• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.5
• /
• pp.1031-1037
• /
• 2011

Pilot symbol assisted modulation (PSAM) can be used for the channel estimation in orthogonal frequency division multiplexing (OFDM) transmission systems. However, imperfect channel estimates in PSAM systems degrade the bit error rate (BER) performance. I derive the BER of PSAM OFDM systems over time dispersive fading channels. The BER performance of OFDM systems with SFBC antenna diversity are analyzed, where data is transmitted over time and frequency selective Rayleigh fading channel. The performance of this PSAM SFBC OFDM systems, gauged by the average bit error rate, is analyzed considering the channel estimation error.

• Journal of Environmental Science International
• /
• v.26 no.9
• /
• pp.999-1011
• /
• 2017

In this study, the Chiu-2D velocity-flow rate distribution based on theoretical background of the entropy probability method was applied to actual ADCP measurement data of Gangjung Stream in Jeju from July 2011 to June 2015 to predict the parameter that take part in velocity distribution of the stream. In addition, surface velocity measured by SIV (Surface Image Velocimeter) was applied to the predicted parameter to calculate discharge. Calculated discharge was compared with observed discharge of ADCP observed during the same time to analyze propriety and applicability of depth of water velocity average conversion factor. To check applicability of the predicted stream parameter, surface velocity and discharge were calculated using SIV and compared with velocity and flow based on ADCP. Discharge calculated by applying velocity factor of SIV to the Chiu-2D velocity-flow rate distribution and discharge based on depth of water velocity average conversion factor of 0.85 were $0.7171m^3/sec$ and $0.5758m^3/sec$, respectively. Their error rates compared to average ADCP discharge of $0.6664m^3/sec$ were respectively 7.63% and 13.64%. Discharge based on the Chiu-2D velocity-flow distribution showed lower error rate compared to discharge based on depth of water velocity average conversion factor of 0.85.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.12 no.4
• /
• pp.380-386
• /
• 2019

In this paper, in order to compare the mixing ratio according to the feeding method, the input error of the main material and the sub material was measured and analyzed for 100 cycles using raw material having the same viscosity. As a result of the piston pump method, the input error of main material and sub material varied greatly from 0g to 3g, and the maximum error ratio was 10.3%. In the dual-screw rotation method, the input error varied from 0.01g to 0,4g, and the maximum error ratio was 0.41%, and almost no input error occurred. As the process cycle increased, it was found that the feed was almost uniform. The dual-screw rotary two-component mixing system was used to measure and analyze the inputs of the main and sub materials for 100 using three types of liquid silicones with different viscosities of the raw materials. As a result, the average error was 0.75g and the error rate was less than 1% regardless of the viscosity of the applied raw materials. When rae materials having the same viscosity were used, the average error ratio of the piston pump method was 4.09%.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.3
• /
• pp.475-481
• /
• 2009

The frequency and probability of deadlock are influential factors in the design of algorithms for deadlock. However, little work has been done in this area because it's not easy to analyze how factors such as the characteristics of process or resource, resource request and release patterns, or the number of process affect the occurrence of deadlock. This study was designed to reduce remarkably the number of state by adapting the model 'state (a,b)t' to represent the resource allocation state, as well as to include the effect of resource error rate and recovery rate in the system analysis. Various formulas about deadlock occurrence were resulted in this study such as the average time interval of deadlock, the probability that a process requesting a resource waits or deadlocks, and the probability that a request deadlocks in a cycle of length 2.

• Journal of Information Technology Applications and Management
• /
• v.28 no.4
• /
• pp.13-20
• /
• 2021

In this paper, I was applied the life distribution following linear failure rate distribution, Lindley distribution and Burr-Hatke exponential distribution extensively used in the arena of software reliability and were associated the reliability possessions of the software using the nonhomogeneous Poisson process with finite failure. Furthermore, the average value functions of the life distribution are non-increasing form. Case of the linear failure rate distribution (exponential distribution) than other models, the smaller the estimated value estimation error in comparison with the true value. In terms of accuracy, since Burr-Hatke exponential distribution and exponential distribution model in the linear failure rate distribution have small mean square error values, Burr-Hatke exponential distribution and exponential distribution models were stared as the well-organized model. Also, the linear failure rate distribution (exponential distribution) and Burr-Hatke exponential distribution model, which can be viewed as an effectual model in terms of goodness-of-fit because the larger assessed value of the coefficient of determination than other models. Through this study, software workers can use the design of mean square error, mean value function as a elementary recommendation for discovering software failures.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.14 no.4
• /
• pp.657-662
• /
• 2019

The power consumption of wearable sensors and electrocardiogram regulators should be very low to extend the network lifetime and anticipated QoS( : Quality of Service) control such as error correction and authentication of data processed by WBAN( : Wireless Body Area Network) nodes is important. Therefore, QoS control is the most urgent concern to implement WBAN in health monitoring regulations. For optimal QoS control, we compare the energy efficiency and the average number of transmissions with IEEE 802.15.6 and the error correction method considering energy efficiency. The performance of the proposed error correction technique shows that the energy efficiency and the transmission rate are improved by adjusting the coding rate appropriately using the channel estimation.

