• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2000.05a
• /
• pp.128-131
• /
• 2000

This paper describes design for dual-linear polarization antenna using EMC(electromagnetic-coupled) dipole. EMC dipole has a simple element structure and it is fed by microstrip line. Vortical and horizontal polarization are determined by structure of dipole fed by microstrip line. FDTD Method is used for an analysis of antenna element. Length, width, height and offset of dipole are designed for 1-element antenna. Resonant length of diploe differs from the calculated value by a formula because of coupling effect of dipole and feed line. Radiation Power is controlled by the offset of dipole. In prectical fabrication of antenna array, a constant height of dipoles is required. Therefore, the teflon plate with height of 0.8 mm is considered in antenna element design for the vertical polarization.

• ETRI Journal
• /
• v.31 no.1
• /
• pp.77-79
• /
• 2009

The wave concept iterative procedure (WCIP) is used to analyze a quasi-square open metallic ring frequency selective surface (FSS). The quasi-square open metallic ring FSS is dual-polarized. When the incident plane wave is polarized in a direction parallel to the FSS' coupled parallel strips, it shows two rejecting bands. Moreover, another rejecting band can be obtained if the source plane wave is perpendicularly polarized with respect to the FSS' coupled parallel strips. The three resonant frequencies are inversely proportional to the length of the FSS' coupled strips to provide an easy fine tuning of the FSS structure. The simulated results obtained using WCIP are compared to the measured results, and a good agreement is reported.

• Proceedings of the KIPE Conference
• /
• 2002.07a
• /
• pp.525-528
• /
• 2002

A Novel Zero Current Switching(ZCS) Pulse Width Modulation(PWM) boost converter for reducing two rectifiers reverse recovery related losses Is proposed. The switches of the proposed converter are operating to work alternatively turn-on and turn-off with soft switching(ZVS, ZCS) condition. The reverse recovery related switching losses and EMI problems of the proposed converter eliminates the reverse recovery current of the freewheeling diode(D, Dl) by adding the resonant inductor Lr, in series with the switch S2. The voltage and current stresses of the components are similar to those in its conventional hard switching counterpats. As mentioned above, the characteristics are verified through experimental results.

• Proceedings of the KIPE Conference
• /
• 2018.07a
• /
• pp.286-287
• /
• 2018

Recently, the development of renewable energy using solar energy is drawing attention. One of these PV systems, the Dual buck Inverter, is one of the topologies used in conjunction with the system, characterized by high efficiency and shoot-through reduction. However, current distortion appears severely in grid connection. So, in this paper, the method of compensation through PR controller was verified through simulation as an analysis of current distortion components and a control method to improve them.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2002.11a
• /
• pp.311-314
• /
• 2002

본 논문에서는 저가의 FR4 칩의 전면과 후면을 이용하여 ISM대역을 만족하는 이중대역 특성의 평면 역F 칩 안테나(PIFcA)를 설계ㆍ분석하였다. 제안된 PIFcA의 크기는 21$\times$5$\times$1mm이고, 10㏈ 반사손실을 기준으로 하여 2.45㎓에 9.54%(2390~2630MHz), 5.775㎓에서 13.89%(5670~6520MHz)의 이중대역 특성을 갖는다. 안테나는 2.45㎓에서 2.2㏈i, 5.77㎓에서 5.2㏈i의 이득특성을 나타내며, 방사패턴은 일반적인 PIFA 방사패턴과 유사하다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.4
• /
• pp.351-356
• /
• 2009

A dual-mode annular ring antenna for both global positioning system(GPS) and satellite digital multimedia broad-casting(DMB) is designed. The proposed antenna consists of a coupling feed line and four slots on the annular ring patch. The gap between the feed line and the annular ring patch is used for an input impedance matching, and the slot length is used for adjusting the resonant frequency of the $TM_{21}$ mode at the DMB frequency. The antenna was fabricated and measured. The experimental results show that the antenna resonants at the GPS and DMB frequencies with suitable bandwidths, and had a broadside radiation pattern at the GPS band and a conical beam radiation pattern at the DMB band.

• ETRI Journal
• /
• v.30 no.2
• /
• pp.268-274
• /
• 2008

This paper proposes an open-loop clock recovery circuit (CRC) using two high-Q dielectric resonator (DR) filters for 39.8 Gb/s and 42.8 Gb/s dual-mode operation. The DR filters are fabricated to obtain high Q-values of approximately 950 at the 40 GHz band and to suppress spurious resonant modes up to 45 GHz. The CRC is implemented in a compact module by integrating the DR filters with other circuits in the CRC. The peak-to-peak and RMS jitter values of the clock signals recovered from 39.8 Gb/s and 42.8 Gb/s pseudo-random binary sequence (PRBS) data with a word length of $2^{31}-1$ are less than 2.0 ps and 0.3 ps, respectively. The peak-to-peak amplitudes of the recovered clocks are quite stable and within the range of 2.5 V to 2.7 V, even when the input data signals vary from 150 mV to 500 mV. Error-free operation of the 40 Gb/s-class optical receiver with the dual-mode CRC is confirmed at both 39.8 Gb/s and 42.8 Gb/s data rates.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.06a
• /
• pp.580-583
• /
• 2007

In this paper, we proposed a slot antenna for dual band ISM that was transformed from a slot antenna structure. Proposed antenna was designed and fabricated that transformed feed line was changed existing slot antenna feed line to appear resonances at dual band. Bandwidth of the designed and fabricated slot antenna for ISM dual band is 8.23%, 4.8% at the resonated frequency at 2.45 GHz, 5 GHz. And we observed the resonant frequency and bandwidth according to change of feed line and slot length. Also, the measured radiation pattern characteristic of fabricated antenna is compared and analyzed E-plane and H-plane at 2.45 GHz, 5GHz.

• ETRI Journal
• /
• v.35 no.2
• /
• pp.344-347
• /
• 2013

This letter presents a compact dual-mode tri-band bandpass filter by using a short-circuited stub-loaded stepped-impedance resonator (SIR) and a short-circuited stub-loaded uniform impedance resonator. Also, a hairpin SIR geometry is introduced to miniature the size of this filter while maintaining excellent performance. The use of a short-circuited stub at the central point of the hairpin SIR can generate two resonant modes in two passbands. Its equivalent circuit structure is analyzed by using the even-odd mode theory. For demonstration purposes, a tri-band filter for the applications of the Global Positioning System at 1.57 GHz, Worldwide Interoperability for Microwave Access at 3.5 GHz, and wireless local area networks at 5.2 GHz is designed, fabricated, and measured.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.10a
• /
• pp.70-72
• /
• 2011

In this paper, Dual-band monopole antenna for MIMO system is proposed. At this time the FR-4 substrate was used as a dielectric is 4.4, the size of 83mm * 50mm * 1.6mm size 3mm, the width of the proposed antenna by a $50{\Omega}$ microstrip line feed, and, LTE in the frequency 746-787MHz, 1710-1755MHz has been designed to operate at the resonant frequency less than-10dB and showed a good return loss in the operation.