• 한국재료학회지
• /
• 제4권3호
• /
• pp.268-279
• /
• 1994

단일상을 갖는 $Bi_2S_2CaCu_2O_{8+x}$ (2212)의 x-ray 분말 pattern을 a=5.408, c=30.83 $\AA$의 격자상수 및 역격자 벡터 $q^*=0.211b^*-c^*$을 갖는 pseudo tetragonal subcell을 이용하여 모두 index하였다. 임계온도 110K를 갖는 $Bi_2S_2CaCu_2O_{10+x}$ 상은 incommensurate supercell에 속하는 매우 많은 x-ray분말선들을 가지고 있다. Indixing guide로 전자회절사진(electron diffraction photographs)을 이용 x-ray분말 pattern에 대한 지수결정방법을 얻었다.$Bi_2S_2CaCu_2O_{10+x}$(2223)의 단위세표(unit cell)는 기하학적으로 격자상수 a=5.411, b=5.420, c=37.29(2) A을 갖는 orthorhombic subcell이다. Supercell반사 지수들은 subcell의 파 벡터 $\pm q^*=0.211b^*-0.78c^*$을 갖는 k,1지수로부터 영향을 받은 것이다. b 방향으로의 inconnensurate성분 $\delta$는 두 상에 대해 다 같으나, 2212에서 2223 상으로의 변환에 따라 c 방향으로의 초격자성분(superlattic component)은 connensurate($\varepsilon$=1)로부터 incommensurate($\varepsilon$=0.78)로 변한다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 Vol.19
• /
• pp.390-391
• /
• 2006

A high Tc superconducting with a nominal composition of $Bi_2Sr_2Ca_2Cu_3O_y$ was prepared by the citarte method. The solid precursor produced by the dehydration of the gel at $120^{\circ}C$ for 12h is not in the amorphous state as expected but in a crystalline state X-ray diffraction peaks of nearly the same angular position as the peaks of high Tc phase were observed in the precursor. After pyrolysis at $400^{\circ}C$ and calcination at $840^{\circ}C$ for 4h, the (001)peak of the high Tc phase was cleary observed. Experimental results suggest that the intermediate phase formed before the formation of the superconducting phase may be the most important factor in determining whether it is easy to form the high Tc phase or not, because the nucleation bafflers of the two superconducting phase may be altered by the variation of the crystal structures of those Intermediate phase.

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2001년도 학술대회 논문집
• /
• pp.84-88
• /
• 2001

The optimum cross-sectional area Profile of gas-cooled high-temperature superconductor (HTS) current lead is analyzed to have minimum helium boil-off rate. The conventional constant area HTS lead has much higher helium consumption than the optimum HTS lead considered in this study. The optimum HTS lead has variable cross-sectional area to have constant safety factor. An analytical formula of optimum shape of lead and temperature profile are obtained. For multi-step HTS current leads, the optimum tape lengths and minimum heat dissipation rate are also formulated. The developed formulations are applied to the Bi-2223 material, and the differences between constant area, constant safety-factor, and multi-step current leads are discussed.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 2000년도 High Temperature Superconductivity Vol.X
• /
• pp.280-284
• /
• 2000

The prototype high-T$_c$ superconducting (HTS) power transmission cables have been designed and fabricated multi layers of spirally wound HTS tapes. The cables were made Bi-2223 based Ag-sheathed HTS tapes, and tested in LN$_2$. Critical currents of 700A dc and better were achieved. The magnetic flux density and field direction were analyzed in the cable configuration. In this paper the results of analysis and tests of HTS power transmission cables were described.

• Progress in Superconductivity
• /
• 제7권1호
• /
• pp.22-27
• /
• 2005

We have studied the standardization of critical temperature measurements by using an ac susceptometer. Wire forms of NbTi, $Nb_{3}Sn$, and Bi-2223 superconductors were prepared to measure the temperature dependences of the magnetization. In order to study the optimum ac magnetic field and frequency, various amplitudes from 2 Oe to 10 Oe with frequencies from 11.3 Hz to 1033 Hz were applied to three specimens. Analytical comparison of the magnetic curves with the resistive curves was accomplished to investigate validity of using the new method.

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2000년도 KIASC Conference 2000 / 2000년도 학술대회 논문집
• /
• pp.69-72
• /
• 2000

AC losses in multifilamentary HTS tapes can be classified to hysteresis loss, coupling loss, and eddy current loss from the viewpoint of their generation mechanism. From the viewpoint of the major magnetic field component generating them, they can be classified to magnetization loss, transport loss, and total loss. Dividing superconductor to fine filaments, twisting filaments bundle and increasing transverse resistivity are effectively reduce magnetization loss and total loss when the external magnetic field is relatively large. Recently, twisted multifilamentary Bi 2223 tapes with pure silver matrix were fabricated and the reduction of magnetization loss was proved experimentally in the parallel magnetic field to the tape wide face. However, when the perpendicular magnetic field is applied, increasing transverse resistivity is required essentially to reduce the AC losses. The transverse resistivity was increased successfully by the introduction of resistive barrier between filaments.

• Transactions on Electrical and Electronic Materials
• /
• 제2권2호
• /
• pp.42-45
• /
• 2001

An ozone condensation system is evaluated from the viewpoint of an ozone supplier for Bi-superconductor thin film growth. An ozone condenser by a selective adsorption on the silica gel surface is constructed. Ozone density is evaluated by three methods; ultraviolet absorption, thermal decomposition and Q-mass analyzing methods. Thermal decomposition method is found to be available to the density evaluation from dilute to highly condensed ozone. The highest ozone density condensed by the adsorption method is evaluated to be 97 mol%.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 2002년도 High Temperature Superconductivity Vol.XII
• /
• pp.78-78
• /
• 2002

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 춘계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.9-11
• /
• 2001

현 단계에서도 임계전류밀도가 약 $100A/mm^2$로 충분히 높아 전력분야 응용이 기대되는 Bi-2223테이프에 대한 교류손실을 초전도 전력기기의 실제 상황을 고려하여 측정하였다. 중요한 평가 결과로서는 먼저 통전손실 특성은 외부 교류자장의 세기뿐만 아니라 방향에 따라서도 매우 상이하였으며, 비교적 외부자장이 큰 경우는 동저항손실 메카니즘이, 작은 경우는 그 외의 또 다른 손실 메카니즘이 지배적이었다. 또한 수평자장에 대한 자화손실 특성은 코아 모델로부터 계산된 손실과 비교적 잘 일치하였다. 따라서 자화손실은 히스테리시스 손실 메카니즘이 지배적이라 할 수 있으며, 측정된 자화손실은 저온 초전도체에서는 볼 수 없었던 약한 주파수 의존성을 보였을 뿐만 아니라 외부자장의 세기에 따라서도 주파수 의존 특성이 상이하였다.

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2003년도 추계학술대회 논문집
• /
• pp.274-277
• /
• 2003

Critical current(Ic) degradation of HTS tapes after bending is one of the hottest issues in HTS development and application studies. Many people are measuring Ic degradations for effect of bending radius. However even if the bending radius is larger than the breaking radius a HTS tapes can be damaged by repetitive bending, which is unavoidable in the winding processes. Therefore, We studied the Ic degradation after repetitive bending. at 77K with self-field, of Bi-2223 tapes processed by "Powder-in-Tube" technique, which was made by America Superconductor Corporation(AMSC) and superconductiing tapes that strain is imposed measured critical current by temperature difference of L$N_2$ and normal temperature. Like this, critical current could measure that degradation about 1~3％ by temperature difference. These results will amount the most important basis data in power electric machine of superconductivity cable, magnet, etc that winding work is require.