• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.515-516
• /
• 2008

We studied about new module technology to solve warpage problems that produce bending of cell in the LCD (Liquid crystal display). Characteristics of cell gap and glass bending of applying heat Panel's PAD part and cell at various temperature was investigated. When applies heat and compresses PAD party only in case of compressing COG(Chip on Glass), uniformity of cell gap that happen by glass bending by temperature of these compressing COG in the PAD party is decreased.

• Applied Science and Convergence Technology
• /
• v.24 no.5
• /
• pp.196-202
• /
• 2015

Human blood consists of 55% of plasma and 45% of blood cells such as white blood cell (WBC) and red blood cell (RBC). In plasma, there are many kinds of promising biomarkers, which can be used for the diagnosis of various diseases and biological analysis. For diagnostic tools such as a lab-on-a-chip (LOC), blood plasma separation is a fundamental step for accomplishing a high performance in the detection of a disease. Highly efficient separators can increase the sensitivity and selectivity of biosensors and reduce diagnostic time. In order to achieve a higher yield in blood plasma separation, we propose a novel fluid wing structure that is optimized by COMSOL simulations by varying the fluidic channel width and the angle of the bifurcation. The fluid wing structure is inspired by the inertial particle separator system in helicopters where sand particles are prevented from following the air flow to an engine. The structure is ameliorated in order to satisfy biological and fluidic requirements at the micro scale to achieve high plasma yield and separation efficiency. In this study, we fabricated the fluid wing structure for the efficient microfluidic blood plasma separation. The high plasma yield of 67% is achieved with a channel width of $20{\mu}m$ in the fabricated fluidic chip and the result was not affected by the angle of the bifurcation.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.42 no.11
• /
• pp.41-48
• /
• 2005

The crosstalk effects that can be observed in the very dee submicron semiconductor chips are due to the coupling capacitances between interconnect lines. The accuracy of the full-chip timing analysis is determined by the accuracy of the estimated propagation delays of cells and interconnects within the chip. This paper presents a CMOS cell driver model and delay calculation algerian capturing the crosstalk effects due to the coupling capacitances. The proposed model and algorithm were implemented in a delay calculation program and used to estimate the propagation delays of the benchmark circuits extracted from a chip layout. We observed that the average discrepancy from HSPICE simulation results is within $1\%$ for the circuits with a victim affected by $0\~10$ aggressors.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.2
• /
• pp.62-70
• /
• 1999

This paper introduces a possibility of a low-cost, high-resolution fingerprint sensor chip. The test chip is composed of $64{\times}256$ sensing cells(chip size : $2.7mm{\times}10.8mm$). A new detection circuit of charge sharing is proposed, which eliminates the influences of internal parasitic copacitances. This the reduced sensing-capacitor size enables a high resolution of 600dpi, using even conventional 0.6${\mu}m$ CMOS process. The partial fingerprint image captured therefrom are synthesized into a full fingerprint image with a image synthesis algorithm. The problems and possibilities of image synthesis technique are also analyzed and discussed.

• Proceedings of the IEEK Conference
• /
• 2002.07c
• /
• pp.2000-2003
• /
• 2002

In this paper, an IC chip of a cell- network type circuit constructed with 1-dimensional chaos circuits is reported. The circuit, is designed by sing switched-current (Sl) techniques. In the proposed circuit, by controlling connections of cells, an S- dimensional circuit (S ＝ 1, 2, 3,…) and a synchronization system can be constructed easily. Furthermore, in spite of faults of a few cells, the circuit can reconstruct above-mentioned systems only to change connections of cells. This feature will open up new vista for engineering applications which are used in a distance place such as space, deep sea, etc. since it is difficult to repair faults of these application systems. To investigate the characteristics of the circuit, SPICE simulations are performed. The VLSI chip is fabricated from the layout design using a CAD tool, MAGIC. The proposed circuit is integrable by a standard 1.2 $\mu\textrm{m}$ CMOS technology.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.11 no.6
• /
• pp.732-741
• /
• 2018

