• ETRI Journal
• /
• v.33 no.4
• /
• pp.528-536
• /
• 2011

In this paper, we analyze the location accuracy of real-time locating systems (RTLSs) in multipath environments in which the RTLSs comply with the ISO/IEC 24730-2 international standard. To analyze the location error of RTLS in multipath environments, we consider a direct path and indirect path, in which time and phase are delayed, and also white Gaussian noise is added. The location error depends strongly on both the noise level and phase difference under a low signal-to-noise ratio (SNR) regime, but only on the noise level under a high SNR regime. The phase difference effect can be minimized by matching it to the time delay difference at a ratio of 180 degrees per 1 chip time delay (Tc). At a relatively high SNR of 10 dB, a location error of less than 3 m is expected at any phase and time delay value of an indirect signal. At a low SNR regime, the location error range increases to 8.1 m at a 0.5 Tc, and to 7.3 m at a 1.5 Tc. However, if the correlation energy is accumulated for an 8-bit period, the location error can be reduced to 3.9 m and 2.5 m, respectively.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.15 no.3
• /
• pp.874-890
• /
• 2021

With the widespread deployment of the fifth-generation (5G) communication networks, various real-time applications are rapidly increasing and generating massive traffic on backhaul network environments. In this scenario, network congestion will occur when the communication and computation resources exceed the maximum available capacity, which severely degrades the network performance. To alleviate this problem, this paper proposed an intelligent resource allocation (IRA) to integrate with the extant resource adjustment (ERA) approach mainly based on the convergence of support vector machine (SVM) algorithm, software-defined networking (SDN), and mobile edge computing (MEC) paradigms. The proposed scheme acquires predictable schedules to adapt the downlink (DL) transmission towards off-peak hour intervals as a predominant priority. Accordingly, the peak hour bandwidth resources for serving real-time uplink (UL) transmission enlarge its capacity for a variety of mission-critical applications. Furthermore, to advance and boost gateway computation resources, MEC servers are implemented and integrated with the proposed scheme in this study. In the conclusive simulation results, the performance evaluation analyzes and compares the proposed scheme with the conventional approach over a variety of QoS metrics including network delay, jitter, packet drop ratio, packet delivery ratio, and throughput.

• ETRI Journal
• /
• v.45 no.1
• /
• pp.163-170
• /
• 2023

We report an electroabsorption modulator (EAM)-integrated distributed Bragg reflector laser diode (DBR-LD) capable of supporting a high data rate and a wide wavelength tuning. The DBR-LD contains two tuning elements, plasma and heater tunings, both of which are implemented in the DBR section, which have blue-shift and red-shift in the Bragg wavelength through a current injection, respectively. The light created from the DBR-LD is intensity-modulated through the EAM voltage, which is integrated monolithically with the DBRLD using a butt-joint coupling method. The fabricated chip shows a threshold current of approximately 8 mA, tuning range of greater than 30 nm, and static extinction ratio of higher than 20 dB while maintaining a side mode suppression ratio of greater than 40 dB under a window of 1550 nm. To evaluate its modulation properties, the chip was bonded onto a mount including a radiofrequency line and a load resistor showing clear eye openings at data rates of 25 Gb/s nonreturn-to-zero and 50 Gb/s pulse amplitude modulation 4-level, respectively.

• Journal of information and communication convergence engineering
• /
• v.22 no.1
• /
• pp.14-22
• /
• 2024

This study presents the design of a Wilkinson power divider for three-way output ports (WPD3OP), which incorporates a defected ground structure (DGS). An asymmetric power divider is integrated into the output ports of the conventional Wilkinson power divider (WPD), establishing a three-way output port configuration. The DGS introduces periodic or irregular patterns into the ground plane to suppress unwanted electromagnetic wave propagation, and its incorporation can enhance the performance of the power divider, in terms of the power-division ratio, isolation, and bandwidth, by reducing spurious resonances. The proposed design algorithm for an asymmetric power divider for three-way output ports is analyzed via circuit simulations using High-Frequency Simulation Software (HFSS). The results verify the validity of the proposed method. The analysis of the WPD3OP integrated with DGS certifies the achievement of a center frequency of 2 GHz. This confirmation is supported by schematic ideal design simulation results and measurements encompassing insertion losses, return losses, and isolation.

• Journal of Families and Better Life
• /
• v.27 no.5
• /
• pp.25-42
• /
• 2009

This study examines the actual state of using digital convergence products by consumers, and analyzes the expectation that consumers have regarding digital convergence products and the actual satisfaction of the digital convergence products. In addition, it analyzes factors affecting the satisfaction with digital convergence products. First, mobile phones, which 99.4% of those surveyed had, cameras, which 90.6% had, and mp3s, which 71.8% had, were found to be necessities. Second, the ratio of owning digital convergence products was 79.5%, 48.1%, and 52.4%, respectively. In the case of a mobile phones, a digital convergence type is already common. Third, regarding the reason for purchasing digital convergence products, they chose convergence products because there was no product with a simple function that they wanted to have: 38.2% in terms of a mobile phone, 47.2% for a camera, and 28.2% for an mp3. This shows that a consumer's choice was infringed in a great deal at the back of remarkable quantitative growth in digital convergence products. Fourth, the analysis of the factor regarding the consumer's expectation on digital convergence products showed 3 kinds of factors, i.e., expectation of benefit, expectation of risk, and expectation of situation. Fifth, as a result of analyzing the structural model regarding the effect on satisfaction by a consumer's expectation and the outcome on digital convergence products, all the expectations and outcomes of benefit, risk, and situation did not have a direct effect on satisfaction. Only an indirect effect through inconsistency showed a statistical significance.

