• Journal of Biosystems Engineering
• /
• v.21 no.1
• /
• pp.52-59
• /
• 1996

In this study, the combined forces of electro-osmosis and compression were applied to cabbage dewatering and their effects were discussed. Nine treatments of combined forces consisting of three levels of voltage and compression were applied to chopped and macerated chinese cabbage placed in the experimental set-up consisted of cylinder-piston. The results showed that as both voltage and pressure increased the dewatering rates increased and the combined force of voltage and compression was a very effective means in the dewatering of chinese cabbage in which the largest dewatering rate difference, 72%, was found between the combined force of 30V with 68.2kPa and no voltage(0V) with 68.2kPa. However, no significant difference was found between the voltage of 0 and 10volts in 9.75kPa and the pressure of 68.2kP and 126.7kPa in 30volts. The maximum and minimum dewatering rate were 82% in the combined force of 30 volts of 126.7kPa and 8% in 0 volt of 9.75kPa, respectively. Within the experimental trials, it appeared that the best treatment combination would be pressure of 68.2kPa and voltage of 30V producing dewatering rate of 80ft in which the produced liquid contained about 1% solid. Employing this dewatering method as a pretreatment before drying process can contribute in considerable energy saving in agricultural wastes treatment.

• Resources Recycling
• /
• v.15 no.4 s.72
• /
• pp.36-43
• /
• 2006

There was some difficulty dewatering properties due to small porosity diameter of cake, when pigment sludge contained fine particle was formed by cake under the dewatering. It was difficult to dewater the sludge with fine particles with the conventional mechanical dewatering method. This study was to improve the dewatering rate as discharging the water from porosity of cake easily, supplying the low heat to the cake layer. Thermal dewatering equipment of piston type to keep up constant temperature on the cake was set up and relative experiment was conducted for sludge of 200 g with fine pigment particle. As test results. filtration of 176.8 g, cake weight of 19.4 g, cake thickness of 4.2 mm was measured, and it was analyzed that the water content of cake was 47 wt% and dewatering velocity, which moaned the residual d교 sloid amount per dewatering area, was $2.1DS\;m^{2}{\cdot}cycle$. This results showed that filtration increased, cake weight and thickness decreased and dewatering velocity increased against mechanical dewatering method. And water content of cake decreased about 30%, so the result which dewatering rate improved was drew generally. The reason is that the inner vapor pressure working at the cake porosity increased as applying the low heat to the cake layer, which lead to discharge the water from porosity easily. Therefore, this study was estimated by the useful technology for sludge reduction.

• Journal of Biosystems Engineering
• /
• v.19 no.1
• /
• pp.3-8
• /
• 1994

An experiment on the expression and dewatering of chinese cabbage was conducted in order to investigate its dewatering behavior. Chopped cabbage was packed into cylinder and pressed by piston upto the predetermined pressure on Instron-1000. The rates of dewatering were affected domintantly by the applied pressure, but not significantly by the packed amount of cabbage in the cylinder. The pressure effect was increased very abruptly at first, but the increase rate was very low at high pressure greater than 20 MPa, showing great deviation from linear dependence of flow rate on pressure in Darcy's Law. Therefore, water expression from cabbage was not Newtonian flow of water through cell wall. In fact, the squeezed water contained a lot of solid particles, about 3% of solid cabbage particles, showing destruction of cell wall. It appeared that compression and dewatering of vegetable wastes in the low pressure. under 20 MPa, is more desirable for later treatment of the dewater. More researches are needed in order to develop a treatment method for the solid particles in the expressed water before an expeller treatment system can be applied to vegetable wastes.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09c
• /
• pp.125-128
• /
• 2010

A large quantity of purified water sludge is generated in modern cities around the world. Dewatering is essential to reduce the volumes transported off-site for disposal. Traditionally employed methods such as solar drying methods are time-consuming. There are urgent demands for developing alternatives to dewater the sludge in a less time-consuming manner. In this paper, siphon method is proposed to dewater the high-water-content sludge with plastic drainage plate installed horizontally. A group of comparative tests are conducted to preliminarily investigate the dewatering behavior of the purified water sludge with siphon and solar drying methods, respectively. On the basis of the test results, the availability and effectiveness of the new method is verified. It may provide an innovative solution to treat the purified water sludge more effectively.

• Journal of the Korean Geosynthetics Society
• /
• v.7 no.1
• /
• pp.23-29
• /
• 2008

Recently, dewatering process method of high water content materials that utilize geotextile has many applications in variety fields. It is method of dewatering to solid step through self-weight consolidation process after pour sludge using filtering efficiency and dewatering efficiency. Analyzed application of domestic manufactured geotextile tube that can examine physical characteristics of geotextile tube and filling soil and achieve filtering efficiency and dewatering efficiency. Based on the various laboratory and field test results mixing proportions of water and soil is about 6:4 at least. Polypropylene geotextile is more effective for drainage and dewatering function of geotextile tube application.

