• Analytical Science and Technology
• /
• v.23 no.3
• /
• pp.240-246
• /
• 2010

A technique for the determination of trace Cu(II) in various real samples by FAAS after the column preconcentration onto p-dichlorobenzene-SA adsorbent, which is microcrystalline p-dichlorobenzene loaded with salicylaldoxime (SA) has been developed. Several experimental conditions such as pH of the sample solution, the amount of chelating agent salicylaldoxime, the amount of adsorbent p-dichlorobenzene-SA, and flow rate of sample solution were optimized. The interfering effects of various concomitant ions were investigated. $CN^-$ interfered more seriously than any other ions. However, the interference by $1\;{\mu}g\;mL^{-1}\;CN^-$ could be overcome completely by controlling the concentration of Ni(II) to $20\;{\mu}g\;mL^{-1}$. The linear range, correlation coefficient ($R^2$) and detection limit obtained by this technique were $3.0\sim100\;ng\;mL^{-1}$, 0.9901, and $3.1\;ng\;mL^{-1}$, respectively. For validating this technique, the aqueous samples (wastewater, reservoir water and stream water) and the food samples (orange juice, fresh egg and skim milk) were used. Recovery yields of 93~104% were obtained. These measured mean values were not differents from ICP-MS data at 95% confidence level. The good results were obtained from the experiments using the rice flour certified reference material (CRM) sample. Based on the experimental results, it was found that this technique could be applied to the preconcentration and determination of Cu(II) for various real samples.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.7 no.1
• /
• pp.47-58
• /
• 2004

Loss factors of A356, Mn-Cu alloy and aluminum matrix composites reinforced with $SiC_p$ and Ni-coated graphite particles at various contents have been investigated using clamped-free cantilever beam method. The loss factors of half-power bandwidth of the specimens were measured over a wide range of frequencies from 50 to 3300Hz. Among the specimens, Al-10%$SiC_p$-10%$C_p$ showed the highest loss factor at the mode I, while Mn-Cu alloy showed the highest loss factors at the modes II and III. Consequently, at the mode I the Al-10%$SiC_p$--10%$C_p$ showed the loss factor of 0.00093, which is 2.64 and 1.58 times higher than those of A356 and Mn-Cu alloy, respectively.

• Journal of Soil and Groundwater Environment
• /
• v.20 no.7
• /
• pp.103-111
• /
• 2015

Soil washing with ethylenediaminetetraacetic acid (EDTA) is highly effective in the remediation of soils contaminated with heavy metals. The EDTA recycling process is a requisite for reducing the operating cost. The applicability of Na₂S addition on the precipitation of heavy metals from the spent soil washing solution and thereby recycling of EDTA was investigated. Addition of Na₂S into the single metal-EDTA and the mixed metal-EDTA solutions ([Na₂S]/[metal-EDTA] ratio = 30, reaction time = 30 min and pH = 7~9) was highly effective in the separation of Cu and Pb from metal-EDTA complexes, but not for Ni. The Zn removal efficiency varied with pH and slightly increased upto 40% as the reaction time increased from 0 to 240 min which was longer than those for Cu and Pb. Ca(OH)₂ was subsequently added to induce further precipitation of Zn and Ni and to reduce the Na₂S dose. At the [Na₂S]/[metal-EDTA] ratio of 10, the removal efficiencies of all heavy metals excluding Ni were above 98% with the dose of Ca(OH)₂ at 0.002, 0.006 and 0.008 g into 100 mL of Cu-, Pb- and Zn-EDTA solutions, respectively. However, Ca(OH)₂ addition was not effective for Ni-EDTA solution. A further research is needed to improve metal removal efficiency and subsequent EDTA recycling for the real application in field-contaminated soils.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.24-24
• /
• 2009

ENIG(Electroless Nickel Immersion Gold) is the surface treatment method that is used most widely at fine pitch's SMT and BGA packaging process. In this paper, we have studied the effect of P content variation during ENIG process on those phenomena related to the solder joint. The effect of P content was discussed using the results obtained from FE-SEM, EPMA, EDS and FIB. Finally, it was concluded that the more P-content in Ni layer, the thicker P-rich layer.

