• Journal of the Society of Disaster Information
• /
• v.1 no.1
• /
• pp.3-26
• /
• 2005

In recent years, there is growing concern about the potential use of biological agents in war or acts of terrorism accompanied an increased realization that rapid preparedness and response are needed to prevent or treat the human damage that can be caused by these agents. The threat is indeed serious, and the potential for devastating numbers of casualties is high. The use of agents as weapons, even on a small scale, has the potential for huge social and economic disruption and massive diversion of regional and national resources to combat the threat, to treat primary disease, and to clean up environmental contamination. Biological weapons are one of weapons of mass destruction (or mass casualty weapons, to be precise. since they do not damage non-living entities) that are based on bacteria, viruses, rickettsia, fungi or toxins produced by these organisms. Biological weapons are known to be easy and cheap to produce and can be used to selectively target humans, animals, or plants. Theses agents can cause large numbers of casualties with minimal logistical requirements (in wide area). The spread of disease cannot be controlled until there is awareness of the signs of infection followed by identification of agents; and if the organism is easily spread from person to person, as in the case of smallpox, the number of casualties could run into the tens of thousands. Biological weapons could be used covertly, there can be a lot of different deployment scenarios. A lot of different agents could be used in biological weapons. And, there are a lot of different techniques to manufacture biological weapons. Terrorist acts that make use of Biological Agents differ in a number of ways from those involving chemicals. The distinction between terrorist and military use of Biological Weapon is increasingly problematic. The stealthy qualities of biological weapons further complicate the distinction between terrorism and war. In reality, all biological attacks are likely to require an integrated response involving both military and civilian communities. The basic considerations when public health agencies establish national defence plan against bioterrorism must be 1) arraying various laws and regulations to meet the realistic needs, 2)education for public health personnels and support of concerned academic society, 3)information collection and cooperative project with other countries, 4)Detection and surveillance(Early detection is essential for ensuring a prompt response to biological or chemical attack, including the provision of prophylactic medicines, chemical antidotes, or vaccines) and 5) Response(A comprehensive public health response to a biological or chemical terrorist event involves epidemiologic investigation, medical treatment and prophylaxis for affacted persons, and the initiation of disease prevention or environmental decontamination measures). The purpose of this paper is providing basic material of preparedness and response for biological terrorism in modern society.

• Korean Management Science Review
• /
• v.32 no.4
• /
• pp.109-133
• /
• 2015

This paper considers the allocation and engagement scheduling of air defense missiles by using MIP (mixed integer programming). Specifically, it focuses on developing a realistic MIP model for a real battle situation where multiple enemy missiles are headed toward valuable defended assets and there exist multiple air defense missiles to counteract the threats. In addition to the conventional objective such as the minimization of surviving target value, the maximization of total intercept altitude is introduced as a new objective. The intercept altitude of incoming missiles is important in order to minimize damages from debris of the intercepted missiles and moreover it can be critical if the enemy warhead contains an atomic or chemical bomb. The concept of so called the time window is used to model the engagement situation and a continuous time is assumed for flying times of the both missiles. Lastly, the model is extended to simulate the situation where the guidance radar, which guides a defense missile to its target, has the maximum guidance capacity. The initial mathematical model developed contains several non-linear constraints and a non-linear objective function. Hence, the linearization of those terms is performed before it is solved by a commercially available software. Then to thoroughly examine the MIP model, the model is empirically evaluated with several test problems. Specifically, the models with different objective functions are compared and several battle scenarios are generated to evaluate performance of the models including the extended one. The results indicate that the new model consistently presents better and more realistic results than the compared models.

