• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.16 no.4
• /
• pp.477-497
• /
• 1994

The purpose of this study was to investigate the effect of timing of implant insertion on osseointegration after tooth extraction. Fifteen mongrel dogs, weighing 15kg or more, were used. The lower right 1st, 2nd, 3rd, 4th premolars and 1st molar were extracted under general anesthesia. Implants were inserted at 2, 4, and 8 weeks after extraction of the teeth, being designated as 2-, 4-, and 8-week groups, respectively. Results obtained were as follows. 1. Macroscopically there was neither an infection at the implant site nor an exposure of the implant. 2. Histologically the surrounding bone of the implant was less mature in the 2-week group than in the 4- and 8-week groups. 3. The implant-bone contact ranged from 75 to 82%, with no significant differences among the groups. No increase in the implant-bone contact was found with increasing healing periods from 4 to 12 weeks after implant insertions. 4. The average depth (0.64mm) of the fibrous connective tissue ingrowth in the 2-week group was slightly deeper than those in the 4- (0.51mm) and 8-week (0.53mm) groups at 12 weeks after implant insertion. 5. the implant-bone interfacial bond strengths were 73.05 kgf in the 2-week group, 69.71 kgf in the 4-week group and 73.76 kgf in the 8-week group. No significant difference was noted in pullout force among the groups. The degree of confidence of interfacial bone strength was highest in the 8-week group, followed by the 4- and 2-week groups. These results indicate that at least 4 weeks of healing period will be required before implant is to be inserted following tooth extraction.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.24 no.3
• /
• pp.556-561
• /
• 1997

Intentional replantation of the posterior teeth has been performed as a last resort except extraction when it is impossible to perform the conventional endodontic or surgical endodontic treatment. Many studies have done with the prognosis, and root resorption, of which the responsibility might have been injury of periodontal ligament and remaining periodontal lesion, proved to be major cause of failure. Intentional replantation, however, can exclude anatomic difficulty, risk of nerve injury, and maxillary sinus trauma that surgical access can raise, especially in posterior teeth, and it is reported that success rate is not less than surgical endodontics, independent of replantation of traumatically avulsed teeth. The success of intentional replantation can be evaluated with, clinically, reduction of pocket depth, pain and mobility(physical mobility), and, radiographically, hard tissue formation, reduction of periapical radiolucency. In this case report, for the maxillary left first bicuspid with dens evaginatus that had periapical lesion, painfulness, mobility and showed no reduction of mobility after even extirpation and a number of irrigation, extraction followed by extraoral root filling with calcium hydroxide and replantation was performed. Based on many studies, it is concluded that hard tissue formation capacity of calcium hydroxide, preceded extirpation before extraction, and careful extraction without injuring periodontal ligament affected successful results of this case.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.35 no.1
• /
• pp.67-75
• /
• 1993

This study is to analyze both root growth and soil moisture extraction pattern during the growing period of upland crops with respect to soybean, redpepper, sesame. Field and lysimeter tests were conducted under 12 treatments of soil moisture level by the San Cristobal experimental design(1981) and 3 soil type(sand, sandy loam, silty loam) for 4 years('87-'90) at the experimental plot of Rural Development Administration located in Suwon. The results of this study are summarized as follows : 1.For soybean, redpepper and sesame, root growth in dry soil was better than that in wet soil and it could be expressed as a sin function in terms of time. Maximum root depth was about 55cm, 44cm, 40cm respectively. 2.The average soil moisture extraction pattern for soybean, redpepper and sesame were 61.4%, 62.8%, 79.5% for zone l(0-l5cm). 25.5%, 27.1%, 18.3%, for zone 2(15-30cm).11.4%, 9.8%, 2.3% for zone 3(30-45cm), 1.7%, 0.3%, 0.04% for zone 4(45-60cm) respectively. This means that Zone 1 would be the dominant zone in irrigation scheduling. 3.With respect to soybean, the soil moisture extraction pattern(SMEP) was varied somewhat according to the erent maintenance of soil moisture level. The average SMEP for high maintenance of soil moisture was 46%, 29%, 17%, 8%, for middle maintenance of soil moisture was 43%, 29%, 17%, 11 % and for low maintenance of soil moisture was 40%, 28%, 20%, 12%, respectively. 4.With respect to soybean, the soil moisture in the upper layer was distinctly consumed more than that in the lower layer for clay loam soil and the soil moisture of all layers was consumed evenly for sand soil. The SMEP for sandy loam soil showed a middle result compared with the above 2 soil types.

