• Bulletin of the Korean Chemical Society
• /
• v.33 no.6
• /
• pp.1925-1928
• /
• 2012

Adsorption of alkali metals (Li, Na, and K) on the surface of magnesium oxide nanotubes (MgONTs) with different diameters was investigated using density functional theory. According to the obtained results, the most stable adsorption site was found to be atop the oxygen atom of the tube surface with adsorption energies in the range of -0.25 to -0.74 eV. HOMO-LUMO gap ($E_g$) of the tubes dramatically decreases upon the adsorption of the alkali metals, resulting in enhancement of their electrical conductivity enhancement. The order of $E_g$ decrement caused by the metal adsorption is as follows: K > Na > Li. The results suggest that the MgONTs were transformed from semi-insulator to semiconductor upon the alkali metal adsorption. Increasing the tube diameter, the HOMO/LUMO gap of the pristine tube is enhanced and adsorption energies of the alkali metals are decreased.

• Analytical Science and Technology
• /
• v.11 no.4
• /
• pp.248-253
• /
• 1998

The adsorption and separation behaviors of alkali, alkaline earth and transition metal ions using a poly-dibenzo-18-crown-6 were investigated in aqueous solution. The adsorption degree(E) and distribution ratio(D) of alkali, alkaline earth metal ions were Li(I)$t_R$) of metal ions were affected by the adsorption degree(E) and distribution ratio(D). This results showed good separation efficiency of K(I), Sr(II), Ag(I) and Pb(II) from the mixed metal solution.

• Journal of Korean Society for Atmospheric Environment
• /
• v.25 no.4
• /
• pp.316-324
• /
• 2009

Carbon based sorbents for $CO_2$ adsorption were prepared by impregnation with alkali metals ($Li^+$, $K^+$) and alkaline earth metals ($Ca^{2+}$, $Mg^{2+}$). BET surface area of test sorbents was lower than the intrinsic activated carbon. In particular, impregnation of $Ca^{2+}$ or $Mg^{2+}$ resulted in lower surface area of specific adsorption sites than that of $Li^+$ or $K^+$. While the adsorption capacity for $CO_2$ was high in the sorbents containing $Ca^{2+}$ and $Mg^{2+}$, strong interaction with $CO_2$ would cause to drop the capacity after regeneration. The adsorption was found high relatively in the flow with a high concentration of $CO_2$ and in a low flow rate. The adsorption isotherm for the present modified AC sorbents fits well with the Freundlich model.

• Journal of the Korean Applied Science and Technology
• /
• v.30 no.3
• /
• pp.494-503
• /
• 2013

In this study, $CO_2$ adsorbent was produced for minimizing energy loss due to ventilation within the building. For improved selectivity about low concentration of $CO_2$ in multiple-use facilities, the ball type adsorbent was modified from a commercial zeolite, alumina, alkali metals and activated carbon with mixing LiOH, binder, and $H_2O$. We measured specific surface area, pore characteristic, and crystal structure of the modified adsorbent. Effects of alkalization on the absorptive properties of the adsorbents were investigated. Continuous column tests (2,000 ppm) and batch chamber tests ($4m^3$, 5,000ppm) showed that the modified adsorbent indicated about the selectivity of $CO_2$ more than 9.7% (0.613 mmol/g) compared with ordinary adsorbents and $CO_2$ removal efficiency of 88.8% within l hour, respectively. It was estimated that the modified adsorbent was applicable to indoor environments.

• Journal of the Korean Society of Industry Convergence
• /
• v.6 no.3
• /
• pp.201-205
• /
• 2003

The effects of adsorption and desorption of alkali-metals on Si(111) surface were investigated by using AES and RHEED-system. The adsorption system is a fundamental interest because of its unique electronic properties such as measurement of work function change, adatom-core level shift. It was found that the growth node of K on Si(111) surface was layer by layer growth and the saturation coverage was 2.0ML at room temperature. Superstructure changes on Si(111) surface according to the alkali-metal thickness and substrate temperatures were accurately defined. By applying the isothermal desorption method, the desorption energies of Li/Si(111) and K/Si(111) surfaces was measured. On Li/Si(111) and K/Si(111) surfaces, the desorption energies were 3.07 eV, 2.19 eV respectively.

• The Korean Journal of Food And Nutrition
• /
• v.11 no.6
• /
• pp.595-599
• /
• 1998

A batch experiment was conducted to evaluate the removal capacity of welsh onion(Allium fistulosum L.), shallot (Allium ascalonicum L.), garlic (Allium sativum L.) roots as an adsorbent for Ni and Pb in aqueous solution. One gram of the dried Allium root powder was reacted in 100ml of solution containing 10mg of each heavy metal and effects of metal concentration, pH, temperature, and size of adsorbent on the removal efficiency were evaluated. The results were as follows ; The amount of adsorption of heavy metal ions were higher with the smaller particles size of adsorbent. Garlic root was high adsorption capacity of Pb, especially. The higher concentration of heavy metal solution was, the more amount of adsorption of heavy metals was. The adsorption ratio was differed from a kind of heavy metal. As the temperature increased, the amount of adsorption of Ni and Pb by shallot and welsh onion were decreased. The amount of adsorption of Ni was high under alkali conditions but the amount of adsorption of Pb was high under neutral and acidity condition.

