• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1997년도 춘계학술대회 논문집
• /
• pp.20-22
• /
• 1997

In ours study, we investigated the various properties in Te-light doped $Sb_{85}$G $e_{15}$ thin films such as the change of reflectance and transmittance according to phase change from amorphous to crystalline states In all films the transmittance was decreased, but the reflectance was increased by annealing. Particularly, the reflectance between as- deposited state and annealed state showed the largest change in the T $e_{0.5}$($Sb_{85}$G $e_{15}$ )$_{99.5}$ thin film at 780nm, which was about 40% in as-deposited state and about 70% in annealed state. Therefore, it might be considered that the T $e_{0.5}$($Sb_{85}$G $e_{15}$ )$_{99.5}$ thin film is recording medium showing to a good optical properties if it is used to optical recording of the phase change type. change type.ype.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2008년도 하계종합학술대회
• /
• pp.297-298
• /
• 2008

A new equalization method for perpendicular magnetic recording channels is proposed. The proposed equalizer incorporates the Gaussian sum approximation into a Kalman filtering framework to mitigate inter-symbol interference in perpendicular magnetic recording systems. The proposed equalizer consists of a bank of linear equalizers using the Kalman filtering algorithm and its output is obtained by combining the outputs of linear equalizers through the Gaussian sum approximation.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2000년도 하계종합학술대회 논문집(5)
• /
• pp.110-112
• /
• 2000

Recently, the interest and the importance of the signal monitoring and recording during sleep is increasing. Conventional paper based recording systems are being replaced by digital type and polysomnographic system. We developed special digital signal processor system for the polysomnographic recording. This system consists of digital signal processing part and PC interface part for user's convenience. This system includes two digital filters, one fur low pass filtering of high frequency noise and the other for notch filtering of 60Hz AC noise. This system can be used for the efficient and convenient measurement of polysomnographic signals and also can be developed for the portable use.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1988년도 춘계학술대회 논문집
• /
• pp.74-77
• /
• 1988

This paper reports the properties of antireflection structure and hole formation of Te-based systems. The optical-recording characteristics of metallic recording media are enhanced significantly by incorporating the metal(Al) layer into an antreflection trilayer structure. Due to the interface condition inherent in the design of the trilayer structure, reflectivity from holes is ranked low fraction (<10%). The hole formation is carried by $Ar^+$ Laser(488nm). For 20nsec pulse duration, hole opening power(threschold) of $(Te_{86}Se_{14})_{50}Bi_{50}$ trilayer is lower than that of monolayer that used in this experiment. Hole shapes of the whole sample were clean.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1990년도 하계학술대회 논문집
• /
• pp.15-18
• /
• 1990

In this paper, perpendicular magnetic recording system which consists of a single pole head and a double, layer medium is analyzed by using 2D-finite element simulation and Preisach model for describing hysteresis characteristics. For confirming this method, we compare the calculated magnetic field intensity which is above the isolated transition of magnetization and scale up experimental data which have already published. The results show a good agreement and we can conclude that this method is very useful to analyze perpendicular magnetic recording system.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2008년도 춘계학술대회 논문집
• /
• pp.1962-1967
• /
• 2008

A event recorder system stores a train speed and the related information for train operation in real time. Using those information, we can analysis the train operation and the reason of train accident. Currently the event recorder only manipulate the data related the train operation mechanically and electrically. In this paper we propose the event recorder to record the voice communication between the manager in the control center and train operator. By recording the voice communication in the high speed train, the correctness of analysis of train accident can be increased. The system architecture of the event recorder with voice recording is studied and interface between other equipment is proposed. And the software architecture of new event recorder is developed. We study the method of converting analog voice signal into digital data and compressing method. Also the architecture of memory to store the compressed voice data and regeneration of original analog voice are studied.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 2009년도 춘계학술대회 논문집
• /
• pp.68-69
• /
• 2009

Heat Assisted Magnetic Recording (HAMR) is one of the most promising candidates for high density magnetic storages over 1 Tb/$in^2$ areal density. Since the precise light delivery to the head is a key factor to realize HAMR application, it is required to establish the light delivery using micro laser module and micro actuator. For the careful control of micro actuator, a laser module was designed including laser diode, optical fiber, collimating lens, and fabricated V-groove substrate. In addition, the basic aligning method between the laser module and HAMR head was studied by the detection of current change in photo diode due to the amount of reflected light from the head.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2003년도 통신소사이어티 추계학술대회논문집
• /
• pp.382-385
• /
• 2003

Introduction of digital broadcasting service does not only mean the change of information transmission method but also the change of total broadcasting system. In past day, Television was only received one-sided information from broadcasting station, but digital broadcasting means that digital television becomes the most important means of information transmission by the introduction of new programming, lots of channels, data service, multi communication. In the age of the digital broadcasting, the recording and replay medium's interest is getting higher. The medium is able to record more than 24 hours' digital broadcasting programs without additional tapes. In this paper the recording and replay device using HDD was implemented and device driver based on linux was programmed. It has Intel PXA250 processor and hard disk is used as storage equipment. And transport Stream is saved on hard disk through PXA250's data bus. FIFO is added to solve the different saving speed and FPGA is also added to display the saved data.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1988년도 추계학술대회 논문집
• /
• pp.46-46
• /
• 1988

Structural and magnetic properties of Co-Cr-Mo films were investigated in connection with sputtering conditions. Films were prepared using a convention RF sputtering system. X-ray diffractometry, scanning electron microscopy and transmission electron microscopy were employed to investigate structure properties. Vibrating sample magnetometry was used for coercivity and saturation magnetization measurements. Co-Cr-Mo films displayed reasonable values of perpendicular coercivity and saturation magnetization for perpendicular recording media and showed good perpendicular orientation of the hcp c-axis to the film surface. Perpendicular coercivity was strongly dependent upon substrate technique showed better c-axis orientation than hose using the stationary substrate. Co-Cr-Mo films of 2.9 at. % Mo content showed maximum perpendicular coercivity and saturation magnetization. The films deposited at lower Ar pressure showed good magnetic properties. There was no explicit relationship between the columnar structure and c-axis orientation. Co-Cr-Mo films was found to have suitable structural and magnetic properties for perpendicular recording media.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 A
• /
• pp.262-264
• /
• 2003

This paper develops an ADWHM(Advanced Digital Watt Hour Meter) based on RISK type'8bit micro-controller, which has voltage management data recording function, load management data recording function as well as the existing watt-hour data recording data function. It can enhance greatly the economics of the existing remote meter reading system. Also it can improve highly the quality of power supplied to the electric customer by minimizing the voltage management cost and by enhancing the efficiency of load management.