• 한국농공학회지
• /
• 제38권6호
• /
• pp.64-73
• /
• 1996

The three-dimensional strength behavior of compacted decomposed granite soil was studied using cubical triaxial tests with independent control of the three principal stresses. All specimens were loaded under conditions of principal stress direction fixed and aligned with the directions of compacted plane. For comparable test conditions, the major principal strain and volume strain to failure were smallest when the major principal stress acted perpendicular to the compacted plane. The opposite extremes were obtained when the major principal stress acted parallel to the compacted plane. In cubical triaxial tests with same b values and with ${\theta}$ values in one of three sectors of the octahedral plane, independent of the range of ${\theta}$, higher friction angles are obtained in tests with b greater than in triaxial compression tests in which b 0.0, Comparison between the results of the drained cubical triaxial tests on lksan compacted decomposed granite soil and the cross section of the Mohr-Coulomb failure surface as well as the cross section of the Mohr-Coulomb failure surface were made. Lade's isotropic failure criterion based on vertical specimens overestimates the strengths for tests performed with values of 0 between 90˚ and 1 50˚ the Mohr-Coulomb criterion generally underestimates the strengths of tests performed with values of ${\theta}$ between $0^{\circ}$ and $180^{\circ}$ except around the $120^{\circ}$.

• 한국지반공학회지:지반
• /
• 제10권3호
• /
• pp.111-118
• /
• 1994

A series of drained cubical triaxial tests was performed to investigate the finfluence of the intermediate principal stress on the deformation and strength characteristics of sand. Test results showed that the strength of sand as represented by the friction angle increased from triaxial compression condition (b:0) with increasing magnitude of the intermediate principal stress until the vus of b reached 0.75, land it decreased slightly with closing to b= 1. Also it was found that the projection of the plastic strain increment vector on the octahedral plane was perpendicular to the trace of the failure surface on that plane. The prediction by the isotropic single hardening model sllowed good coinidence with experimental results.

• 한국지반공학회지:지반
• /
• 제9권4호
• /
• pp.83-92
• /
• 1993

세 주응력을 서로 독립적으로 조절할 수 있는 입방체형삼축시험기를 이용하여 모래에 대한 일련의 배수삼축시험이 실시되었다. 실험결과 모래의 응력 -변형률거동과 강도는 중간주응력의 크기에 따라 각기 다른 특성을 보이는 것으로 나타났다. 우선 최소주응력이 일정한 상태에서 중간 주응력이 증가함에 따라 파괴시의 축변형률 e1은 감소하는 경향이 있으며 체적팽창현상은 증가 하는 것으로 나타나고 있다. 그리고 내부마찰각은 축차응력비 b가 증가함에 따라 증가하다 b가 1 부근에 접근하면서 약간 감소하는 경향을 보이고 있다. 한편 Mohrfoulomb규준은 모래의 파괴 강도를 과소산정하는 경향을 보이고 있으나 Lade의 파괴규준은 시험치와 좋은 일치를 보이고 있다.

• 한국농공학회지
• /
• 제42권3호
• /
• pp.97-106
• /
• 2000

The study is closely relevant to Lade's single work hardening model. This model has been shown to have good applicability to cohesive soils. However the validation of this model on the clayey soils has not been satisfactorily reported. To scrutinize the applicability of this model on clayey foundation the laboratory tests for Kwangyang clayey soils were performed using the improved cubical triaxial test apparatus designed originally by Lade. A computer program was developed by which soil parameters for the single work-hardening model can be rationally determined by deleting some dispersed test data generated usually at the initial stage of laboratory tests. And using the program numerical analysis of the cubical clayey specimens using intermediate principal stress was carried out and a good agreement between observed values and numerical results was found.

• 한국농공학회지
• /
• 제41권2호
• /
• pp.70-79
• /
• 1999

The lower ground of structure, in which the strip loads, such as earth dams and embankments , are signiificantly working on , is required to be interpreted as a state of plane strain where the strain of intermediated principal stress direction is put '0' . The plane strain state is frquently observed in actural soil engineering case. For those case, drained stress-strain and strength behavior of Iksan weathered granite soil prepared in cubical specimens with cross-anisotropic fabric was studied by conventional triaxial compression, plane strain and cubial triaxial tests with independent control of the three principal stress. All specimens were loaded under conditions of principl stress directions fixed and aligned with the directions of the material axes. As a result of research , when a ground condition is analyzed under plane strain state, the shear strength obtained from the conventional triaxial compression test can be understimated.

