• Journal of the Semiconductor & Display Technology
• /
• v.10 no.2
• /
• pp.57-63
• /
• 2011

Photovoltaic effect is confirmed in DSSC fabricated under the common conditions. In upper electrodes, validity of ZnO as new TCO material was investigated and an improvement of characteristics in DSSC was tried by control of process conditions at semiconductive powder layer. ZnO thin film showed very high resistivity, therefore efficiency of solar cell was lower than that of conventional ITO-related material. DSSC characteristics was able to improve by thin blocking layer doposited between the TCO and semiconductor layer.

• Journal of Sensor Science and Technology
• /
• v.14 no.2
• /
• pp.85-90
• /
• 2005

In this study, we have fabricated a three branches vertical Hall sensor for detecting three phases rotation informations of miniaturized brushless motor. The sensor gives three position signals phase shifted by $120^{\circ}$, corresponding to the motor driving signals. The branch has one Hall output and one input each other. The central part acts as common driving input. Sensor has branch width of $150{\mu}m$ and distance from central electrode to Hall electrode of $100{\mu}m$. The sensitivity of sensor is 250 V/$A{\cdot}T$ at magnetic field of 0.1 T. It has also showed three sine waves of Hall voltages with $120^{\circ}$ phase over a $360^{\circ}$ rotation. A packaged sensing part are $2{\times}2mm^{2}$ and has been successfully tested on a motor rotation at a speed up to 60,000 rpm.

• Journal of Oriental Neuropsychiatry
• /
• v.20 no.2
• /
• pp.111-120
• /
• 2009

Objectives : This study was performed to investigate the effects of Needle Electrode Electrical Stimulation (NEES) on ischemia-induced cerebrovascular accidents. After obstruction and reperfusion of ${\ast}{\ast}$ arteries in white mice, the amounts of necrosis and inflammation related substances IL-6, Caspase-3, and PARP, C-fos were measured in neurons of the hippocampus. The following results were obtained. Methods : This study used 21 male specific pathogen free (SPF) SD (Sprague Dawley) rats, 8 weeks of age and approximately 300 g in weight, that were given at least 1 week to adapt to the lab environment Each exposed artery was completely occluded with non-absorbent suture thread and kept in that state for 5 minutes. The sutures were then removed to allow reperfusion of blood. Test group is control group for comparison with the common carotid artery occlusion models, a GI group that underwent common carotid artery occlusion, and a needle electrode electrical stimulation (NEES) group that underwent NEES after artery occlusion. The GI and NEES groups were given 12, 24, or 48 hours of reperfusion before NEES. NEES device (PG6, ITO, Japan, 9V, current, 2Hz) was used to stimulate the right and left acupoint ST36 of the SD rats for 30 minutes while they were sedated with 3% isoflurane. An immunohistochemistry test was done on the forebrains of the GI induced rats. All the data collected from this study was symbolized and analyzed using a statistics processing program (SPSS 12.0K/PC). The level of significance was set at ${\alpha}$=0.05 and a T-TEST analysis was used to find out the effects of treatment on each of the groups: the normal group, the CVA induced group, and the treatment after CVA induction group. Results : Both PARP and C-fos immuno-reactive cells, related to apoptosis, were greater in the GI groups than the NEES group. Caspase and IL-6 immuno-reactive cells, related to inflammation, were greater in the GI and NEES groups than the control group. Conclusions : This research was conducted to study the effects of NEES on CVA due to ischemia. Occlusion and reperfusion was performed on the common carotid arteries of white rats, after which amounts of substances related to neuron necrosis and inflammation - PARP, IL-6, Caspase-3, and C-fos - were measured in the Hippocampus

• Journal of the Korean Chemical Society
• /
• v.50 no.3
• /
• pp.208-215
• /
• 2006

