• The Journal of Advanced Prosthodontics
• /
• v.4 no.4
• /
• pp.227-234
• /
• 2012

PURPOSE. The aims of this pilot study were to introduce implant loading devices designed for animal study and to evaluate the validity of the load transmission ability of the loading devices. MATERIALS AND METHODS. Implant loading devices were specially designed and fabricated with two implant abutments and cast metal bars, and orthodontic expansion screw. In six Beagles, all premolars were extracted and two implants were placed in each side of the mandibles. The loading device was inserted two weeks after the implant placement. According to the loading protocol, the load was applied to the implants with different time and method, simulating early, progressive, and delayed loading. The implants were clinically evaluated and the loading devices were removed and replaced to the master cast, followed by stress-strain analysis. Descriptive statistics of remained strain (${\mu}{\varepsilon}$) was evaluated after repeating three cycles of the loading device activation. Statistic analysis was performed using nonparametric, independent t-test with 5% significance level and Friedman's test was also used for verification. RESULTS. The loading devices were in good action. However, four implants in three Beagles showed loss of osseointegration. In stress-strain analysis, loading devices showed similar amount of increase in the remained strain after applying 1-unit load for three times. CONCLUSION. Specialized design of the implant loading device was introduced. The loading device applied similar amount of loads near the implant after each 1-unit loading. However, the direction of the loads was not parallel to the long axis of the implants as predicted before the study.

• Journal of the Korean Chemical Society
• /
• v.30 no.4
• /
• pp.345-351
• /
• 1986

Monoxo-bridged binuclear molybdenum(V) complex, $[Mo_2O_3\;(bipy)_2\;(NCS)_4]$ in aqueous acetone mixture produces the corresponding dioxo-bridged binuclear molybdenum(V) complex, $MoO_4(bipy)_2(NCS)_2$. The rate of conversion of $[Mo_2O_3(bipy)_2(NCS)_4]$ to $MoO_4(bipy)_2(NCS)_2$ has been measured by spectrophotometric method. The rate of formation of dioxo-bridged binuclear molybdenum(V) complexes with solvent water follows the rate law, rate = k$[Mo_2O_3(bipy)_2(NCS)_4]\;[H_2O]$. The reaction mechanism for the formation of dioxo-bridged complex is discussed. The observed negative volume of activation shows that the complex is strongly attracted to the solvent molecules at transition state.

• Journal of the Korean Chemical Society
• /
• v.32 no.4
• /
• pp.291-296
• /
• 1988

Rates of the reaction for p-nitrobenzyl chloride, benzyl chloride and p-methylbenzyl chloride with pyridine in DMF solvent have been measured by an electric conductivity method at $40^{\circ}\;and\;50^{\circ}C$ under various pressures. From those rate constants, the activation parameters ${\Delta}V^{\neq},\;{\Delta}{\beta}^{\neq},\;{\Delta}H^{\neq},\;{\Delta}S^{\neq},\;{\Delta}G^{\neq}$) were evaluated. ${\Delta}V^{\neq}\;and\;{\Delta}{\beta}^{\neq}$ are both negative valued, but ${\Delta}H^{\neq}$ is positive and ${\Delta}S^{\neq}$ is large negative value. From the evaluation of the initial state and transition state which was resulted from substituents and pressure, it was found that this reaction proceeds through bimolecular reaction.

• Journal of the Korean Chemical Society
• /
• v.21 no.1
• /
• pp.38-43
• /
• 1977

The rate constant of the reaction of 3-or 4-substituted pyridines with benzyl benzenesulfonate in acetone at $35^{\circ}C$ were determined by an electric conductivity method. According to the Hammett plot, the rates were increased the electron donating ability at the $S_N2$ reaction of benzyl benzenesulfonate with pyridine and 4-$NH_2$ pyridine was correlated with ${\sigma}^+$ than Hammett ${\sigma}$ value. This result was explained that $NH_2$ group and N atom in pyridine are largely contribute by resonance. In Br$\"{o}$nsted plot, 4-amino and electron attracting group were deviated from the increasing part at linearity. It was considered to solvent effects on substituents. A mechanistic possibility was proposed to account for the results. Some activation parameters were also calculated.

• Journal of the Korean Chemical Society
• /
• v.31 no.6
• /
• pp.527-533
• /
• 1987

Kinetic studies on the complexing of aquamolybdenum(Ⅳ) trimer with thiocyanate have been carried out using the spectrophotometric method. The observed rate constant, $k_{obsd}$ is given by $k_{obsd}\;=\;{k_O + k_H[H^+]^2}(SCN^-) + k_r$. At 25$^{\circ}$C and ionic strength of 2.30 the values of $k_f$ and $k_r$ are $(3.78 {\pm} 0.61) {\times} 10^{-4}M^{-1}s^{-1}$ and $(6.93 {\pm} 2.39) {\times} 10^{-4}s^{-1}$, respectively. Activation parameters are ${\Delta}H^* = 50.71{\pm}6.91 kJmol^{-1}$ and ${\Delta}S^* = -121.65JK^{-1}mol^{-1}$. The mechanism is proposed and discussed.

