• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.34 no.9
• /
• pp.341-348
• /
• 1985

This paper deals with a surface charge simulation method of calculating three-dimensional electric fields and capacitance. The principle is to divide the electrode surface into rectangular or triangular elements of which charge density is the linear function of the electrode coordinate and to formulate a linear equation for the coefficients of charge density function and to determine those coefficients by boundary conditions. It has been shown that the method can give satisfactory results for thin rectangular plates where the other methods is difficult to be applied.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.15 no.2
• /
• pp.19-21
• /
• 1978

The electrical drift mobility of charge carrier of Cholesteryl Benzoate was measured by Polarity inversion method in the temperature range 140~ 185$^{\circ}C$. with a view to revealing the mechanism of charge carrier transport. The electrical drift mobility of charge carrier of that increased from 2.5$\times$10-7$\textrm{cm}^2$/V.sec to 2.0$\times$10-6$\textrm{cm}^2$/v.sec as the temperature increased. As a result of the experiment, the mechanism of current transport is believed to be ionic mechanism.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.51 no.4
• /
• pp.183-187
• /
• 2002

The efficient and rational transmission tariff structure is one of the crucial factors in creation of fair and competitive electricity markets. Transmission charge can be largely categorized into the line usage charge, system reliability charge, access charge and others. Any transmission tariff should be able to reflect these cost components reasonably. This paper suggests an approach amenable to allocating the transmission reliability costs reasonably with reflection of line sensitivity and line outage rate.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.13 no.5
• /
• pp.530-537
• /
• 2013

An explicit surface potential calculation method of gate-all-around MOSFET (GAAMOSFET) devices which takes into account both interface trap charge and varying doping levels is presented. The results of the method are extensively verified by numerical simulation. Results from the model are used to find qualitative and quantitative effect of interface trap charge on subthreshold slope (SS) of GAAMOSFET devices. Further, design constraints of GAAMOSFET devices with emphasis on the effect of interface trap charge on device SS performance are investigated.

• Particle and aerosol research
• /
• v.5 no.2
• /
• pp.71-81
• /
• 2009

In this study, Nylon 6,6 electrospun (ES) nanofiber filter media were prepared at various spinning conditions. The ES filters tested had no intrinsic electrical charges. The ES filters were triboelectrically charged in the course of filter sample handling, and the charge was drastically decayed in a few hours. On the other hand, the corona charged melt blown filter media showed a permanent electrical charge. The electrical charge state of the ES filters was also examined by comparing collection efficiencies of ES filters for uncharged and charged aerosol particles.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.6
• /
• pp.305-311
• /
• 2004

Charge transport phenomena of polyaniline-DBSA/High Impact Polystyrene (PAM-DBSA/HIPS) blends have been studied through an examination of electrical conduction. HIPS used host polymer in the blends and PANI-DBSA obey a space charge limited conduction mechanism and a ohmic conduction mechanism respectively. However, PANI-DBSA/HIPS blends do not obey any classical conduction mechanism. Analysis of conduction mechanism revealed that the charging current of PANI-DBSA/HIPS blends increased with the increase of PANI-DBSA content. This result migrlt be explained by the reduction in the distance between PANI-DBSA particles enabling the charge carriers to migrate from a chain to a neighboring chain via hopping or micro tunneling. It was also found that the charging current of PANI-DBSA/HIPS blends decreased as the temperature was elevated, which is of typical phenomena in metals. It is speculated that the charge transport in PANI-DBSA particle was somewhat constrained due to strong phonon scattering.

• Journal of the Korea Safety Management & Science
• /
• v.2 no.2
• /
• pp.187-200
• /
• 2000

The charge and discharge current in EPR(Ethylene Propylene Rubber), which were irradiated with the radiant capacity of 0~600 ［kgy/h］, have been measured in order to investigate the influence of the atmosphere (oxygen, air and vacuum) on electrical properties. It has been shown that the charge and discharge current increase as the amount of radiant capacity increases in air and vacuum atmosphere. This electrical property degradation can be speculated due to that the C＝O radicals or impurities, which comes from during shaping process, may act as dipoles. On the other hand, the charge and discharge current are shown to be higher in the amount of 1［kgy/h］ than these in 10［kgy/h］ in air atmosphere, because the charge and discharge current can be increased as the exposure time is extended with slower rate. Under the same amount of irradiation, the charge and discharge current in oxygen atmosphere are shown to be higher than those in vacuum. This is possibly due to that the main chain can be broken by oxidation when it is exposed to the $\gamma$ -rays.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.7
• /
• pp.860-864
• /
• 2018

The signal of space charge distribution measured in polymer insulating materials by the PEA has some noises due to the system circuits and the ringing phenomena in the sensor of PVDF and so on forth. It's magnitude mainly depends on the thickness of the insulation material, and it is also affected by the attenuation and dispersion when traveling in a dielectric material. In order to make it reliable, the correcting process for the signal is essential. In this study, we proposed the new deconvolution process on the measured signal of space charge distribution in the flat XLPE insulator, and developed a new signal processing algorithm. Using this, we could improve the reliability of the measured signal much and analyze the effects of space charge clearly in materials.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.19 no.2
• /
• pp.139-148
• /
• 2014

State-of-charge (SOC) is one of the significant indicators to estimate the driving range of the electric vehicle and to control the alternator of the conventional engine vehicles as well. Therefore its precise estimation is crucial not only for utilizing the energy effectively but also preventing critical situations happening to the power train and lengthening the lifetime of the battery. However, lead-acid battery is time-variant, highly nonlinear, and the hysteresis phenomenon causes large errors in estimation SOC of the battery especially under the frequent discharge/charge. This paper proposes a novel estimation technique for the SOC of the Lead-Acid battery by using a well-known Extended Kalman Filter (EKF) and an electrical equivalent circuit model of the Lead-Acid battery considering diffusion and hysteresis characteristics. The diffusion is considered by the reconstruction of the open circuit voltage decay depending on the rest time and the hysteresis effect is modeled by calculating the normalized integration of the charge throughput during the partial cycle. The validity of the proposed algorithm is verified through the experiments.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1995.11a
• /
• pp.171-174
• /
• 1995

Space charge formation in epoxy loaded with silica and calcium carbonate has been studied. The epoxy itself showed almost no charge at up to 40 kV/mm. The addition of fillers such as SiO$_2$and CaCO$_3$resulted in homocharge formation, which was attributed to the interfacial trapping of injected charge at epoxy/filler interfaces. The amount of charge showed a maximum at 20-40 parts per hundred resin above which the charge decreased gradually. This was tentatively attributed to the enhanced interconection of charge transport path by an increased filler content