• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.14 no.6
• /
• pp.1375-1383
• /
• 1994

The water distribution system problem consists of finding a minimum cost system design subject to hydraulic and operational constraints. Since the municipal water distribution system problem is nonconvex with multiple local minima, classical optimization methods find a local optimum. An outer flow search - inner optimization procedure is proposed for choosing a better local minimum for the water distribution systems. The pipe network is judiciously subjected to the outer search scheme which chooses alternative flow configurations to find an optimal flow division among pipes. Because the problem is nonconvex, a global search scheme called Stochastic Probing method is employed to permit a local optimum seeking method to migrate among various local minima. A local minimizer is employed for the design of least cost diameters for pipes in the network. The algorithm can also be employed for optimal design of parallel expansion of existing networks. In this paper one municipal water distribution system is considered. The optimal solutions thus found have significantly smaller costs than the ones reported previously by other researchers.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.10
• /
• pp.20-28
• /
• 2007

Zigbee sensor network base on IEEE802.15.4 has local address of 2 byte on transmit packet data which is pick up the address for each sensor node. Sensor network is requested low power, low cost, many nodes at hues physical area. There for Zigbee is very good solution supporting for next Ubiquitous generation but the Zigbee sensor network has address allocation problem of each sensor node. Is established standard from Zigbee Alliance, to the address allocation method uses Cskip algorithm. The Cskip algorithm use the hazard which allocates an address must blow Hop of the maximum modification and child node number. There is to address allocation and from theoretically it will be able to compose a personal 65536 sensor nodes only actual with concept or space, only 500 degree will be able to compose expansion or the low Zigbee network. We proposed an address allocation method using coordinate value for Zigbee sensor network.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.30 no.1
• /
• pp.39-46
• /
• 2017

In this paper, a model updating procedure based on the response surface method combined with the multi-objective optimization was proposed and applied for updating of the FE models representing a low-rise reinforced concrete building before and after the seismic retrofit. The dynamic properties to be matched were obtained from vibration tests using a small shaker system. By varying the structural parameters according to the central composite design, analysis results from the initial FE model using a commercial software were collected and used to produce two regression functions each of which representing the errors in the natural frequencies and mode shapes. The two functions were used as the objective functions for multi-objective optimization. Final solution was determined by examining the Pareto solutions with one iteration. The parameters representing the stiffnesses of existing concrete, masonry, connection stiffness in expansion joint, new concrete, retrofitted members with steel section jacketing were selected and identified.

• Korean journal of food and cookery science
• /
• v.20 no.4
• /
• pp.380-386
• /
• 2004

This study was carried out to investigate the quality characteristics of Jeung-Pyun with respect to the addition ratio of pigmented rice and fermentation method. As the mont of pigmented rice was increased, the moisture content of the products added with yeast tended to increase more than those made in the traditional way. Regardless of fermentation method, L value and b value of Jeung-Pyun without pigmented rice were higher than those of Jeung-Pyun with pigmented rice, for which the values were significantly low. The samples with 5% or 10% pigmented rice had a high degree of expansion. The other samples showed no visible difference. The hardness, cohesiveness, springiness and chewiness tended to decrease. On the other hand, the adhesiveness was increased. In both fermentation methods, as the amount of pigmented rice was increased, the gelatinization degree was raised. In sensory evaluation, the characteristics of Jeung-Pyun with 30% pigmented rice were very poor, except for the characteristics on pore uniformity. The other samples and both fermentation methods were hardly different.

• 한국전산유체공학회:학술대회논문집
• /
• 2006.05a
• /
• pp.311-314
• /
• 2006

The supersonic flow around tandem cavities was investigated by three- dimensional numerical simulations using the Reynolds-Averaged Navier-Stokes(RANS) equation with the $\kappa-\omega$ thrbulence model. The flow around a cavity is characterized as unsteady flow because of the formation and dissipation of vortices due to the interaction between the freestream shear layer and cavity internal flow, the generation of shock and expansion waves, and the acoustic effect transmitted from wake flow to upstream. The upwind TVD scheme based on the flux vector split using van Leer's limiter was used as the numerical method. Numerical calculations were performed by the parallel processing with time discretizations carried out by the 4th-order Runge-Kutta method. The aspect ratio of cavities are 3 for the first cavity and 1 for the second cavity. The ratio of cavity interval to depth is 1. The ratio of cavity width to depth is 1 in the case of three dimensional flow. The Mach number and the Reynolds number were 1.5 and $4.5{\times}10^5$, respectively. The characteristics of the dominant frequency between two-dimensional and three-dimensional flows were compared, and the characteristics of the second cavity flow due to the fire cavity flow cavity flow was analyzed. Both two dimensional and three dimensional flow oscillations were in the 'shear layer mode', which is based on the feedback mechanism of Rossiter's formula. However, three dimensional flow was much less turbulent than two dimensional flow, depending on whether it could inflow and outflow laterally. The dominant frequencies of the two dimensional flow and three dimensional flows coincided with Rossiter's 2nd mode frequency. The another dominant frequency of the three dimensional flow corresponded to Rossiter's 1st mode frequency.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.13 no.6
• /
• pp.480-489
• /
• 1988

