• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2000.06a
• /
• pp.157-164
• /
• 2000

A mechanical equipment room with various equipments may be the largest source of noise and vibration. Without sufficient consideration for noise and vibration control in the phase of designing, it causes some problems after completing construction or enormous cost necessary to correct the problems. Therefore, it is essential to consider the method of noise and vibration control, but the systematic guideline of noise and vibration is not provided yet. This study aims to investigate the actual condition of noise and vibration generated from mechanical equipments in apartment buildings, for providing the guideline of its control.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2009.11a
• /
• pp.35-39
• /
• 2009

Recently, the flat-plate structure is widely used because it has many advantages such as reduction of story height, long span etc than the RC rahmen structure. Furthermore, application of the flat-plate is on the increase because of flexible plan unlike wall structure. Long span have been at a disadvantage for vibration serviceability evaluation, however studies about vertical direction vibration of flat-plate structure has not been carried out. This study analysis the characteristics according to slab structure to make an experiment on vibration and floor impact noise for the flat-plate structure in construction performance laboratory in Kolon E&C R&D center, the flat-plate structure applied to the post-tension method, and the wall structure in apartment houses.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.16 no.7 s.112
• /
• pp.777-783
• /
• 2006

In this study, quantitative ground vibration values and damping coefficient produced by underwater blasting were measured and analyzed. Also, hydrospace noise in aquafarm and noise in atmosphere as well as ground vibrations were measured, and maximum values of these results were 86,8 dB(A), 147,8dB(A), 0.244 cm/s, respectively, With these results, vibration influence about snakehead (channa argus) and structures were examined. the damage of those was proved that is not. Equations of vibration ($V_{50%}=1.507SD^{-0.536},\;V_{95%}=2,171SD^{-0.536}$) and hydrospace noise ($SL=293.2SD^{-0.164}$) were presented from quantitative experiment results. respectively. The results of the study may be applied for the evaluation of the influence on aquafarm as a basic data before having main underwater blasting at construction sites.

• Journal of Environmental Impact Assessment
• /
• v.17 no.6
• /
• pp.381-391
• /
• 2008

The instances of the damage to livestock are increasing with frequent environmental disputes on the noise and vibration. This study analyzed 134 open cases dealing with the environmental disputes on livestock damaged by noise and vibration, and being intervened by National Environmental Dispute Resolution Commission. The environmental disputes on the noise and vibration account for 86% of all the disputes, and cases of the consequent damages to livestock have increased. As shown in the 134 cases, pig is the most lethal livestock attacked by the noise and vibration. During last 10 years, 89% of the noise damages hurting the livestock resulted from the noises pertaining to construction and 58% was due to the noise damages from the road constructions. The noise levels in the range of 70~80 dB(A) and the vibration levels of 70~75 dB(V) caused most of the disputes. The average rate of reimbursement for the livestock damages for the last 10 years was higher than the average rate of reimbursement of the total disputes intervened by National Dispute Resolution Commission.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2013.10a
• /
• pp.631-632
• /
• 2013

• Journal of the Korean GEO-environmental Society
• /
• v.14 no.6
• /
• pp.5-11
• /
• 2013

Because the regulation for a noise and a vibration in our country has been being reinforced more and more, a more environment-friendly pile construction method than a current low-noise and low-vibration method was needed for the close construction in the downtown area. In this study, the characteristics of a screw concrete pile method for noise and vibration-free method was explained, and it's vertical bearing capacity was studied in the base of the static pile load test data of the screw concrete piles. Constructed by two methody; a pre-digging shoe type construction method and a toe-jetting shoe type construction method. The vertical load bearing capacity of a screw pile constructed by the former was more about 70% than that of a screw pile constructed by the latter.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2000.06a
• /
• pp.53-62
• /
• 2000

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.17 no.11
• /
• pp.1021-1027
• /
• 2007

A construction noise is the main reason for people's petition among the pollution. The purpose of this study is to develop the noise prediction program to see the level of the noise on the construction site more accurately. For this purpose, the database of the power level on the various equipments was made. The noise reduction by distance and the noise reduction by diffraction of barrier were mainly considered and calculated. The simple noise prediction program will provide the information about proper height and length of the potable barrier which satisfies noise criteria of the construction sites from a construction planning stage. To investigate the reliability of this program, the predicted data was compared with the measured data. An average of difference between measured data and predicted data is $0.1{\sim}2.8\;dB(A)$ and a coefficient of correlation is about $0.85{\sim}0.95$.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2010.10a
• /
• pp.554-555
• /
• 2010

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.05a
• /
• pp.113-116
• /
• 2005