• Transactions on Electrical and Electronic Materials
• /
• v.6 no.5
• /
• pp.229-232
• /
• 2005

Direct characterization of band alignment at chemical bath deposition $(CBD)-CdS/Cu_{0.93}(In_{1-x}Ga_x)Se_2$ has been carried out by photoemission spectroscopy (PES) and inverse photoemission spectroscopy (IPES). Ar ion beam etching at the condition of the low ion kinetic energy of 400 eV yields a removal of surface contamination as well as successful development of intrinsic feature of each layer and the interfaces. Especially interior regions of the wide gap CIGS layers with a band gap of $1.4\~1.6\;eV$ were successfully exposed. IPES spectra revealed that conduction band offset (CBO) at the interface region over the wide gap CIGS of x = 0.60 and 0.75 was negative, where the conduction band minimum of CdS was lower than that of CIGS. It was also observed that an energy spacing between conduction band minimum (CBM) of CdS layer and valance band maximum (VBM) of $Cu_{0.93}(In_{0.25}Ga_{0.75})Se_2$ layer at interface region was no wider than that of the interface over the $Cu_{0.93}(In_{0.60}Ga_{0.40})Se_2$ layer.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.05a
• /
• pp.115.1-115.1
• /
• 2011

최근 기본적인 pin 구조의 박막 cell 에서 i layer를 최적화 시키는 방안으로 double layer 구조가 많이 연구되고 있다. 본 연구에서는 ASA(Advanced Semicon ductor Analysis) simulation을 이용하여 i-double layer 최적화에 대한 연구를 진행해 보았다. 두께 150/150nm의 i double layer의 band gap 가변을 한 simulation 결과를 보았을 때, p쪽의 band gap이 상승하면서 intrinsic layer 내의 field가 증가하여 recombination center가 감소하였으나 FF의 감소가 있었다. n쪽의 band gap을 상승 시켰을때 n/i 쪽 field 증가로 Voc가 상승되어 초기 효율이 증가하였으나 intrinsic layer내의 field가 감소하여 recombination center가 오히려 증가하였다. 결과적으로 electric field와 효율을 동시에 고려했을 때 두께 300nm, 1.75의 band gap을 가지는 single layer 보다 150/150nm두께에 1.8/1.7 또는 1.8/1.75의 bandgap을 가지는 double layer를 사용하였을 때 보다 높은 효율을 얻을 수 있었다.

• Proceedings of the IEEK Conference
• /
• 2001.06b
• /
• pp.101-104
• /
• 2001

In this paper, we have analyzed algorithm about physical layer, data link layer and MAC layer of out-of-band specified in the DVS 178 and designed architecture of Out-of-band processor. Out-of-band processor extracts session key information from EMM packet to descramble MPEG-2 TS packet scrambled. Also, analyze EAS Packet including emergency alert information to provide emergency communications such as national emergency. In this paper, we have implemented prototype board for out-of-band processor.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.17 no.2
• /
• pp.271-276
• /
• 2017

The triple-gate tunnel FETs encapsulated with an epitaxial layer (EL TFETs) is proposed to lower the subthreshold swing of the TFETs. Furthermore, the band-to-band tunneling based on the maximum electric-field can occur thanks to the epitaxial layer wrapping the Si fin. The performance and mechanism of the EL TFETs are compared with the previously proposed TFET based on simulation.

• Proceedings of the KIEE Conference
• /
• 2008.10b
• /
• pp.513-514
• /
• 2008

A scalable satellite broadcasting system is designed to guarantee quality of multimedia service cooperatively utilizing both Ku Band and Ka band. In the system, video streams are separated into a base layer and an enhancement layer, and are transmitted over the two channels, Ku Band and Ka band, respectively. A basic quality of service using the base layer stream can be provided even when the enhancement layer stream over Ka band channel is unavailable by rain attenuation. A rain fall model is simulated using Barlett-Lewis Pulse model and is used in the operation test of the implemented sacalable satellite broadcasting system.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.62 no.1
• /
• pp.127-132
• /
• 2013

In this paper, we design the physical layer of Guardian modem for wireless public networks. The physical layer is composed of a dual-band RF (Radio Frequency) transceiver and a baseband-processor with quasi-orthogonal codes. The 2.4/5GHz dual-band RF transceiver can overcome the communication difficulty of dense 2.4GHz band for wireless public environment. Also the quasi-orthogonal code can reduce the required ASIC (Application Specific Integrated Circuit) design area. Finally, we analyze the performance of the developed system in viewpoint of data rate, BER (Bit Error Rate), PER (Packet Error Rate). Moreover we verify the performance of the dual-band RF communication.

