• 전자공학회논문지 IE
• /
• v.44 no.2
• /
• pp.1-7
• /
• 2007

The increasing high frequency capabilities of CMOS have resulted in increased RF and analog design in CMOS. Design of RF and analog circuits depends critically on device S-parameter characteristics, magnitude of real and imaginary components and their behavior as a function of frequency. Utilization of scaled high performance CMOS technologies poses challenges as concerns for reliability degradation mechanisms increase. It is important to understand and quantify the effects of the reliability degradation mechanisms on the S-parameters and in turn on small signal model parameters. Various physical effects influencing small-signal parameters, especially the transconductance and capacitances and their degradation dependence, are discussed in detail. The measured S-parameters of H-gate and T-gate devices in a frequency range from 0.5GHz to 40GHz. All intrinsic and extrinsic parameters are extracted from S-parameters measurements at a single bias point in saturation. In this paper we discuss the analysis of the small signal equivalent circuits of RF SOI MOSFET's verificated for the purpose of exacting the change of parameter of small signal equivalent model followed by device flame.

• Asian-Australasian Journal of Animal Sciences
• /
• v.23 no.4
• /
• pp.530-536
• /
• 2010

Cdc25B is a mitotic regulator that might act as a starter phosphatase to initiate the positive feedback loop at the entry into mitotic (M) phase. In the present study, distribution of Cdc25B mRNA in duodenal mucosa of the chicken was demonstrated by means of in situ hybridization histochemistry (ISHH) using sense and antisense digoxigenin (DIG)-labeled RNA probes. The results showed that there were many labeled cells distributing in the duodenal mucosa of the adult chicken. Of these labeled cells, 81.60${\pm}$9.63% of Cdc25B mRNA positive cells was distributed in the basilar part and mid-portion of the intestinal gland and 36.21${\pm}$8.81% in the middle and basilar portion of villi of the small intestine of the chicken, respectively. Most of these labeled cells were positive in the regions of the stem cell and proliferation. The signals of ISHH decreased from basilar to upper part in the crypt of Lieberkuhn and weakened in the inferior villi of the duodenum. Moreover, the positive signals were both in the cytoplasm and cell nucleus. However, the labeled cells were negative in both the lamina muscularis mucosae and muscular layer. The results of ISHH suggested the existence of Cdc25B mRNA and vigorous proliferation activities in the duodenal mucosa of adult chicken, replenishing the cells which had sloughed off from the superior part of the villus. Our results provide some molecular evidence for a regular pattern of avian intestinal epitheliosis and functional partition and provide an approach to further study of the locations of Cdc25B in the chicken.

• Journal of fish pathology
• /
• v.6 no.2
• /
• pp.103-110
• /
• 1993

Total genomic DNA library of Serratia marcescens was prepared by inserting Sau3AI partial digesting fragments(above 5 kb) into the dephosphorylated BamHl site of pUC19. In primary screening, two colonies were selected by observing the halo around E. coli transformants grown on the swollen colloidal chitin media. Secondary screening was performed by soaking two colonies with a few drops of 4-methylumbelleliferryl N-acetyl-$\beta$-D-glucocosaminide(4-MuNGlcNAc). As 4-MuNGlcNAc is a specific, fluorogenic substrate for chitinase, the positive clones produce light fluorescence by the exposure under the long wave U.V. light(360 nm). From genomic DNA library derived from pUC19, we have isolated two different chitinase clones, pCH1(11.0Kb) and pCH2(7.5Kb), which show completely different restriction map to each other. The cross-hybridization of pCH1EA and pCH2 have not revealed any hybridization signals to each other.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.2
• /
• pp.115-127
• /
• 1991

In this paper. we dIscussed wIth the ISDN numberIng system of Korea 2digIt of NDC(National Destination Code)is assigned to the common carrier indenttification and an other the service network identification code as conbining the flIst and second dIgIt. The last ot NDC is applicable to for each area code. Resulty. we become 10 digit number for toll system vice 7 digit for local numbering. It is satisfactory to CCITT recommandtion and also. We has been suggested that existing network the mobile. pagget, FAX, TELEX and public networks are able to be connetcted to the ISDN. Near the 1994. we guess that it is fully occupied with 7 digit number to the metropolitan area to solve this problem, after divide to 3 part provincial area southern. nothem and mid-Korea. We suggested that special number system are reorganized with the new and existing service numbers plan. Although, we don't deal with the SA of ISDN numbering systems. Resultly, know that we are to design efficiently number system as 3 digit code for ISDN/NSN.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.4
• /
• pp.909-916
• /
• 2015

Recently, as shown demands and the need for Cloud dig data, large-scale data centers, as well as factory unit's have also vigor. This study focuses the system design that can integrate various facilities on the data center build upon of the factory and the midsize group. Because the integrated facilities management of midsize groups should have variety of sensors and devices requires integrated monitoring system that can manage them as a whole. In this study, it constitutes a integrated model protocol interface of the various facilities, it suggests ways to avoid the errors that may occur during design to study the development and systematically carried out. For this purpose, this study provides the analysis of a failure information delivery time and integration scenario for efficient analysis and evaluation of an integrated monitoring system.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.12
• /
• pp.2892-2898
• /
• 2015

We propose a new Double-Independent-Gate Ambipolar Silicon-Nanowire Field Effect Transistor(DIG Ambi-SiNWFET). The proposed transistor has two types of gate such as polarity gate and control gate. The polarity gate determines the operation that the gate bias controls NMOSFET or PMOSFET. The voltage of control gate controls the current characteristic of the transistor. We investigated systematically work functions of the two gates and source/drain to operate ambipolar current-voltage characteristics using 2D device simulator. When the work functions of polarity gate, control gate and source/drain are 4.75eV, 4.5eV, and 4.8eV, respectively, it showed the obvious ambipolar characteristics.

