• International Journal of Air-Conditioning and Refrigeration
• /
• 제9권4호
• /
• pp.27-36
• /
• 2001

A new two-phase non-boiling convective heat transfer correlation for turbulent flow $(Re_{SL}>4000)$ in vertical tubes with different fluid flow patterns and fluid combinations was developed using experimental data available from the literature. The correlation presented herein originates from a careful analysis of the major non-dimensional parameters affecting two-phase heat transfer. This model takes into account the appropriate contributions of both the liquid and gas phases using the respective cross-sectional areas occupied by the two phases. A total of 255 data points from three available studies (which included the four sets of data) were used to determine the curve-fitted constants in the improved correlation. The performance of the new correlation was compared with two-phase correlations from the literature, which were developed for specific fluid combinations.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 2003년도 춘계학술대회논문집
• /
• pp.474-480
• /
• 2003

The wavelike flow mark phenomenon is one of the surface defects that can arise during the injection stage of the injection molding process. We have performed a numerical analysis using a finite element method for the injection molding to verify the validity of “Go-over” hypothesis. Also, we have compared the results of numerical analysis with available experimental data. Numerical analysis results of the flow marks are qualitatively in good agreement with experimental data of reference, but are quantitatively deviated from experimental data in a consistent manner. A parametric study has been performed to examine the correlative effects of various injection molding processing parameters and material properties on the flow mark size.

• Journal of Electrical Engineering and information Science
• /
• 제3권2호
• /
• pp.274-279
• /
• 1998

We investigate a Leaky Bucket(LB) scheme with a threshold in the data buffer, where leaky rate changes depending on the contents of data buffer. We use the fluid flow model for the analysis of the LB scheme with a threshold. We model the bursty input source as markov modulated fluid flow(MMFF) As performance measures we obtain loss probability and mean delay. We present some numerical results to show the effects of the level of a threshold, the rate of token generation, the size of token pool, and the size the data buffer on the performances of the LB scheme with a threshold.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2015년도 추계학술대회
• /
• pp.109-111
• /
• 2015

The Arctic transportation offers big opportunities as shorter transport distances, less fuel consumption, less carbon emissions, faster deliveries of goods, and more profits. The present study is aimed to investigate a future flow to deal with policy in arctic transportation using Big data analysis.

• 한국가스학회지
• /
• 제20권1호
• /
• pp.13-22
• /
• 2016

본 연구에서는 다단계 수압파쇄와 수평시추가 적용된 셰일가스정에서 생산자료의 유동형태에 따라 적절한 분석 방법과 궁극가채량을 산출하는 기법을 결정하는 방법을 정리한 흐름도를 제안하였다. 또한 1차 천이유동만이 나타나는 현장자료에 대해 생산천이유동 분석을 수행할 때 고려해야 하는 사항들을 제안하였다. log-log 그래프와 시간제곱근 그래프 분석을 통해 생산자료의 유동 특성을 분류할 수 있고, 이 결과, 1차 천이유동만이 나타나는 생산자료는 이 유동이 종료되는 시점을 정확히 예측하여 이 시점을 기준으로 생산성을 각각 예측하여야 한다. 이 시점은 미세탄성파 탐사자료 해석을 통해 균열자극부피의 면적을 계산함으로써 산출할 수 있다. 공저압력자료나 미세탄성파 탐사자료가 없다면 셰일가스정에 적절한 경험적 방법을 활용하여 생산성을 예측할 수 있다. 생산기간이 짧은 자료는 상대적으로 생산기간이 긴 인접 생산정의 자료를 활용하여 생산기간의 적절성을 평가한 후 필요하다면 생산초기 자료를 제외하고 분석하는 것이 정확도를 향상시킬 수 있다. 또한 미세탄성파 탐사자료 해석에 의해 산출된 SRV는 분석방법이나 분석자의 주관에 의해 과대, 과소 평가될 수 있기 때문에 파쇄 단계, 파쇄유체 주입량, 생산성 분석을 통한 적절성평가를 수행하여 필요한 경우, 저류층 시뮬레이션, 균열모델링, 생산천이분석을 통해 재산정하는 것이 필요하다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 추계학술대회 논문집 학회본부 A
• /
• pp.17-19
• /
• 2000

This paper deals with Load Flow Program for client/server system. Clients play roles of input and output of the data. The client upload input-data file to the server which takes the part of the function of solving the Load Flow. The developed LF COM(Component Object Model) carry out solving the Load Flow and saving the result and the input data to DataBase. It proved the developed System to be compatible through the Case Study.