• Spatial Information Research
• /
• v.3 no.2
• /
• pp.135-146
• /
• 1995

The purpose of this study is to develop a GIS application and interface model (GISCELWAB) for the temporal and spatial simulation of surface runoff from a small watershed. The model was constituted by three sub - models : The input data extraction model (GISINDATA) which prepares cell-based input data automatically for a given watershed, the cell water balance model(CELWAB) which calculates the water balance for a cell and simulates surface runoff of watershed simultaneously by the interaction of cells, and the output data management model(GISOUTDISP) which visualize the results of temporal and spatial variation of surface runoff. The input data extraction model was developed to solve the time-consuming problems for the input-data preparation of distributed hydrologic model. The input data for CELWAB can be obtained by extracting ASCII data from a vector map. The output data management model was developed to convert the storage depth and discharge of cell into grid map. This model ean-bles to visualize the temporal and spatial formulation process of watershed storage depth and surface runoff wholly with time increment.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.39 no.1
• /
• pp.9-16
• /
• 2002

This paper proposes a new 3D modeling technique using disparity-motion relationship and feature points. To generate the 3D model from real scene, generally, we need to compute depth of model vertices from the dense correspondence map over whole images. It takes much time and is also very difficult to get accurate depth. To improve such problems, in this paper, we only need to find the correspondence of some feature points to generate a 3D model of object without dense correspondence map. The proposed method consists of three parts, which are the extraction of object, the extraction of feature points, and the hierarchical 3D modeling using classified feature points. It has characteristics of low complexity and is effective to synthesize images with virtual view and to express the smoothness of Plain regions and the sharpness of edges.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.14 no.3
• /
• pp.1086-1103
• /
• 2020

The automatic identification and classification of image-based weld defects is a difficult task due to the complex texture of the X-ray images of the weld defect. Several depth learning methods for automatically identifying welds were proposed and tested. In this work, four different depth convolutional neural networks were evaluated and compared on the 1631 image set. The concavity, undercut, bar defects, circular defects, unfused defects and incomplete penetration in the weld image 6 different types of defects are classified. Another contribution of this paper is to train a CNN model "RayNet" for the dataset from scratch. In the experiment part, the parameters of convolution operation are compared and analyzed, in which the experimental part performs a comparative analysis of various parameters in the convolution operation, compares the size of the input image, gives the classification results for each defect, and finally shows the partial feature map during feature extraction with the classification accuracy reaching 96.5%, which is 6.6% higher than the classification accuracy of other existing fine-tuned models, and even improves the classification accuracy compared with the traditional image processing methods, and also proves that the model trained from scratch also has a good performance on small-scale data sets. Our proposed method can assist the evaluators in classifying pipeline welding defects.

• Journal of Dental Anesthesia and Pain Medicine
• /
• v.24 no.4
• /
• pp.285-295
• /
• 2024