A simply prepared graphite, pencil-type working electrode was utilized to monitor fenitrothion concentrations, using the cyclic voltammetry (CV) and square-wave (SW) stripping voltammetry methods. The optimum conditions for analysis were sought. A very low detection limit was obtained compared to that obtained when other common voltammetry methods are used. The optimal parameters of the pencil-type electrode were found to be as follows: a pH of 3.7, a frequency of 500 Hz, an SW amplitude of 0.1 V, an increment potential of 0.005 V, an initial potential of -0.9V, and a deposition time of 500 sec. The analytical detection limit was determined to be 6.0 ngL-1 (2.16410-11 molL-1) fenitrothion at SW anodic and CV, and the relative standard deviation at the fenitrothion concentration of SW anodic 10 ugL-1 was 0.30% (n = 15) under the optimum conditions. Analysis was directly conducted through in-vivo real-time assay.

• Journal of Welding and Joining
• /
• v.2 no.1
• /
• pp.30-40
• /
• 1984

Moisture content in the coating of an electrode is known to cause defects such as porosities, fish eyes and cracks in the weld metal, however, quantitative relationship between them is not clearly understood. In this study widely consumed and the most common type of arc welding rods such as ilmenite and low hydrogen type were chosen for the investigation, and attempts were made to correlate the relationship between the mechanical properties and gas contents when welding was carried out with electrodes of various moisture contents. As the relative humidity changed from 70% to 92%, it was determined that moisture content to reach saturation was in the range of 0.6~6.8%. As the moisture content in the electrode coating was increased, the amount of gaseous components (H, O, N) in the weld metal was accordingly increased, especially diffusible hydrogen showed prominent effect, i.e. it increased proportionally to the increase of the moisture content. The mechanical properties of the weld metal was observed to become more inferior as the diffusible hydrogen was greater. It was determined for ilmenite type of electrode that the increase of hydrogen content was approximately 1.8ml per unit weight percent increase of moisture and also tensile strength resulted lowering from $45.3kg/\textrm{mm}^2$ to $42.7kg/\textrm{mm}^2$ as moisture content increased from 0.7% to 6.8%. For low hydrogen type the increase of the hyrogen was about 2.4ml per unit percent of moisture and tensile strength decreased from $63.0kg/\textrm{mm}^2$ to $53.8kg/\textrm{mm}^2$ particularly in the region of moisture content 0.1~4.2%.

• Journal of Korean Society of Water and Wastewater
• /
• v.31 no.5
• /
• pp.373-381
• /
• 2017

$RuO_2$ is a common active component of Dimensionally Stable Anodes (DSAs) for chlorine evolution that can be used in wastewater treatment systems. The recent improvement of chlorine evolution using nanostructures of $RuO_2$ electrodes to increase the treatment efficiency and reduce the energy consumption of this process has received much attention. In this study, $RuO_2$ nanorod and nanosheet electrodes were simply fabricated using the sol-gel method with organic surfactants as the templates. The obtained $RuO_2$ nanorod and nanosheet electrodes exhibit enhanced electrocatalytic activities for chlorine evolution possibly due to the active surface areas, especially the outer active surface areas, which are attributed to the increase in mass transfers compared with a conventional nanograin electrode. The electrocatalytic activities for chlorine evolution were increased up to 20 % in the case of the nanorod electrode and 35% in the case of the nanosheet electrode compared with the nanograin electrode. The $RuO_2$ nanorod 80 nm in length and 20-30 nm in width and the $RuO_2$ nanosheet 40-60 nm in length and 40 nm in width are formed on the surface of Ti substrates. These results support that the templated $RuO_2$ nanorod and nanosheet electrodes are promising anode materials for chlorine evolution in future applications.

