• 한국토양환경학회지
• /
• 제3권1호
• /
• pp.83-92
• /
• 1998

본 연구는 가스 포집관을 설치한 쓰레기 매립지에서의 가스 유동에 따른 모델 해석으로 부터 다음의 결과를 얻었다. 1) 저항이 없는 유량 계측기의 오차는, 투기계수 $10^{-14}$ $m^{2}$(실트; 포화투수계수 $10^{-7}$ m/s)보다 작은 복토를 쓰고 가스 발생량을 계측한다면, \circled1 직경 l0m 내에서는 0.5 mL/s 이상, \circled2 직경 20m 내에서는 2mL/s 이상, \circled3 직경 50m 내에서는 10 mL/s 이상의 유량범위에서, 정확한 계측치를 얻을 수 있다. 2)복토층의 \circled1투기계수가 $10^{-16}$$m^{2}$(점토; 포화투수계수 $10^{-9}$( m/s)에서는, 3종(bubblemeter, water head indicator and rotor meter)의 유량 계측기 모두 50m까지 유효한 계측이 가능하다. \circled2투기계수가 1$10^{-14}$$m^{2}$에서는, bubble meter and water head indicator는 5m 이하, rotor meter는 15m 내의 범위에서 유효한 계측이 가능하다. \circled3투기계수가 $10^{12}$$m^{2}$에서는 가스 포집관의 2m범위 이내에서만 유효히 계측된다. 3) 가스 포집관에 유량 계측기를 설치하면, 계측조건의 변화로 정상조건까지의 도달시간은 bubble meter와 water head indicator는 약 1일, roter meter는 약 1시간 정도가 소요된다.

• 한국군사과학기술학회지
• /
• 제14권1호
• /
• pp.55-61
• /
• 2011

This paper presents bubble wake measurement results generated by the planing hull. The bubble was generated by SNAME TMB model(No. 4876) with hard chine at the CWC(Circulating Water Channel). ABS(Acoustic Bubble Spectrometer) was used to measure bubble wake measurement. The manufactured model is one meter in length and uniform velocity to generate the bubble at CWC is 3m/s, relatively higher speed than conventional hull form. Measurements were performed successfully and measured results show well the general characteristics of bubble wake generated by planing hull. Furthermore, experimental equations are proposed for the practical use.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2008년도 추계학술대회B
• /
• pp.2310-2315
• /
• 2008

In this paper, study on performance analysis of bubble pump on the domestic solar water heater system is presented. Device of this experiment is consisted of bubble pump, solar collector and heat exchanger. At the mean time, this system have attached temperature sensors and pressure sensors at bubble pump. In addition, the flow meter was installed at outlet of heat exchanger. And then result of experimental study, average value of the heat exchange amount in heat exchanger was about 7.9kcal/hr, the maximum value of the heat amount in water tank($0.4m^3$) was 489.7kcal/hr and the maximum value of the mass flow rate in bubble pump was about $0.5{\ell}/min$.

• 한국안전학회지
• /
• 제32권1호
• /
• pp.75-81
• /
• 2017

A series of laboratory experiments has been performed in order to investigate the behavior of water-air two-phase flow in a horizontal pipe. A conductivity meter has been applied to detect the irregular alternation of air at the specific points in flows. The experimental condition has been established according to the water and air flowrates. Passing time, which is the time length for a measuring probe to pass through the entire length of a specific bubble, has been defined to evaluate the size of bubbles in the flow. Passing length, which can be considered as the equivalent value to bubble size and determined from the product of passing time and cross-sectional averaged velocity, and its corresponding occurrence frequency have been analyzed to classify the air flow patterns according to the condition of air and water fluxes. From the result, the dependancy of flow patterns on the variation of air-water flux ratio has been investigated and the existence of thresholds also checked for classifying the behavior of air in the flow.

• 멤브레인
• /
• 제26권1호
• /
• pp.38-42
• /
• 2016

올레핀/파라핀 혼합 기체의 분리를 위한 올레핀 촉진 수송 분리막의 제조를 위해 amide 작용기를 가지며 glassy한 특성을 보이는 polyvinylpyrrolidone (PVP) 고분자를 분리막의 matrix로서 사용하였다. 분리막의 기체 투과 실험은 propylene과 propane 50 : 50의 부피비로 혼합된 기체를 사용하였고, bubble meter와 gas chromatography를 사용해 투과도와 선택도를 측정하였다. 또한 SEM image와 FT-IR을 통해 막의 특성을 조사하였다. 100시간의 장시간 성능 측정 결과 선택도는 약 15, 투과도는 약 1.3 GPU 이상을 각각 유지하였다. 기존의 poly(2-ethyl-2-oxazoline) $(POZ)/AgBF_4/Al(NO_3)_3$ 분리막과 비교함으로써, 고분자 matrix로서의 PVP 특성을 확인하였다.

• 한국수자원학회논문집
• /
• 제48권7호
• /
• pp.535-543
• /
• 2015

기포가 포함된 다상흐름의 측정은 중요함에도 불구하고 많은 제약이 있었다. 특히, 공극률이 높은 다상 흐름은 밀도차의 급격한 변화와 두꺼운 공기-물 경계면으로 인해 측정이 매우 어렵다. 본 연구에서는 공극률에 상관없이 기포흐름을 측정할 수 있는 기포영상유속측정법과 다발 광섬유유동측정계를 소개하고자 한다. 기포영상측정기법의 경우, 화상측정시 발생하는 원근에 의한 오차를 최소화하고 추정할 수 있는 피사계 심도에 대한 계산방법을 제시하여 정도 분석을 위한 방안을 제시하였다. 다발 광섬유유동측정계는 얇은 광섬유의 특성을 이용해 다발로 제작하여 측정률을 증가시키고자 하였다. 제시된 두 기법을 기포플룸에 적용하여 신뢰도를 검토하였으며 잘 일치하는 것을 확인하였다. 소개된 기법으로 대표적인 하천 다상흐름인 도수흐름을 측정하여 그 적용성을 검토하였다.

