• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.7 s.361
• /
• pp.1-6
• /
• 2007

In this paper, the spiral zeroth-order resonance (ZOR) antenna using composite right- and left-handed (CRLH) transmission line is proposed. The zeroth-order resonant characteristics of the antenna are described by dispersion relation of a periodic structure. The size of the $2{\times}2$ spiral ZOR antenna is $0.155{\lambda}_{0}{\times}0.155{\lambda}_{0}$. By increasing shunt inductance of CRLH transmission line, the size of this antenna is reduced by 65% compared with that of a mushroom ZOR antenna. The radiation pattern of this antenna have omnidirectional pattern which is similar to that of mushroom ZOR antenna.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.10a
• /
• pp.72-73
• /
• 2016

In this paper, we studied a method for miniaturizing a broadband stacked patch antenna structure which is widely used for bandwidth improvement. Main patch is a rectangular microstrip patch antenna fed by a 50-ohm microstrip line, and a parasitic patch is laid above the main patch. The size of the main patch is designed to be resonated near the center frequency of the desired frequency band. Then parasitic patch longer than main patch is placed above the main patch. The distance between two patches might be adjusted so as to achieve impedance matching using a shunt open stub. The shunt matching stub is inserted underneath the parasitic patch and so it does not require additional space, which enables the proposed antenna structure to be advantageous in miniaturizing antenna. The effects of the various parameters on the antenna performance are examined, and we introduced the design procedure for the proposed antenna to operate in the frequency range of 2.3-2.7 GHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.2
• /
• pp.223-230
• /
• 2008

A CRLH-TL based compact metamaterial antenna on a magneto-dielectric material is proposed. The proposed antenna is composed of two patches and vias, which is loaded by a magneto-dielectric material constructed by SRRs. The characteristic of SRRs is studied, and the size reduction of the antenna by using the magneto-dielectric material is confirmed. The simulated resonant frequency of the antenna has showed a decrease of 7.13 % at - 1st-order resonant mode, and 23.9 % at zeroth-order resonant mode. A zeroth-order resonant antenna is fabricated and measured, which has a resonant frequency of 1.888 GHz, a bandwidth of 0.48 %, a gain of 0.534 dBi, and an efficiency of 51.7 %.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.5 s.120
• /
• pp.563-568
• /
• 2007

In this paper, the proposed package antenna, which is meander line structure with short pin, is miniaturized to realize RF-SoP at 900 MHz RFID band. The RFID BGA(Ball Grid Array) chip is put in a cavity of LTCC Layers. The coupling and cross talk, which are happen between BGA chip and proposed package antenna, are reduced by faraday cage, which consists of ground and via fences, is realized to enhance the isolation between BGA chip and antenna. The proposed antenna structure is focused on the package level antenna realization at low frequency band. The novel proposed package antenna size is $13mm{\times}9mm{\times}3.51mm$. The measured resonance frequency is 0.893 GHz. The impedance bandwidth is 9 MHz. The maximum gain of radiation pattern is -2.36 dBi.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.5
• /
• pp.333-338
• /
• 2019

In this study, we introduce a dual-band ground radiation antenna using an endless metal-rim mode control method that operates in the WLAN band. In the proposed antenna, the metal-rim modes are excited as one- and two-wavelength-mode radiators by a dual-band ground radiation antenna, which occupies a small space on the ground plane. The metal rim surrounds the ground plane with a gap of only 2 mm. In addition, two capacitors are inserted between the ground plane and the endless metal rim to control the one- and two-wavelength modes of the endless metal rim. Based on simulation and measurement results, we noted that the proposed antenna has an impressively high radiation performance.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.5
• /
• pp.759-766
• /
• 2022

