• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.12
• /
• pp.1287-1296
• /
• 2009

It is very important to estimate the Signal to Noise Ratio(SNR) of received signal in time varying channel state. Most SNR estimation techniques derive the SNR estimates solely from the samples of the received signal after the matched filter. In the severe distorted wireless channel, the performance of these estimators become unstable and degraded. LP-based SNR estimator which can operate on data samples collected at the front-end of a receiver shows more stable performance than other SNR estimator. In this paper, we study an efficient SNR estimation algorithm based on LP and propose a new estimation method to decrease the computation complexity. Proposed algorithm accomplishes the SNR estimation process efficiently because it uses the forward prediction error and its conjugate value during the linear prediction error update. Via the computer simulation, the performance of this proposed estimation method is compared and discussed with other conventional SNR estimators in digital communication channels.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.16 no.2
• /
• pp.63-70
• /
• 2016

To increase throughput efficiency and improve performance, FTN(Faster Than Nyquist) method and LDPC(Low Density Parity Code) codes are employed in DVB-S3 system. In this paper, we proposed efficient turbo equalization model to minimize inter symbol interference induced by FTN transmission. This paper introduces two conventional scheme employing SIC(Successive Interference Cancellation) and BCJR equalizer. Then, we proposed new scheme to resolve problems in this two conventional scheme. To make performance improved in turbo equalization model, the outputs of LDPC and BCJR equalizer are iteratively exchange probabilistic information. In fed LDPC outputs as extrinsic informa tion of BCJR equalizer. we split LDPC output to separate bit probabilities. We compare performance of proposed scheme to that of conventional methods through using simulation in AWGN(Additive White Gaussian Noise) channel. We confirmed that performance was improved compared to conventional methods as increasing throughput parameters of FTN.

• Journal of Institute of Control, Robotics and Systems
• /
• v.17 no.1
• /
• pp.47-53
• /
• 2011

To enable the efficient operation of ITS, it is necessary to collect location data for vehicles on the road. In the case of futuristic transportation systems like ubiquitous transportation and smart highway, a method of data collection that is advanced enough to incorporate road lane recognition is required. To meet this requirement, technology based on radio frequency identification (RFID) has been researched. However, RFID may fail to yield accurate location information during high-speed driving because of the time required for communication between the tag and the reader. Moreover, installing tags across all roads necessarily incurs an enormous cost. One cost-saving alternative currently being researched is to utilize GNSS (global navigation satellite system) carrierbased location information where available. For lane recognition using GNSS, a precise digital map for determining vehicle position by lane is needed in addition to the carrier-based GNSS location data. A "precise digital map" is a map containing the location information of each road lane to enable lane recognition. At present, precise digital maps are being created for lane recognition experiments by measuring the lanes in the test area. However, such work is being carried out through comparison with vehicle driving information, without definitions being established for detailed performance specifications. Therefore, this study analyzes the performance requirements of a precise digital map capable of lane recognition based on the accuracy of GNSS location information and the accuracy of the precise digital map. To analyze the performance of the precise digital map, simulations are carried out. The results show that to have high performance of this system, we need under 0.5m accuracy of the precise digital map.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.7 s.110
• /
• pp.665-672
• /
• 2006

In this paper, we propose and fabricate the dual-band microstrip patch antenna with parasitic patch for S-DMB(Satellite-Digital Multimedia Broadcasting) and ITS (Intelligent Transport System) services. The measured - 10 dB bandwidth and the minimum return loss is 300 MHz and - 27 dB for S-DMB, 600 MHz and -17 dB for ITS, respectively. It is noticed that the measured and simulated results are agreed well. The S-DMB antenna has conical beam pattern in the vertical plane and has omni-directional beam pattern in the horizontal plane. The conical beam pattern has the maximum gain about 4.2 dBi when ${\theta}$ is $45^{\circ}$ at the center frequency of 2.6 GHz. The ITS antenna has directional beam pattern in the vertical plane that has maximum gain about 6.4 dBi when ${\theta}$ is $0^{\circ}$ at the center frequency of 5.8 GHz.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.7 no.1
• /
• pp.23-31
• /
• 2007

