• 한국건축시공학회지
• /
• 제6권4호
• /
• pp.93-98
• /
• 2006

Admixture materials are used in mixing concrete or mortar to improve quality and performance of the concrete. This study examines the potential use of talc as a substitute for cement, the benefits of recycling waste resources for economical efficiency and quality improvement of concrete. The test was carried out by replacing the plain mix with fine grains of talc at the rate of 10%, 20%, and 30%. Talc was divided into three groups depending on the degree of pulverizing. For wet concrete, porosity, slump, bleeding per unit, and setting time by penetration resistance were measured; similarly, for dry concrete, strength and watertight Property were tested. Test results showed that the amount of bleeding and setting time could be shortened, but the strength and watertight proofing severely deteriorated. However, at the replacement rate of 10%, talc showed equal performance with the plain at all degrees of pulverization, which suggests its potential use as admixture material.

• 한국건축시공학회지
• /
• 제6권2호
• /
• pp.73-79
• /
• 2006

The purpose of this study is to enhance the development of construction waste-recycling technologies and its economical efficiency by developing environment-friendly tetrapod, precast concrete, where recycled aggregate is used in order to promote recycling of waste concrete. The results of concrete mechanic characteristics experiments by the circulation coarse aggregate-replacement ratio are as the following. The circulation aggregate is lower and higher than natural aggregate in specific gravity and absorption ratio, respectively so that in case of mix proportioning, unit volume increases, while unit aggregate amount decreases. From the result, sufficient experiments of physical characteristics of circulation aggregate are required to get proper mix proportioning. When circulation aggregate-replacement ratio increases, compressive strength tends to decrease comprehensively, but 50% of replacement ratio is good enough to use. When circulation coarse aggregate's replacement ratio is 0%, drying shrinkage, which causes cracks in concrete and deteriorates durability, shows the minimum length change and the higher the ratio, the larger the length change. Thus. when using circulation coarse aggregate, drying shrinkage should be fairly examined. In freezing-and-thawing resistance, weight loss tends to comprehensively increase its loss at the circulation aggregate-mixed site. And the examination of surface aggregate-omission ratio is further needed and dynamic elastic modulus and durability factor(DF) require more study as well. In order to use circulation aggregate to tetrapod, a clear standard for strength should be first prepared and at the same time, more study about durability is needed.

• 상하수도학회지
• /
• 제25권5호
• /
• pp.707-717
• /
• 2011

Replacement of old water distribution pipes for protecting water quality induced by pipe corrosion requires enormous budget. Even after the replacement, however, corrosion can occur again at any times and, therefore, inhibitive measure of the corrosion will be not only economical but needed to diminish the consumers' distrust on tap water quality. In 2008, National Environmental Research Institute did a survey on 8 major drinking water source and proposed to establish the Langelier Saturation Index(LI) as a corrosion index in Drinking Water Quality Criteria. Among the water industries of Korea, K-Water is the only one that set up the level of pH over 7.0 and LI above -1.5 on yearly average basis. However, no systematic regulation including LI to inhibit the corrosive tendency has been established yet. In this paper, LI values out of 31 drinking water treatment plants were analyzed and two-stage control of LI value as a measure of corrosive tendency of water is proposed. Primarily, water treatment facilities may operate the system at a target LI value below -1.5. Following the investigation on the effect caused by adjusting the LI value on water quality and corrosiveness, it will be desirable to improve LI value below -1.0 in the long run. In addition to the LI, supplemental use of Larson's modified ratio (LMR) which incorporates hydraulic detention time will be necessary. Several methods to prove the inhibitive effect of improving the LI value on water quality have been also suggested.

• 한국화재소방학회논문지
• /
• 제16권2호
• /
• pp.1-7
• /
• 2002

유도등은 일정한 조도를 가지고 상용전원에 의하여 항상 점등되어 있어야 함으로 전력소비 및 광원 교체등 경제적 손실과 관리상의 문제가 있게 된다. 본 논문은 이제까지 광원으로 사용하고 있던 형광등이나 백열전구 대신에 소비전력이 적은 고효율 발광다이오드를 사용하여 전력소비의 절감과, 점검시의 문제점을 개선하기 위해 원격제어가 가능한 새로운 유도등회로를 제안하고 실험한 것이다. 그 결과 원격제어 스위치에 의한 유도등 점검을 제어각의 범위에서 쉽게 제어할 수 있었으며 반응시간은 600〔$\mu$s〕로 매우 빠르게 동작하였다. 또한 출력 상승시간(Rise time)과 하강고시간(Fall time)은 최대 200〔ns〕로 예민하게 반응하였다. 광원으로 고효율 발광다이오드를 사용함으로 광원을 교체해야 하는등의 문제를 제거하였으며 전력소비를 감소시킬 수 있음을 확인하였다.

