• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.725-727
• /
• 2009

Lowering the dielectric constant is one of the important issues for the efficiency and the power consumption in the plasma display panel (PDP) industry. This study examined the effect of the addition of ceramic filler (up to 10% of crystalline and amorphous silica, respectively) to a $B_2O_3$-ZnO- $P_2O_5$ glass matrix on the dielectric, coefficient of thermal expansion, etching behaviors and residual stress for the barrier ribs in plasma display panels. The dielectric constant of barrier ribs is affected by containing two types of $SiO_2$ filler for the barrier rib composition in PDP.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.229-229
• /
• 2007

In this study, HEMA-based hydrophilic copolymers were synthesized and dielectric constant (K) of the polymer thin films were investigated by change hydroxyl group (-OH) ratio in the polymer chain. The different hydroxyl group ratios were characterized by FT-IR and its thin films were obtained by spin coating. As a result, due to the moisture absorption of the hydrophilic thin film, the dielectric constant has been increased as was expected. The highest dielectric constant (K=4.19, @1MHz) was observed at 40% hydroxyl group ratio among the several polymers.

• Transactions on Electrical and Electronic Materials
• /
• v.10 no.4
• /
• pp.116-120
• /
• 2009

Ceramic-polymer composites have been investigated for their suitability as embedded capacitor materials because they combine the processing ability of polymers with the desired dielectric properties of ceramics. This paper discusses the dielectric properties of the ceramic ($BaTiO_3$)-polymer (Epoxy) composition as a function of ceramic particle size at a ceramic loading of 40 vol%. The dielectric constant of these ceramic-polymer composites increases as the powder size decreases. Results show that ceramic-polymer composites have a high dielectric constant associated with the $BaTiO_3$ powder with a 200 nm particle size, high insulation resistance, high breakdown voltage (> 22 KV/mm), and low dielectric loss (0.018-0.024) at 1 MHz.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1998.11a
• /
• pp.187-190
• /
• 1998

In this paper a probe for the' measurement of dielectric properties of dielectric sheet materials is designed and implemented as a coaxial air line type. Using the broadband impedance method with this measurement probe the dielectric constant and loss tangent of the glass-epoxy and teflon are determined in the frequency range of 0.1 - l.O[GHz] with the temperature variation from $25[^{\circ}C]$ up to $65[^{\circ}C]$. A measured relative dielectric constant of the glass-epoxy is 4.42 and a loss tangents is 0.019 relatively, and the relative dielectric constants of teflon is 2.17 and a loss tangents is 0.002 relatively

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1989.06a
• /
• pp.21-25
• /
• 1989

Theory and experimental results are presented to show the possibility of using a dielectric rod resonator method for characterizing dielectric materials at microwave frequency. The measuring structure is a resonator made up of a cylindrical dielectric rod placed between two parallel conducting plates. In this system, the TE$\_$011/ mode frequency was adapted to minimize the effect of the air-gap between the rod and the conducting plates. The dielectric properties are computed from the resonance frequencies, structure dimensions and 3-dB bandwidth.

• Proceedings of the KIEE Conference
• /
• 1992.07b
• /
• pp.747-749
• /
• 1992

In this study, $0.45Pb(Fe_{1/2}Nb_{1/2})O_3-(0.55-x)Pb(Fe_{2/3}W_{1/3})O_3-xPb(Mg_{1/3}Nb_{2/3})O_3(x=0.20, 0.25, 0.30)$ (x=0.20, 0.25, 0.30) ceramics were fabricated by the mixed oxide method. The sintering temperature and time were 950-990[$^{\circ}C$], 2[hr], respectively. The dielectric and structural properties with the composition and sintering temperature were investigated for the application as multilayer ceramic capacitors. To improve the dielectric loss, specimens doped with $MnO_2$, (0$\sim$2.0 [mol%] ) were fabricated and their dielectric properties were studied. With increasing the amount of $MnO_2$, dielectric constant was decreased and transition temperature was increased. Dielectric constant and dielectric loss of the 0.45PFN-0.30PFW-0.25PMN+$MnO_2$(1.0[mol.%]specimen(970[$^{\circ}C$]) had a good properties of 11,227, 1.3[%].

