• 한국정밀공학회지
• /
• 제13권10호
• /
• pp.112-122
• /
• 1996

In order to monitior machine tool condition and diagnose alarm states due to electrical and mechanical faults, and expert system using diagnostic parameters of NC machine tools was developed. A model-based knowledge base was constructed via searching and comparing procedures of diagnostic parameters and state parameters of the machine tool. Diagnostic monitoring results generate through a successive type inference engine were graphically displayed on the screen of the console. The validity and reliability of the expert system was rcrified on a vertical machining center equipped with FANUC OMC through a series of experiments.

• Journal of Acupuncture Research
• /
• 제23권5호
• /
• pp.11-21
• /
• 2006

The 7-zone-diagnostic system(ABR-2000, BIO MEDIC 700Plus, CP-6000A, OMD 3000, VEGA-DFM 722) is a diagnostic device which applies pulse signals to predetermined bodily locations. Applying alternating positive and negative stress to tissues with positive and negative pulses first manifests itself as negative and positive wave forms. This system make a diagnosis of functional disorder or some typical organic diseases include stress of the mind or the body, and the energetic situation, reserves. We are known a disorder or disease throw the result charts. And these result represents various characteristic signals are assisted diagnosis and care. These result chart contains disorder flow wave forms and some valuable diagnostic hints or marks. But we have several various products for the 7-zone-diagnostic system. I think that we need the comparative analysis of the general rule and the decipher for each equipment. Because these letters(marks) each product are different, we necessary various plentiful research and suitable statistics in these points. And we must carry out many various research in the future.

• 융합보안논문지
• /
• 제12권3호
• /
• pp.99-106
• /
• 2012

오늘날 대표적 웹 해킹 공격기법은 크로스사이트스크립팅(XSS)과 인젝션 취약점 공격, 악성 파일 실행, 불안전한 직접 객체 참조 등 이다. 웹해킹 보안시스템인 접근통제 솔루션은 웹 서비스로 접근하는 패킷을 통제하지 않고 내부로 유입시킨다. 때문에 만약 통과하는 패킷이 악의적으로 조작 되었을 경우에도 이 패킷이 정상 패킷으로 간주된다. 이때 방어시스템은 적절한 통제를 하지 못하게 된다. 따라서 성공적인 웹 서비스를 보증하기 위하여 웹 애플리케이션 취약점 진단시스템 개발이 실질적이며 절실히 요구되는 대안이다. 웹 애플리케이션 취약점 진단시스템 개발은 개발절차 정립, 웹 시스템 취약점 진단범위 설정, 웹 어플리케이션 분석, 보안 취약점 점검항목 선정의 단계가 진행 되어야 한다. 그리고 진단시스템에서 필요한 환경으로서 웹 시스템 사용도구, 프로그램언어, 인터페이스, 변수가 설정되어야 한다.

• 대한의용생체공학회:의공학회지
• /
• 제12권1호
• /
• pp.63-70
• /
• 1991

Design of Arrhythmia Automatic Diagnostic System Using Decision Table We have developed an arrhythmia automatic diagnostic system using decision table which is based on the criteria of Minnesota code. This system is divided into two Parts. One is wave detection algorithm using significant point extraction method, the other is arrhythmia diag- nostic algorthm. The proposed system allows physicians to diagnose more accurately by pro- viding the objective information about a lot of computer -processed ECG data.

• 대한안전경영과학회:학술대회논문집
• /
• 대한안전경영과학회 2004년도 춘계학술대회
• /
• pp.153-159
• /
• 2004

There are various types of PLM(product liability management) according to corporation management level. It is necessary to develop diagnostic methods and application systems for PLM as well as to establish an efficient PLM system. This paper aims to propose a PLM system which can be applied to product with high-reliability and high-safety, and diagnostic methods for PLM based on AHP, and also show an empirical application of the proposed PL management system for Auto Test Robot System of the Mobile Phone (EVT 4320).