• Journal of Navigation and Port Research
• /
• v.30 no.8 s.114
• /
• pp.637-642
• /
• 2006

In this paper, we made an experiment on materials of two kinds. First, we made a study of Multi-layer EM wave absorbers using Sendust. In result, The bandwidth of the Multi-layer Sendust EM wave absorbers over 10 dB is extended in S-Band. Second, we investigated the mixing effects of AI(OH)3 on Multi-layer Sendust EM wave Absorbers. In result, the Multi-layer Sendust EM wave absorbers mixed with Al(OH)3 showed a extended bandwidth over 10 dB compared with non-mixed Multi-layer Sendust EM wave absorbers in S-Band.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2006.06b
• /
• pp.97-101
• /
• 2006

In this paper, Multi-layer EM wave absorbers using Sendust are presented. The bandwidth of the Multi-layer Sendust EM wave absorbers over 10 dB is extended in S-Band And we investigated the mixing effects of $Al(OH)_3$ on Multi-layer Sendust EM wave Absorbers. As a result, the Multi-layer Sendust EM wave absorbers mixed with $Al(OH)_3$ showed a extended bandwidth over 10 dB compared with non-mixed Multi-layer Sendust EM wave absorbers in S-Band.

• Journal of the Korean institute of surface engineering
• /
• v.48 no.6
• /
• pp.260-268
• /
• 2015

The thermal barrier coating (TBC) for inner wall of liquid-fuel rocket combustor consists of NiCrAlY as bonding layer and $ZrO_2$ as a top layer. In most case, the plasma spray coating is used for TBC process and this process has inherent possibility of cracking due to large difference in thermal expansion coefficients among bonding layer, top layer and metal substrate. In this paper, we suggest crack-free TBC process by using a precise electrodeposition technique. Electrodeposited Ni-P/Cr double layer has similar thermal expansion coefficient to the Cu alloy substrate resulting in superior thermal barrier performance and high temperature oxidation resistance. We studied the effects of phosphorous concentrations (2.12 wt%, 6.97 wt%, and 10.53 wt%) on the annealing behavior ($750^{\circ}C$) of Ni-P samples and Cr double layered electrodeposits. Annealing temperature was simulated by combustion test condition. Also, we conducted SEM/EDS and XRD analysis for Ni-P/Cr samples. The results showed that the band layers between Ni-P and Cr are Ni and Cr, and has no formed with heat treatment. These band layers were solid solution of Cr and Ni which is formed by interdiffusion of both alloy elements. In addition, the P was not found in it. The thickness of band layer was increased with increasing annealing time. We expected that the band layer can improve the adhesion between Cr and Ni-P.

• Journal of Broadcast Engineering
• /
• v.8 no.2
• /
• pp.181-197
• /
• 2003

Notion Compensation(MC) technique using Sub-Band Coding with the hierarchical structure is efficient to estimate real motion. In the hierarchical pyramid method, low-band MC pyramid method is popular, where the upper layer estimate the glover motion and next lower layer estimate the local motion. The low-band MC pyramid scheme has two problems. First, because the quantization errors at lower layer are accumulated when using coding and quantizing, it is impossible to search the exact Motion Vector(MV) Second, because of the top-down search problem in the hierarchical structure, MV mismatch in upper layer causes serious MV in lower layer So. we propose new hierarchical MC pyramid method based on edge classification. In this Paper, we show that the performance of proposed Pass-band motion compensation pyramid technique is better than low-band motion compensation pyramid. Also, in the pyramid motion estimation, we propose initial MV estimation scheme based on the edge-pattern classification. As a result, we find that PSNR was increased.