• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.11C
• /
• pp.1573-1580
• /
• 2004

In this paper, an adaptation mode controller for adaptive microphone array system is proposed for high-quality speech acquisition in real environments. To ensure proper adaptation of the adaptive array algorithm, the proposed adaptation mode controller uses not only temporal information, but also spatial information. The proposed adaptation mode controller is constructed with two processing stages: an initialization stage and a running stage. In the initialization stage, a sound source localization technique is adopted, and a signal correlation characteristic is used in the running stage. For the adaptive may algorithm, a generalized sidelobe canceller with an adaptive blocking matrix is used. The proposed adaptation mode controller can be used even when the adaptive blocking matrix is not adapted, and is much stable than the power ratio method. The proposed algorithm is evaluated in real environment, and simulation results show 13dB SINR improvement with the speaker sitting 2m distance from the may.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.13 no.1
• /
• pp.70-78
• /
• 2003

This paper dealt with an experimental study on the hydroelastic vibration of clamped perforated rectangular plates submerged in water. The penetration of holes in the plates had a triangular pattern with P/D (pitch to diameter) 1.750, 2.125, 2.500, 3.000 and 3.750. The natural frequencies of the perforated plates in air were obtained by the analytical method based on the relation between the reference kinetic and maximum potential energy and compared with the experimental results. Good agreement between the results was found for the natural frequencies of the perforated plates in air. It was empirically found that the natural frequencies of the perforated plate in air increase with an increase of P/D, on the other hand, the natural frequencies of the perforated plate in contact with water decrease with an increase of P/D. Additionally. the effect of the submerged depth on the natural frequency was investigated.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.4
• /
• pp.634-641
• /
• 2000

A switchable VCO for DECT handset is designed and fabricated. In dual mode radios, a single VCO is desired to operate at two different frequencies to meet the requirement of two mode(Tx, Rx). The three design types of switchable VCO are switched resonator VCO, switched mode VCO and dual band VCO. In this paper, we use the switched resonator VCO type using pin diode switch to change the total amount of capacitance in the tank circuit. At the bias condition of 3 V and 13mA, the output power and phase noise are better than6.5dBm and -104dBc/Hz at 25khz offset from the carrier, respectively , across the operating frequency range. From these results, the fabricated switched VCO is applicable to the DECT handset.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.3
• /
• pp.51-57
• /
• 2010

A dual-mode direct conversion receiver is developed in $0.13\;{\mu}m$ RF CMOS process for IEEE 802.11n based wireless LAN and IEEE 802.16e based mobile WiMAX application. The RF receiver covers the frequency band between 2.3 and 2.7 GHz. Three-step gain control is realized in LNA by using current steering technique. Current bleeding technique is applied to the down-conversion mixer in order to lower the flicker noise. A frequency divide-by-2 circuit is included in the receiver for LO I/Q differential signal generation. The receiver consumes 56 mA at 1.4 V supply voltage including all LO buffers. Measured results show a power gain of 32 dB, a noise figure of 4.8 dB, a output $P_{1dB}$ of +6 dBm over the entire band.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.9
• /
• pp.907-915
• /
• 2002

In this paper, a compact digital phase shifter to be used an active phased array antenna system for satellite communications was proposed. The even and odd mode analysis for a given reflection-type phase shifter, which uses a folded hybrid coupler as a base element, was performed and the design parameters were derived. Also, to verify experimentally the electrical performances of the proposed structure, X-band 4-bit digital phase shifter was designed and fabricated using Teflon soft substrate $({\varepsilon}_r; =\;2.17)$. Its circuit size was less than 3.5 cm $\times$ 3.0 cm, and it exhibited at least 50 % size reduction as compared with the conventional unfolded configuration. The experimental results of the fabricated phase shifter showed that the average insertion loss and insertion loss variation were less than 3.5 dB, $\pm$ 0.6 dB within the operating band, 7.9 ~ 8.4 GHz, respectively. And, input and output return loss were more than 10 dB, respectively. Also, the phase response of the phase shifter showed 4-bit operation with $\pm$3$^{\circ}$ rms phase error.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.2
• /
• pp.77-83
• /
• 2011

In this paper, we present the design procedure of the synchronizer and the demodulator of a 13.56MHz RFID PJM tag, which was standardized in ISO 18000-3 mode 3. We optimize the algorithms in order to minimize the number of registers and implement them based on international standard. The designed module is simulated by Modelsim and FPGA. The synchronizer is composed of 3 correlators that is implemented by 1,024(16bit ${\times}$ 64cycle) registers. The demodulator is composed of 2 correlators that is implemented by 128(2bit ${\times}$ 64cycle) registers. The simulation performed with the demodulator integrated with the synchronizer shows that it works at about 87% success rate with the test data of SNR -2dB and 100% with those of SNR 4dB.