In this paper, we propose a multi-band small antenna with CPW(Coplanar Waveguide) feeding structure WLAN(Wireless Local Area Network) and WiMAX (Worldwide Interoperability for Microwave Access) bands. The proposed antenna is designed two slit in the modified monopole type radiator and FR-4 substrate, which is thickness 1.0 mm, and the dielectric constant is 4.4. The size of proposed antenna is 15.1 mm⨯16.41 mm, and total size of proposed antenna is 17.5 mm⨯16.4 mm. From the fabrication and measurement results, From the fabrication and measurement results, bandwidths of 439 MHz (2.06 to 2.499 GHz), 840 MHz (3.31 to 4.25) and 1,315 MHz (5.23 to 6.545 GHz) were obtained on the basis of -10 dB impedance bandwidth. Also, 3D radiation pattern characteristics of the proposed antenna are displayed and measured gains 2.24 dBi, 2.83 dBi, and 2.0 dBi shown in the three frequency band, respectively.

• Journal of electromagnetic engineering and science
• /
• v.12 no.4
• /
• pp.234-239
• /
• 2012

This paper presents a compact K-band Doppler radar sensor for human vital signal detection that uses a radar configuration with only single coupler. The proposed radar front-end configuration can reduce the chip size and the additional RF power loss. The radar front-end IC is composed of a Lange coupler, VCO, and single balanced mixer. The oscillation frequency of the VCO is from 27.3 to 27.8 GHz. The phase noise of the VCO is -91.2 dBc/Hz at a 1 MHz offset frequency, and the output power is -4.8 dBm. The conversion gain of the mixer is about 11 dB. The chip size is $0.89{\times}1.47mm^2$. The compact Ka-band Doppler radar system was developed in order to demonstrate remote human vital signal detection. The radar system consists of a Ka-band Doppler radar module with a $2{\times}2$ patch array antenna, baseband signal conditioning block, DAQ system, and signal processing program. The front-end module size is $2.5{\times}2.5cm^2$. The proposed radar sensor can properly capture a human heartbeat and respiration rate at the distance of 50 cm.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.5
• /
• pp.484-491
• /
• 2013

In this paper, the method of designing a wideband antenna has been introduced through the design technique that simultaneously employs L- and slot-type feeds. Using the two kinds of feeds and additional fence structure, a compact wideband patch antenna has been realized. The size of the patch has been reduced by about 30 % based on the low frequency(824 MHz) and the full fractional bandwidth is wider than 100 %. The L-feed element is for the EM coupling feeding at the low frequency, while it functions as a feeding line for the power coupling through the slot at the high frequency. The proposed antenna has been designed not only for wideband operations but also for a proper array element with a reduced size. Thus, the foundation for developing the ultra wideband patch array antennas has been prepared. The fabricated antenna has been found to have good characteristics on V.S.W.R and the radiation patterns over the full bands. The experimental and computed results are shown to be in good agreement.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.2
• /
• pp.244-250
• /
• 2012

The compact dipole antenna elements and array structure is proposed. The array structure is designed for applicator in regional hyperthermia treatment to enhance the uniformity of the heat distribution which makes the treatment effective and prevents overheating. The compact dipole is designed with branched dipole and matching network to have small size and symmetric shape. The temperature simulation with specific absorption rate(SAR) and bio-heat equation is performed to have heat distribution. The applicator is designed, fabricated, and measured with multi-channel thermometer in 30 and 60 minutes. The simulation and measurement results showed agreement and the simulation in body circumstance has proper temperature result for hyperthermia therapy.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.1
• /
• pp.46-53
• /
• 2008

In general, the cassegrain dual offset reflector is used for the satellite communication antenna, but is analyzed as the reflector system for the CPTR(Compact Payload Test Range) facility in here. The near-field at the test zone of the CPTR is obtained by using the physical optics approximation. The CPTR has to provide a uniform plane wave with the minimum amplitude and phase ripple and the low cross polarization. Therefore, in this paper, the near-field pattern are calculated, and the ripple and taper of the field and the cross polarization are investigated with the variation of the reflector geometry and the position of the test region. Especially, the cross polarization of the antenna axis direction which is not found in the satellite reflector antennas is investigated.