• Journal of the Optical Society of Korea
• /
• v.18 no.6
• /
• pp.783-787
• /
• 2014

This paper presents an improved vertical alignment nematic liquid crystal mode characterized by the protrusions or slits of the top substrate and additional stripe type common electrodes with polarity switching of the bottom substrate to improve multi-domain vertically aligned (MVA) and patterned vertically aligned (PVA) nematic modes. MVA and PVA modes have disadvantages such as an LC disclination in the vicinity of the middle region of electrodes between the top and bottom protrusions in MVA mode or the top and bottom slits in PVA mode. Therefore, the stripe type common electrode generating a horizontal electric field and the protrusion or slit producing some pretilt of liquid crystals (LCs) were used to improve the LC disclination, which influences the transmittance and response speed. The simulation results showed that the proposed VA mode has higher transmittance than the MVA and PVA modes. As a result, the proposed VA mode can improve the response speed and transmittance remarkably, which makes it useful for upgrading the LCD display quality.

• Journal of International Academy of Physical Therapy Research
• /
• v.1 no.1
• /
• pp.10-18
• /
• 2010

This study was performed to investigate the effects of Needle Electrode Electrical Stimulation(NEES) on ischemia-induced cerebrovascular accidents. After obstruction and reperfusion of arteries in white mice, the amounts of necrosis and inflammation related substances Bax, IL-6, Caspase-3, and COX-2 were measured in neurons of the fore-brain. The following results were obtained. This study used 21 male specific pathogen free(SPF) SD rats, 8 weeks of age and approximately 300g in weight. Each exposed artery was completely occluded with non-absorbent suture thread and kept in that state for 5 minutes. The sutures were then removed to allow reperfusion of blood. Test group is control group(common carotid artery occlusion models), a GI(underwent common carotid artery occlusion), and NEES(underwent NEES after artery occlusion). The GI and NEES groups were given 12, 24, or 48 hours of reperfusion before NEES. NEES device(PG6, ITO, Japan, 9V, current, 2Hz) was used to stimulate the bilateral acupoint ST36 of the SD rats for 30 minutes while they were sedated with 3% isoflurane. An immuno-histochemistry test was done on the forebrains of the GI induced rats. Both Bax and Caspase-3 immuno-reactive cells, related to apoptosis, were greater in the GI than the NEES group. Cox-2 and IL-6 immuno-reactive cells, related to inflammation, were greater in the GI and NEES groups than the control group. We can expect that applying NEES after ischemic CVA is effective for preventing brain cells from being destroyed. And we can conclude NEES should be applyed on early stage of ischemic CVA.

• Analytical Science and Technology
• /
• v.20 no.4
• /
• pp.289-295
• /
• 2007

A simple electric circuit of an infrared photodiode electrode (IPDE) was utilized to monitor iron using square-wave (SW) anodic stripping voltammetry (SV) and cyclic voltammetry (CV). The optimum analytical conditions were determined and were compared with those of common working electrodes. The comparison showed that CV is more sensitive and convenient to use than the common voltammetry methods. At the optimized conditions, the working ranges of 0.1- to 0.8- and 0.85- to 6.0 mg/L iron was obtained. Relative standard deviation of 15 measurements of iron (0.4 mg/L) was 0.09%. The analytical detection limit was found to be $80{\pm}0.6ug/L$, which was applied to iron in waste water.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.49 no.12
• /
• pp.673-678
• /
• 2000

The dielectric barrier discharge(DBD) is a common method to create a nonthermal plasma in which electrical energy is used to create electrons with a high average kinetic energy. The unique aspect of dielectric barrier discharges is the large array of short lifetime(10ns) silent discharges created over the surface of the dielectric. A silent discharge is generated when the applied voltage exceeds the breakdown voltage of the carrier gas creating a conduction path between the applied electrode and grounded electrode. As charge accumulates on the dielectric, the electric field is reduced below the breakdown field of the carrier gas and the silent discharge self terminates preventing the DBD cell from producing a thermal arc. In fact, the most significant application of dielectric barrier discharges is to generate ozone for contaminated water treatment. Therefore, experiments were perfomed at 1∼2[bar] pressure using a coaxial geometry single dielectric barrier discharge for ozone concentrations and energy densities. The main result show that the concentration and efficiency of ozone are influenced by gas nature, gas quantity, gas pressure, supplied voltage and frequency.