• Journal of the Korean Chemical Society
• /
• v.13 no.1
• /
• pp.41-44
• /
• 1969

Eine neuentwickelte Methode zur Herstellung von Me${\ss}$praparaten wird fur die Bestmmung der Spurenelemente in Wasser Rontgenfluroreszspektrometrie angewendet. Supuren von Kupfer, Blei, Zink, Nickel, Kobalt und Eisen werden aus großen Mengen von naturlichem Wasser durch Verdampfen konzentriert. Aus der konzentrierten Losung werden die Spurenelemente durch Einleitung von Schwefelwasserstoff bei pH 8 unter Zusatz von Aluminiumsulfat-Trager ausgefallt. Die Niederschlage der Metallsulfide werden durch Membranfilter filtriert, mit Gelatine fixiert und ihre Absolutmengen durch Rontgenfloreszenzanalyze bestimmt. Kupfer, Blei, Zink, Nickel, Kobalt und Eisen werden bei einer Konzentration von 2.5 bis 50.0 p.p.b. mit einer relativen Standardabweichung 14.0% gemesser.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.23 no.4
• /
• pp.322-327
• /
• 2003

Giant magnetoresistance(GMR) NiO multilayer, which has been used to reading head of highly dense magnetic recording, was fabricated, and oxidized in an air during 80 days to study the dependence of magnetoresistance properties on residual stress in the interfaces. The magnetoresistance ratio and the exchange biasing $field(H_{ex})$ of $NiO(60nm)/Ni_{81}Fe_{19}(5nm)/Co(0.7nm)/Cu(2nm)/Co(0.7nm)/Ni_{81}Fe_{19}(7nm)$ spin valves were increased from 4.9% to 7.3%, and 110 Oe to 170 Oe after natural oxidation in the atmosphere for 80 days, respectively. The sheet resistivity ${\rho}$ decreased from $28{\mu}{\Omega}m$ to $17{\mu}{\Omega}m$, but ${\Delta}p$ did not almost change after the oxidation. Therefore, the increase of MR ratio is due to the decrease in the sheet resistivity. the reduced resistance may result from the increase in the reflection of conduction electrons at the oxidized top surface. Also, the increase in the exchange biasing field is originated from the reduction of residual stress at the interface of $NiO/Ni_{81}Fe_{19}$ according as the aging time increases.

• Journal of radiological science and technology
• /
• v.38 no.4
• /
• pp.347-353
• /
• 2015

The purpose of this study is to suggest proper additional filtration by comparisons patient dose and image quality among additional filters in digital chest tomosynthesis (DTS). We measured the effective dose, dose area product (DAP) by changing thickness of Cu, Al and Ni filter to compare image quality by CD curve and SNR, CNR. Cu, Al and Ni exposure dose were similar thickness 0.3 mm, 3 mm and 0.3 mm respectively. The exposure dose using filter was decreased average about 33.1% than non filter. The DAP value of 0.3 mm Ni were decreased 72.9% compared to non filter and the lowest dose among 3 filter. The effective dose of 0.3 mm Ni were decreased 48% compared to 0.102 mSv effective dose of non filter. At the result of comparison of image quality through CD curve there were similar aspect graph among Cu, Al and Ni. SNR was decreased average 19.07%, CNR was average decreased 18.17% using 3 filters. In conclusion, Ni filtration was considered to be most suitable when considered comprehensive thickness, character, sort of filter, dose reduction and image quality evaluation in DTS.

• Bulletin of the Korean Chemical Society
• /
• v.27 no.5
• /
• pp.642-648
• /
• 2006

Mushroom tyrosinase (MT) structural changes in the presence of $Cu ^{2+}$ and $Ni ^{2+}$ were studied separately. Far-UV CD spectra of the incubated MT with the either of the metal ions indicated reduction of the well-ordered secondary structure of the enzyme. Increasing in the maximum fluorescence emission of anilinonaphthalene-8-sulfonic acid (ANS) was also revealing partial unfolding caused by the conformational changes in the tertiary structure of MT. Thermodynamic studies on the chemical denaturation of MT by dodecyl trimethylammonium bromide (DTAB) showed decrease in the stability of MT in the presence of $Cu ^{2+}$ or $Ni ^{2+}$ using their activation concentrations. Both activities of MT were also assessed in the presence of different concentrations of these ions, separately, with various monophenols and their corresponding diphenols. Kinetic studies revealed that cresolase activity on p-coumaric acid was boosted in the presence of either of the metal ions, but inhibited when phenol, L-tyrosine, or 4-[(4-methylphenyl)azo]-phenol was substrate. Similarly, catecholase activity on caffeic acid was enhanced in the presence of $Cu ^{2+}$ or $Ni ^{2+}$, but inhibited when catechol, L-DOPA, or 4-[(4-methylbenzo)azo]-1,2-benzenediol was substrate. Results of this study suggest that both cations make MT more fragile and less active. However, the effect of the substrate structure on the MT allosteric behavior can not be ignored.