• Journal of Distribution Science
• /
• v.15 no.1
• /
• pp.83-93
• /
• 2017

Purpose - After the transition, the development of defense industry in Eastern Europe has been regressed. Recently, they have internationally recognized that new products have been exported and contributed to the Innovation-Based Manufacturing of national economy such as unmanned reconnaissance aircraft, water purification technology, and mobile chemical laboratory, etc. The military forces in Eastern Europe are re-armed by the localization of self-produced munitions in their own defense industry, and then emphasize fostering their own defense industry. Thus, if they make a collaboration with other nations as a industrial cluster, it will gain a competitive edge on the defense industry. Research design, data, and methodology - The study was designed with the data of each national defense department. The research of the subject was reviewed before and after the transition. Thousands of workers have worked in defense industries before the transition, however, the defense industry and experts left after the transition. The Hungarian defense spending on GDP also dropped sharply from 1.72% in 2000 to 0.85% in 2013. But, due to the crisis in Ukraine and the crisis of Syrian refugees, the Viségrad Group (V4) member countries have also increased their interest in a defense and industries as well as the confidence in the EU and NATO. Results - On the whole, the joint of military training and purchase of defense materials were found in order to form the EU cooperative combat troops in CEE. There are the implementation of a joint manual plan for strengthening V4 security policy and the joint military exercises for V4 every year, and the others are electronic warfare and innovation of V4 national forces. Through such a performance analysis methodology, we found that the defense industry is developed through the national cluster cooperation among CEEs and spreading global distribution. Conclusions - Eastern Europe and Balkan countries have been looking forward to cooperating with the non-EU countries such as Korea and other defense industries. There are a lot of potential development into a new civilian cooperation defense industry for global-distribution. Thus, Korea should develop electronic commercial applications, not just as a weapon exporting region.

• KSBB Journal
• /
• v.17 no.2
• /
• pp.158-161
• /
• 2002

In this study, a prototype fiber-optic biosensor was fabricated using the inhibition of enzyme reaction by organophosphorus compounds to detect organophosphorus compounds, which is nervous toxic material an? is used as chemical weapon and pesticide. Enzyme, substrate, and inhibitor for enzyme reaction were acetylcholinesterase (key enzyme in nervous cell), acetylthiocholine iodide, and paraoxon (a kind of organophosphorus compounds), respectively. The detection principle of sensor is the detection of enzyme reaction inhibited by organophosphorus compounds by the quantitative measurement of acetic acid, which was achieved by absorbance measurement using litmus solution that maximum absorbance band is changed by pH. To fabricate prototype fiber-optic biosensor, high bright LED and photodiode was used as light source and light intensity detector, respectively. From the experimental results using a prototype biosensor, the linear change of sensor signal was obtained in a range of 0-2 ppm inhibitor concentrations. From these results, it was verified that the quantitative measurement of organophosphorus compounds could be achieved fast (within 2 minutes) and accurately by a prototype fiber-optic biosensor.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.40 no.4
• /
• pp.96-104
• /
• 2017

A one-shot system (device) refers to a system that is stored for a long period of time and is then disposed of after a single mission because it is accompanied by a chemical reaction or physical destruction when it operates, such as shells, munitions in a defense weapon system and automobile airbags. Because these systems are primarily related with safety and life, it is required to maintain a high level of storage reliability. Storage reliability is the probability that the system will operate at a particular point in time after storage. Since the stored one-shot system can be confirmed only through inspection, periodic inspection and maintenance should be performed to maintain a high level of storage reliability. Since the one-shot system is characterized by a large loss in the event of a failure, it is necessary to determine an appropriate inspection period to maintain the storage reliability above the reliability goal. In this study, we propose an optimal inspection policy that minimizes the total cost while exceeding the reliability goal that the storage reliability is set in advance for the one-shot system in which periodic inspections are performed. We assume that the failure time is the Weibull distribution. And the cost model is presented considering the existing storage reliability model by Martinez and Kim et al. The cost components to be included in the cost model are the cost of inspection $c_1$, the cost of loss per unit time between failure and detection $c_2$, the cost of minimum repair of the detected breakdown of units $c_3$, and the overhaul cost $c_4$ of $R_s{\leq}R_g$. And in this paper, we will determine the optimal inspection policy to find the inspection period and number of tests that minimize the expected cost per unit time from the finite lifetime to the overhaul. Compare them through numerical examples.