In order to maximize the usable capacity of a BMS (battery management system) that uses several battery cells connected in series, a cell balancing technique that equips each cell with the same voltage is needed. In the active cell balancing circuit using a multi-winding transformer, a balancing circuit that transfers energy directly to the cell (cell-to-cell) is composed of a PMOS switch and a gate driving chip for driving the NMOS switch. The TLP2748 photocoupler and the TLP2745 photocoupler are required, resulting in increased cost and reduced integration. In this paper, instead of driving PMOS and NMOS switching devices by using photocoupler, we proposed 70V BCD process based PMOS gate driving circuit, NMOS gate driving circuit, PMOS gate driving circuit and NMOS gate driving circuit with improved switching time. ${\Delta}t$ of the PMOS gate drive switch with improved switching time was 8.9 ns and ${\Delta}t$ of the NMOS gate drive switch was 9.9 ns.

• Journal of Microbiology and Biotechnology
• /
• v.16 no.8
• /
• pp.1229-1235
• /
• 2006

A lab-on-a-chip (LoC) was designed for simultaneous monitoring of microorganisms, antibiotic residues, somatic cells, and pH in raw milk. The LoC was fabricated from polydimethylsiloxane (PDMS) using microelectromechanical system (MEMS) technology, which consisted of two parts; a protein array and microchannel. The protein array was fabricated by immobilizing five types of antibodies corresponding to two microorganisms, two antibiotic residues, and somatic cells. A sol-gel film was deposited on a glass substrate to immobilize the antibodies. The target analytes in raw milk could be bound with the corresponding antibody by an immunoreaction, and the antigen-antibody complex was detected using fluorescence microscopy. SNARF-dextran was used as a pH indicator, and the SNARF-entrapped hydrogel was attached to the microchannel in the chip. After injecting the milk sample into the channel, the pH was measured by monitoring the change in fluorescence intensity by fluorescence microscopy. The on-chip simultaneous assay of two microorganisms (E. coli O157:H7 and Streptococcus agalactiae), two antibiotic residues (penicillin G and dihydrostreptomycin), and neutrophils was successfully accomplished using the proposed LoC system.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.10
• /
• pp.186-194
• /
• 1996

The SliM (sliding memory plane) array processor has been proposed to alleviate disadvantages of existing mesh-connected SIMD(single instruction stream- multiple data streams) array processors, such as the inter-PE(processing element) communication overhead, the data I/O overhead and complicated interconnections. This paper presents the deisgn and implementation of SliM image processor ASIC (application specific integrated circuit) chip consisting of mesh connected 5 X 5 PE. The PE architecture implemented here is quite different from the originally proposed PE. We have performed the front-end design, such as VHDL (VHSIC hardware description language)modeling, logic synthesis and simulation, and have doen the back-end design procedure. The SliM ASIC chip used the VTI 0.8$\mu$m standard cell library (v8r4.4) has 55,255 gates and twenty-five 128 X 9 bit SRAM modules. The chip has the 326.71 X 313.24mil$^{2}$ die size and is packed using the 144 pin MQFP. The chip operates perfectly at 25 MHz and gives 625 MIPS. For performance evaluation, we developed parallel algorithms and the performance results showed improvement compared with existing image processors.

• Journal of Microbiology and Biotechnology
• /
• v.22 no.2
• /
• pp.226-229
• /
• 2012

Bacterial hemoglobin from Vitreoscilla (VHb) is recognized as a good fusion protein for the soluble expression of foreign protein. In this study, we generated a monoclonal antibody (MAb) against VHb for its detection. For the rapid screening of MAb, a protein chip technology based on the Alexa-488 (A488) dye labeling method was introduced. In order to fabricate the chip, the VHb protein was chemically coupled to the chip surface and then the culture supernatants of 84 hybridoma cell lines were spotted onto the VHb chip. The bound MAbs were measured by A488-modified anti-mouse IgG. A single spot (MAb A10) exhibited significantly high signal intensity. The immunoblot analysis evidenced that the MAb A10 can detect VHb-fused proteins with high specificity.

• 한국생물공학회:학술대회논문집
• /
• 2005.10a
• /
• pp.737-738
• /
• 2005