel plate. The numerical results show good agreement with the results of the experiments.