• The Korean Journal of Air & Space Law and Policy
• /
• v.25 no.2
• /
• pp.79-112
• /
• 2010

The Beijing Convention of 2010 taken together effectively establishes a new broader and stronger civil aviation security framework. This adoption would significantly advance cooperation in prevent of the full range of unlawful acting relation to civil aviation and the prosecution and punishment of offenders. First, the Beijing Convention of 2010 will require parties to criminalize a number of new and emerging threats to the safety of civil aviation, including using aircraft as a weapon and organizing, directing and financing acts of terrorism. These new treaties reflect the international community's shared effort to prevent acts of terrorism against civil aviation and to prosecute and punish those who would commit them. Second, this convention will also require States to criminalize the transport of biological, chemical, nuclear weapons and related material. These provisions reflect the nexus between non-proliferation and terrorism and ensure that the international community will act to combat both. Third, this Convention shall not apply to aircraft used in military, customs or police services. As a substitute, International Humanitarian Law will be applied in a case. Moreover, the National Jurisdiction and the application of the law will be extended farther. The treaty promotes cooperation between States while emphasizing the human rights and fair treatment of terrorist suspects.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.11 no.6
• /
• pp.123-132
• /
• 2012

Gas sensors has been used very differently that depending on following purposes; Automotive (exhaust gas, fuel mixture gas, oxygen, particulates), agriculture / food industry (fresh, stored, CO2, humidity, NH3, nitrogen oxide gas, organic gas, toxic gas emitted from pesticides and insecticides), industrial / medical (chemical gas, hydrogen, oxygen and toxic gases), military (chemical weapon), environmental measurements (CO and other air pollution consisting of sulfur and nitrogen gas), residential (LNG, LPG, butane, indoor air, humidity). The types of industrial toxic substances are known about 700 species and many of these exist in gaseous form under normal conditions. he multi-gas detection sensors will be developed for casualties that detect the most important and find easy three kinds of gases in marine plant; carbon dioxide(CO2), carbon(CO), ammonia(NH3). Package block consists of gas sensing device minor ingredient, rf front end, zigbee chip. Develope interworking technology between the sensor and zigbee chip inside a package. Conduct a performance test through test jig about prototype zigbee sensor module with rf output power and unwanted emission test. This research task available early address when poisonous gas leaked from large industrial site and contribution for workers' safety at the enclosed space.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.6
• /
• pp.525-538
• /
• 2014

Safety of reactive systems is one of the most important research areas in the field of weapon development. A NoGo response or at least a low-order explosion should be ensured to prevent unexpected accidents when the reactive system is impacted by high-velocity projectile. We investigated the shock-induced detonation of cased reactive systems subject to a normal projectile impact to the cylindrical surface based on two-dimensional hydrodynamic simulations using the I&G chemical rate law. Two types of energetic materials, namely LX-17 and AP-based solid propellant, were considered to compare the dynamic responses of the reactive system when subjected to the threshold impact velocity. It was found that shock-to-detonation transition phenomena occurred in the cased LX-17, whereas no full reaction occurred in the propellant.

• Journal of the Korea Society for Simulation
• /
• v.22 no.1
• /
• pp.9-20
• /
• 2013

Defense M&S for weapons effectiveness is a realistic way to support virtual warfare similar to real warfare. As the war paradigm becomes platform-centric to network-centric, people try to utilize smartphones as the source of sensor, and command/control data in the simulation-based weapons effectiveness analysis. However, there have been limited researches on integrating smartphones into the weapon simulators, partly due to high modeling cost - modeling cost to accomodate client-server architecture, and re-engineering cost to adapt the simulator on various devices and platforms -, lack of efficient mechanisms to exchange large amount of simulation data, and low-level of security. In this paper, we design and implement Smartphone Adaptor to utilize smartphones for the simulationbased weapons effectiveness analysis. Smartphone Adaptor automatically sends sensor information, GPS and motion data of a client's smartphone to a simulator and receives simulation results from the simulator on the server. Also, we make it possible for data to be transferred safely and quickly through JSON and SEED. Smartphone Adaptor is applied to OpenSIM (Open simulation engine for Interoperable Models) which is an integrated simulation environment for weapons effectiveness analysis, under development of our research team. In this paper, we will show Smartphone Adaptor can be used effectively in constructing a Live simulation, with an example of a chemical simulator.