• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.25 no.12
• /
• pp.107-112
• /
• 2011

Multiple ground rods are commonly used to obtain the low ground impedance, but they will not reduce the ground impedance unless the spacings between the ground rods are sufficient. This paper presents the experimental results of frequency-dependent resultant ground impedance of two ground rods in parallel. The resultant ground impedance of two ground rods in parallel were measured as functions of the spacing and length of ground rods and the frequency of test currents and were discussed based on the potential interferences. As a consequence, the frequency-dependent ground impedance of single ground rod and two combined ground rods give capacitive. It was found that the effect of potential interference on the ground impedance is directly associated with the frequency-dependent ground impedance and is strong in low frequency. Also, in order to reduce the increasing rate of resultant ground impedance of two ground rods due to potential interference to within 10(%), two ground rods in parallel will be placed over one rod length apart.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.1A
• /
• pp.84-92
• /
• 2004

Eigenstructure-based adaptive beamfoming has advantages of fast convergence and the insentivity to errors in the arrival angle of the desired signal. Eigen-decomposing the sample matrix to extract a basis for the Sl (signal plus interference) subspace, however, is very computationally expensive. In this paper, we present a simple subspace based beamforming which utilizes off-diagonal elements of the sample matrix to estimate the Sl subspace. The outputs of overlapped subarrays are combined to produce the final adaptive output, which improves SINR (signal-to-interference-plus-noise ratio) comapred to exploiting a single subarray. The proposed adaptive beamformer, which employs an efficient angle estimation is very roubust to errors in both the arrival angles and the number of the incident signals, while the eigenstructure-based beamforer suffers from severe performance degradation.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1984.10a
• /
• pp.53-56
• /
• 1984

This paper shows that the error probabilities for coherent and noncoherent BF나 systems combined with FH in the presence of single channel tone interference. The performance is developed as functions of the signal to noise ratio and jamming to noise ratio. A specific results for two phases of ㅠ/4 and ㅠ/2 is obtained.

• Journal of Institute of Control, Robotics and Systems
• /
• v.20 no.9
• /
• pp.977-983
• /
• 2014

A repeat-back jamming signal is an intentionally re-broadcasted GNSS (Global Navigation Satellite System) interference. In this paper, a novel repeat-back jamming detection scheme is proposed. The proposed scheme uses a combined pseudo random noise signal (C-PRN) and is available for a generic GNSS receiver with a single antenna. The C-PRN signal is made by combining several received pseudo random noise signals that had been transmitted from the visible GNSS satellites. Through a Monte-Carlo simulation, the detection probability of a repeat-back jamming signal detected with the proposed scheme is presented.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.3
• /
• pp.484-490
• /
• 2016

Full-duplex communication can enhance wireless capacity by enabling simultaneous transmission and reception of the signals on the same frequency spectrum. Such a benefit, however, is only achieved when strong self-interference is well canceled below a sufficient level. To achieve this goal, there have been several approaches for cancellation, each of which is combined with digital-domain cancellation for a higher gain. In this paper, we implement two self-interference cancellation techniques and integrate them with a software defined radio-based wireless communication testbed. Two cancellation techniques (antenna cancellation and noise subtraction) are implemented and the cancellation gain is measured via real experiments. The results show that the gain of the antenna placement technique highly depends on the placement of a receiving antenna and the highest gain is achieved at the expected point, and we show that combining the noise subtraction circuit with the antenna placement further improves the cancellation gain.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.8
• /
• pp.2797-2820
• /
• 2015

In order to accommodate huge number of antennas in a limited antenna size, a large scale antenna array is expected to have a three dimensional (3D) array structure. By using the Active Antenna Systems (AAS), the weights of the antenna elements arranged vertically could be configured adaptively. Then, a degree of freedom (DOF) in the vertical plane is provided for system design. So the three-dimension MIMO (3D MIMO) could be realized to solve the actual implementation problem of the massive MIMO. However, in 3D massive MIMO systems, the pilot contamination problem studied in 2D massive MIMO systems and the inter-cell interference as well as inter-vertical sector interference in 3D MIMO systems with vertical sectorization exist simultaneously, when the number of antenna is not large enough. This paper investigates the interference management towards the above challenges in 3D massive MIMO systems. Here, vertical sectorization based on vertical beamforming is included in the concerned systems. Firstly, a cooperative joint vertical beams adjustment and pilot assignment scheme is developed to improve the channel estimation precision of the uplink with pilots being reused across the vertical sectors. Secondly, a downlink interference coordination scheme by jointly controlling weight vectors and power of vertical beams is proposed, where the estimated channel state information is used in the optimization modelling, and the performance loss induced by pilot contamination could be compensated in some degree. Simulation results show that the proposed joint optimization algorithm with controllable vertical beams' weight vectors outperforms the method combining downtilts adjustment and power allocation.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.22 no.2
• /
• pp.11-19
• /
• 2021

