• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제50권9호
• /
• pp.445-452
• /
• 2001

Two switching signal patterns are proposed to prevent short circuit of PWM ac choppers. The voltage detection method and the current detection method are proposed to execute two switching signal patterns. In the voltage detection method, the dead-time has to be inserted to the switching signals after polarity of input voltage is checked by voltage transducer at input side. In the current detection method, the direction of load current is checked by current transducer at output side, and the dead-time delay is not considered. Controlling circuit built by current detection method is simple because the dead-time delay is considered. The experimental results are presented to prevent short circuit of ac chopper safely.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2006년도 전력전자학술대회 논문집
• /
• pp.254-256
• /
• 2006

A Novel way to support typical Thermal Shut Down(TSD) circuit is proposed. In power ICs, on-time or on-duration is the key factor to anticipate an abrupt increase of internal temperature. Such an abrupt raise of the temperature can cause TSD circuit cannot protect on proper time due to the temperature detection delay come from the physical distance or the imperfect coupling between heat sources and detector. The proposed circuit checks the duty ratio touched their maximum or not in every cycle. Once duty ratio touches the maximum duty, new circuit generates the warning signal to the TSD circuit and lowers pre-determined temperature for shut down to compensate the detection delay. The novel circuit will be analyzed to the transistor level and checked the validity by simulation.

• 전자공학회논문지A
• /
• 제33A권2호
• /
• pp.205-216
• /
• 1996

In this paper we propose an efficient robust path delay fault test genration algorithm for detection of path delay faluts in combinational ligic circuits. In the proposed robust test genration approach, the testability measure is computed for all gates in the circuit under test and these computed values are used to genrate weighted random delay test vetors for detection of path delay faults. For genrated robust test vectors, we perform fault simulation on ISCAS '85 benchmark circuits using parallel pattern technqieus. The results indicate that the proposed test genration method not only increases the number of detected robust path delay faults but also reduces the time taen to genrate robust tests.

• 한국항행학회논문지
• /
• 제7권2호
• /
• pp.141-148
• /
• 2003

본 논문에서는 미상 디지털 통신 신호의 심볼율을 검출하기 위한 기술들을 소개하고 그 성능을 비교해 본다. 심볼율은 delay and multiplier, square law 또는 Hilbert 변환을 이용한 방법 등의 회로를 통과한 신호의 전력스펙트럼 밀도에서 검출해 낼 수 있다. 이러한 회로들을 통과한 신호를 이산 푸리에 변환(discrete Fourier Transform) 한 결과에서 많은 스펙트럼 라인과 복수개의 피크(peak)가 검출되고 그 중 첫 번째 피크가 심볼율을 나타내는 주파수에 위치하게 된다. 만약 해당 심볼율이 아닌 다른 주파수상의 스펙트럼 라인의 값이 첫 번째 피크보다 크다면 심볼율은 잘못 검출될 것이다. 그러므로 첫 번째 피크의 값과 가장 큰 주변 스펙트럼 라인의 값의 비를 이용하여 심볼율 검출기의 성능을 비교하였다. MPSK 변조 방식에서는 -20dB 이하의 Es/N0에서는 delay and multiplier가 가장 우수한 성능을 보였고 -20dB 이상의 Es/N0에서는 Hilbert 변환 방식이 더 좋은 성능을 나타내었다. 또한 QAM 변조 방식에서 delay and multiplier 회로는 낮은 Es/N0에서는 심볼율을 검출할 수 없으며 square law 방식은 MPSK 변조 방식에서 보다 우수한 성능을 나타내었다.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1994년도 Proceedings of the Korea Automatic Control Conference, 9th (KACC) ; Taejeon, Korea; 17-20 Oct. 1994
• /
• pp.7-12
• /
• 1994

This paper describes an outline of pseudorandom M-sequence and its applications to measurement and control engineering. At first, generation and properties of M-sequence is briefly described and then its applications to delay time measurement, information transmission by use of M-array, two dimensional positioning, fault detection of logical circuit, fault detection of RAM, linear and nonlinear system identification.

• 전기학회논문지
• /
• 제60권6호
• /
• pp.1146-1151
• /
• 2011

There are two methods for train control in information transmission by using track circuit system and installing wayside transmitter. Information signal is transmitted to the on-board antenna by using rails. Continuous information about train intervals, speed and route is received by on-board antenna in AF track circuit system. The information signal is included with carrier wave and received by magnetic coupling in the on-board antenna. Therefore, it is important to define standard current level in the AF track circuit system. When current flowed to rails is low, magnetic sensors are not operated by decreasing magnetic field intensity. Hence, SNR is decreased because electric field intensity is decreased. When the SNR is decreased, there is the serious influence of noise upon demodulation. So, the frequency of information signal is not extracted in frequency response. Thus, it is possible to happen to train accident and delay as the information signal is not analyzed in the on-board antenna. In this paper, standard energy density is calculated by using Parseval's theory in UM71c track circuit. Hence, detection time of information signal is presented.

• 전기학회논문지
• /
• 제64권1호
• /
• pp.182-187
• /
• 2015

In the three-phase power system, when any one-phase or two-phases is open-phase, the unbalanced current flows and the single-phase power supplies to three-phase loads. Specially, motor coil and transformer coil receive over-current. As a result, great damage as well as electrical fire can occur to the power system. In order to improve these problems, this paper proposes that an open-phase detection device is designed by a new algorithm using electric potential difference between the resultant voltage of neutral point and ground, and a control circuit topology of open-phase protector is composed of highly efficient semiconductor devices. It improves response speed and reliability. The control algorithm circuit also operates the cut-off of a conventional residual current protective device (RCD) which flows an enforced leakage current to ground wire at open-phase accident. Furthermore, time delay circuit is added to prevent the incapable operation of open-phase protector about instantaneous open-phase not open-phase fault. The time delay circuit improves more reliability.

• 전자공학회논문지A
• /
• 제32A권5호
• /
• pp.31-41
• /
• 1995

In this paper, the relationship between k consecutive outputs of the conventional differential detector and output of differential detector with k-symbol periods delay for differential MSK and GMSK systems is investigated. It is hown that there exists periodity in modulo-2 sum and product of k successive outputs of the conventional differential detector with the output of a detector with k-symbol periods delay circuit. This relationships are used to achieve performance gains over conventional differential detection. The error rate performance of the method is carried out by computer simulation and performance improvement is achieved for differential MSK and GMSK systems.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1995년도 추계학술대회 논문집
• /
• pp.187-189
• /
• 1995

A Surface Acoustic Wave Gas sensor for NO, CO, H$_2$gas detection was designed fabricated, and tested. A delay line device was designed to composite a single mode SAW oscillator which enables to measure a SAW velocity. To reduce the effect of temperature and humidity, dual delay line oscillator circuit was used. And final output was measured by digital frequency counter. NO, CO, H$_2$gas were detected by WO$_3$thin film deposited on the path of the Delay Line.

• 전기학회논문지P
• /
• 제53권1호
• /
• pp.22-27
• /
• 2004

BiCMOS circuit consist of CMOS part which constructs logic function, and bipolar part which drives output load. In BiCMOS circuits, transistor stuck-open faults exhibit delay faults in addition to sequential behavior. In this paper, proposes a method for efficiently generating test pattern which detect stuck-open in BiCMOS circuits. In proposed method, BiCMOS circuit is divided into pull-up part and pull-down part, using structural property of BiCMOS circuit, and we generate test pattern using set theory for efficiently detecting faults which occured each divided blocks.