• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 하계학술대회 논문집 Vol.4 No.1
• /
• pp.223-226
• /
• 2003

We propose an improvement method for a $\underline{G}ate$ $\underline{OX}ide(GOX)$ thinning at the edge of $\underline{S}hallow$ $\underline{T}rench$ $\underline{I}solation(STI)$, when STI is adopted to Dual Gate Oxide(DGOX) Process. In the case of SOC(System On-a-Chip), the DGOX process is usually used for realizing both a low and a high voltage parts in one chip. However, it is found that the severe GOX thinning occurs from at STI top edge region and a dent profile exists at the top edge of STI, when conventional DGOX and STI process carried out in high density device chip. In order to overcome this problem, a new DGOX process is tried in this study. And we are able to prevent the GOX thinning by H2 anneal, partially SiN liner skip, and a method which is merged a thick sidewall oxide(S/O) with a SiN pull-back process. Therefore, a good subthreshold characteristics without a double hump is obtained by the prevention of a GOX thinning and a deep dent profile.

• Transactions on Electrical and Electronic Materials
• /
• 제16권5호
• /
• pp.254-259
• /
• 2015

This paper reports the optimized mixed-signal performance of a high-voltage (HV) laterally double-diffused metaloxide-semiconductor (LDMOS) field-effect transistor (FET) with a dual gate oxide (DGOX). The fabricated device is based on the split-gate FET concept. In addition, the gate oxide on the source-side channel is thicker than that on the drain-side channel. The experiment results showed that the electrical characteristics are strongly dependent on the source-side channel length with a thick gate oxide. The digital and analog performances according to the source-side channel length of the DGOX LDMOS device were examined for circuit applications. The HV DGOX device with various source-side channel lengths showed reduced by maximum 37% on-resistance (R_ON) and 50% drain conductance (g_ds). Therefore, the optimized mixed-signal performance of the HV DGOX device can be obtained when the source-side channel length with a thick gate oxide is shorter than half of the channel length.

• 전자공학회논문지
• /
• 제51권3호
• /
• pp.177-184
• /
• 2014

화학기상증착의 텅스텐 실리사이드 듀얼 폴리 게이트 구조에서 플로린이 게이트 산화막에 미치는 영향을 전기적 물리적 측정 방법을 사용하여 연구하였다. 플로린을 많이 함유한 텅스텐 실리사이드 NMOS 트랜지스터에서 채널길이가 감소함에 따라 게이트 산화막 두께는 감소하여 트랜지스터의 롤업(roll-off) 특성이 심화된다. 이는 게이트 재 산화막 열처리 공정에 의해 수직방향으로의 플로린 확산과 더불어 수평방향인 게이트 측면 산화막으로의 플로린 확산에 기인한다. 채널길이가 짧아질수록 플로린의 측면방향 확산거리가 작아져 수평방향 플로린 확산이 증가하고 그 결과 게이트 산화막의 두께는 감소하게 된다. 반면에 PMOS 트랜지스터에서는 P형 폴리를 만들기 위한 높은 농도의 붕소가 플로린의 게이트 산화막으로의 확산을 억제하여 채널길이에 따른 산화막 두께 변화 특성이 보이지 않는다.

• 전기전자학회논문지
• /
• 제26권3호
• /
• pp.500-505
• /
• 2022

본 연구에서는 새로운 구조의 dual gate tri-layer split channel 박막트랜지스터를 제작하였다. 전류 구동 능력을 향상시키기 위해 액티브 층의 양쪽에 게이트를 형성하였고 전하이동도를 증가시키기 위하여 액티브 층에서 채널이 형성되는 구간인 첫번째 층과 세번째 층에 전도성이 높은 ITO 층을 배치하였다. 추가적으로 분할 채널을 이용하여 채널의 series 저항을 낮추면서 분할한 채널의 측면에서도 accumulation을 유도하여 전하이동도를 향상시켰다. 기존의 single gate a-ITGZO 박막트랜지스터가 15 cm²/Vs의 전하이동도를 가지는 반면 dual gate tri-layer split channel 박막트랜지스터는 134 cm²/Vs의 높은 전하이동도를 가졌다.