In this paper, we propose a non-orthogonal multiple access (NOMA) method based on channel alignment to simultaneously transmit multiple unicast and multicast streams in frequency-efficient manner. In this method, all receivers in a multicast cluster use the receive beamforming vectors that align their channels, and the base station uses the aligned channel information to design the transmit beamforming vectors that eliminate interference between multicast clusters. Using the effective receive channel information combined with the transmit beamforming vectors, unicast receivers design their own receive beamforming vectors that eliminate interference between unicast receivers. Since the proposed method effectively eliminates the interference, it achieves a higher sum rate than the existing orthogonal multiple access (OMA) method in high SNR regions. In addition, we present a hybrid method that exploits the benefits of the proposed NOMA method and the existing OMA method. Depending on the channel state, the hybrid method adaptively employs the existing OMA method, which improves the received signal power, in low SNR regions and the proposed NOMA method, which effectively eliminates the interference, in high SNR regions, thereby achieving a good sum rate over the entire SNR region.

• Carbon letters
• /
• v.24
• /
• pp.41-46
• /
• 2017

The microstructure, flexural properties, electrical conductivity, thermal conductivity and electromagnetic interference (EMI) shielding effectiveness (SE) of epoxy composites filled with multi-walled carbon nanotubes (CNTs), exfoliated graphite nanoplatelets (xGnPs) and CNT-xGnP hybrid filler were investigated. The EMI SE of the CNT-xGnP hybrid composite was higher than 25 dB at 100 MHz while that of the xGnP based composite was almost zero. The flexural modulus of the CNT-xGnP based epoxy composite continuously increased to 3.32 GPa with combined filler content up to 10 wt% while that of the CNT based epoxy composites slightly decreased to 1.96 GPa at 4 wt% CNT, and dropped to 1.57 GPa at 5 wt% loading, which is lower than that of epoxy. The CNT and CNT-xGnP samples had the same EMI SE at the same surface resistivity, because samples with the same surface conductivity have the same amount of the charge carriers.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.6
• /
• pp.1095-1102
• /
• 2010

This paper presents an equalizer reducing CCI(cell-to-cell interference) in MLC NAND flash memory. High growth of the flash memory market has been driven by two combined technological efforts that are an aggressive scaling technique which doubles the memory density every year and the introduction of MLC(multi level cell) technology. Therefore, the CCI is a critical factor which affects occurring data errors in cells. We introduced an equation of CCI model and designed an equalizer reducing CCI based on the proposed equation. In the model, we have been considered the floating gate capacitance coupling effect, the direct field effect, and programming methods of the MLC NAND flash memory. Also we design and verify the proposed equalizer using Matlab. As the simulation result, the error correction ratio of the equalizer shows about 20% under 20nm NAND process where the memory channel model has serious CCI.

• Journal of Korea Multimedia Society
• /
• v.16 no.5
• /
• pp.601-609
• /
• 2013

One of the most serious factors constraining the next generation cellular mobile consumer communication systems will be the severe co-channel interference experienced at the cell edge. Such a capacity-degrading impairment combined with the limited available spectrum resource makes it essential to develop more spectrally efficient solutions to enhance the system performance and enrich the mobile user's application services. This paper proposes a unique hybrid method of frequency hopping (FH) and subcarrier-reuse-partitioning that can maximize the system capacity by efficiently utilizing the available spectrum while at the same time reduce the co-channel interference effect. The main feature of the proposed method is that it applies an optimal combination of different frequency reuse factors (FRF) and FH-subcarrier allocation patterns into the partitioned cell regions. From the simulation results, it is shown that the proposed method can achieve the optimum number of subcarrier subsets according to the frequency-reuse distance and results in better performance than the fixed FRF methods, for a given partitioning arrangement. The results are presented in the context of both blocking probability and BER performances. It will also be shown how the proposed scheme is well suited to FH-OFDMA based cellular systems aiming at low co-channel interference performance and optimized number of subcarriers.