• Journal of Wetlands Research
• /
• v.25 no.2
• /
• pp.75-82
• /
• 2023

Data for measuring the flow rate of streams are used as important basic data for the development and maintenance of water resources, and many experts are conducting research to make more accurate measurements. Especially, in Korea, monsoon rains and heavy rains are concentrated in summer due to the nature of the climate, so floods occur frequently. Therefore, it is necessary to measure the flow rate most accurately during a flood to predict and prevent flooding. Thus, the U.S. Geological Survey (USGS) introduces 1, 2, 3 point method using a flow meter as one way to measure the average flow rate. However, it is difficult to calculate the average flow rate with the existing 1, 2, 3 point method alone.This paper proposes a new 1, 2, 3 point method formula, which is more accurate, utilizing one probabilistic entropy concept. This is considered to be a highly empirical study that can supplement the limitations of existing measurement methods. Data and Flume data were used in the number of holesman to demonstrate the utility of the proposed formula. As a result of the analysis, in the case of Flume Data, the existing USGS 1 point method compared to the measured value was 7.6% on average, 8.6% on the 2 point method, and 8.1% on the 3 point method. In the case of Coleman Data, the 1 point method showed an average error rate of 5%, the 2 point method 5.6% and the 3 point method 5.3%. On the other hand, the proposed formula using the concept of entropy reduced the error rate by about 60% compared to the existing method, with the Flume Data averaging 4.7% for the 1 point method, 5.7% for the 2 point method, and 5.2% for the 3 point method. In addition, Coleman Data showed an average error of 2.5% in the 1 point method, 3.1% in the 2 point method, and 2.8% in the 3 point method, reducing the error rate by about 50% compared to the existing method.This study can calculate the average flow rate more accurately than the existing 1, 2, 3 point method, which can be useful in many ways, including future river disaster management, design and administration.

• Journal of Environmental Health Sciences
• /
• v.26 no.3
• /
• pp.50-54
• /
• 2000

Ventilation rates can be measured directly by a tracer decay method, although little is known of the effects of different sampling intervals on decay rte calculations. This study determined variations in decay rates calculated by three techniques using residential ozone decay data. The calculation techniques were a regression technique, decay techniques using half-life and average-life, and finite difference techniques using two different time intervals. Variation associated with regression technique calculations for residential ozone decay rates based on data from both sample intervals were within 10% (2.81$\pm$1.88 hr-1). However, both half-life and finite difference technique calculations using a shorter-time interval were significantly different from those obtained with the regression technique(p<0.05). Therefore, the use of short sampling intervals in tracer decay may cause significant error in decay rate calculations.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1998.08a
• /
• pp.159-164
• /
• 1998

We proposes a new detecting algorithm of DTMF tone for low bit ate vocoder so that we use DTMF tones for signalling inthe digital network. Using DTMF tones for signalling, we could not change the conventional IS-95 protocol and control the mobile phone. We apply the root finding to detection of formants and bandwidth to search whether DTMF tones or voice and moreover to find what's kinds of DTMF tones, for instance 1, 2, 3, ......., #, *, A, B, ...., etc. Consequently, proposed method has a good result which is 0.000944% average error rate. It is satisfied with rcommended error rate in ITU-T($\pm$1.8%).

• International Journal of Contents
• /
• v.14 no.1
• /
• pp.18-27
• /
• 2018

The objective of this study was to derive approximate closed-form error rates for M-ary burst symbol transmission (MBST) of dual-hop adaptive decode-and-forward (ADF) cooperative relay systems over quasi-static Rayleigh fading channels. Within a burst, there are pilot symbols and data symbols. Pilot symbols are used for channel estimation schemes and each relay node's transmission mode selection schemes. At first, our focus was on ADF relay systems' error-events at relay nodes. Each event's occurrence probability and probability density function (PDF) were then derived. With error-event based approach, we derived a tractable form of PDF for combined signal-to-noise ratio (SNR). Averaged error rates were then derived as approximate expressions for arbitrary link SNR with different modulation orders and numbers of relays. Its accuracy was verified by comparison with simulation results.