• Journal of the Korean Society of Mechanical Technology
• /
• v.13 no.1
• /
• pp.23-29
• /
• 2011

The measurement of ice properties such as thickness, strength are important to know the performance of the ice breaking vessel. The measuring equipment of ice properties and methods are summarized in this paper. The actual measured data are also described. The strength of ice at Svalbard area on April 2010 is much stronger than the Chukchi Sea on August 2010. The mean strength of Svalbard is about 500 kPa and one of Chukchi Sea is 250 kPa. The first sea trial in Arctic sea using Araon was carried out in the Chukchi Sea. The power and speed was also measured to check the ship performance in ice. The speed was measured from GPS(Global Positioning System) and engine power was recorded from DPS(Dynamic Positioning system) of Araon. The design target of Araon in level ice is 3 knots in 1m thickness and 630 kPa flexible strength but mean speed in Chuckchi sea is 3.98 knots when 6.6 MW engine power, 2.4m ice thickness and 250 kPa strength. This results comes from the difference of ice types and the weak flexible strength of ice but it will be a good information to know the performance of Araon in similar ice condition.

• Journal of the Society of Naval Architects of Korea
• /
• v.53 no.6
• /
• pp.529-535
• /
• 2016

This study focuses on the comparison of measured data from 6-DOF motion sensor and strain gauge installed in the IBRV ARAON during 2015 summer voyage in the Arctic. Procedures to calculate the global ice load from MotionPak II inertial measurement system and the local load from stain gauge system are discussed. The ship's speed and peak load are determined in the concept of an ice collision "event". It is found that the peak values in the global ice calculated form whole ship motion analysis fall in the range of 1.5~3 times of the local ice load based in strain gauge measurement.

• Journal of the Society of Naval Architects of Korea
• /
• v.58 no.5
• /
• pp.330-338
• /
• 2021

This paper focuses on the improvement of the influence coefficient matrix method for estimation of local ice load on the icebreaking research vessel ARAON. The influence coefficient matrix relates ice pressure on the hull plate to the measured/calculated hull strain/stress. Conventionally von Mises equivalent stresses representing hull stresses and ice pressure acting on the hull plate are utilized to assemble the influence coefficient matrix. Because of the three dimensional features of the ship-ice collision process, an enhanced method to assemble the influence coefficient matrix is derived considering ice loads in the X, Y, and Z direction simultaneously. Furthermore the location of ice loads acting on hull-plate may fall outside the measuring sensor area, and the enhanced influence coefficient matrix is modified to reduce the difference between the actual and the estimated ice loads by expanding the domain outward from the sensor area. The developed method for enhanced influence coefficient matrix is applied to IBRV ARAON during the 2019 Antarctic ice field test and the local ice loads in three directions are efficiently calculated compared to those by a conventional method.

• Journal of Advanced Research in Ocean Engineering
• /
• v.1 no.3
• /
• pp.186-197
• /
• 2015

In summer 2010, field measurements of local ice loads were carried out in the Arctic Ocean using the Korean first icebreaking research vessel, ARAON. In some previous studies by the authors, several investigations for the data measured at 2010 including the relationship between the measuring points and ice loads, the possibility for observation of higher ice load and the relationship between the ship speed and ice loads were reported. During 10 days in August 2013, new field measurements were performed in similar waters of the Arctic Ocean using the same vessel, ARAON. The aim of this study is to investigate the statistical properties of 2013 measurements and compare results by two periods.

• Korean Journal of Remote Sensing
• /
• v.30 no.5
• /
• pp.677-686
• /
• 2014

Sea ice covers wide area in Terra Nova Bay in East Antarctica where the Jangbogo Antarctic Research Station was built in 2014, which affects greatly on the sailing of an icebreaker research vessel. In this study, we analyzed the optimum sea route and sailable period of the icebreaker to visit the Jangbogo Antarctic Research Station by using sea ice concentration data observed by passive microwave sensors such as Special Sensor Microwave/Imager (SSM/I) and Special Sensor Microwave Imager/Sounder (SSMIS) for the last decade, and by using sea route of the Araon, an icebreaker of Republic of Korea, from 2010 to 2012. It is found that Araon sailed in the route of sea ice concentration up to 78%. Sailing speed of the Araon decreased due to increasing sea ice concentration. However, Araon maintained the speed close to the average speed for the entire sailing period (~11 kn) in the route of sea ice concentration up to 70%. Therefore, we confirm that the Araon can sail typically in the route which shows sea ice concentration below 70%. We derived annually available sailing period in recent 10 years for the sea route of the Araon in 2010, 2011 and 2012, which is defined as the period showing sea ice concentration below 70% through the route. Maximum sailable period was analyzed to be 61 and 62 days for the route of the Araon in 2010 and 2011, respectively. However, the typical sailing in the routes was unavailable in some years because sea ice concentration was higher than 70% through the routes. Meanwhile, the sailable period for the routes of the Araon in 2012 was observed in every year, which was a minimum of 15 days and is a maximum of 89 days. Therefore, we could suggest that optimum route of icebreaker to visit the Jangbogo Antarctic Research Station is the route of the Araon in 2012. High resolution images from SAR or optical sensors are necessary to investigate sea ice condition near shoreline of Jangbogo research station due to several kilometers of low resolution of sea ice concentration.