• 반도체디스플레이기술학회지
• /
• 제14권2호
• /
• pp.41-45
• /
• 2015

From 20nm technology node, the finFET has become standard device for ULSI's. However, the finFET process made stacking gate non-volatile memory obsolete. Some reported capacitor-less DRAM structure by utilizing the FBE. We present possible non-volatile memory device structure similar to the dual gate MOSFET. One of the gates is left floating. Since body of the finFET is only 40nm thick, control gate bias can make electron tunneling through the floating gate oxide which sits across the body. For programming, gate is biased to accumulation mode with few volts. Simulation results show that the programming electron current flows at the interface between floating gate oxide and the body. It also shows that the magnitude of the programming current can be easily controlled by the drain voltage. Injected electrons at the floating gate act similar to the body bias which changes the threshold voltage of the device.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2018년도 춘계학술대회
• /
• pp.171-172
• /
• 2018

Dual gate L-shaped tunnel field-effect-transistor (DG-LTFET) is presented in this study. DG-LTFET achieves near vertical subthreshold slope (SS) and its ON current is also found to be higher then both conventional TFET and LTFET. This device could serve as a potential replacement for conventional complimentary metal-oxide-semiconductor (CMOS) technology.

• 한국진공학회지
• /
• 제8권4A호
• /
• pp.490-495
• /
• 1999

In 0.18 $\mu \textrm m$ LOGIC device, the etch rate of NMOS polysilicons is different from that of PMOS polysilicons due to the state of polysilicon to manufacture gate line. To control the etch profile, we tested the ratio of $Cl_2$/HBr gas and the total chamber pressure, and also we reduced Back He pressure to get the vertical profile. In the case of manufacturing the gate photoresist line, we used Bottom Anti-Reflective Coating (BARC) to protect refrection of light. As a result we found that $CF_4O_2$ gas is good to etch BARC, because of high selectivity and good photoresist line profile after etching BARC. in the results of the characterization of plasma damage to the antenna effect of gate oxide, NO type thin film(growing gate oxide in 0, ambient followed by an NO anneal) is better than wet type thin film(growing gate oxide in $0_2+H_2$ ambient).

• 한국전기전자재료학회논문지
• /
• 제28권11호
• /
• pp.698-703
• /
• 2015

In this study, we fabricated the dual gate (DG) ion-sensitive field-effect-transistor (ISFET) with flexible polyimide (PI) extended gate (EG). The DG ISFETs significantly enhanced the sensitivity of pH in electrolytes from 60 mV/pH to 1152.17 mV/pH and effectively improved the drift and hysteresis phenomenon. This is attributed to the capacitive coupling effect between top gate and bottom gate insulators of the channel in silicon-on-transistor (SOI) metal-oxide-semiconductor (MOS) FETs. Accordingly, it is expected that the PI-EG based DG-ISFETs is promising technology for high-performance flexible biosensor applications.

• Journal of Electrical Engineering and information Science
• /
• 제3권2호
• /
• pp.261-266
• /
• 1998

This paper describes the fabrication and characterization of dual-polysilicon gated surface channel 0.1$\mu\textrm{m}$ CMOSFETs using BF2 and arsenic as channel dopants. We have used and LDD structure and 40${\AA}$ gate oxide as an insulator. To suppress short channel effects down to 0.1$\mu\textrm{m}$ channel length, shallow source/drain extensions implemented by low energy implantation and SSR(Super Steep Retrograde) channel structure were used. The threshold voltages of fabricated CMOSFETs are 0.6V. The maximum transconductance of nMOSFET is 315${\mu}$S/$\mu\textrm{m}$, and that of pMOSFET is 156 ${\mu}$S/$\mu\textrm{m}$. The drain saturation current of 418 ${\mu}$A/$\mu\textrm{m}$, 187${\mu}$A/$\mu\textrm{m}$ are obtained. Subthreshold swing is 85mV/dec and 88mV/dec, respectively. DIBL(Drain Induced Barrier Lowering) is below 100mV. In the device with 2000${\AA}$ thick gate polysilicon, depletion in polysilicon near the gate oxide results in an increase of equivalent gate oxide thickness and degradation of device characteristics. The gate delay time is measured to be 336psec at operation voltage of 2V.

• 한국전기전자재료학회논문지
• /
• 제25권9호
• /
• pp.671-676
• /
• 2012

In this paper, TCAD assessment of 30-V class n-channel EDMOS (extended drain metal-oxide-semiconductor) transistors with DWFG (dual work function gate) structure are described. Gate of the DWFG EDMOS transistor is composed of both p- and n-type doped region on source and drain side. Additionally, lengths of p- and n-type doped gate region are varied while keeping physical channel length. Two-dimensional device structures are generated trough TSUPREM-4 and their electrical characteristics are investigated with MEDICI. The DWFG EDMOS transistor shows improved electrical characteristics than conventional device - i.e. higher transconductance ($g_m$), better drain output current ($I_{ON}$), reduced specific on-resistances ($R_{ON}$) and higher breakdown characteristics ($BV_{DSS}$).