• Archives of Pharmacal Research
• /
• v.22 no.4
• /
• pp.335-339
• /
• 1999

The oxidation-reduction potentials of cosmetic raw materials, showing tyrosinase inhibitory action, and phenolic compounds structurally similar to L-tyrosine were determined by cylcic voltammetry. The voltammograms obtained could be classified ito 4 patterns (patterns 1-4). Patterns 1, characterized by oxidation and reduction peaks as a pair, was observed with catechol, hydroquinone or phenol, and pattern 2 exhibiting another oxidation peak in addition to oxidation and reduction peaks as a pair was found with arbutin, kojic acid, resorcinol, methyl p-hydroxybenzoate and L-tyrosine as the substrate of tyrosinase. Pattern 3 with an independent oxidation peak only was expressed by L-ascorbic acid, and pattern 4 with a reduction peak only at high potentials, by hinokitiol. The tyrosinase inhibitory activity of these compounds was also evaluated using the 50% inhibitory concentration ($IC_{50}$) and the inhibition constant (Ki) as parameters. Hinokitiol, classified as patterns 4, showed the highest inhibitory activity (lowest $IC_{50}$ and Ki). Hydroquinone showing the second highest activity belonged to pattern 1, which also included compounds exhibiting pattern 2 was relatively low with Ki values being in the order of 10-4 M. Although there was no consistent relationship between oxidation-reduction potentials and tyrosinase inhibitory action, the voltammetry data can be used as an additional index to establish the relationship between the structure and the tyrosine inhibitory activity.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.8
• /
• pp.1195-1201
• /
• 2004

Tyrosinase was covalently immobilized on platinum electrode according to the method we developed for laccase (Bull. Korean Chem. Soc. 2002, 23(7), 385) and p-chlorophenol, p-cresol, and phenol could be detected with sensitivities of 334, 139 and 122 nA/ ${\mu}M$ and the detection limits of 1.0, 2.0, and 2.5 ${\mu}M$, respectively. The response time ($t_{90\%}$) is 3 seconds for p-chlorophenol, and 5 seconds for p-cresol and phenol. The optimal pHs of the sensor are in the range of 5.0- 6.0. This sensor can tolerate at least 500 times repeated injections of p-chlorophenol with retaining 80% of initial activity. In case of tyrosinase and laccase co immobilized platinum electrode, the sensitivities are 560 nA/ ${\mu}M$ for p-phenylenediamine (PPD) and 195 nA/ ${\mu}M$ for p-chlorophenol, respectively. The sensitivity of the bi-enzyme sensor for PPD increases 70% compared to that of only laccase immobilized one, but the sensitivity for p-chlorophenol decreases 40% compared to that of only tyrosinase immobilized one. The sensitivity increase for the bi-enzyme sensor for PPD can be ascribed to the additional catalytic function of the co-immobilized tyrosinase. The sensitivity decrease for p-chlorophenol can be explained by the “blocking effect” of the co-immobilized laccase, which hinders the mass transport through the immobilized layer. If PPD was detected with the electrode that had been used for p-chlorophenol, the sensitivity decreased 20% compared to that of the electrode that had been used only for PPD. Similarly, if p-chlorophenol was detected with PPD detected electrode, the sensitivity also decreased 20%. The substrate-induced conformation changes of the enzymes in a confined layer may be responsible for the phenomena.

• Journal of Electrochemical Science and Technology
• /
• v.8 no.1
• /
• pp.7-14
• /
• 2017

This study aims to examine the influences of substrates/diffusion layers (DL) and oxygen reduction reaction catalysts ($M_{ORR}$) on the performance of $M_{ORR}/IrO_2$/DL-type bifunctional oxygen electrodes for use in polymer electrolyte membrane (PEM)-type unitized regenerative fuel cells (URFC). The $M_{ORR}/IrO_2$/DL electrodes were prepared via two sequential steps: anodic electrodeposition of $IrO_2$ on various DLs and fabrication of $M_{ORR}$ layers (Pt, Pd, and Pt-Ru) by spraying on $IrO_2/DL$. Experiments using different DLs, with Pt as the $M_{ORR}$, revealed that the roughness factor of the DL mainly determined the electrode performance for both water electrolyzer (WE) and fuel cell (FC) operations, while the contributions of porosity and substrate material were insignificant. When Pt-Ru was utilized as the $M_{ORR}$ instead of Pt, WE performance was enhanced and the electrode performance was assessed by analyzing round-trip efficiencies (${\varepsilon}_{RT}$) at current densities of 0.2 and $0.4A/cm^2$. As a result, using Pt-Ru instead of Pt alone provided better ${\varepsilon}_{RT}$ at both current densities, while Pd resulted in very low ${\varepsilon}_{RT}$. Improved efficiency was related to the additional catalytic action by Ru toward ORR during WE operation.