In this paper, UWB system did research about effect that interference effect with neighborhood single equipment or group equipment gets in broadcasting communication service. For this, 2.6425GHz SDMB(Satellite Digital Multimedia Broadcasting) that a special of electric wave interference is near frequency-band including interference of signal by unnecessary radiation level that is radiated in UWB system, and degree of 3.4125GHz broadcasting relay net that is In-band frequency-band and interference effect that get in service analyzed comparison and, modulation of broadcasting relay net and interference measurement equipment used Impulse and OFDM methods. Impulse method was $BER\;=\;1{\times}\;10^{-4}$ that broadcasting signal receiption is possible at 1.4m point because interference effect happens from 2m point in SDMB system, and it was $BER\;=\;1{\times}\;10^{-4}$ that OFDM method receives interference effect from 0.8m point and broadcasting signal receiption is possible at 0.5m point. Also, about Gap-Filler center frequency, In case of space interval more than 0.01m, there was no interference effect. Therefore, for the electric wave of UWB system that is small output applies to system without interference effect in broadcasting communication service, confirmed that UWB system of OFDM method is less interference effect than UWB system of Impulse method.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.12B
• /
• pp.1037-1041
• /
• 2004

In this paper we propose a new conceptual slave clock system in which remotely located clock is synchronized to the reference clock by intermediation of the satellite time, show a probability of adoption to real network by experiments. This new proposed method has lots of structural advantages over the existing methods because all of the node clocks can be maintained with the same hierarchical quality. The measurement results show that the accuracy of the experimental slave clock system can be kept within a few parts in 1012 and that the MTIE (Maximum Time Interval Error) meets the ITU-T Recommendation G.811 for the primary reference clock A prototype system having fully automatic operational functions has been realized, and it is expected to be commercially used as a node clock for synchronization in the digital communication network in the near future.

• Journal of Satellite, Information and Communications
• /
• v.12 no.2
• /
• pp.11-14
• /
• 2017

In this paper, we introduce a method of light focusing effect using prism structure to solve optical discontinuity of conventional external signage LED panels. The prims structures were patterned on a transparent polycarbonate substrate with MEMS and femto-second laser process. We have confirmed that the patterned prism structures on the substrate made artificial LED lights on empty space between the panels by light guide effect of the structure. The artificial light's lateral positions were controlled by thickness of polycarbonate substrate. This cost effective prim patterned transparent film can be utilized on digital signage LED panels to achieve good optical communication.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.63 no.4
• /
• pp.23-32
• /
• 2021

For agricultural water management, it is essential to establish the digital infrastructure data such as agricultural watershed, irrigated area and canal network in rural areas. Approximately 70,000 irrigation facilities in agricultural watershed, including reservoirs, pumping and draining stations, weirs, and tube wells have been installed in South Korea to enable the efficient management of agricultural water. The total length of irrigation and drainage canal network, important components of agricultural water supply, is 184,000 km. Major problem faced by irrigation facilities management is that these facilities are spread over an irrigated area at a low density and are difficult to access. In addition, the management of irrigation facilities suffers from missing or errors of spatial information and acquisition of limited range of data through direct survey. Therefore, it is necessary to establish and redefine accurate identification of irrigated areas and canal network using up-to-date high resolution images. In this study, previous existing data such as RIMS (Rural Infrastructure Management System), smart farm map, and land cover map were used to redefine irrigated area and canal network based on appropriate image data using satellite imagery, aerial imagery, and drone imagery. The results of the building the digital infrastructure in rural areas are expected to be utilized for efficient water allocation and planning, such as identifying areas of water shortage and monitoring spatiotemporal distribution of water supply by irrigated areas and irrigation canal network.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.9 s.112
• /
• pp.866-873
• /
• 2006

In this paper, we proposed and fabricated the single-feed dual-band circular patch antenna for S-DMB(Satellite-Digital Multimedia Broadcasting) and ITS(Intelligent Transport Systems) services. The manufactured dual-band antenna showed that the measured -10 dB bandwidth and the minimum return loss was 90 MHz and -35 dB for S-DMB, 180 MHz and -18 dB for ITS, respectively. It is noticed that the measured and the simulated results are agreed well. And the antenna gain of S-DMB and ITS has 2.3 dBi and 2.7 dBi, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.3
• /
• pp.461-470
• /
• 1999

This paper presents the description of a 4-bit digital p-i-n diode phase shifter that was designed for quasimillimeter wave band satellite receiver to use in phased-array systems. 180$^{\circ}$ and 90$^{\circ}$ cells are designed in reflection type that consists of a 3-dB rat-race hybrid coupler, 45$^{\circ}$ and 22.5$^{\circ}$ cells are designed in loaded-line type to reduce the size of circuit and the number of diode to be used. The 4-bit phase shifter uses eight p-i-n diodes mounted in the microstrip circuit. The average insertion loss for the 16 phase states is 6.92dB over the 19.8~20.3 GHz band and maximum phase error is 6.2$^{\circ}$ at 20 GHz.