• 한국지능시스템학회논문지
• /
• 제14권3호
• /
• pp.267-272
• /
• 2004

본 논문에서는 농산물 저온저장시설의 냉동기용 지능형 진단 시스템을 제안한다. 제안하는 방법은 냉동기에 고장이 발생하면 냉동기 주요배관의 온도가 변화하는 성질을 이용하였다. 주요배관의 온도와 고장부위의 관계를 신경회로망을 이용하여 학습함으로써 고장상태를 추론할 수 있다. 제안된 방법을 구현하기 위하여 온도계측시스템 및 진단프로그램을 개발하였다. 개발된 시스템을 현장에 적용 실험하여 제안된 방법의 유용성을 검증하였다.

• 한국정밀공학회지
• /
• 제15권11호
• /
• pp.218-226
• /
• 1998

In this study a neural network based expert system designed to diagnose operating status of a rotating spindle system supported by ball bearings was introduced. In order to facilitate practical failure situations, five exemplary abnormal status was fabricated. Out of several possible data source locations, seven most effective spots were chosen and proven to be the most successful in predicting single and multiple abnormalities. Increased signal strength was measured around where abnormality was embedded. Signal mea-surement locations producing high prediction rate were also classified. Even though multiple abnormalities were hard to be decoupled into their individual causes, proposed diagnostic system was somewhat effective in predicting such cases under certain combination of sensor locations. Among several abnormal operating conditions, highest prediction rate can be expected when signal is spoiled by the failure or damage in outer race. Proposed diagnostic system was again proven to be the most effective system in analyzing and ranking the importance of data sources.

• Nuclear Engineering and Technology
• /
• 제46권6호
• /
• pp.725-736
• /
• 2014

It is very important to detect and identify small anomalies and component failures for the safe operation of complex and large-scale artifacts such as nuclear power plants. Each diagnostic technique has its own advantages and limitations. These facts inspire us not only to enhance the capability of diagnostic techniques but also to integrate the results of diagnostic subsystems in order to obtain more accurate diagnostic results. The article describes the outline of four diagnostic techniques developed for the condition monitoring of the fast breeder reactor "Monju". The techniques are (1) estimation technique of important state variables based on a physical model of the component, (2) a state identification technique by non-linear discrimination function applying SVM (Support Vector Machine), (3) a diagnostic technique applying WT (Wavelet Transformation) to detect changes in the characteristics of measurement signals, and (4) a state identification technique effectively using past cases. In addition, a hybrid diagnostic system in which a final diagnostic result is given by integrating the results from subsystems is introduced, where two sets of values called confidence values and trust values are used. A technique to determine the trust value is investigated under the condition that the confidence value is determined by each subsystem.

• 한국의료질향상학회지
• /
• 제19권1호
• /
• pp.64-72
• /
• 2013

Objective: To improve customer satisfaction through accurate information using computerized automation of the test reservation system and by performing all fasting tests on the same day with one fasting. Methods: Quality improvement activities of the test reservation system of Seoul National University Bundang Hospital improves internal and external customer satisfaction at the time of test scheduling by having the reservation system reflect test order and test time automatically and making the system to increase the same day test reservation rate. Results: Test process was smooth due to accurate test reservation and information based on test priority due to the introduction of the computerized test reservation system. Internal and external customer satisfaction improved due to the marked reduction in time required for making a reservation thanks to the improvement of work process. Conclusion: Building a computerized test reservation system was an effective measure to improve external and internal customer satisfaction.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 C
• /
• pp.1694-1697
• /
• 2002

KEPCO is planing to adopt a preventive diagnostic system to obtain the reliability of transformer and GIS in 765kV substation. KEPRI has developed the preventive diagnostic system for 765kV substation since 1997. We used various sensors and fault detecting devices such as a dissolved gas analyzer in oil, a ultrasonic detector and LA leakage current detector, etc., and carried out adaptation tests at the both a laboratory and a site. We developed a data acquisition system, a communication control unit and a server system as well. Furthermore, monitoring program and diagnostic expert system were also developed. This paper describes the preventive diagnostic system for 765kV Sin-Ga-Pyong and Sin-Tae-Baek substations which will be operated from 2004.