• Bulletin of the Korean Chemical Society
• /
• v.12 no.5
• /
• pp.487-490
• /
• 1991

Electrochemical studies of alkali metal cations $(Na^+, K^+, Rb^+, Cs^+)$ were performed in methanolic solutions of 18-crown-6 and tetrabutylammonium salts at dropping mercury electrodes (DME) and thin mercury film electrodes (TMFE). All the cations investigated were reduced reversibly at DME in the absence and presence of 18-crown-6, and in the latter the limiting currents were decreased and the reduction potentials shifted to the negative direction. The reduction potentials of the metal ions (0.2 mM) in the presence of the crown (10 mM) were - 2.14 $(Na^+)$, - 2.26 $(K^+)$, - 2.20 $(Rb^+) and - 2.14 $(Cs^+)$ V vs. SCE, respectively. The measured potentials were rationalized with ion recognition of the cations by the crown. Electroreduction at TMFE were highly irreversible. A new representation method of ion recognition is presented. In aqueous solutions, electroreduction of the alkali metal ions were characterized by adsorption.

• Applied Chemistry for Engineering
• /
• v.2 no.3
• /
• pp.270-278
• /
• 1991

Carboxymethyl chitin(CM-chitin) was prepared by the reaction of alkali chitin with monochloroacetic acid in isopropyl alcohol. According to the pH variation, the adsorptivity of this chelating polymer to the alkali-earth metal ions such as $Ca^{2+},\;Mg^{2+}$, $Sr^{2+}$, $Ba^{2+}$ ions was determined by batch method. The adsorption tendency of this chelating polymer to most metal ions was increased with the increase of pH. The highest degree of adsorption was observed toward $Ca^{2+}$ ion among the alkali-earth metal ions. The selectivity adsorption property toward $Ca^{2+}$ ion was examined in the solution of $Ca^{2+}$ and $Mg^{2+}$ ions, and it was observed that CM-chitin showed excellent selectivity to $Ca^{2+}$ ion than $Mg^{2+}$ ion. $Mg^{2+}$ ion bound to CM-chitin molecule in the presence of $Ca^{2+}$ ion owing to low equilibrium constant. In the adsorption experiment of $Ca^{2+}$ and $Mg^{2+}$ ions to the CM-chitin under coexistence of $Na^+$ and $K^+$ ions, it observed that adsorptivity of only $Ca^{2+}$ ions was not affected by these monovalent cations.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2000.02a
• /
• pp.155-155
• /
• 2000

Adsorption of alkali metals on a silicon surface has attracted much attention due to its importance in metal-semiconductor interface technology, In particular, the bonding nature of alkali metal to silicon substrate has been a focus of fundamental research efforts. We examined the adsorbed layer of Cs on a Si(111)-(7$\times$) surface by reactive ion scattering (RIS) of hyperthermal Cs+ beams. RIS from a Cs-adsorbed surface gives rise to Cs, representing pickup of surface Cs by Cs projectile. The Cs intensity is proportional to surface coverage of Cs at a high substrate temperature (473 K), while it varies anomalously with Cs coverage at low temperatures (130-170 K). This observation indicates that RIS selectively detects metallic Cs on surface, but discriminates ionic Cs. Transition from ionic to metallic Cs adlayer is driven by thermal diffusion of Cs and their clustering process.

• Journal of Korean Society for Atmospheric Environment
• /
• v.30 no.1
• /
• pp.68-76
• /
• 2014

The present study has evaluated the $CO_2$ adsorption amount of activated carbon pellets (AC). Coconut shell based test AC were modified with surface impregnation of glycine, glycine metal salts and monoethanolamine for low level $CO_2$ (3000 ppm) adsorption. Physical and chemical properties of prepared adsorbents were analyzed and the adsorbed amount of $CO_2$ was investigated by using pure and 3,000 ppm $CO_2$ levels. The impregnation of nitrogen functionalities was verified by XPS analysis. The adsorption capacity for pure $CO_2$ gas was found to reach upto 3.08 mmol/g by AC-LiG (Activated carbon-Lithium glycinate), which has the largest specific surface area ($1026.9m^2/g$). As for low level $CO_2$ flow the primary amine impregnated adsorbent showed 0.26 mmol/g of adsorption amount, indicating the highest selectivity. An adsorbent with potassium-glycine salts (AC-KG, Activated carbon-Potassium glycinate) instead of amine presented with 0.12 mmol/g of adsorption capacity, which was higher than that of raw activated carbon granules (0.016 mmol/g).