• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1999년도 하계종합학술대회 논문집
• /
• pp.227-230
• /
• 1999

Rigorous formulation for solving the scattered fields by a lossy dielectric wedge is proposed. By employing the Kirchhoff's integrals in the physical domain and the extinction theorem in the mathematically complementary region, it is shown that the accurate solution is obtained by adding the numerically corrected fields generated by the multipole source expansions to the analytically approximated physical optics solution. Its accuracy is affirmed by the extinction behavior of the solution in the complementary region.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2001년도 종합학술발표회 논문집 Vol.11 No.1
• /
• pp.202-206
• /
• 2001

In this paper a novel dielectric resonator (DR) bandpass filter (BPF) with flexible arrangement of attenuation poles is proposed. This DR filter is similar to a conventional DR filter except adding a microstrip line below a DR, which not only shifts the location of attenuation poles, but also improves skirt characteristics. The duplexer with the proposed DR BPF has been yielded better isolation and sharper skirt behavior than that with a conventional DR alter. The implemented duplexer has shown a good performance and been well agreed with the simulation.

• 대한안전경영과학회지
• /
• 제3권4호
• /
• pp.45-52
• /
• 2001

In order to Investigate water tree degradation behavior on XLPE cable, direct voltage of 200 to 800V has been applied to the material at 5$0^{\circ}C$~10$0^{\circ}C$, and the water tree property has been correlated with voltage and temperature. The leakage current was increase as temperature increased and the Ohm's law was generally satisfied in this experiment though some experimental errors were found. The leakage current was decreased and reached to the stable state with time. It was also shown that the time for the stabilization of leakage current was lessened as voltage increased

• Transactions on Electrical and Electronic Materials
• /
• 제17권3호
• /
• pp.129-133
• /
• 2016

Theoretical and graphical analysis of pull-in-voltage and figure of merit for a fixed-fixed capacitive Micro Electromechanical Systems (MEMS) switch is presented in this paper. MEMS switch consists of a thin electrode called bridge suspended over a central line and both ends of the bridge are fixed at the ground planes of a coplanar waveguide (CPW) structure. A thin layer of dielectric material is deposited between the bridge and centre conductor to avoid stiction and provide low impedance path between the electrodes. When an actuation voltage is applied between the electrodes, the metal bridge acquires pull in effect as it crosses one third of distance between them. In this study, we describe behavior of pull-in voltage and figure of merit (or capacitance ratio) of capacitive MEMS switch for five different dielectric materials. The effects of dielectric thicknesses are also considered to calculate the values of pull-in-voltage and capacitance ratio. This work shows that a reduced pull-in-voltage with increase in capacitance ratio can be achieved by using dielectric material of high dielectric constant above the central line of CPW.

• 한국재료학회지
• /
• 제24권4호
• /
• pp.207-213
• /
• 2014

Flexible $BaTiO_3$ films as dielectric materials for high energy density capacitors were deposited on polyethylene terephthalate (PET) substrates by r.f. magnetron sputtering. The growth behavior, microstructure and electrical properties of the flexible $BaTiO_3$ films were dependent on the sputtering pressure during sputtering. The RMS roughness and crystallite size of the $BaTiO_3$ increased with increasing sputtering pressure. All $BaTiO_3$ films had an amorphous structure, regardless of the sputtering pressures, due to the low PET substrate temperature. The composition of films showed an atomic ratio (Ba:Ti:O) of 0.9:1.1:3. The electrical properties of the $BaTiO_3$ films were affected by the microstructure and roughness. The $BaTiO_3$ films prepared at 100 mTorr exhibited a dielectric constant of ~80 at 1 kHz and a leakage current of $10^{-8}A$ at 400 kV/cm. Also, films showed polarization of $8{\mu}C/cm^2$ at 100 kV/cm and remnant polarization ($P_r$) of $2{\mu}C/cm^2$. This suggests that sputter deposited flexible $BaTiO_3$ films are a promising dielectric that can be used in high energy density capacitors owing to their high dielectric constant, low leakage current and stable preparation by sputtering.

