• Structural Engineering and Mechanics
• /
• v.81 no.1
• /
• pp.59-68
• /
• 2022

Prestressed prefabricated hollow core concrete slabs with spans of 5 m and 10 m are commonly used since last century and still in service due to the advantage of construction convenience and durability. However, the end slabs are regularly subjected to cracks at the top and fail with brittleness due to the asymmetric boundary conditions. To better maintain such widely used type of hollow core slabs, the effect of asymmetric constraint in the end slabs are systematically studied through detailed nonlinear finite element analyses and experimental data. Experimental tests of slabs with four prestressed tendons and seven prestressed tendons with different boundary conditions were conducted. Results observe three failure modes of the slabs: the bending failure mode, shear and torsion failure mode, and transverse failure mode. Detailed nonlinear finite element models are developed to well match the failure modes and to reveal potential damage scenarios with asymmetric boundary conditions. Recommendations regarding ultimate capacity of the slabs with asymmetric boundary conditions are made to ensure a safe and rational design of prestressed concrete hollow slabs for short span bridges.

• Ocean and Polar Research
• /
• v.24 no.3
• /
• pp.189-196
• /
• 2002

A multichannel seismic survey was conducted in the southern Ayu Trough which is the only spreading boundary between the Philippine Sea and Caroline plates. The seismic system used in this study comprises of 2.46-l sleeve gun and a 12-channel streamer with a group interval of 6.25m. Migration technique was used to analyze seismic velocity, and poststack depth migration was applied to the stacked data. The sediment thickness obtained from the depth section tends to increase with distance from the spreading axis. Sedimentation rates are poorly constrainted in the study area. The apparent half-spreading rates estimated from the sediment thickness and sedimentation rate from DSDP hole on the caroline plate are 4.7mm/yr and 7.9mm/yr at $1^{\circ}24'N\;and\;0^{\circ}42'N$, respectively, which are fester than Previously suggested. On the basis of new oblique spreading geometry, the recalculated spreading rates are 5.4mm/yr and 9.1mm/yr at $1^{\circ}24'N\;and\;0^{\circ}42'N$, respectively. Seismic sections show that the topography is asymmetric across the Ayu Trough and the acoustic basement is rough. These features are consistent with the earlier suggestion that the Ayu Trough is a slow-spreading divergent boundary. A detailed examination of seismic profiles away from the axis shows that sediments can be divided into two layers which implies a possible change in the spreading rate anuor sedimentation condition during the formation of the trough.

• Journal of Environmental Impact Assessment
• /
• v.22 no.5
• /
• pp.455-466
• /
• 2013

The aim of this study is to seek application plans of National Ecosystem Survey database based on comparison and examination of feasible analysis methods for distribution characteristics of alien plants. In order to set up a correlation analysis method between alien plants and environmental factors, we had reviewed the 3rd National Ecosystem Survey guide book and consequently, two kinds of analysis method were tested. One was 1/25,000 scale map boundary based analysis and the other was representative mountain area based analysis. In this study we restricted the research area to select reliable surveyed database from whole "2011 National Ecosystem Survey flora database" according to two major criteria. First, an area defined by 1/25,000 scale map boundary and representative mountain area where the number of surveyed flora records should be within top 20%. Second, land cover map should also be built up inside that area. As a result, 25 map boundaries and 25 representative mountain areas were extracted to be analyzed. To limit a boundary for every representative mountain area we had analyzed distribution of environmental factors around that area by manual inspection with SPOT-5 remote sensed satellite image then designated 3km buffer zone from each alien plant location in that area. After then, naturalized index (NI) and urbanized index (UI) was calculated and correlations analysis was carried out. With the result of correlation analysis by map boundary only agricultural land area showed significant value of r (0.4~0.6, correlated) and the rest of factors did not. In the case of representative mountain area, the result showed that agricultural land, road and forest area showed significant value of r (0.6~0.8, highly correlated) which was corresponding to existing researches. Therefore, representative mountain area based method is preferable when using the alien plants database of National Ecosystem Survey for species distribution analysis. And also, considering the way of database utilization is strongly suggested at the first stage of survey planning for promoting active use of national ecosystem survey database.

• Knowledge Management Research
• /
• v.20 no.1
• /
• pp.133-153
• /
• 2019

Due to the uncertainty of dynamic business environment, modern organizations have been giving attention to dynamic capabilities beyond traditional notion of core competence. Among them, absorptive capacity and boundary-spanning activity are considered the most important. The former refers to activities regarding acquisition, assimilation, transformation and exploitation of internal and external knowledge. The latter is composed of boundary-loosening and boundary-tightening activities to detect internal or external information and then to preserve, protect, or acquire resources. Thus, both have achieved wide recognition as a potential source of change and innovation. This study investigated the cross-level relation between boundary-spanning leadership at team level and absorptive capacity at individual level. We also explored self-efficacy and extra-role behavior that can affect employees' absorptive capacity. To test multi-level analysis, the survey data were collected from 862 members in 137 teams of different firms. Results revealed that boundary-spanning leadership had the positive cross-level impact on absorptive capacity in the team context. Moreover, absorptive capacity was positively associated with self-efficacy and extra-role behavior at individual level. Based on these findings, we provided theoretical and practical implications to address rapidly changing environments and discussed limitations of this paper for further research.