• 국제초고층학회논문집
• /
• 제12권3호
• /
• pp.195-201
• /
• 2023

This paper reviews the history of the birth and development of the skyscraper in Japan, mainly from the perspective of the legal system, and presents the following points: 1) After 1919, building height was limited to 31 m or less, which continued after the war and defined the skyline of Japan's major cities; 2) The 31-meter height limit became a problem during rapid economic growth. With the development of tall building construction technology, the height limit was eliminated, and skyscrapers were born in Japan in the 1960s; 3) Later, the number of skyscrapers increased more rapidly in the post-bubble period after the collapse of the bubble economy in the 2000s than in the boom years of the 1980s, when the floor-area ratio was relaxed for economic uplift and urban renewal. The number of skyscrapers increased rapidly against the backdrop of the deregulation of the floor-area ratio.

• 대한환경공학회지
• /
• 제34권11호
• /
• pp.772-779
• /
• 2012

본 연구에서는 원뿔형으로 개발된 미세기포형 산기관의 성능향상을 위하여 운용적 측면에서 실험과 전산모사적 방법을 이용하였다. 산기관 잠김깊이의 변화에 대해 성능실험이 용이한 실증 규모의 타워형 생물반응기에 산기관을 장착하여, 잠김깊이가 표준산소전달계수($K_{L}a_{20}$) 및 표준산소전달효율(SOTE) 등 산소전달 성능에 미치는 영향을 실험적으로 연구하였다. 또한, 2상 유동에 관한 유체역학적 전산모사를 이용하여 산기관 수와 잠김깊이에 대한 유동현상을 파악함으로써 산소전달 성능변화에 대한 원인을 규명하였다. 산소전달 성능실험결과, 산기관의 잠김깊이를 6 m에서 12 m로 증가시킴에 따라 표준산소 전달계수는 7% 증가하였으나 표준산소전달효율은 39~72% (5.6 %/m)로 대폭 상승하였다. 유동 해석결과, 산기관의 수가 증가함에 따라 공기 체적분율 및 공기와 시험수의 유속 모두 증가하였으며, 공기와 시험수의 유속 경향은 유사하게 나타났다. 잠김깊이가 증가함에 따라서 공기 체적분율, 공기 및 시험수의 유속은 조금씩 감소하는 경향을 나타냈다. 선회 병류유동은 기포류의 확산과 상승속도를 결정하는 주요 인자로서 선회강도가 과도하게 큰 경우에는 기포 체류시간과 체류량이 감소되므로 산소전달 성능을 저하를 예측할 수 있었다.

• 정보기술과데이타베이스저널
• /
• 제6권2호
• /
• pp.115-130
• /
• 1999

The price structure of housing market varies depending upon market price policy rather than low or high price policy because of IMF. The object of this study is to develop an analysis system for analyzing housing market and its demand. The analysis system consists of four major categories: macro index analysis, market decision analysis, housing market analysis, and consumer analysis. We model each category by using a variety of techniques such as generalized linear model, categorical analysis, bubble analysis, drill-down analysis, price sensitivity meter analysis, optimum price index analysis, profit index measurement analysis, correspondence analysis, conjoint analysis, and multidimensional scaling analysis. Seoul apartment data is analyzed to demonstrate the practical usefulness of the system.

• 한국산업보건학회지
• /
• 제24권4호
• /
• pp.492-500
• /
• 2014

Objectives: The purpose of this study is to estimate the applicability of regional sample collection of environmental samples. The concentration of asbestos fibers were analyzed with two devices. One was an existing commercial air sampling pump that has been proved to be accurate and exact, and the other is a remodeled pump for sample collection which was made from an electric bubble generator originally designed for aquarium fish. Samples were collected with the two devices under the same environmental conditions and collection equipment. A comparative analysis of the concentration of ambient asbestos fiber was then performed. Methods: Based on previous research, six farmhouses with asbestos fiber slate roofs known to have high concentrations of asbestos fiber were selected. Using the existing commercial air sampling pump and the remodeled electric bubble generator, four to seven samples were collected each day one meter downwind from the edge of the slate roof at high volume (about 4 L/min) and low volume (about 1.4 L/min). The analyzer responsible for sample quality control of asbestos fibers counted the number of asbestos fibers with a phase microscope. Results: The rates of flow change of the existed sampler and the remodeled pump at high volume were 0.82% and 0.17%, respectively. The rates of flow change at low volume were 3.83% and 1.09%, but there was not significant difference. The rates of flow change are within the error range (${\pm}5%$) of OSHA analyzing methods. For the high volume sampler, the average asbestos fiber concentration in the air collected by the existed sampler is 6.270 fibers/L and for the remodeled one 5.527 fibers/L, not a significant difference. For the low volume sampler, the average asbestos fiber concentration in the air collected by the existed sampler is 7.755 fibers/L and for the remodeled one 7.706 fibers/L, not a significant difference. The total area of the slate roof of the targeted farmhouse has an effect on the concentration of asbestos fibers in the air from the existing pump and the remodeled one (p<0.01). Conclusions: The sampling function between the existing commercial pump and the remodeled one shows little difference. Therefore, the remodeled pump is considered a pump with a good availability for collecting ambient air asbestos samples.