• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2019.05a
• /
• pp.184-185
• /
• 2019

Korea has defined fine dust as a social disaster as the problem of fine dust and air pollution becomes serious. Fine dust is classified as class one carcinogens because it is harmful to human body. When fine dusts enter the human body, they cause bronchial and skin diseases such as respiratory allergies, irritable pneumonia, asthma and atopy. As the air pollution becomes serious, the government is demanding measures to reduce fine dust. The polluted air in the outdoor is introduced into the room, thereby increasing the pollution degree of the indoor air quality. In this study, an adsorption type matrix for the improvement of indoor air quality was produced. Magnesium oxide and magnesium chloride were used as binders and diatomaceous earth was used as a adsorption material.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.07a
• /
• pp.230-234
• /
• 2000

Bi$_2$Sr$_2$Ca$_{n}$Cu$_{n+1}$ O$_{y}$(n$\geq$0; BSCCO)thin film is fabricated via two different processes using an ion beam sputtering method i.e. co-deposition and layer-by-layer deposition. A single phase of Bi2212 can be fabricated via the co-deposition process. While it cannot be obtained by the layer-by-layer process. Ultra-law growth rate in our ion beam sputtering system brings out the difference in Bi element adsorption between the two processes and results in only 30% adsorption against total incident Bi amount by layer-by-layer deposition, in contrast to enough Bi adsorption by co-deposition.on.n.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2020.06a
• /
• pp.140-141
• /
• 2020

Concrete has a lower thermal conductivity or thermal diffusion coefficient compared to other building materials, so it is widely used as fireproof compartment material or refractory material for structures. However, in the event of thermal damage such as fire, cement curing agents and aggregates act differently, resulting in heat generation or deterioration of tissue due to dehydration, resulting in deterioration of physical properties and fire resistance. Therefore, in this study, the processing structure of cement paste is measured through nitrogen absorption method. The test specimen is a cement paste of 40% W/C and is set at 1000 ℃ under heating temperature conditions. As the temperature rose, the micro-pore mass below was reduced based on about 0.01 감소m, but the air gap above that was increased.Thus, in the range of pores measured in nitrogen adsorption, the air mass tended to decrease under high temperature conditions.

• Journal of Korean Society on Water Environment
• /
• v.21 no.6
• /
• pp.637-642
• /
• 2005

The focus of this study was to examine the phosphorus removal characteristic by zirconium mesoporous structured material synthesized on various conditions. The zirconium sulfate-surfactant mesoporous structured material(ZS) was synthesized by hydro-thermal synthesis. The material has regular hexagonal array of surfactant micelles and sulfate ion ($HSO_4{^-}$). We confirmed that sulfate ion in zirconium mesoporous structured material can be ion-exchanged with phosphate ion ($H_2PO_4{^-}$) in phosphoric acid solution. On the X-ray diffraction (XRD) pattern of ZS, three peaks which shows the important characteristics of hexagonal crystal lattice were observed at (100), (110) and (200). The transmission electron micrograph (TEM) show high crystallization with pore size about $47{\AA}$. The maximum adsorption capacity of ZS was as great as 3.2 mmol-P/g-ZS. From the adsorption isotherm, correlation coefficients were higher for the Langmuir isotherm than the Freundlich isotherm. With the respect of chain length of surfactant, the adsorption capacity for phosphate synthesized with C12 was higher than C16 and C18. The highest amount of adsorbed phosphate on ZS was observed at the surfactant-to-zirconium molar ratio of 0.5 to 1.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.9
• /
• pp.1314-1320
• /
• 2004

The adsorption and configuration of CO molecules adsorbed on W (110) and W (100) surfaces have been calculated by the atomic superposition and electron delocalization molecular orbital (ASED-MO) method. Referred to as the ASED-MO method, it has been used in the present study to calculate the geometries, binding energies, vibrational frequencies, orbital energies, reduced overlap population (ROP), and charges. From these results adsorption properties of ${\alpha}$-state and ${\beta}$-state were deduced. The calculated binding energies are in good agreement with the experimental result. On the W (110), the calculated average binding energies are 2.56 eV for the end-on configuration and 3.20 eV for the lying-down configuration. Calculated vibrational frequency is 1927 $cm^{-1}$ at a 1-fold site and 1161 $cm^{-1}$ at a long-bridge (2) site. These results are in reasonable agreement with experimental values. On the W(100) surface, calculated average binding energies of the end-on and the lying-down are 2.54 eV and 4.02 eV respectively. The differences for binding energy and configuration on the surfaces are explained on the basis of surface-atom coordination and atom-atom spacing. In the favored lyingdown CO configuration on the W(110) and W(100) surfaces, 4 ${\sigma}$ and 1 ${\pi}$ donation interactions, coupled with the familiar 5 ${\sigma}$ donation to the surfaces and back-donations to the CO 2 ${\pi}^{\ast}$ orbital, are responsible for adsorption to the surface.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.39 no.1
• /
• pp.203-209
• /
• 2019