• Electronics and Telecommunications Trends
• /
• v.13 no.5 s.53
• /
• pp.53-64
• /
• 1998

본 고에서는 한파장 폐루프 공진기의 기본특성과 이를 활용한 이중모드 필터 구조 및 필터의 주요특징을 기술하였다. 또한 독립적인 직교공진모드를 이용한 폐루프 공진기의 특성과 공진기의 크기를 소형화 하는 기법 및 소형화 된 공진기의 공진조건 등을 기술하였고, 소형화 된 공진기를 이용한 듀플렉서의 응용 예 등에 대해 기술하였다. 폐루프 공진기를 이용한 이중모드필터 등은 마이크로 스트립 형태로 구현이 가능하기 때문에 MIC 또는 MMIC 등에 적합한 구조이며, 능동소자 등의 삽입이 가능하기 때문에 능동필터, VCO, 튜닝필터 등의 구현이 가능하고 소형의 듀플렉서 설계가 가능하기 때문에 향후 마이크로파 부품분야에서 기대되는 부품이라 할 수 있다.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2012.07a
• /
• pp.178-180
• /
• 2012

본 논문에서는 유럽의 디지털 라디오 전송 규격인 DRM(Digital Radio Mondiale)의 Band II 대역 전송 모드인 모드 E의 전송률 향상 기법을 제안한다. DRM 모드 E는 FM 방송과의 동시방송 등의 문제를 고려하여 100kHz 대역폭에서 186kbps의 전송률을 제공한다. 하지만, 이 전송률은 모바일TV 등 멀티미디어 서비스를 제공하기 위해서는 부족하기 때문에 전송률의 향상이 요구된다. 논문에 제안된 전송률 향상기법은 기존의 DRM 모드에 변조방식 및 부호방식을 추가하는 방식으로 최대 350kbps의 전송률 제공이 가능하며, FAC(Fast Access Channel)의 예약필드에 신규 방식에 대한 정보를 전송함으로써 기존 시스템과 호환성을 유지할 수 있다. 모의실험 결과에서, AWGN(Additive White Gaussian Noise) 채널의 비트오류율 le-4를 기준으로 223kbps의 전송을 위해서는 13dB의 SNR(Signal-to-Noise Ratio)이 요구되며, 351kbps의 전송률 제공을 위해서는 약 18dB의 SNR이 요구됨을 확인할 수 있다. 또한, 다중경로 페이딩 채널환경에서 부호율이 1/2인 경우에는 이동속도보다는 지연확산이 성능에 영향을 주지만, 부호율이 1/2 보다 크며 150Km/h이상 증가하면 오류마루가 발생함을 확인할 수 있다.

• Journal of Power System Engineering
• /
• v.5 no.2
• /
• pp.13-21
• /
• 2001

Diesel emission control is being addressed worldwide to help preserve the global environment. This paper mainly deals with the effects of oxidation catalysts to reduce emissions from the automotive heavy-duty diesel engine. Two types of the oxidation catalyst with different kinds of precious material were used. An 11 litter displacement diesel engine with turbocharger was operated to evaluate DOC with various engine speed, load conditions under D-13 mode cycle. We could propose the detail emission data of an automotive heavy-duty diesel engine and the characteristics of the conversion efficiency of the DOC under the D-13 mode. It was found that the mean conversion efficiencies of CO and THC were 49.7% and 61% under the D-13 mode test, respectively.

• Journal of Advanced Navigation Technology
• /
• v.13 no.3
• /
• pp.337-343
• /
• 2009

In this paper, we proposed a burst mode symbol timing recovery unit that is applicable to the VDL Mode-2 using D8PSK modulation. A method that IIR loop filter is used to minimize symbol timing error is hard to apply to burst mode because its convergence time is long. That is, the fast convergence property is important. In this paper, the proposed method takes one sample which has maximum symbol power after the initial synchronization has been achieved by using preambles. The main principle of operation is that the unit moves one sample clock to advance or retard according to symbol power. We verify that the proposed method is operated well in ${\pm}100$ ppm or greater through the test results between Australia ADS Corp. transmitter and the designed receiver.