• Journal of Environmental Science International
• /
• v.13 no.7
• /
• pp.681-687
• /
• 2004

This study was focused on the manufacturing method of a dewatering aid, which would reduce the water content of the sludge cake by enhancing the dewaterability of sewage sludge. The pretreatment technology for sludge by using radiation and among diverse discarded resources were starfish selected as the material to manufacture the dewatering aid. Starfish went through the process of washing, drying, and pulverizing. The starfish powder made in this process was applied to the digested sludge generated at the sewage treatment plant of D City, and its effects were investigated. The starfish powder that was 300 ${\mu}m$ in particle size was added to the irradiated digested sludge. After the application of the condensation process, the sludge with the starfish powder added was dewatered using the belt press and centrifuge, which were the traditional pressure dewatering devices. As the result, it reduced the water content of the sludge 20% higher than the dewatered cake with no dewatering aid added and irradiation. When the powder was added, it contributed to less use of the coagulant added. The more irradiation dose, the lower water content did the dewatered cake have and the more coagulant was needed for condensation, which seems to be a disadvantage that can be compensated for by the starfish dewatering aid. A small-scaled treatment of the study to a radiation technology and dewatering aid using a discarded resource confirmed the potential of dewaterability. Based on the results saying that the dewatering aid and radiation technology can improve dewatering effects using the traditional dewatering devices, this pretreatment technology will be expected to be applied to sewage treatment plants.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.6B
• /
• pp.661-667
• /
• 2006

In this study, an experiment of sewage sludge dewatering is carried by using electrokinetic method, and the electrokinetic dewatering efficiency of digested sludge is analyzed. Digested sludge without coagulants is selected and gravitational and pressing dewatering methods are applied in combination with electro-osmotic and electro-osmotic pulse technology. After the test of digested sludge, dewatering test of thickened sludge is carried to evaluate the electrokinetic dewatering feasibility of thickened sludge. Under the condition of constantly applied voltage, however, electrical resistance increases with decreasing of water content so that dewatering rate decreases with time. To reduce such a hindrance caused by constantly applied voltage, electro-osmotic pulse technology which is considered to reduce the difference of water content with height, is applied. For the application of electro-osmotic pulse, the dewatered flow rate and the dewatered volume became more increasing from the middle of the dewatering process than that of continuous voltage. Through the test of thickened sludge, electro-osmotic dewatering combined with gravitational and expression also showed high dewatering rate, which proved the possibility of using electrokinetic dewatering.

• Journal of the Korean Geosynthetics Society
• /
• v.10 no.1
• /
• pp.9-18
• /
• 2011

This paper described that the failure causes of reinforced slope are analyzed based on the effect of geological and rainfall. The analysis result confirmed that the rainfall has effects on the stability of reinforced slope. Therefore, it was applied to the dewatering method using collector well for slope stabilized, and then the analysis of seepage and slope stability were conducted on slope with the applied method. The results of seepage analysis are corresponded with failure cause by rainfall and the results of slope stability, which is applied to dewatering method, are satisfied with safety factor criterion. Therefore, it confirmed that the dewatering method using collector could be possible to apply in field and reasonable method for slope stabilized during heavy rainfall.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.10a
• /
• pp.581-590
• /
• 2008

A SWP method is a revolutionary dewatering method. The conventional dewatering method, deep-well method, had ever occurred a civil appeal caused by the well depletion in compliance with the reduction of the groundwater level over a wider area considerably by the deep-well pumping from homogeneous sand-layer ground for a dry-work, while pump groung excavation working in Sendai city, Japan 10 years ago. it'd developed with the problematic proposal to find the new method which can lower the groundwater level only within the sheet pile without any reduction of groundwater outside of the sheet pile and until currently steady improvement came. It's been confirmed with plenty of executional results that there was almost no decreasing of water-level from surroundings, over so many construction-sites including vertical shafts which completely does not enter into non-water permeable layer and pumping ground etc. The SWP method in this time has been introducing initially and carried into a the execution tentatively at a construction-site and made a various result get through the execution.

• Journal of the Korean Geosynthetics Society
• /
• v.8 no.1
• /
• pp.61-66
• /
• 2009

This paper presented that the causes on failure of reinforced slope are analyzed which based on the analyzed result. It had been applied that a method of lowering the groundwater using deepwell for sump. For the stability analysis on applied method, a series of numerical analysis were carried out. Therefore, it could be confirmed that slope stability was affected the dewatering ability of groundwater by the rainfall and this method which was confirmed very reasonable and suitable methods for slope stability, during heavy rainfall, in field.