• Journal of the Korean Ceramic Society
• /
• v.49 no.2
• /
• pp.179-184
• /
• 2012

The size of various alumina ceramics used in semiconductor and display industry is required to increase with increase in wafer and panel size. In this research, large alumina ceramics were fabricated by uniaxial pressing, cold isostatic pressing and filter pressing with commercial powder and thereafter sintering at $1600^{\circ}C$ in gas furnace. The large alumina ceramics exhibited dense microstructure corresponding to 98.5% of theoretical density and 99.8% of high purity. The impurities and microstructural defects of the alumina were found to influence the resistance and dielectric properties. The volume resistances in these four aluminas were almost the same while the pure alumina was higher value. The dielectric constant, dielectric loss and dielectric strength of aluminas were placed within the range of 10.3~11.5, 0.018~0.036, and 10.1~12.4 kV/mm, respectively.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.34 no.5
• /
• pp.337-341
• /
• 2021

Phase evolution, thermal and microwave dielectric properties of cordierite-Al₂O₃ composite were investigated. As the content of Al₂O₃ increased, mullite, sapphirine, and spinel were formed as secondary phases, implying that cordierite may be decomposed by the reaction with Al₂O₃. All sintered specimens exhibited dense microstructures. The densification occurred through liquid phase sintering. As the content of Al₂O₃ increased, the thermal expansion coefficient and the dielectric constant increased, whereas the quality factor decreased. The thermal expansion coefficient, the dielectric constant, and the quality factor of the 90 wt% cordierite 10 wt% Al₂O₃ composite sintered at 1,425℃ were 2.9×10^-6 K^-1, 5.1, and 34,844 GHz, respectively.

• 전기의세계
• /
• v.19 no.5
• /
• pp.8-16
• /
• 1970

The characteristics of dielectric absorption and dispersion in polymerized materials produced in Korea was investigated in MHz band and at several sets of temperature. For this study the theoretical basis stood on the Cole-Cole's empirical formula and it has been extended to the form convenient to investigate the observation. As the result, it has been confirmed that in most cases, two or much more sorts of dipole participate in dielectric propertics of these polymers and the materials containing aromatic molecular structure have, in general, greater loss angle than those constructed chain type molecular structure.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2010.05a
• /
• pp.48.2-48.2
• /
• 2010

The effect of additives as rare-earth in dielectric materials has been studied to meet the development trend in electronics on the miniaturization with increasing the capacitance of MLCCs (multi-layered ceramic capacitors). It was reported that the addition of rare-earth oxides in dielectrics would contribute to enhance dielectric properties and high temperature stability. Especially, dysprosium and thulium are well known to the representative elements functioned as selective substitution in barium titanate with perovskite structure. The effects of these additives on microstructure and electric properties were studied. The 0.8 mol% Dy doped $BaTiO_3$ and the 1.0 mol% Tm doped $BaTiO_3$ had the highest electric properties as optimized composition, respectively. According to the increase of rare-earth contents, the growth of abnormal grains was suppressed and pyrochlore phase was formed in more than solubility limits. Furthermore, the effect of two rare-earth elements co-doped $BaTiO_3$ on the dielectric properties and insulation resistance was investigated with different concentration. The dielectric specimens with $BaTiO_3-Dy_2O_3-Tm2O_3$ system were prepared by design of experiment for improving the electric properties and sintered at $1320^{\circ}C$ for 2h in a reducing atmosphere. The dielectric properties were evaluated from -55 to $125^{\circ}C$ (at $1KHz{\pm}10%$ and $1.0{\pm}0.2V$) and the insulation resistance was examined at 16V for 2 min. The morphology and crystallinity of the specimens were determined by microstructural and phase analysis.