• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.10
• /
• pp.822-827
• /
• 2000

The Si-SiO$_2$interface trap and nitride bulk trap distribution of SONOSFET(polysilicon-oxide-nitride-oxide-semiconductor field effect transistor) NVSM (nonvolatile semiconductor memory) cell is investigated by single junction charge pumping method. The device was fabricated by 0.35㎛ standard logic fabrication process including the ONO stack dielectrics. The thickness of ONO dielectricis are 24$\AA$ for tunnel oxide, 74 $\AA$ for nitride and 25 $\AA$ for blocking oxide, respectively. By the use of single junction charge pumping method, the lateral profiles of both interface and memory traps can be calculated directly from experimental charge pumping results without complex numerical simulation. The interface traps were almost uniformly distributed over the whole channel region and its maximum value was 7.97$\times$10$\^$10/㎠. The memory traps were uniformly distributed in the nitride layer and its maximum value was 1.04$\times$10$\^$19/㎤. The degradation characteristics of SONOSFET with write/erase cycling also were investigated.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.453-456
• /
• 1999

The Si-SiO$_2$interface trap and nitride bulk trap distribution of SONOSFET(polysilicon-oxide-nitride-oxide-semiconductor)NVSM(nonvolatile semiconductor memory) cell were investigated by single charge pumping method. The used device was fabricated by 0.35 7m standard logic fabrication including the ONO cell process. This ONO dielectric thickness is tunnel oxide 24 $\AA$, nitride 74 $\AA$, blocking oxide 25 $\AA$, respectively. Keeping the pulse base level in accumulation and pulsing the surface into inversion with increasing amplitudes, the charge pumping current flow from the single junction. Using the obtained I$_{cp}$-V$_{h}$ curve, the local V$_{t}$ distribution, doping concentration, lateral interface trap distribution and lateral memory trap distribution were extracted. The maximum N$_{it}$($\chi$) of 1.62$\times$10$^{19}$ /cm$^2$were determined.mined.d.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.331-331
• /
• 2012

With the NAND Flash scaling down, it becomes more and more difficult to follow Moore's law to continue the scaling due to physical limitations. Recently, three-dimensional (3D) flash memories have introduced as an ideal solution for ultra-high-density data storage. In 3D flash memory, as the process reason, we need to use poly-Si TFTs instead of conventional transistors. So, after combining charge trap flash (CTF) structure and poly-Si TFTs, the emerging device SONOS-TFTs has also suffered from some reliability problem such as hot carrier degradation, charge-trapping-induced parasitic capacitance and resistance which both create interface traps. Charge pumping method is a useful tool to investigate the degradation phenomenon related to interface trap creation. However, the curves for charge pumping current in SONOS TFTs were far from ideal, which previously due to the fabrication process or some unknown traps. It needs an optimization and the important geometrical effect should be eliminated. In spite of its importance, it is still not deeply studied. In our work, base-level sweep model was applied in SONOS TFTs, and the nonideal charge pumping current was optimized by adjusting the gate pulse transition time. As a result, after the optimizing, an improved charge pumping current curve is obtained.

• Transactions on Electrical and Electronic Materials
• /
• v.5 no.4
• /
• pp.148-152
• /
• 2004

The direct lateral profile and retention characteristics of locally trapped-charges in the nitride layer of the two-bit polysilicon-oxide-nitride-oxide-silicon (SONOS) memory are investigated by using the charge pumping method. After charges injection at the drain junction region, the lateral diffusion of trapped charges as a function of retention time is directly shown by the results of the local threshold voltage and the trapped-charges quantities.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.1
• /
• pp.34-39
• /
• 2014

This paper discusses the 3-level charge pumping (CP) method in planar-type Silicon-Oxide-High-k-Oxide-Silicon (SOHOS) and Silicon-Oxide-Nitride-Oxide-Silicon (SONOS) devices to find out the reason of the degradation of data retention properties. In the CP technique, pulses are applied to the gate of the MOSFET which alternately fill the traps with electrons and holes, thereby causing a recombination current Icp to flow in the substrate. The 3-level charge pumping method may be used to determine not only interface trap densities but also capture cross sections as a function of trap energy. By applying this method, SOHOS device found to have a higher interface trap density than SONOS device. Therefore, degradation of data retention characteristics is attributed to the many interface trap sites.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1992.05a
• /
• pp.82-85
• /
• 1992

