• Journal of the Korean Ceramic Society
• /
• v.47 no.3
• /
• pp.205-209
• /
• 2010

In the last (fourth) section, the discussion will entail a silicon-nitride/silicon-carbide nanocomposite, produced by pyrolysis of liquid polymer precursors, demonstrating one of the lowest creep rates reported so far in ceramics at the comparable temperature of $1400^{\circ}C$. This was first achieved by avoiding the oxynitride glass phase at the intergrain boundaries. One important factor in the processing of these nanocomposites was the use of the electrical field assisted sintering method.

• Journal of Sensor Science and Technology
• /
• v.26 no.2
• /
• pp.91-95
• /
• 2017

Recently, infrared (IR) spectrometers have been required in various fields such as environment, safety, mobile, automotive, and military. This IR dispersive sensor detection method of substances is widely used. In this study, we fabricated a silicon (Si) prism-based near infrared (NIR) spectrometer utilizing micro electro mechanical system (MEMS) technology. Si prism-based NIR spectrometer utilizing MEMS technology consists of upper, middle, and lower substrates. The upper substrate passes through the incident IR ray selectively. The middle substrate, acting as a prism, disperses and separates the incident IR beam. The lower substrate has an amorphous Si (a-Si)-based bolometer array to detect the IR spectrum. The fabricated Si prism-based NIR spectrometer utilizing MEMS technology has the advantage of a simple structure, easy fabrication steps, and a wide NIR region operating range.

• Korean Journal of Materials Research
• /
• v.9 no.1
• /
• pp.99-103
• /
• 1999

We investigated the crystalline behavior in active ion implanted silicon through Raman spectroscopy. Four a-Si(amorphous Si) peaks were observed that are related to the ion implantation induced a-Si layer. After the isochronical anneal(30min). and isothermal anneal($450^{\circ}C$), noticeable recovery of crystalline-Si peak at 519cm\ulcorner and peak center shift of the a-Si TO from 465cm\ulcorner to 480cm\ulcorner were observed by RNM(Random Network Model). By applying RNM and SCLM(Spatial Correlation Length Model), the peak center and FWHM(the Full Width at half Maximum) of a-Si were changed dramatically between T\ulcorner=$200^{\circ}C$ and 30$0^{\circ}C$. From the results, it can be said that there is an abrupt structural change at this temperature region.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07b
• /
• pp.1112-1115
• /
• 2005

In this study, we performed excimer laser activation on Phosphorus or Boron doped a-Si (amorphous silicon) film. We've got a very low sheet resistance (Rs), Rs was 60 ohm/sq. with phosphorus doping and was 65 ohm/sq. with boron doping at each optimized laser irradiation condition. We've found Rs on activated thin film showed an unprecedented behavior in both cases, because Rs had a strong dependency on the crystallinity of the activated Si film.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.711-714
• /
• 2006

Properties of silicon nitride ($SiN_x$) film including physical and electrical characteristics have been studied for improving the stability of hydrogenated amorphous silicon thin-film transistors (a-Si TFTs) in active-matrix liquid-crystal displays (AMLCDs). The instability of a-Si:H TFTs is estimated by accelerated stress test of both bias-temperature stress and bias-illumination stress. The results show that the deposition conditions of $SiN_x$ films with higher power and lower pressure are the best choice for improving the on-current and stability of TFTs.

• Electrical & Electronic Materials
• /
• v.9 no.6
• /
• pp.558-563
• /
• 1996

We fabricated high voltage hydrogenerated amorphous silicon thin film transistors (a Si:H HVTFT) and investigated its temperature dependent characteristics of from 303 K to 363 K. The results show that the drain current was decreased at low gate voltage and increased at high gate voltage exponentially. According to the increasing the thickness of a Si layer, drain current increased. Difference of drain current at 363 K was increasd at the lower gate voltage and decreased at the higher gate voltage. When the drain and gate voltage of 100 V applied, the drain current increased linearly with rise temperature.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.2
• /
• pp.122-130
• /
• 1996

In an effort to learn more about the reaction mechanisms which lead to the compound nucleation at the interface of cobalt and silicon, electrical noise properties has been investigated for cobalt thin films deposited on silicon substrates by the electron beam evaporation and rf sputtering techniques. Microstructural variations at the Co/Si interfaces have been observed by transmission electronmicroscopy. Amorphous structures are observed at the Co/Si interfaces for samples whose cobalt thicknesses are less than 4nm and a polycrystalline compound nucleation has been occurred for thicker films. 1/f noise power same samples, and the spetral density has been normalized. The amplitude of 1/f noise power spectral density shows a gradual increase as the cobalt thickness is increased, and the amplitude has dropped abruptly after the compound nucleation. The variations of the noise parameters areassumed to be an indiction of the phase transformation along the nucleation reaction path, and amplitude has been interpreted as instabilities of the Co/Si interfacial structures.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.5
• /
• pp.117-124
• /
• 1996

The .mu.c-Si:H films have been deposited by PeCVD at the various conditions such as hydrogen dilution ratio, substrate temperature and RF power density. Then, we studied their electrical and optical properties. Top gate hydrogenated micro-crystalline silicon thin film transistors($\mu$c-Si:H TFTs) using $\mu$-Si:H and a-SiN:H films have been fabricated by FECVD. The electrical characteristics of the devices have been investigated by semiconductor parameter analyzer and compared with amorphous silicon thin film transistors (a-Si:H TFTs). In this study, on/off current ratio, threshold voltage and the field effect mobility of the $\mu$c-Si:H TFT were $3{\times}10^{4}$, 5.06V and 0.94cm$^{2}$Vs, respectively.

• Proceedings of the KSME Conference
• /
• 2003.04a
• /
• pp.1407-1411
• /
• 2003

Due to the heat confinement in the shallow region of the target for a short time scale, pulsed laser annealing has received increasing interest for the fabrication of poly-Si thin film transistors(TFTs) on glass as a low cost substrate in the flat panel displays. The formation and growth mechanisms of poly silicon(poly-Si) grains in thin films are investigated using an excimer laser crystallization system. To understand the crystallization mechanism, the grain formations are observed by FESEM analysis. The optical reflectance and transmittance during the crystallization process are measured using HeNe laser optics. A two-step ELC(Excimer Laser Crystallization) process is applied to enhance the grain formation uniformity.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.4
• /
• pp.33-39
• /
• 1997

The crystallization temperature of an amorphous silicon (a-Si) can be lowered down to 400.deg. C by a new method : Double-metal induced lateral crystallization (DMILC). The a-Si film was laterally crystallized from Ni and Pd deposited area, and its lateral crystallization rate reaches up to 0.2.mu.m/hour at that temperature and depends on the overlap length of Ni and Pd films; the shorter the overlap length, the faster the rate. Poly-Silicon thin film transistors (poly-Si TFT's) fabricated by DMILC at 400.deg. C show a field effect mobility of 38.5cm$^{3}$/Vs, a minimum leakage current of 1pA/.mu.m, and a slope of 1.4V/dec. The overlap length does not affect the characteristics of the poly-Si TFT's, but determines the lateral crystallization rate.