• Journal of Ocean Engineering and Technology
• /
• v.33 no.6
• /
• pp.627-631
• /
• 2019

Recently, researchers in Korea and abroad actively have conducted research activities using the ARAON, a Korean icebreaking research vessel. The ARAON regularly conduct research activities in the Arctic and Antarctic waters every year. The icebreaking mode, which can be either continuous breaking or ramming, is determined by the conditions of the ice and the ice-covered waters. When the icebreaker encounters thick sea ice or an ice ridge, ramming is used. At that time, the speed of the ship generally is slower than that of continuous icebreaking. In this study, the ice load signal at the time of repetitive ramming during ARAON's 2012 Antarctic research voyage was analyzed. The time history of the ice load signal and the change in the speed of the ship used in ramming were compared with these values during continuous icebreaking.

• Journal of Ocean Engineering and Technology
• /
• v.32 no.6
• /
• pp.458-465
• /
• 2018

Ice-going ships such as icebreakers, icebreaking tankers, and icebreaking LNG carriers are subjected to wave loads in open water and ice loads in ice-covered water. In terms of the ship's structural design, the local ice load is important. The fatigue failure due to repeated ice loads is also important. ISO 19906 specifies the assessment of the fatigue limit for a polar offshore structures. In addition, Lloyd's Register refers to fatigue damage based on ShipRight FDA ICE. In ShipRight FDA ICE, the fatigue damage indices due to wave and ice loads are simply presented as 0.5 for each load. It also states that the sum of the two fatigue damage indices should not exceed one. This study calculated and analyzed the fatigue damage index and fatigue life considering ARAON's voyage schedules and the assumed Antarctic voyage based on data measured during the Arctic voyage of ARAON in 2010.

• Journal of Advanced Research in Ocean Engineering
• /
• v.1 no.1
• /
• pp.25-35
• /
• 2015

This study presents the analysis of relationship between ship speed and local ice load on the Korean Icebreaker ARAON. The relationship curves were made from the data obtained at two areas: the Arctic and the Antarctic; and for two operation condition: the icebreaking condition in sea ice trial and general operation in ice covered sea. The strain data were converted to the equivalent stress value, and the influence of ship speed on the local ice load was analyzed and compared each other. These analysis results are useful in working on a statistically valid hull design approach.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2011.10a
• /
• pp.175-176
• /
• 2011

• Journal of Ocean Engineering and Technology
• /
• v.28 no.1
• /
• pp.28-33
• /
• 2014

The Korean icebreaking research vessel "Araon" performed four sea trials in the Arctic and Antarctic Seas. The ice properties, such as the ice thickness, floe size, ice strength, and power of the vessel were quite different in these trials. To compare the speeds of ship with the same ice strength and power, the AARC (Arker Arctic Research Center) method is used with a vessel power of 10 MW and an ice strength of 630 Pa in this paper. Based on the analysis results, the speed of the ship was 1.62 knots (0.83 m/s) with a 1.02-m ice thickness and 2.5-km floe size, 5.3 knots (2.73 m/s) with a 1.2-m ice thickness and 1.0-km floe size, and 13.8 knots (7.10 m/s) with a 1.1-m ice thickness and 200-m floe size. The analysis results showed that the ship speed and floe size have an inversely proportional relationship. Two reasonable reasons are given in this paper for the final result. One is an ice breaking phenomenon, and the other is the effect of the ice floe mass. For the breaking phenomenon, the ice breaking force is very small because the ice floe is not breaking but tearing when a ship is passing through a small ice floe. Regarding the effect of the ice floe mass, it is impossible for a ship to push and tear an ice floe if the mass of the ice floe is too large compared to the mass of the ship. The velocity of the ship decreases when the ice floe has a large mass and a large size because the ship has to break the ice floe to move forward.