• Journal of the Korean Electrochemical Society
• /
• v.24 no.3
• /
• pp.35-41
• /
• 2021

In this study, the effect of zwitterionic surfactant on Cu electrodeposition was investigated through cyclic voltammetry. With the addition of (dodecyldimethylammonio)propanesulfonate (DDAPS) as a representative zwitterionic surfactant in the electrolyte for Cu electrodeposition, the electrochemical Cu²⁺ reduction was inhibited on Cu and glassy carbon electrodes. Its inhibition effect was similar to that of cationic surfactant rather than anionic surfactant. Moreover, DDAPS interacted with chloride ion and exhibited the mass transfer-dependent inhibition behavior, which indicates that its inhibition function is associated with the formation of its surface aggregates on anion-covered Cu surface. In addition, adsorbed DDAPS slightly reduced the surface roughness of Cu electrodeposits. These characteristics were similar to those of cationic surfactant, but less obvious. It means the effect of DDAPS on Cu electrodeposition originates from the cationic head group which is shield by anionic head group.

• Journal of the Korean Ceramic Society
• /
• v.34 no.12
• /
• pp.1205-1212
• /
• 1997

The matrices which consisted of SiC whisker, PES(polyesterasulfone) as a binder, span 80(sorbitan monooleate) as a surfactant, TPP(triphenyl phosphate) as a plasticizer and dichloromethane as a solvent, have been prepared by the various methods such as tape casting, rolling, tape cast-coating and roll-coating method. The fuel cells of single stack type using these matrices are characterized by ac impedance spectroscopy and cyclic voltammetry technique. A fuel cell using a matrix prepared by the tape cast-coating method shows the best performance of 466.34 mA/$\textrm{cm}^2$ at 0.6V because it has the lowest polarization resistance at the interface between electrodes and a matrix due to the largest three phase contact region of gases, catalyst and electrolyte.

• Applied Chemistry for Engineering
• /
• v.8 no.4
• /
• pp.640-644
• /
• 1997

We investigated that how both the type and the concentration of coal and the surfactant and the electrolyte added to increase the fluidity of CWM influence rheological characteristics. According to the type of coal, the viscosity of CWM was increased with increasing O/C ratio. Also, the CWM was represented the property of non-Newtonian fluid, having yield stress which was linerarly increased with increasing coal concentration. According to the surfactant used as an additive, the rheological characteristics of CWM was represented the pseudoplastic property as n<1 without relating to the concentration of added surfactants. Also, according to the increase of the amount of electrolyte, n was nearly approached 1. Therfore, we found that CWM opproched Newtonian fluid and that when more than 0.05wt.% of electrolyte were added, yield stress was not shown up.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.9
• /
• pp.1001-1005
• /
• 2004

Rye-sensitized solar cell (DSSC) is a new class of solar cell, which consists of nanoporous TiO$_2$ electrode, dye-sensitizer, electrolyte, and counter electrode. Such cell is operated in sunlight via the principle of photosynthetic electrochemistry. In order to obtain the good dispersion of nano size TiO$_2$ particles In slurry, the pH of solvent, the sort and quantify of solvent additive and the quantity of surfactant were adjusted. As results, the lower the pH of solvent was the lower the viscosity of the slurry became. The addition of ethylene glycol and propylene glycol to dilute HNO$_3$ brought about the lowering of viscosity and the enhancement of stability in slurry. The addition of surfactant lowered the viscosity of slurry. It was possible to obtain the homogeneous and uniformly dispersed mesoporous TiO$_2$ film using the dilute HNO$_3$ solvent of pH 2 with the addition of ethylene glycol and neutral surfactant. DSSC was assembled with TiO$_2$ electrode and Pt electrode, and its photoelectric property was measured using the monochromatic wavelength in the rangee of 350∼700 nm.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2000.05a
• /
• pp.121-124
• /
• 2000

In-situ soil remediation using electrokinetics has been investigated and the attempts for the removal of hydrocarbons have been continued. In this study, the electrokinetic remediation using three different kinds of surfactnats was conducted for the removal of phenanthrene from clay The used surfactnats were APG, Brij30 and SDS. In the solubility test for phenanthrene, the experimental result was APG

• Journal of the Korean Society of Clothing and Textiles
• /
• v.27 no.5
• /
• pp.523-523
• /
• 2003