• Genomics & Informatics
• /
• v.12 no.4
• /
• pp.268-275
• /
• 2014

The harshness of legionellosis differs from mild Pontiac fever to potentially fatal Legionnaire's disease. The increasing development of drug resistance against legionellosis has led to explore new novel drug targets. It has been found that phosphoglucosamine mutase, phosphomannomutase, and phosphoglyceromutase enzymes can be used as the most probable therapeutic drug targets through extensive data mining. Phosphoglucosamine mutase is involved in amino sugar and nucleotide sugar metabolism. The purpose of this study was to predict the potential target of that specific drug. For this, the 3D structure of phosphoglucosamine mutase of Legionella pneumophila (strain Paris) was determined by means of homology modeling through Phyre2 and refined by ModRefiner. Then, the designed model was evaluated with a structure validation program, for instance, PROCHECK, ERRAT, Verify3D, and QMEAN, for further structural analysis. Secondary structural features were determined through self-optimized prediction method with alignment (SOPMA) and interacting networks by STRING. Consequently, we performed molecular docking studies. The analytical result of PROCHECK showed that 95.0% of the residues are in the most favored region, 4.50% are in the additional allowed region and 0.50% are in the generously allowed region of the Ramachandran plot. Verify3D graph value indicates a score of 0.71 and 89.791, 1.11 for ERRAT and QMEAN respectively. Arg419, Thr414, Ser412, and Thr9 were found to dock the substrate for the most favorable binding of S-mercaptocysteine. However, these findings from this current study will pave the way for further extensive investigation of this enzyme in wet lab experiments and in that way assist drug design against legionellosis.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.6
• /
• pp.52-58
• /
• 2008

In this paper, electrically small square loop antenna with SRR (Split Ring Resonator) cover structure is built and tested. The proposed antenna has very small size, ka = 0.34 by Chu limit. The experimental result shows that the resonant frequency and impedance bandwidth($VSWR{\leq}2$) are 906MHz and 5.8MHz (901.7 - 907.5MHz), respectively. The proposed antenna is matched and designed by equivalent circuit model. The proposed antenna is fabricated simple structure without additional matching network and printed on a Teflon substrate without ground plane. Therefore, it has advantages of low cost, small size, and light weight and will be applied to wireless communication systems where small antennas are required.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.7
• /
• pp.2207-2212
• /
• 2012

Dimethylaluminum isopropoxide (DMAI, $(CH_3)_2AlO^iPr$) as a single precursor, which contains one aluminum and one oxygen atom, has been adopted to deposit non-stoichiometric aluminum oxide ($AlO_x$) films by low pressure metal organic chemical vapor deposition without an additional oxygen source. The atomic concentration of Al and O in the deposited $AlO_x$ film was measured to be Al:O = ~1:1.1 and any serious interfacial oxide layer between the film and Si substrate was not observed. Gaseous by-products monitored by quadruple mass spectrometry show that ${\beta}$-hydrogen elimination mechanism is mainly contributed to the $AlO_x$ CVD process of DMAI precursor. The current-voltage characteristics of the $AlO_x$ film in Au/$AlO_x$/Ir metalinsulator-metal (MIM) capacitor structure show high ON/OFF ratio larger than ${\sim}10^6$ with SET and RESET voltages of 2.7 and 0.8 V, respectively. Impedance spectra indicate that the switching and memory phenomena are based on the bulk-based origins, presumably the formation and rupture of filaments.

• The Korean Journal of Physiology and Pharmacology
• /
• v.6 no.5
• /
• pp.269-274
• /
• 2002

