• Proceedings of the Korean Magnestics Society Conference
• /
• 2003.06a
• /
• pp.260-261
• /
• 2003

It is recognized that the magnetization reverses with a sequence of discrete and jerky jumps, known as the Barkhausen effect. Recently, interest in the Barkhausen effect has grown as it is a good example of dynamical critical behavior, evidenced by experimental observation of a power law distribution of the Barkhausen jump size. So far, most experimental studies have been carried out on bulk samples using a classical inductive technique, which is difficult to apply to thin film samples mainly due to the ]ow signal intensity. For this reason, very few experiments have been done on two-dimensional ferromagnetic thin films. In this talk, we report a direct domain observation of Barkhausen avalanche at criticality in Co and MnAs thin films investigated by means of a magnetooptical microscope magnetometer (MOMM), capable of time-resolved domain observation with an image grabbing rate of 30 frames/s in real time. In Fig. 1, we demonstrate a series of six representative domain-evolution patterns of 25-nm Co film observed successively by means of the MOMM, where one can directly witness Barkhausen avalanche.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2002.04a
• /
• pp.70-71
• /
• 2002

No Abstract, See Full Text

• Journal of the Korean Magnetics Society
• /
• v.4 no.2
• /
• pp.142-149
• /
• 1994

The Barkhausen noise was measured as the change of line width(39~1.22 mm) and scratching angle($90^{\circ}~50^{\circ}$) with respect of rolling direction in grain-oriented 3 % Si-Fe of 0.30 and 0.27 mm thickness. The two peak phenomena of the noise envelope observed for non-scratching and scratching of line width 39 mm was explained by large activation energy during $180^{\circ}$ domain wall nucleation and annihilation processes. The amplitudes of the noise envelpoes were decreased as the decrement of scratching line width, but did not almost changed below line width of 9.75 mm. It was explained that the decrease in the envelope with increasing scratching number is associated with lower activation energy of $180^{\circ}$ domain nucleation and annihilation in the vicinity of the scratching area. The noise power was decreased as narrower line width. The dependence of the power on the scratching angle was sharpest decreaded at the 50 angle.

• Proceedings of the Acoustical Society of Korea Conference
• /
• autumn
• /
• pp.231-234
• /
• 2000

In relation to a non-destructive evaluation of irradiation damage of micro-structure of interstitial, void and dislocation, the changes in the hysteresis loop and Barkhausen noise amplitude and the harmonics frequency due to neutron irradiation were measured and evaluated. The Mn-Mo-Ni low alloy steel of reactor pressure vessel was irradiated to a neutron fluence of $2.3\times10^{19}n/cm^2$ $(E\ge1MeV)$ at $288^{\circ}C.$The saturation magnetization of neutron irradiated metal did not change. Neutron irradiation caused the coercivity to increase, whereas susceptibility to decrease. The amplitude of Barkhausen noise parameters associated with the domain wall motion were decreased by neutron irradiation. The spectrum of Barkhausen noise was analyzed with an applied frequency of 4Hz and 8Hz, and a sampling time of 50 $\mu$ sec and 20 $\mu$ sec. The harmonic frequency of Joule effect shows 4Hz, 8Hz, 12Hz and 16Hz reflected from an unirradiated specimen. On the contrary, the harmonic frequency disappeared for the irradiated specimen. Harmonic frequency of induced voltage of sinusoidal magnetic field And Spectrum of Barkhausen noise on material is determined.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.05a
• /
• pp.59-72
• /
• 1999

In this thesis, we measured the Barkhausen effect of CoFeSiB amorphous ribbon and then investigated its possibility to be used as a sensor material. We used a sample of composition $($Fe_{0.06}$$Co_{0.94}$)_${0.79}$$Si_{2.1}$$B_{18.9}$ with a thickness 12[pm1, width 2.5[rnml and length 5[cm], which was fabricated by a single roll method. In order to improve magnetic characteristics of the sample, we had carried on annealing in the magnetic field and in none magnetic field. And, experimented results to the magnetic characteristics show that the ribbon has large Barkhausen jump even in weak magnetic field below 0.5[0el. From the results, we confirmed that the sample can be used as an magnetic sensor material.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2008.12a
• /
• pp.179.2-179.2
• /
• 2008

• 한국초전도학회:학술대회논문집
• /
• v.14
• /
• pp.59-59
• /
• 2004

• Journal of the Korean Society for Heat Treatment
• /
• v.5 no.3
• /
• pp.157-164
• /
• 1992

Barkhausen noise (BN) is created by the abrupt changes in the magnetization of materials under applied AC magnetizing field. These changes are known to be sensitive to residual and applied stresses. In this study, BN theory was reviewed and it was examined how BN intensity was affected by simultaneous stress, hardness and microstructural changes. Also, magnetoelastic effect was used to evaluate residual stresses through carrying out the cantilever beam test. An increase in BN intensity was observed when applied and residual stress changes from compression into tension. Microstructural softening by tempering also increased the amount of BN. Therefore, the quantitative evaluation of residual stress and microstructural changes will be possible, provided BN method is more studied about various materials through comparing with different stress measuring techniques.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1996.11a
• /
• pp.89-92
• /
• 1996

In this paper, we mention the study on the sensing function of amorphous magneto- striction wire with about 125${\mu}{\textrm}{m}$$\Phi$ in diameter. The wire in fabricated by using injection and quenching method under the high speed rotating water flow. The wire\`s compotion is (Fe$_{75}$ $Co_{25}$)$_{77}$Si$_{8}$B$_{15}$ , and generates sharp Matteucci voltage by large Barkhausen jump effect even the weak magnetic field. In this study, we don\`t use pick-up coil. Instead, we apply external magnetic field of 3.6Oe in the direction orthogonal to the wire. Then, we detect Matteucci voltage of 1.lmV to both side of 20cm amorphous-wire. Thus, we find that the fabricated wire has the function necessary as the high sensitive sensor material.l.al.l.

• Journal of the Korean Magnetics Society
• /
• v.5 no.4
• /
• pp.251-260
• /
• 1995

It has been reported that Co-based amorphous ferromagnetic alloys annealed in a small magnetic field develop a reproducible, asymmetric hysteresis loop. If the direction of the field during annealing is regarded as +, the magnetization reversal from - to + is smooth and reversible, with its slope determined by the demagnetizing field of the sample. This phenomenon is called the asymmetric magnetization reversal (AMR). The shape of the hyster-esis loop depends sensitively on the condition during the anneal and the alloy composition. Here, we report on the effect of the annealing temperature and time on AMR in a zero magnetostrictive ferromagnetic amorphous alloy. The AMR effect develops in a very short time at a reasonably high temperature, but is stabilized by annealing for a prolonged time.