The change of interactions of anionic surfactants, sodium dodecyl sulfate(SDS) and sodium tetradecyl sulfate(575) in the presence of electrolytes, to the chitosan-based polyelectrolyte(sol＇n and gel phase) were studied. The chitosan gel used in this study were crosslinked with epichlorohydrin(ECH). Binding isotherms were determined by potentiometric technique using a surfactant ion selective solid-state electrode and the results were represented by using the sequence generating function(SGF) method. The results of binding isotherm were shown comparatively high cooperativity. The addition of electrolytes in the chitosan/SDS system resulted in a shift of the binding to higher free surfactant concentration because of screen effect by the electrolytes. Degree of binding of chitosan gel was higher than that of chitosan sol＇n. And also a conformational phase transition of the chitosan gel in the presence of electrolytes has been investigated.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.27 no.5
• /
• pp.524-532
• /
• 2003

The change of interactions of anionic surfactants, sodium dodecyl sulfate(SDS) and sodium tetradecyl sulfate(575) in the presence of electrolytes, to the chitosan-based polyelectrolyte(sol＇n and gel phase) were studied. The chitosan gel used in this study were crosslinked with epichlorohydrin(ECH). Binding isotherms were determined by potentiometric technique using a surfactant ion selective solid-state electrode and the results were represented by using the sequence generating function(SGF) method. The results of binding isotherm were shown comparatively high cooperativity. The addition of electrolytes in the chitosan/SDS system resulted in a shift of the binding to higher free surfactant concentration because of screen effect by the electrolytes. Degree of binding of chitosan gel was higher than that of chitosan sol＇n. And also a conformational phase transition of the chitosan gel in the presence of electrolytes has been investigated.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.4
• /
• pp.543-546
• /
• 2007

Herein, a new electrochemical method was described for the determination of ciprofloxacin based on the enhancement effect of an anionic surfactant: sodium dodecyl benzene sulfonate (SDBS). In pH 4.0 phosphate buffer and in the presence of 1.0 × 10-4 mol/L SDBS, ciprofloxacin yields a well-defined and sensitive oxidation peak at the carbon paste electrode (CPE). Compared with that in the absence of SDBS, the oxidation peak current of ciprofloxacin remarkably increases in the presence of SDBS. The experimental parameters, such as supporting electrolyte, concentration of SDBS, and accumulation time, were optimized for ciprofloxacin determination. The oxidation peak current is proportional to the concentration of ciprofloxacin over the range from 8.0 × 10-8 to 5.0 × 10-6 mol L-1. The detection limit is 2.0 × 10-8 mol L-1 after 2 min of accumulation. This new voltammetric method was successfully used to detect ciprofloxacin in drugs.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.09a
• /
• pp.215-218
• /
• 2004

The electrokinetically enhanced soil flushing had a great potential to improve the removal efficiency of polycyclic aromatic hydrocarbons (PAHs) from low permeable soils. A semi-pilot study of surfactant-enhanced electrokinetic process was investigated for the removal of phenanthrene from kaolinite. A nonionic surfactant, Tergitol 15-S-12 at 10 g/L was introduced as a flushing agent and 0.001M of sodium chloride was used as an electrolyte. When the constant voltage of 100 V was applied to the system for 25 days, only 0.66 kWh of electric power was consumed and the amount of electroosmotic flow was 6.9 L. The removal efficiency of phenanthrene was about 40 % and it can be improved by increasing the ion concentration of the flushing solution or the applied voltage.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.31 no.3
• /
• pp.10-18
• /
• 1999

The influence of simple electrolyte or anionic trashes on cationic starch adsorption was examined using deinked pulp and bleached thermomechniical pulp. Adsorbed amounts of cationic starches increased slightly , then decreased abruptly as the concentration of simple electrolyte increased. This phenomenon was discussed based on the compression of electrical double layer and conformation change of starch molecules. Also, the effect of the type of simple electrolytes on starch adsorption was examined and discussed. Addition of sodium slilicate increased starch adsorption since it increased surface charge density of fibers. On the other hand, addition of kraft lignin decreased cationic demand of the pulp slurries and adsorbed amounts of cationic starches. Nonionic surfactant did not show any significant effect on the cationic demand of pulp slurries. When simple electrolytes were added to the stock , grater adsorption or cationic starches was obtained with starches of lower degree of substitution . On t도 other hand, amount of adsorbed starches decreased for lower DS starches when the concentration of anionic trashes increased.