• Journal of the Optical Society of Korea
• /
• 제18권5호
• /
• pp.466-471
• /
• 2014

An asynchronous optical packet-switching (AOPS) node with load-balancing capability can achieve better performance in reducing the high packet-loss ratio (PLR) and time delay caused by unbalanced traffic. This paper proposes a novel dynamic load-balancing algorithm for an AOPS node with limited buffer and without wavelength converters, and considering the data flow distribution and service levels. By calculating the occupancy state of the output ports, load state of the input ports, and priorities for data flow, the traffic is balanced accordingly. Simulations demonstrate that asynchronous variant data packets and output traffic can be automatically balanced according to service levels and the data flow distribution. A PLR of less than 0.01% can be achieved, as well as an average time delay of less than 0.46 ns.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 D
• /
• pp.2492-2494
• /
• 2003

Urine analysis is one of the most important medical examination in the hospital. Not only the data for the ingredients of urine through chemical analysis, but also the data related to fluid dynamics, e.g., peak flow rate, average flow rate, may provide some useful information about patient's state of health. Therefore, we develop the portable system to measure and analyse fluid volume/flow rate in this study. This system can store and print the measured data during the pre-specified time interval, and provide some meaningful data related with fluid dynamics. We explain the method and the technical stuff to implement the system, and show the result.

• 대한공간정보학회지
• /
• 제24권2호
• /
• pp.15-24
• /
• 2016

This study conducted an evaluation of the extent of debris flow damage using SINMAP, which is slope stability analysis software based on the infinite slope stability method, and FLO-2D, a hydraulic debris flow analysis program. Mt. Majeok located in Chuncheon city in the Gangwon province was selected as the study area to compare the study results with an actual 2011 case. The stability of the slope was evaluated using a DEM of $1{\times}1m$ resolution based on the LiDAR survey method, and the initiation points of the debris flow were estimated by analyzing the overlaps with the drainage network, based on watershed analysis. In addition, the study used measured data from the actual case in the simulation instead of existing empirical equations to obtain simulation results with high reliability. The simulation results for the impact of the debris flow showed a 2.2-29.6% difference from the measured data. The results suggest that the extent of damage can be effectively estimated if the parameter setting for the models and the debris flow initiation point estimation are based on measured data. It is expected that the evaluation method of this study can be used in the future as a useful hazard mapping technique among GIS-based risk mapping techniques.

• Nuclear Engineering and Technology
• /
• 제55권3호
• /
• pp.1105-1117
• /
• 2023

In this study, the pressure drop behavior of single- and two-phase flows of air and water through the porous beds filled with uniform and non-uniform sized spherical particles was examined. The pressure drop data in the single-phase flow experiments for the uniform particle beds agreed well with the original Ergun correlation. The results from the two-phase flow experiments were analyzed using numerical results based on three types of previous models. In the experiments for the uniform particle beds, the data on the two-phase pressure drop clearly showed the effect of the flow regime transition with a variation in the gas flow rate under stagnant liquid condition. The numerical analyses indicated that the predictability of the previous models for the experimental data relied mainly on the sub-models of the flow regime transitions and interfacial drag. In the experiments for the non-uniform particle beds, the two-phase pressure loss could be predicted well with numerical calculations based on the effective particle diameter. However, the previous models failed to accurately predict the counter-current flooding limit observed in the experiments. Finally, we propose a relation of falling liquid velocity into the particle bed by gravity to appropriately simulate the CCFL phenomenon.