• 한국수자원학회논문집
• /
• 제42권7호
• /
• pp.525-535
• /
• 2009

본 연구에서는 상수관망에서 개별적으로 노후도가 심하여 개량이 필요한 구간을 보다 정확하게 구분하기 위해 새로운 개별관로 정의 방법이 개발되었다. 적절한 관로 최소구성성분 길이를 결정하기 위하여 여러 가지 관로 최소구성성분 길이에 대한 평균 누적파손횟수경사선의 분산값을 비교하여 가장 큰 분산값을 나타내는 관로 최소구성성분 길이인 4 m 를 연구대상 지역의 상수관망에 적용하였으며 관로 ID는 39개로 구분되어졌다. 관로의 경제적 최적교체 시기는 한계파손율과 관로의 파손경향모형을 이용하여 결정되었는데, 각 관로 ID에 대하여 관로의 선형적 파손경향, 지수적 파손경향 또는 선형과 지수형 사이에 있는 파손경향 모두에 적용될 수 있는 General Pipe Break Prediction Model(Park and Loganathan, 2002)과 수정된 시간척도를 이용한 ROCOF(Park et al., 2007)를 적용하여 연구대상 상수관망의 최적교체시기를 산정 및 분석하였다. ROCOF 모형화 과정에서 대수-선형과 와이블 ROCOF를 적용 후 최대로그우도 추정값을 비교하여 최대로그우도가 큰 값을 가지는 ROCOF를 각 관로 ID의 ROCOF로 사용하였다. 관로파손으로 인한 사회적 비용이 관로의 최적교체시기에 미치는 영향도 분석되었다.

• 대한안전경영과학회지
• /
• 제6권1호
• /
• pp.49-60
• /
• 2004

Industrial facilities are becoming more complex and various with rapidly developing technologies. A number of installations and equipments are increased to improve productivity, and they are operated under the condition of high temperature and pressure. They are continuously repaired, replaced or abolished because of the deterioration with time, but their repair and replacement are not easy for economical and environmental concerns. If possible, the deteriorating equipments should be inspected and repaired effectively considering the state of maintenance and preservation, economic efficiency, and safety. That's where RBI(Risk Based Inspection) fits in. Even if RBI technology has been known among specialists, there were no tools readily available and it was hard to practice and apply RBI in industrial inspection and safety management. In the development of the qualitative RBI, the overall algorithm adopted API-581 BRD. The qualitative RBI program was developed to search the appling process.

• 대한임베디드공학회논문지
• /
• 제10권3호
• /
• pp.151-156
• /
• 2015

Recently, an embedded flash memory has been widely used for the Internet of Things(IoT). Due to its nonvolatility, economical feasibility, stability, low power usage, and fast speed. With respect to power consumption, the embedded memory system must consider the most significant design factor. The objective of this research is to design high performance and low power NAND flash memory architecture including a dual buffer as a replacement for NOR flash. Simulation shows that the proposed NAND flash system can achieve better performance than a conventional NOR flash memory. Furthermore, the average memory access time of the proposed system is better that of other buffer systems with three times more space. The use of a small buffer results in a significant reduction in power consumption.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 춘계 학술발표회 논문집(II)
• /
• pp.41-44
• /
• 2006

Recently, single shell lining method of construction is studied by economical method of construction to make use of high-performance shotcrete of permanent shotcrete lining concept in the UStA, Europe, Japan etc. High-performance shotcrete use is essential as permanent support that single shell lining method of construction has two functions of lining and support to shotcrete. In this research, optimum accelerator amount was decided after setting time test using alkai-free and cement mineral accelerator. Also replacement ratio of silica fume and fly-ash was determined.

• 대한화학회지
• /
• 제66권4호
• /
• pp.284-297
• /
• 2022

The antibacterial activity of metallic nanoparticles (NPs), especially silver (Ag), has been investigated during the course of time in various chemical reactions for antibiotics free agents. Green synthesis of metallic NPs using either microorganisms or plant-extracts has appeared as a simple and replacement to chemical and physical methods. The synthesizing of these NPs through ecofriendly methods signifies an exceedingly applicable approach for offering economical, preferring scalability and possessing negligible ecological influences. Essential-oils are among the subordinate metabolites of plants and their antibacterial anti-inflammatory characteristics have been investigated widely and are commonly attained from the aromatic plants. The usage of essential-oils as reducing agents in biosynthesizing of Ag NPs bring together the interaction of a vital antibacterial agent that simplify the nucleation and growth process within the NPs formation. This review article is offering a progressive process of Ag NPs synthesis using essential oils along with proposing the most applicable formation mechanisms and their antibacterial activities.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 A
• /
• pp.501-503
• /
• 2000

Since an arrester has been generally used at the distribution line and abroad for the protection of electrical equipments against overvoltage (or abnormal surge) taking place in or from an electrical system, a fault, especially, in the distribution line is very likely to result in the destruction of insulation of other protection devices to cause an overall paralysis of a power system, a chaos. Considering the importance of arresters, its earlier replacement than its proposed life cycle causes an economical loss, and a negligence not to replace or repair it in time gives rise to a crucial accidence. The purpose of this paper is to invent an electric leakage current detector and to solve such problems by the continuous and regular inspection of an arrester.