• Journal of the Institute of Convergence Signal Processing
• /
• v.2 no.3
• /
• pp.73-78
• /
• 2001

BP neural network model and multiple-regression model were composed for forecasting the special-days load. Special-days load was forecasted using that neural network model made use of pattern conversion ratio and multiple-regression made use of weekday-change ratio. This methods identified the suitable as that special-days load of short and long term was forecasted with the weekly average percentage error of 1∼2[%] in the weekly peak load forecasting model using pattern conversion ratio. But this methods were hard with special-days load forecasting of summertime. therefore it was forecasted with the multiple-regression models. This models were used to the weekday-change ratio, and the temperature-humidity and discomfort-index as explanatory variable. This methods identified the suitable as that compared forecasting result of weekday load with forecasting result of special-days load because months average percentage error was alike. And, the fit of the presented forecast models using statistical tests had been proved. Big difficult problem of peak load forecasting had been solved that because identified the fit of the methods of special-days load forecasting in the paper presented.

• Physical Therapy Korea
• /
• v.30 no.1
• /
• pp.15-22
• /
• 2023

Background: Delivery workers repeatedly get in and out of trucks and walk or run to deliver packages during work. Iliotibial band syndrome (ITBS) is a well-known non-traumatic overuse injury of the lateral side of the knee caused by frequent knee flexion and extension. Hip muscle strength is among the factors that prevent lower extremity injuries. Although many studies have examined the relationship between ITBS and hip muscle strengths, there was no study comparing hip muscle strength and ratio between delivery workers with and without ITBS. Objects: This study aimed to compare hip muscle strength and hip internal/external rotator and adductor/abductor strength ratios between delivery workers with and without ITBS. Methods: Fourteen delivery workers with ITBS matched inclusion criteria in the present study among 20 participants. Because total sample size was required 28 subjects by G*power program (ver. 3.1.9.4; University of Trier), 14 delivery workers without ITBS were recruited. Hip muscle strengths were measured in a side-lying position using a Smart KEMA pulling sensor (KOREATECH Co. Ltd.). An independent t-test was used to compare hip muscle strengths and hip internal/external rotator and hip adductor/abductor strength ratios between delivery workers with and without ITBS. Results: The adductor/abductor strength ratio was significantly greater in delivery workers without ITBS than in those with ITBS (p < 0.05). The strengths of the hip abductor, hip adductor, hip internal rotator, hip external rotator, and the ratio of internal/external rotator strengths were not significantly different between the delivery workers with and without ITBS (p > 0.05). Conclusion: This study's findings showed that delivery workers with ITBS had significantly lesser adductor/abductor strength ratio, while the strengths of the hip abductor and adductor muscles did not differ significantly. These results suggest that adductor/abductor strength ratio should be considered when evaluating and treating ITBS in delivery workers.

• Journal of Korea Multimedia Society
• /
• v.19 no.2
• /
• pp.443-450
• /
• 2016

This paper deals with a kind of packing problem of which the goal is to compose one or more templates which will be used to produce the items of different types. Each template consists of a fixed number of slots which are assigned to the different types of items and the production of the items is accomplished by printing the template repeatedly. The objective is to minimize the total number of produced items. This problem is known to be NP-hard. We present a polynomial time approximation algorithm which has a constant approximation ratio. The proposed algorithm is based on the well-known first-fit strategy.

• Journal of Korea Multimedia Society
• /
• v.18 no.4
• /
• pp.437-442
• /
• 2015

Voice activity detection is very important process that voice activity separated form noisy speech signal for speech enhance. Over the past few years, many studies have been made on voice activity detection, but it has poor performance in low signal to noise ratio environment or fickle noise such as car noise. In this paper, it proposed new voice activity detection algorithm using ensemble variance based on wavelet band entropy and soft thresholding method. We conduct a survey in a lot of signal to noise ratio environment of car noise to evaluate performance of the proposed algorithm and confirmed performance of the proposed algorithm.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.31 no.3
• /
• pp.177-181
• /
• 2018

We prepared ZnS thin films via chemical bath deposition (CBD) in an aqueous solution of ammonia ($NH_3$) and hydrazine ($N_2H_4$). The composition ratio of hydrazine used was 0%, 17%, 22%, 29%, or 50%. We investigated the effects of hydrazine and ammonia on the growth, and the structural and optical properties of ZnS in terms of surface uniformity, voids, and grain size. We found that during the growth of ZnS films, hydrazine was very effective for improving the surface morphology and layer uniformity with fast layer formation, while it had no effect on the bandgap energy, $E_g$.