• 한국재료학회지
• /
• 제34권7호
• /
• pp.321-329
• /
• 2024

In this work, a series of BaTiO₃-based ceramic materials, Ba(Al_0.5Nb_0.5)_xTi_1-xO₃ (x = 0, 0.04, 0.06, 0.08), were synthesized using a standard solid-state reaction technique. X-ray diffraction profiles indicated that the Al+Nb co-doping into BaTiO₃ does not change the crystal structure significantly with a doping concentration up to 8 %. The doping ions exist in Al³⁺ and Nb⁵⁺ chemical states, as revealed by X-ray photoelectron spectroscopy. The frequency-dependent complex dielectric properties and electric modulus were studied in the temperature range of 100~380 K. A colossal dielectric permittivity (>1.5 × 10⁴) and low dielectric loss (<0.01) were demonstrated at the optimal dopant concentration x = 0.04. The observed dielectric behavior of Ba(Al_0.5Nb_0.5)_xTi_1-xO₃ ceramics can be attributed to the Universal Dielectric Response. The complex electric modulus spectra indicated the grains exhibited a significant decrease in capacitance and permittivity with increasing co-doping concentration. Our results provide insight into the roles of donor and acceptor co-doping on the properties of BaTiO₃-based ceramics, which is important for dielectric and energy storage applications.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 1993년도 추계 학술발표 강연 및 논문 개요집
• /
• pp.133-133
• /
• 1993

• 한국결정성장학회지
• /
• 제30권3호
• /
• pp.110-116
• /
• 2020

MLCC(Multi-Layer Ceramic Capacitor)의 유전체 층에 사용되는 BaTiO₃ 입자는 안정한 TCC(Temperature Characteristics of Capacitance) 거동을 갖기 위해 core/shell 구조를 갖는다. 지금까지 shell의 특성은 core/shell 구조의 전체 특성에서 유추해 왔다. 이는 core/shell 구조가 겨우 수 ㎛의 작은 크기로 shell 특성만 구별해서 측정하기가 어렵기 때문이다. 본 실험에서는 micro-contact법을 이용하여 확산쌍 시편의 계면에 형성된 확대된 core/shell 구조에 Pt 전극을 증착하여 35~135℃ 에서 shell 영역의 독립적인 TCC 거동을 측정하였다. 그 결과, 65℃에서 최대 유전율 값을 갖는 완만한 피크의 확산 상전이(Diffusion Phase Transition) 거동인 core의 특성과 구별되는 거동을 관찰하였으며, 이는 core/shell 구조의 온도-유전거동을 묘사하는 모델링에서 실험 자료로 활용될 것으로 본다.

• Advances in materials Research
• /
• 제2권2호
• /
• pp.77-91
• /
• 2013

High quality nanoparticles of neodymium barium niobium ($NdBa_2NbO_6$) perovskites have been synthesized using an auto ignition combustion technique for the first time. The nanoparticles thus obtained have been characterized by powder X-ray diffraction, thermo gravimetric analysis, differential thermal analysis, Fourier transform infrared spectroscopy, Raman spectroscopy and transmission electron microscopy. UV-Visible absorption and photoluminescence spectra of the samples are also recorded. The structural analysis shows that the nano powder is phase pure with the average particle size of 35 nm. The band gap determined for $NdBa_2NbO_6$ is 3.9 eV which corresponds to UV-radiation for optical inter band transition with a wavelength of 370nm. The nanopowder could be sintered to 96% of the theoretical density at $1325^{\circ}C$ for 2h. The ultrafine cuboidal nature of nanopowders with fewer degree of agglomeration improved the sinterability for compactness at relatively lower temperature and time. During the sintering process the wide band gap semiconducting behavior diminishes and the material turns to a high permittivity dielectric. The microstructure of the sintered surface was examined using scanning electron microscopy. The striking value of dielectric constant ${\varepsilon}_r=43$, loss factor tan ${\delta}=1.97{\times}10^{-4}$ and the observed band gap value make it suitable for many dielectric devices.

• 마이크로전자및패키징학회지
• /
• 제21권4호
• /
• pp.111-115
• /
• 2014

다마신 구리 배선에서의 동적인 전기장에 따른 절연체 파괴거동을 연구하였다. DC, 단극성, 및 이극성 펄스 조건 중에서 절연체의 수명은 이극성 펄스 조건에서 가장 길었다. DC 및 단극성 펄스 조건에서는 절연체에 가해지는 전기장의 방향이 바뀌지 않지만 이극성 펄스 조건에서는 전기장의 방향이 반복적으로 180도 바뀌기 때문에, 이극성 펄스 조건에서는 절연체의 구리오염이 억제되고, 이로 인해서 절연체 수명이 이극성 펄스 조건에서 가장 긴 것으로 판단된다. 단극성 펄스 조건에서 펄스 주파수가 커질수록 DC 조건보다 절연체의 수명이 증가하였다. 이는 절연체 수명에 구리오염 뿐만 아니라 내재적인 절연파괴현상이 상당한 영향을 미치며, 절연체 분자결합파괴가 일어날 확률은 펄스 폭이 좁아질수록 감소한다고 판단된다.