A large number of factors such as osteotropic hormones, cytokines, or growth factors are related to the bone remodeling which is characterized by the coupling of osteoclast-mediated bone resorption and osteoblast-mediated bone formation. Recent investigations have indicated that cytokines such as $interleukin-1{\beta}\;(IL-1{\beta})$ and tumor necrosis $factor-{\alpha}\;(TNF-{\alpha})$ play a potential role in the bone resorption associated with a variety of pathological conditions such as inflammatory osteolytic disease. Collagen is the most abundant protein of the extracellular matrix of bone, and the participation of collagenase in bone resorption has been widely investigated. In this study, effects of $IL-1{\beta}$ and $TNF-{\alpha}$ on the release of collagenase from osteoblastic cells were measured. The gelatinase activity was also measured by gel substrate analysis (zymography) after electrophoresis of conditioned media of osteoblastic cell culture. $IL-1{\beta}$ increased the collagenase activity in ROS17/2.8 and HOS cell culture. $TNF-{\alpha}$ also increased the collagenase activity of osteoblastic cells. When two kinds of cytokines were treated simultaneously in the culture of osteoblastic cells, synergistic increase of collagenase activity was seen in ROS17/2.8 cells. $IL-1{\beta}$ and $TNF-{\alpha}$ significantly increased the collagenase activity after 6 hour treatment in the osteoblastic cell culture, and there was no additional increase according to the culture period. Osteoblastic cells released the gelatinase and molecular weight of this enzyme was measured about 70 KDa as assessed by zymogram. $IL-1{\beta}$ and $TNF-{\alpha}$ showed increase of the gelatinase activity produced by ROS17/2.8 and HOS cells. Taken together, this study suggested that $IL-1{\beta}$ and $TNF-{\alpha}$ can modulate bone metabolism, at least in part, by increased release of collagenase and gelatinase from osteoblasts.

• Food Science of Animal Resources
• /
• v.27 no.4
• /
• pp.496-500
• /
• 2007

The lactase activities of nine species of lactic acid bacteria were compared using the chromogenic substrate, $o-nitrophenyl-{\beta}-D-galactopyranoside$. Streptococcus thermophilus KACC 91147 had the highest lactase activity among a total of thirty strains of Lactobacillus and S. thermophilus tested, including commercial strains. S. thermophilus KACC 91147 released $0.30{\pm}0.12\;mg/mL$ of galactose in treated milk A ($10^7\;CFU/mL$) and $6.49{\pm}0.38\;mg/mL$ in treated milk B ($10^9\;CFU/mL$ milk) over 2 hours. In milk tolerance tests, the blood glucose level (BGL) of 6 volunteers (2 males and 4 females) clinically diagnosed as lactose intolerant increased 3.0 mg/dl after drinking milk A, but a significant (p<0.05) additional increase of $11.2{\pm}4.18\;mg/dl$ was found after drinking milk B. This result suggests that the addition of S. thermophilus KACC 91147 cells into milk aids the digestion of lactose in milk and ameliorates the symptoms of lactose-intolerant individuals due to the activity of lactase from the lactic streptococci.

• Journal of Convergence for Information Technology
• /
• v.11 no.3
• /
• pp.167-173
• /
• 2021

There is an increasing interest in manufacturing various electronic devices on a bendable substrate. In this paper, we observed a surface morphology by annealing for 20 minutes at temperatures of 150 ℃, 350 ℃, and 550 ℃, respectively, with samples coated by chromium and aluminum. Data on surfaces are investigated using high-resolution SEM and AFM that can measure roughness up to nm. There is no difference from the sample without heat treatment up to 350 ℃, but the change of crystal grains can be observed at 550 ℃. In the future, for application to the flexible optoelectronic field, additional characteristics such as electrical conductivity and reflectivity will be analyzed and optical devices will be manufactured. In conclusion, we will explore the possibility of applying metal materials to flexible electronic devices.

• Journal of Electrochemical Science and Technology
• /
• v.12 no.3
• /
• pp.323-329
• /
• 2021

This work presents a contrasting behavior of formic acid oxidation (FAO) on the Pt and Bi deposits on different Pt substrates. Using irreversible adsorption method, Bi and Pt were sequentially deposited on Pt electrodes of nanoparticle (Pt NP) and disk (Pt disk). The deposited layers of Bi and Pt on the Pt substrates were characterized with X-ray photoelectron spectroscopy, transmission microscopy and scanning tunneling microscopy. The electrochemical behaviors and FAO enhancements of Pt NP and Pt disk with deposited Bi only (i.e., Bi/Pt NP and Bi/Pt disk), were similar to each other. However, additional deposition of Pt on Bi/Pt NP and Bi/Pt disk (i.e., Pt/Bi/Pt NP and Pt/Bi/Pt disk) changed the electrochemical behavior and FAO activity in different ways depending on the shapes of the Pt substrates. With Pt/Bi/Pt NP, the hydrogen adsorption was suppressed and the surface oxidation of Pt was enhanced; while with Pt/Bi/Pt disk, the opposite behavior was observed. This difference was interpreted as a stronger interaction between the deposited Bi and Pt on Pt NP than that on Pt disk. The FAO performance on Pt/Bi/Pt NP is much better than that on Pt/Bi/Pt disk, most likely due to the difference in the interaction between the deposited Pt and Bi depending on the shapes of Pt substrates. In designing FAO electrochemical catalysts using Pt and Bi, the shape of a Pt substrate was concluded to be critically considered.