• Mycobiology
• /
• v.36 no.4
• /
• pp.260-265
• /
• 2008

Cyclic voltammetric measurements were performed for Co(II), Ni(II), Cu(II) and Zn(II) complexes of 1 : 1 alternating copolymer, poly(3-nitrobenzylidene-1-naphthylamine-co-succinic anhydride) (L) and Ni(II) and Cu(II) complexes of 1 : 1 alternating copolymer, poly(3-nitrobenzylidene-1-naphthylamine-co-methacrylic acid) ($L^1$). The in vitro biological screening effects of the investigated compounds were tested against the fungal species including Aspergillus niger, Rhizopus stolonifer, Aspergillus flavus, Rhizoctonia bataicola and Candida albicans and bacterial species including Staphylococcus aureus, Escherichia coli, Klebsiella pneumaniae, Proteus vulgaris and Pseudomonas aeruginosa by well diffusion method. A comparative study of inhibition values of the copolymers and their complexes indicates that the complexes exhibit higher antimicrobial activity. Copper ions are proven to be essential for the growth-inhibitor effect. The extent of inhibition appeared to be strongly dependent on the initial cell density and on the growth medium. The nuclease activity of the above metal complexes were assessed by gel electrophoresis assay and the results show that the copper complexes can cleave pUC18 DNA effectively in presence of hydrogen peroxide compared to other metal complexes. The degradation experiments using Rhodamine B dye indicate that the hydroxyl radical species are involved in the DNA cleavage reactions.

• Journal of the Mineralogical Society of Korea
• /
• v.13 no.4
• /
• pp.205-220
• /
• 2000

북동태평양 C-C지역의 우리나라 광구에서 산출되는 망간단괴의 내부조직을 크게 주상조직 층상대, 첨상조직 층상대, 첨상조직 괴상대, 첨상조직 다공질대 및 괴상조직 괴상대로 구분하였다. 주상조직 층상대에서는 버나다이트(vernadite)가 가장 우세하게 산출되며, 첨상조직 층상대에서는 부서라이크(buserite)가 함께 산출된다. 첨상조직 괴상대는 부서라이트의 산출이 두드러지며, 부분적으로 토도로카이트(todorokite)가 수반된다. 첨상조직 다공질대는 첨상체 또는 구상체로 이루어지며 부분적으로 괴상조직으로 교대되는데 주로 토도로카이트와 부서라이트로 구성되어 있다. 괴상조직을 갖는 괴상대에서는 토도로카이트와 버네사이트(birnessite)가 부서라이트와 함께 산출된다. 각 조직대별로 미세조직을 이루는 엽리들에 대해 전자현미분석을 실시하였다. 엽리의 화학조성을 구성하는 요인은 상관계수 군집분석에 의해 Mn-K의 Mn군, Cu-Ni-Zn-Mg(Ca-Na)의 Cu-Ni-Mg군 Fe-Co-Ti(Ca-P)의 Fe군과 Si-Al의 Si군 등 네 개군으로 구분된다. 각 조직대는 세 개 또는 네 개의 군으로 구성되며 이들 각군은 단괴에서 산출되는 광물과 밀접한 관계를 가진다. Mn군은 토도로카이트, Cu-Ni-Mg군은 부서라이트, Fe군은 함코발트수산화철광물, 그리고 Si군은 규산염광물에서 주로 기인하는 것으로 생각된다. 엽리의 화학조성은 이들 광물의 조합과 구성광물의 화학조성에 따라 지배되고 한 조직대내에서도 여러종류의 조합을 보이는데 이는 각 조직대의 엽리들의 성인과 밀접한 관련이 있는 것으로 생각된다.