In this study, charge pumping method was used to investigate the Si-SiO$_2$interface characteristics of the nonvolatile SNOSFET memory devices, fabricated using the CMOS 1 Mbit processes (1.2$\mu\textrm{m}$ design rule), with thin oxide layer of 30${\AA}$ thick and nitride layer of 525${\AA}$ thick on the n-type silicon substrate (p-channel). Charge pumping current characteristics with the pulse base level were measured for various frequencies, falling times and rising times. By means of the charge dynamics in a non-steady state, the average Si-SiO$_2$interface state density and capture cross section were determined to be 3.565${\times}$10$\^$11/cm$\^$-2/eV$\^$-1/ and 4.834${\times}$10$\^$-16/$\textrm{cm}^2$, respectively. However Si-SiO$_2$ interface state densities were disributed 2.8${\times}$10$\^$-11/～5.6${\times}$10$\^$11/cm$\^$-2/～6${\times}$10$\^$11/cm$\^$-2/eV$\^$-1/ in the lover half of energy gap.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2015.08a
• /
• pp.216.2-216.2
• /
• 2015

본 연구에서는 charge pumping method에서 사용되는 변수들의 변화를 이용하여 hot carrier stress가 MOSFET소자의 oxide내에서의 trap 분포에 어떤 영향을 미치는지에 대해서 연구하였다. trap 분포를 확인하기 위해 스트레스 전 후에 reverse bias와 주파수에 따른 trap의 양을 측정 하였다. 스트레스 전과 후에 reverse bias와 주파수가 감소할수록 trap이 증가하는 모습이 나타났고, 스트레스 후에는 전과 비교하여 전반적으로 trap의 양이 증가하였다. 또한, 스트레스 전과 후에 MOSFET소자의 trap density는 center region에서 $2.89{\times}$10^10에서 $1.64{\times}$10^10으로 감소하였고, drain region에서 $2.83{\times}$10^10에서 $5.26{\times}$10^10으로 증가한 것을 확인하였다. 이는 reverse bias와 주파수의 가변에 따라서 trap의 공간적 분포를 측정할 수 있다는 것을 의미한다.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.328.1-328.1
• /
• 2014

MOSFET degradation의 대부분은 hot-carrier injection에 의한 interface state (Dit)의 생성에서 비롯되며 따라서 본 연구에서는 신뢰성에 대한 한 가지 방법으로 Charge pumping method를 이용하여 MOSFET의 interface trap(Dit)의 변화를 측정하였다. 소스와 드레인을 ground로 묶고 게이트에 펄스를 인가한 후 Icp를 측정하여 Dit를 추출하였다. 온도를 293~343 K까지 5 K씩 가변했을 때 293K의 Icp(${\mu}A$)는 0.12 nA 313 K는 0.112 nA 343 K는 0.926 nA이며 Dit (cm-1/eV-1)는 $1.61{\times}10^{12}$ (Cm-2/eV-1) $1.49{\times}10^{12}$ (Cm-2/eV-1) $1.23{\times}10^{12}$ (Cm-2/eV-1)이다. 측정결과 Dit는 Icp가 높은 지점에서 추출되며 온도가 높아지게 되면 Icp전류가 낮아지고 Dit가 줄어드는 것을 볼 수 있다. 온도가 올라가게 되면 carrier들이 trap 준위에서 conduction band 위쪽에 이동하게 되어서 interface에 trap되는 양이 작아지게 된다. 그래서 이때 Icp를 이용해 추출한 Dit 는 실제로 trap의 양이 줄어든 것이 아니라 Thermal excess 현상으로 인해 측정되는 Icp의 양이 줄어든 것으로 분석할 수 있다.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1994.11a
• /
• pp.59-64
• /
• 1994

The Si-SiO$_2$interface trpas of the degraded short-channel SONOSFET memory devices were investigated using the charge pumping techniques. The degradation of devices with write/erase cycle appeared as the increase of the Si-SiO$_2$interface trap density. In order to determine the capture cross-section of the interface trap. I$\_$CP/-V$\_$GL/ characteristic curves were measured at different temperatures. Also, the spatial distributions of Si-SiO$_2$interface trap were examined by the variable-reverse bias boltage method.

• Transactions on Electrical and Electronic Materials
• /
• v.17 no.1
• /
• pp.25-28
• /
• 2016

We investigate the effect of interface states on the endurance of a charge trap flash (CTF) NOR array using charge pumping methods. The endurance test was completed from one cell selected randomly from 128 bit cells, where the memory window value after 10² program/erase (P/E) cycles decreased slightly from 2.2 V to 1.7 V. However, the memory window closure abruptly accelerated after 10³ P/E cycles or more (i.e. 0.97 V or 0.7 V) due to a degraded programming speed. On the other hand, the interface trap density (Nit) gradually increased from 3.13×10¹¹ cm⁻² for the initial state to 4×10¹² cm⁻² for 10² P/E cycles. Over 10³ P/E cycles, the Nit increased dramatically from 5.51×10¹² cm⁻² for 10³ P/E cycles to 5.79×10¹² cm⁻² for 10⁴ P/E cycles due to tunnel oxide damages. These results show good correlation between the interface traps and endurance degradation of CTF devices in actual flash cell arrays.