• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.457-458
• /
• 2009

In this work, transparent conducting Al-doped zinc oxide (AZO) films were prepared on Coming glass substrate by RF magnetron sputtering using an Al-doped ZnO target (Al: 2 wt.%) at room temperature and all films were deposited with athickness of 150 nm. We investigated the effects of the post-annealing temperature and the annealing ambient on structural, electrical and optical properties of AZO films. The films were annealed at temperatures ranging from 300 to $500^{\circ}C$ in steps of $100^{\circ}C$ using rapid thermal annealing equipment in oxygen. The thickness of the film was observed by field emission scanning electron microscopy (FE-SEM) and grain size was calculated from the XRD spectra using the Scherrer equation and their electrical properties were investigated using a hole measurement and the reflectance of AZO films was investigated by UV-VIS spectrometry.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.12
• /
• pp.46-53
• /
• 1997

The TMA gas sensors are fabricated with the ZnO-based thin films grown by a RF magnetron sputtering method. The hall effect measurement and AES analysis are carried out to investigate the effects of the sputtering gases and dopants which effect on the electrical resistivity and sensitivity to TMA gas. We measure the cfhanges of the surface carrier concentration, haall electron mobility, electrical resistivity, surface condition, and depth profile of the films. The ZnO-based thin film sensors sputtered in oxygen, or added with dopants showed a high sruface carrier concentration, film sensors sputtered in oxygen and doped with 4.0 wt.% $Al_{2}$O$_{3}$, 1.0 wt.% TiO$_{2}$, and 0.2 wt% v$_{2}$O$_{5}$ showed the highest surface carrier concentration of 5.952 * 10$^{20}$ cm$^{-3}$ , hall electron mobility of 176.7 cm$^{2}$/V.s, lowest electrical resistivity of 6*10$^{-5}$ .ohm.cm and highest sensitivity of 12. These results were measured at a working temperature of 300.deg. C to 8 ppm TMA gas.

• Proceedings of the KIEE Conference
• /
• 2006.10a
• /
• pp.67-68
• /
• 2006

We prepared the AZO thin film with different $O_2$ gas flow rate. the AZO thin films were deposited on glass substrate at room temperature, working gas pressure of 1mTorr. the electrical, structural and optical properties of AZO thin films were investigated by using Hall Effect measurement system, X-ray Diffractometer (XRD) and UV-VIS spectrometer. From the results, we could obtain that AZO thin film with low resistivity of $8.5{\times}10^{-4}{\Omega}cm$ was exhibited in specific $O_2$ gas flow rate. Also, the transmittance of over 80% in visible range was observed in specific $O_2$ gas flow rate. In all of the AZO thin film with the transmittance of over 80%, diffraction peak of (002) direction was observed, while amorphous peak was observed in the AZO thin film with the low transmittance.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.204.1-204.1
• /
• 2013

Fluorine, the radius of which is close to that of oxygen, could be an appropriate anion doping candidate. A lower lattice distortion could be expected for F doping, compared with Al, Ga, and In doping. F-doped ZnO (FZO) and undoped ZnO nanorods were grown onto glass substrate by the hydrothemal method. The doping level in the solution, designated by F/Zn atomic ratio of was varied from 0.0 to 10.0 in 2.0 steps. To investigate the effects of the structure and optical properties of FZO nanorods were investigated using X-ray diffraction, UV-visible spectroscopy and photoluminescence (PL). For the PL spectra, the maximum peak position of NBE moves to higher energy, from 0 to 4 at.%. As the doping concentration increases, the maximum peak position of NBE gradually moves to lover energy, from 4 to 10 at.%.

• Journal of the Korean Vacuum Society
• /
• v.18 no.5
• /
• pp.377-383
• /
• 2009

Aluminum-doped zinc oxide (AZO) thin films were deposited on sapphire substrate by using radio-frequency magnetron sputtering and were performed in the temperature range of $600-900^{\circ}C$ by rapid thermal annealing (RTA). The crystallographic structure and the surface morphology were investigated by using X-ray diffraction and scanning electron microscopy, respectively. The crystallinity of the films was improved with increasing the annealing temperature and the average size of crystalline grains was found to be 50 nm. All the thin films showed an average transmittance of 92% in the wavelength range of 400-1100 nm. As the annealing temperature was increased, the bandgap energy was decreased and the violet photoluminescence (PL) signal at 400 nm replaced the ultraviolet PL signal. The electrical properties of the thin films showed a significant dependence on the annealing temperature.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.30 no.2
• /
• pp.115-118
• /
• 2017

Highly photosensitive and wide bandgap amorphous silicon oxide (a-$SiO_x$:H) films were developed at low temperature ranges ($100{\sim}150^{\circ}C$) with employing plasma-enhanced chemical vapor deposition by optimizing $H_2/SiH_4$ gas ratio and $CO_2$ flow. Photosensitivity more than $10^5$ and wide bandgap (1.81~1.85 eV) properties were used for making the a-$SiO_x$:H thin film solar cells, which exhibited a high open circuit voltage of 0.987 V at the substrate temperature of $100^{\circ}C$. In addition, a power conversion efficiency of 6.87% for the cell could be improved up to 7.77% by employing a new n-type nc-$SiO_x$:H/ZnO:Al/Ag triple back-reflector that offers better short circuit currents in the thin film photovoltaic devices.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.1
• /
• pp.115-120
• /
• 2009