• Economic and Environmental Geology
• /
• v.30 no.4
• /
• pp.363-369
• /
• 1997

As a part of the study to know the deep geological structure of the Ogcheon Zone. gravity survey is performed along the survey line of which direction is roughly perpendicular to major faults of the Zone. Recent studies for petrology. geochemistry. and structural geology in south-western Ogcheon Zone are outlined. Raw gravity data are corrected to obtain Bouguer anomalies and the anomalies are interpreted to obtain subsurface structures along the survey line. The subterranean density discontinuities determined from the power spectrum method are appeared at depths of 15.4 km and 2.8 km. It is considered that the depth of 15.4 km indicates the boundary between upper and lower crust. Probably the depth of 2.8 km represents the boundary between upper volcanic formations and granites. Alternatively. the observed Bouguer anomalies are interpreted in terms of lateral density variation model. Finally. the subterranean geological structure to satisfy the Bouguer anomalies is presented through the iterative forward method in which results obtained from surface geological informations and from the inverse method are adopted as an initial model.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.11
• /
• pp.7855-7862
• /
• 2015

Cadastral map information is created by registering parcel information such as location, lot number, land category and boundary through the cadastral survey. However, with regard to boundary point coordinate, computerized cadastral information data was registered to either two decimal places (unit in centimeter) or three decimal places (unit in millimeter) so that a confusion in cadastral administration and cadastral survey has been caused. Therefore, the purpose of this study is to look for a method of matching two different coordinate systems through the consideration of registration of cadastral information data and area calculation. In conclusion, the result of the investigation not only shows that areal change and the creation of minute polygons resulted from land alteration could be solved by changing boundary point coordinate from two decimal places to three decimal places, but also suggests that the related laws and regulations to register boundary point coordinate to three decimal places should be institutionally corrected and applied.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.32 no.spc4_2
• /
• pp.393-400
• /
• 2014

"Master Plan of Cadastral Resurvey Project" aims to put the governmental budget of 1.3 trillion Won into the cadastral resurvey project until 2030 that reflects the preliminary feasibility study, conducted by government at 2012. The cadastral Resurvey, which takes 78.8% of the expenses in the project, has to take an critical role for earning the most effective results from the project. The cadastral confirmation surveying take up almost 13% of the project and is controlled under the areal SOC(Social Overhead Capital) projects in current "Master Plan of Cadastral Resurvey Project". Also, the affiliations of cadastral resurvey and linear SOC projects are expected to bring advanced results, although those are excluded from cadastral confirmation surveying. For linear SOC projects, the land division survey is conducted by using boundary stakes in boundary survey, while the cadastral resurvey is conducted within the SOC project area, after the completion of the project. In this study, we could conclude that cadastral resurvey results with the world geodetic system from boundary survey at the point of land division could be produced without the duplication of land division and cadastral resurvey. As a result, the expected benefits are 73,877 parcels and 4,078 million won, annually.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.11a
• /
• pp.577-584
• /
• 2000

Seismic refraction survey was peformed for 10 lines along NE-SW and NW-SE directions above Nampoong gallery at Makyo-ri, Dogye, Samcheok, Kangwon-do. 48 geophones were laid in line with the interval of 1m, and a 5Kg hammer was used as a source at 5 points for each line. Data processing was done using reciprocal time method, GRM, and traveltime tomography which utilizes wavefront expansion method for forward process and SIRT for inversion. The result shows that the first layer has its lower boundary between 3.49m and 8.88m. The P-wave velocity of the first and the second layer were estimated as 270 360m/s and 1550 1940m/s respectively. When the boundary of the first and second layer is smooth enough and the velocity difference is large enough, GRM has little advantage over reciprocal time method. The result of reciprocal method and traveltime tomography shows consistency. The northeast part of the boundary has syncline structure, which is similar to the topography above. This implies that the collapse of the cavities of Nampoong gallery result in the subsidence of the ground surface. The subsidence is in progress across the Youngdong railroad, therefore a proper reinforcement work is required.

• Journal of Digital Convergence
• /
• v.11 no.1
• /
• pp.191-198
• /
• 2013

The interests in alternative office systems and solutions (called smart work in Korea) are growing. With the lens of boundary theory, this paper tries to understand the nature of work/nonwork boundaries which smart work will be expected to blur. Boundary theory provides permeability, boundary strength, and interference as its key concepts and an empirical study is performed about the individual perception on those concepts. The result of the survey from telecommuters and/or smart work center users at the Company K shows that they perceive work/nonwork permeability, boundary strength, and interference are asymmetric. The result suggests that asymmetric nature of the work/nonwork boundaries should be taken into account when alternative office systems are brought into use.

• Journal of IKEEE
• /
• v.25 no.4
• /
• pp.650-663
• /
• 2021

Subsurface topology estimation is an important factor in the geophysical survey. Electrical impedance tomography is one of the popular methods used for subsurface imaging. The EIT inverse problem is highly nonlinear and ill-posed; therefore, reconstructed conductivity distribution suffers from low spatial resolution. The subsurface region can be approximated as piece-wise separate regions with constant conductivity in each region; therefore, the conductivity estimation problem is transformed to estimate the shape and location of the layer boundary interface. Each layer interface boundary is treated as an open boundary that is described using front points. The subsurface domain contains multi-layers with very complex configurations, and, in such situations, conventional methods such as the modified Newton Raphson method fail to provide the desired solution. Therefore, in this work, we have implemented a 7-layer artificial neural network (ANN) as an inverse problem algorithm to estimate the front points that describe the multi-layer interface boundaries. An ANN model consisting of input, output, and five fully connected hidden layers are trained for interlayer boundary reconstruction using training data that consists of pairs of voltage measurements of the subsurface domain with three-layer configuration and the corresponding front points of interface boundaries. The results from the proposed ANN model are compared with the gravitational search algorithm (GSA) for interlayer boundary estimation, and the results show that ANN is successful in estimating the layer boundaries with good accuracy.