• 대한토목학회논문집
• /
• 제8권2호
• /
• pp.99-107
• /
• 1988

과압밀점토(過壓密粘土)에 대한 일련의 입방형삼축시험(立方型三軸試驗)이 실시되었다. 삼축시험(三軸試驗)은 세 주응력(主應力)을 서로 독립적으로 제어시킬 수 있는 입방체형삼축시험기(立方體型三軸試驗機)를 사용하여 실시되었다. 점토공시체(粘土供試體)로는 현장(現場)에서 직접 채취된 자연시료(自然試料)를 삼축(三軸) chamber 내(內)에서 과압밀비(過壓密比)가 5가 되게 만든 입방체형공시체(立方體型供試體)가 사용되었으며 본연구결과(本硏究結果), 중간주응력(中間主應力)은 과압밀점토(過壓密粘土)의 응력변형률(應力變形率), 비배수강도(非排水强度), 유효강도(有效强度), 유효내부마찰각(有效內部摩擦角) 및 간극압(間隙壓)에 큰 영향을 미치고 있음이 구명(究明)되었다. 중간주응력(中間主應力)이 최소주응력(最小主應力)과 같지 않은 경우의 과압밀점토파괴강도(過壓密粘土破壞强度)는 Mohr-Coulomb 파괴규준(破壞規準)에 의하여 과소평가(過小評價)되나 Lade규준(規準)에 의하여는 대단히 양호하게 산정된다. 또한 과압밀점토(過壓密粘土)의 비배수강도(非排水强度)는 Tresca규준(規準)에 일치하지 않는다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 1994년도 연약지반처리위원회 봄 학술발표회 논문집 연약지반처리
• /
• pp.3-12
• /
• 1994

Based on the shear failure mechanism, hydraulic fracturing criteria are extended to three dimensional stress state. According to the situation of the directions of borehole and major principal stress axes, three equations can be derived for three dimensional hydraulic fracturing problems. By comparing these equations, a single criterion is selected for hydraulic fracturing pressure in cohesive soils. The criterion is a function of maximum principal stress, minimum principal stress and soil parameters in UU conditions. The equation indicates that with any increase in maximim principal stress, hydraulic fracturing pressure decreases. In order to prove the integrity of the criteria, laboratory tests are performed on compacted cubical specimens using true a triaxial apparatus. The shape and direction of fractures are determined by injecting colored water after fracture initiation. It is found that the direction of fractures are perpendicular to the o1 plane.

• 한국농공학회지
• /
• 제37권2호
• /
• pp.73-85
• /
• 1995

This study aimes at investigating the applicability of single surface work - hardening model(7, 8) to clayey soils through FEM analysis. The comparison was carried out for the results between numericaL analysis and cubical triaxial tests in which confined stress was applied differently and 3-directional principal stress can be controlled. Furthermore, the results of the numerical analysis were compared with observed values of load test on the 2-dimensional model foundation composed of clayey soils. The agreement between nu- merical and observed values proved to be of high accuracy, which indicates that numeri- cal techniques developed during this study using the model can be used for the prediction of settlement, leteral displacement and pore water pressure of actual soft foundation of clayey soils.

• 한국농공학회지
• /
• 제37권2호
• /
• pp.64-72
• /
• 1995

A series of cubical triaxial tests with three independent principal stresses was per- formed on Baekma river sand( # 40~100). It was found that the major principal strain at failure remained approximately constant for b values larger than about 0.3 for both the drained and undrained condition, and thereafter increased as b value decreased. The test results showed that the direction of the strain increment at failure form acute angles with the failure surfaces for both the drained and undrained condition. The results were thus not in agreement with the normality condition from classic plasticity theory. Howev- er, it was found that the projections of the plastic strain increment vectors on the octahe- dral plane were perpendicular to the failure surface in that plane. Failure strength in terms of effective stress anlaysis was greatly influenced by the variation of intermediate principal stress and so was failure criterion. The effective stress failure surfaces for both the drained and undrained condition were estimated quite well by use of Lade's failure criterion.

• 한국지반공학회지:지반
• /
• 제4권3호
• /
• pp.35-42
• /
• 1988

이방성과추밀점토의 3차원 강도특성을 조사하기 위하여 일연의 압밀비배수 입방기형삼축시험이 실시되었다. 현장에시 직접 채취된 자연시료가 사용되었으며, 공시체의 주응력축을 시초채취시의 직교 좌표축과 일치시켜 정팔면체면상의 3차원 성괴면이 충분히 얻어질 수 있도흑 충분한 회수의 시험을 실시하였다. 본 연구결과, 측정된 유효내부라찰각은 재료축방향에 따라 현저하게 차이를 보이고 있으나 동일한 정팔면체면상에 투영시킨 응력상태로 부터 구한 수정된 유효내부마찰각은 이방성을 거의 보이지 않았다. 따라서 등방체의 파양규준으로 제안된 Lade의 파장각잘은 업방성과맥밀점 토의 파괴규준으로도 충분한 실용성이 있음을 알 수 있었다. 또한 파양시의 변형율 증분벡터도 정팔면체면상의 파괴면에 직교성을 보였다.