The 3wt.% Al-doped zinc oxide (AZO) thin films were fabricated on Coming 1737 substrates at a fixed oxygen pressure of 200 mTorr with various substrate temperatures ($100\;{\sim}\;250^{\circ}C$) by using pulsed laser deposition in order to investigate the microstructure, optical, and electrical properties of AZO thin films. All thin films were shown to be c-axis oriented, exhibiting only a (002) diffraction peak. The AZO thin film, fabricated at 200 mTorr and $250^{\circ}C$, showed the highest (002) orientation and the full width at half maximum (FWHM) of the (002) diffraction peak was $0.44^{\circ}$. The optical transmittance in the visible region was higher than 85 %. The Burstein-Moss effect, which shifts to a high photon energy, was observed. The electrical property indicated that the highest carrier concentration ($3.48{\times}10^{20}cm^{-3}$) and the lowest resistivity ($1.65{\times}10^{-2}{\Omega}cm$) were obtained in the AZO thin film fabricated at 200 mTorr and $250^{\circ}C$.

• Proceedings of the KIEE Conference
• /
• 2007.11a
• /
• pp.108-109
• /
• 2007

Microstructure and electrical properties of Ga-doped ZnO (GZO) films grown on $Al_2O_3$ templates by Pulsed Laser Deposition (PLD) are investigated utilizing X-ray diffraction method and Hall measurement, respectively. In order to determine the optimized operating condition of the PLD, statistical design of experiment (DOE) is employed. It provides the systematic and efficient methodology for characterization and modeling of PLD processing with a relatively small number of experiments. The most optimized recipe of the process factors is obtained by response optimizer in Minitab.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.90-90
• /
• 2011

Transparent conducting oxide (TCO) films have been intensively utilized in the electric applications, such as, displays, lightings and solar cells due to the good electric conductivity with an excellent transmittance of the visible light. We, herein present an excellent Al-doped ZnO film (AZO), which has been fabricated by co-sputtering method. An as-deposited AZO film had an optical transmittance of 84.78% at 550 nm and a resistivity of $7.8{\times}10^{-3}{\Omega}cm$. A rapid annealing process significantly improved the optical transmittance and electrical resistivity of the AZO film to 99.67% and $1{\times}10^{-3}{\Omega}cm$, respectively. The fabricated AZO film was fabricated for a metal-semiconductor-metal (MSM) structure. The AZO film-embedding MSM device was highly responsive to a UV light.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.259-259
• /
• 2011

염료감응형 태양전지(Dye-Sensitized Solar Cells:DSSC)는 환경 친화적이며, 저가의 공정에 대한 가능성으로 기존의 고가의 결정질 실리콘 태양전지의 경제적인 대안으로 각광을 받고 있다. 최근 염료감응형 태양전지는 투명 전도성 산화막(Transparent Conducting Oxide : TCO)으로 사용되는 Fluorine Tin Oxide (FTO)가 증착된 유리기판 위에 주로 제작된다. FTO는 낮은 비저항과 가시광선 영역에서 높은 투과도를 가지는 우수한 전기-광학적 특성을 갖지만, 비교적 공정이 까다로운 Chemical Vapor Deposition (CVD)법으로 제조하며, 전체 공정비용의 60%를 차지하는 높은 생산단가로 인해 현재 FTO를 대체할 재료개발 연구가 활발히 진행되고 있다. 그 중 ZnO (Zinc Oxide)는 우수한 전기-광학적 특성과 비교적 저렴한 가격으로 새로운 TCO로써 주목받고 있다. ZnO는 넓은 energy band gap (3.4 [eV])의 육방정계 울자이트(hexagonal wurtzite) 결정 구조를 가지는II-VI족 n형 반도체 물질이며, III족 금속원소인 Al, Ga 및 In 등의 불순물을 첨가하면 TCO로서 우수한 전기-광학적 특성과 안정성을 나타낸다. 이들 물질중 $Zn^{2+}$ (0.060 nm)의 이온반경과 유사한 $Ga^{2+}$0.062 nm) 이온이 ZnO의 격자반경을 최소화 시킬 수 있다는 장점으로 최근 주목 받고 있다. 하지만 Ga-doped ZnO (GZO)의 경우 DSC에 사용되는 루테늄 계열의 산성 염료 하에 장시간 두면 표면이 파괴되는 문제가 발생하며, $TiO_2$ paste를 Printing 후 열처리하는 과정에서도 박막의 파괴가 발생할 수 있다. 이를 방지하기 위해 $TiO_2$ Blocking Layer를 GZO 투명전극 위에 증착하였다. 또한, $TiO_2$ Blocking Layer를 적용한 GZO 박막을 전면전극으로 이용하여 DSC를 제작하여 효율을 확인하였다. 2wt%의 $Ga_2O_3$가 도핑된 ZnO 박막은 20mTorr 400$^{\circ}C$에서 Pulsed Laser Deposition (PLD)에 의해 성장되었고, $TiO_2$박막은 Ti 금속을 타겟으로 이용하여 30mTorr 400$^{\circ}C$에서 증착되었다. Scanning electron microscopy (FE-SEM)을 이용한 박막 분석 결과 $TiO_2$가 증착된 GZO 박막의 경우 표면 파괴가 일어나지 않았다. Solar Simulator을 이용하여 I-V특성 측정결과 상용 FTO를 사용한 DSC 수준의 효율을 나타내었다. 이에 따라 Pulsed Laser Deposition을 이용해 제작된 GZO 기판은 $TiO_2$ Blocking Layer를 이용하여 표면 파괴를 방지할 수 있었으며, 이는 향후 염료감응형 태양전지의 투명전극에 적용 가능 할 것으로 판단된다.