Although CDP stacking of common depth gathering is used to get the zero-offset-section, the exploding reflector concept is examined for the modeling of zero source to receiver offset sections in this paper. The acoustic wave equation is compared with a one way wave equation which represents the upgoing wave field only. The one way wave equation used is not derived through an expansion and, therefore, can represent dips up do 90b degrees and may not lost the signals by the dipping angles. There is apparently no simple counterpart of this equation is the space domain and it can be conveniently implemented only by a Fourier method. This paper compares their modeling technique with ray tracing and wave method for over thrust structure which is one of the geological structures are dificult to process and interpret. As a result of modeling much clean and accurate signals, especially, diffractions form the corner and dipping angles can be gathered.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.15 no.1
• /
• pp.43-51
• /
• 2010

This paper proposes an analysis of voltage delay and compensation for current control in H-Bridge Multi-Level (HBML) inverters for a medium voltage motor drive with vector control. It is shown that the expansion and modularization capability of the HBML inverter is improved in case of using Phase-Shifted Pulse Width Modulation (PSPWM) since individual inverter modules operate more independently. But, the PSPWM of HBML has a phase difference between reference voltage and real voltage, which can cause instability in the current regulator at high speed where the ratio of the sampling frequency to the output frequency is insufficient. This instability of the current regulator is removed by adding a proposed method which compensate a phase difference between reference voltage and real voltage. The proposed method is suitable for HBML inverter controlled by PSPWM with low switching frequency and high speed motor drive. The validity of the proposed method is verified experimentally on 6,600[V] 1,400[kW] induction motor fed by an 13-level HBML inverter.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.12
• /
• pp.1343-1352
• /
• 1992

This paper presents a new and easy method to obtain the Fourier transforms of the n-th order cosine-pulses whose maximum amplitudes are uniform. The new method is focused on deriving a formula which is recursively related following their orders and can be well applied to some numerical solutions. On the other hand, this method also offers more compact procedures in view of analytical solutions than the conventional methods because the results are consist of the sum of two functions which are easily calculated. Especially, the formula can be represented as a complete recursion by the separation of coefficients originated by the authors and the resulting difference equation is given by the sum of the original 'sinc' functions shifted by some symmetrical factors and multiplied by some constants. The constants are easily decided from the binomial coefficients and the shifting factors from the corresponding exponential differences in the expansion of $(a+b)^n$.

• Journal of Technology Innovation
• /
• v.22 no.3
• /
• pp.287-310
• /
• 2014

Due to the toughening intelligence-based competitions among nations, it has become important to industrialize R&D results. To industrialize R&D results through technology transfer, the transfer fee between a technology developer and a company should be discussed. While discussing the transfer fee, the results of technology valuation have been used. However, due to the unreliability of its result, the technology transfer market has not been expanded. In this paper, we discuss the improvement of the reliability of the technology valuation method to expand the technology transfer market. The proposed scheme provides graph-type technology valuation results according to various industrial scenarios using objective technology and market data. With the use of the proposed scheme, the technology developer and the consumer (i.e., the company) can determine the appropriate technology transfer fee. Thus, the proposed scheme is expected to contribute to the expansion of the technology transfer market.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.10
• /
• pp.5251-5259
• /
• 2013

This study aims to make sustainable and future-oriented eco-archipelagic city through developed trend of analysis physical design method and correlation analysis between design method and development purpose for archipelagic development. First, EU cases had variety developed thema and identity such as science city, leisure and resort city, commercial city, ecology city in environmental theory aspects but, Korean cases have plenty of problems such as focused development of leisure and resort city for fund profit, imperfected native people's developed knowledge learning and understanding and figure out that they will not make to the sustainable development for islands of archipelagic. Second, as a in-depth analysis, the application of methods and developed trend were figured out by correlation analysis between physical design methods and development purpose through result(physical design methods) of case studies. As a result, contents and design methods from development purposes have to develop by multilateral aspects and also, native resident will have to require infrastructure expansion about service contents for smooth communication and sustainable information sharing.