Background: In human dentition, the most commonly impacted teeth are the mandibular third molars (M3M). The removal or extraction of these teeth often causes anxiety in patients due to the perceived pain involved in the process. Therefore, pain must be effectively managed using anesthesia. The use of newer local anesthetic drugs can help minimize side effects and drug interactions. Traditionally, adrenaline is used as a vasoconstrictor along with lignocaine. When combined with lignocaine, the alpha agonists dexmedetomidine and clonidine can extend the duration of anesthesia, thereby reducing the need for additional pain-relieving medications. Methods: This study used a randomized, triple-blind, parallel-arm design. Sixty patients were screened, and 45 systemically healthy patients requiring unilateral surgical removal of impacted mandibular third molars with similar difficulty (moderate-to-difficult according to the Modified Pederson's Index) were included in the study. Patients were allocated into three groups as follows: Group A: 2% Lignocaine Hydrochloride with 1:100,000 Adrenaline, Group C: 2% Lignocaine Hydrochloride with 15 ㎍/mL Clonidine, and Group D: 2% Lignocaine Hydrochloride with 1 ㎍/mL Dexmedetomidine. The evaluated parameters were the time of onset of anesthesia, depth of anesthesia, hemodynamic parameters, and duration of postoperative analgesia. Results: Group D had a faster onset of action and prolonged duration of postoperative analgesia compared with Groups A and C. No statistically significant differences were observed between the three groups in terms of the depth of anesthesia and hemodynamic parameters. Conclusion: Group D exhibited a significantly more rapid onset of anesthesia than Groups A and C, and the postoperative analgesic effect in Group D was significantly prolonged (7.22 hours) compared with that in Groups A (4.54 hours) and C (2.1 hours). Patients receiving the Group D solution experienced an extended period of comfort without the need for analgesics for up to 7.22 hours post-procedure.

• Journal of Korea Multimedia Society
• /
• v.9 no.9
• /
• pp.1139-1149
• /
• 2006

This paper describes a novel and efficient algorithm, which extracts focused objects from still images with low depth-of-field (DOF). The algorithm unfolds into four modules. In the first module, a HOS map, in which the spatial distribution of the high-frequency components is represented, is obtained from an input low DOF image [1]. The second module finds OOI candidate by using characteristics of the HOS. Since it is possible to contain some holes in the region, the third module detects and fills them. In order to obtain an OOI, the last module gets rid of background pixels in the OOI candidate. The experimental results show that the proposed method is highly useful in various applications, such as image indexing for content-based retrieval from huge amounts of image database, image analysis for digital cameras, and video analysis for virtual reality, immersive video system, photo-realistic video scene generation and video indexing system.

• Journal of information and communication convergence engineering
• /
• v.8 no.6
• /
• pp.645-650
• /
• 2010

In this paper, we present the effect of binocular cues which plays crucial role for the visualization of a stereoscopic or 3D image. This study is useful in extracting depth and disparity information by image processing technique. A linear relation between the object distance and the image distance is presented to discuss the cause of cybersickness. In the experimental results, three dimensional view of the depth map between the 2D images is shown. A median filter is used to reduce the noises available in the disparity map image. After the median filter, two filter algorithms such as 'Gabor' filter and 'Canny' filter are tested for disparity visualization between two images. The 'Gabor' filter is to estimate the disparity by texture extraction and discrimination methods of the two images, and the 'Canny' filter is used to visualize the disparity by edge detection of the two color images obtained from stereoscopic cameras. The 'Canny' filter is better choice for estimating the disparity rather than the 'Gabor' filter because the 'Canny' filter is much more efficient than 'Gabor' filter in terms of detecting the edges. 'Canny' filter changes the color images directly into color edges without converting them into the grayscale. As a result, more clear edges of the stereo images as compared to the edge detection by 'Gabor' filter can be obtained. Since the main goal of the research is to estimate the horizontal disparity of all possible regions or edges of the images, thus the 'Canny' filter is proposed for decipherable visualization of the disparity.

• Journal of Broadcast Engineering
• /
• v.17 no.4
• /
• pp.676-683
• /
• 2012

Motion estimation in video coding greatly affects implementation complexity. In this paper, a reducing method of the complexity in motion estimation is proposed by using both the depth and color cameras. We obtain object information with video sequence from distance information calculated by depth camera, then perform labeling for grouping pixels within similar distances as the same object. Three search regions (background, inside-object, boundary) are determined adaptively for each of motion estimation blocks within current and reference pictures. If a current block is the inside-object region, then motion is searched within the inside-object region of reference picture. Also if a current block is the background region, then motion is searched within the background region of reference picture. From simulation results, we can see that the proposed method compared to the full search method remains the almost same as the motion estimated difference signal and significantly reduces the searching complexity.