A number of industrial zones in South Korea were reported contaminated by heavy metals. Such contamination could cause severe damage to the subsurface environment including soil and groundwater. The treatment of zeolite mixing with soil at the bottom of such industrial zones might prevent, or at least reduce the damage of contamination by adsorption of the heavy metals from the leakage. However, such mixtures should maintain the proper bearing capacity as a foundation fill material from the geotechnical point of view at the same time. To investigate the effect of mixtures of zeolite with local soils for the adsorption of heavy metals (Zn, Pb) and sustainability of bearing capacity, adsorption isotherm tests and direct shear test with compaction tests were performed. Results showed that the mixing zeolite with local soils effectively reduces the spreading of the heavy metal contamination when maintaining its proper geotechnical properties as a fill material of industrial zones.

• Carbon letters
• /
• v.12 no.2
• /
• pp.112-115
• /
• 2011

The scope of this work investigates the relationship between the amount of oxygen-functional groups and hydrogen adsorption capacity with different concentrations of phosphoric acid. The amount of oxygen-functional groups of activated carbons (ACs) is characterized by X-ray photoelectron spectroscopy. The effects of chemical treatments on the pore structures of ACs are investigated by $N_2$/77 K adsorption isotherms. The hydrogen adsorption capacity is measured by $H_2$ isothermal adsorption at 298 K and 100 bar. In the results, the specific surface area and pore volume slightly decreased with the chemical treatments due to the pore collapsing behaviors, but the hydrogen storage capacity was increased by the oxygen-functional group characteristics of AC surfaces, resulting from enhanced electron acceptor-donor interaction at interfaces.

• Carbon letters
• /
• v.2 no.1
• /
• pp.37-43
• /
• 2001

Mercury has been identified as a potential health and environmental hazardous material. Activated carbon adsorption offers promising potential for the control of mercury emissions, and sulfur impregnated (sulfurized) activated carbons has been shown to be an effective sorbent for the removal of vapor phase $Hg{\circ}$ from sources. In this work, vapor phase mercury adsorption by sulfur impregnated activated carbons were investigated. Sulfur impregnated activated carbons were made by variation of impregnation temperature, and the comparison of adsorption characteristics with commercial virgin and sulfurized carbons were made. Factors affecting the adsorption capacity of virgin and sulfurized activated carbons such as pore characteristics, functional groups and sulfur impregnation conditions were discussed. It was found that the sulfur allotropes plays a critical role in adsorption of mercury vapor by sulfurized activated carbons.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.2
• /
• pp.241-248
• /
• 2011

This research was performed to evaluate the efficacy of phosphate removal from wastewater by surface-modified wood powder and to clarify the removal mechanisms. In this work, Pinus rigida which is abundant in Korea and has little economic value was used in preparation of the wood powder as a sorbent material. The experiments were carried out in 2 phases, isothermal adsorption test and column test. The results of adsorption test fitted well both the Langmuir and Freundlich isothermal equations. Adsorption capacity was highest with the bark powder followed by the mixed powder(50% bark powder and 50% woody powder) and woody powder. Phosphate removal efficiency was as high as 98% at initial phosphate concentration of 50mg/L. Specific surface area of the powder increased following the experiment and phosphate removal was speculated to occur through adsorption mechanism. Energy dispersive X-ray analysis(EDXA) revealed that the phosphate adsorbed onto the surface of the powder was in the form of strengite($FePO_{4}$).

• Journal of the Korean Ceramic Society
• /
• v.43 no.12 s.295
• /
• pp.846-851
• /
• 2006

This paper discuss the adsorption and fluidity properties of recycled cement powder with different hydration hysteresis and particle size. Reactivity of hydrated fine powder was negligible low. Therefore, the adsorption and fluidity properties with super-plasticizer for hydrated recycled cement powder was very important for using additive material. Adsorption amount of super-plasticizer was increased by the finer hydrated recycled cement powder addition. And the fluidity of hydrated recycled cement powder was very poor than un-hydrated cement powder. To Improve the fluidity of hydrated recycled cement powder, PC super-plasticizer is the more effective than NS super-plasticizer.