• Journal of the Korean Institute of Educational Facilities
• /
• v.2 no.2
• /
• pp.17-25
• /
• 1995

Because of energy crisis and environment pollution, we have become more conscious of the need to conserve heat in buildings. In response to this need. new requirements have been developed for insulation and other matters relating to energy consumption. Among others, more promising is to use the energy that is all around us in the dynamic forces of nature:the wind, tides, waves, rivers, geothermal hot spots, and the sun. The problem is that we have not been forced to find the technological means to convert these natural energies into usable forms because it has been too easy simply to dig or pump our energy out of the ground. Now, the problem is not a shortage of energy itself, but a shortage of technology for converting the energy that lies aoo around us into usable forms. Energy-conversion technology is the real issue, and solar energy is one of the brightest and most promising frontiers in energy conversion. All buildings are wrapped in a skin. Generally skins protect the person in stay from rain, wind, dust, noise, cold, hot etc.. However, there are some skins that provide energy from given environment into the building. Out of aoo, transparent insulation material is one of these materials that most effectively satisfies this kind of envelope function. Since, there are no research on transparent insulation in Korea, it has been studied very actively in Europe and in America. Thus, in this thesis, we will theoratically study and analyze how the heat flows through a trans arrent insulated opaque wall of a school building in Korea. It will be an important information for the effective using guidelines of transparent insulation materials in Korea.

• Journal of the Korean Society of Earth Science Education
• /
• v.4 no.1
• /
• pp.1-11
• /
• 2011

This study was carried out to analyze primary gifted education systems in Korea and China. The results of the research are as follows : (1) The objectives of the gifted children education of two countries are same. They intend to dig out hidden talent and giftedness of gifted children. They emphasize the development of creativity in the gifted children through the various special teaching methods. (2) Korea has been doing the gifted education limitedly focused on the 4th grade students in elementary school after regular school curriculum, but China has performed gifted education from primary school to university quite systematically. (3) Korea tend to select the students based on the objective sources such as teachers' observation, recommendation, school scores, but this has limit to find out the real potential genius. China has the similar problems, but they consider of the comprehensive talented and abilities in students at school unit level. (4) Both countries have the teacher training systems for study to make more efficient programs and methods in gited education. It has been emphasized the necessity of gifted education to expand the range and target. Most of all it is very essential to train the teachers to manipulate the gifted education programs. The government should be persue the multiplicity and professionality now. So there are so many things to learn from China since they managed the gifted education in a regular curriculum of the school.

• Proceedings of the Korea Contents Association Conference
• /
• 2003.11a
• /
• pp.204-209
• /
• 2003

In an urban area telecommunication using wireless system, the accurate prediction and analysis of wave propagation characteristics are very important to determine the service area, optimized selection of base station, and cell design, etc. In the stage of these analyses, we have to present the propagation prediction model which is varied with the type of antenna, directional angle, and configuration of the ground in our urban area. In addition we need to perform an analysis of the conventional model which is similar to ours and dig out the parameters to evaluate the wave environment before the cell design for the selected area. In this paper, we propose a wave propagation prediction model concerning the topography and obstacles in our urban area. We extract the parameters and apply them to the proposed wave environment for the simulation analyzing the propagation characteristics. Throughout these analyzing procedure, we extracted the essential parameters such as the position of the base station, the height of topography, and adequate type and height of the antenna with our preferable correctness.

• Journal of the Korean Society of Systems Engineering
• /
• v.9 no.2
• /
• pp.23-36
• /
• 2013

Plant industry is one of technology-intensive and most prosperous industries in Korea because of its recent prosperity and promising outlook in export. However, no Korean EPC company has yet been well prepared in lifting their capacity sufficient enough to get the upstream conceptual or basic design and engineering orders for sizable plant projects which are known as the more value-added. If systems engineering, a methodology which developed complex systems such as airplanes and has been justified its effectiveness in Defense and NASA projects, can be integrated with plant engineering which should be developed and applied based on the requirements of so many stakeholders, conditions, lifecycle concepts, and constraints of the projects, huge synergic effect is expected particularly in developing a specific upstream design, which is a conceptual or basic design. The notion of integration with each other between systems engineering and plant engineering can be really the crux of EPC's success in any plant projects. This paper suggests an approach showing a methodology how to dig out, analyze, evaluate, verify and implement the stakeholders' requirements into a plant design in conceptual phase using the theory and skills of systems engineering. ISO/IEC 15288 well known systems engineering standards is used. Carbon capture system is used for a case study, for it is an emerging technology in reducing emissions of carbon dioxide causing global warming from flue gas after combustion. Here systems engineering was proven to play a substantial role in enhancing the capability of designers in developing a conceptual design of whole plant or certain part of crucial plant systems.