• Journal of the Korean Chemical Society
• /
• v.37 no.6
• /
• pp.577-584
• /
• 1993

The reaction rates of para-substituted benzoyl chlorides with substituted pyridines have been measured employing the conductometry method in acetonitrile, and pseudo-first order and second order rate constants are determined at various pressures and temperatures. The activation parameters (${\Delta}V^\neq, {\Delta}{\beta}^{\neq}, {\Delta}H^{\neq}, {\Delta}S^{\neq} {\Delta}G^{\neq}$) and the Hammett ρ-values are determined from the values of rate constants. The values of △${\Delta}V^\neq, {\Delta}{\beta}^{\neq}and {\Delta}S^{\neq}$ are all negative. The Hammett ρ-values are negative for the nucleophile (ρ$_X$), and positive for the substrate (ρ$_Y$) over the pressure range studied. The results of kinetic studies for pressure and substituent show that these reactions proceed in typical S$_N$2 reaction mechanism and in bond formation favored with elevating pressure.

• Korean Journal of Materials Research
• /
• v.24 no.1
• /
• pp.60-65
• /
• 2014

Fe-based amorphous coatings were fabricated on a soda-lime glass substrate by the vacuum kinetic spray method. The effect of the gas flow rate, which determines particle velocity, on the deposition behavior of the particle and microstructure of the resultant films was investigated. The as-fabricated microstructure of the film was studied by field emission scanning electron microscopy (FE-SEM) and high resolution transmission electron microscopy (HR-TEM). Although the activation energy for transformation from the amorphous phase to crystalline phase was lowered by severe plastic deformation and particle fracturing under a high strain rate, the crystalline phases could not be found in the coating layer. Incompletely fractured and small fragments 100~300 nm in size, which are smaller than initial feedstock material, were found on the coating surface and inside of the coating. Also, some pores and voids occurred between particle-particle interfaces. In the case of brittle Fe-based amorphous alloy, particles fail in fragmentation fracture mode through initiation and propagation of the numerous small cracks rather than shear fracture mode under compressive stress. It could be deduced that amorphous alloy underwent particle fracturing in a vacuum kinetic spray process. Also, it is considered that surface energy caused by the formation of new surfaces and friction energy contributed to the bonding of fragments.

• Nuclear Engineering and Technology
• /
• v.2 no.2
• /
• pp.85-95
• /
• 1970

An attempt has been made to do interpretation of the fast neutron dose with two threshold detectors incorporated with the Harwell criticality locket. This method is based on the assumption that the spectral distribution of fission neutrons in criticality accidents may be governed by one spectral parameter. The surface-absorbed dose for a unit fission neutron fluence seems to be insensitive to spectral shifts of the fission neutron spectrum. The average cross-sections for the activation detectors, however, are considerably changed with the neutron spectral shape, which may lead to a large error in calculating the dose from the reaction rate if one uses a fixed value for the average cross sections regardless of the neutron spectral distribution. Besides, the doses calculated from three representative formulae for fission neutron spectra have been compared : these formulae are Watt, Cranberg at al. and Maxwellian forms. The results obtained front the Maxwellian formula show a departure from the Watt and Cranberg's, both being similarly close.

• YAKHAK HOEJI
• /
• v.44 no.4
• /
• pp.300-307
• /
• 2000

Expression of xenobiotic-metabolizing enzymes can be altered by xenobiotics, which represents changes in the production of reactive metabolic intermediates as well as toxicities in tissues. Metabolic intermediates derived from xenobiotics are considered to produce the reactive oxygen species including drug free radicals and hydroxyl free radicals, which would be ultimately responsible for drug-induced toxicities. The effects of 1,2-benzothiazine anti-inflammatory agents on the expression of xenobiotic-metabolizing enzymes including major cytochrome P450s, microsomal epoxide hydrolase (mEH) and glutathione S-transferase (GST) were studied in the liver with the aim of providing the part of information on potential production of reactive metabolites and hepatotoxicity by the agents. The synthetic compounds 24, 36 and 39 exhibited anti-inflammatory effects in rats as assessed by the Randall-Selitto method. The anti-inflammatory effect was detected as early as at 30 min after gavaging the agents with the ED5O being noted at 80 mg/kg, which was comparable to that of ibuprofen. Treatment of rats with each compound (100 mg/kg, 3d) resulted in no significant induction in the immunochemically-detectable cytochromes P45O 1A1/2, P450 2B1/2, P45O 2 Cl1 and P45O 2El. Changes in the mEN expression were also minimal, as evidenced by both Western blot and Northern blot analyses. Hepatic GST expression was slightly increased by the agents: GST Ya protein and mRNA expression was ～1.5-fold increased after treatment with compounds 24 and 39, whereas GST Yb1/2 and Yc1/2 mRNA levels were elevated 2- to 3-fold. In summary the effects of the synthetic 1,2-benzothiazines on the expression of major P45O, mEH and G57 were not significant, providing evidence that metabolic activation of the agents, potential drug interaction and hepatotoxicity would be minimal.

• Physical Therapy Rehabilitation Science
• /
• v.9 no.1
• /
• pp.36-42
• /
• 2020

Objective: Many caregivers often carry infants using baby carriers until they are approximately 36 months old. The purpose of this study was to compare the muscular activity of the trunk and lower leg muscles during trunk flexion-extension movements in correspondence to various wearing methods of a baby carrier blanket. Design: Cross-sectional study. Methods: Sixteen healthy adult women were to wear baby carrier blankets in five different ways in terms of direction and height, followed by flexion-extension of the trunk. Erector spinae (ES), rectus abdominis, rectus femoris (RF), biceps femoris (BF) muscle activities and triaxial acceleration of trunk were investigated. Results: The front-wearing method of the baby carrier blanket increased the muscular activity of the ES muscle, and wearing the baby carrier blanket at waist height in the same direction was significantly higher than wearing it at pelvic height (p<0.05). As the angle of flexion increased during trunk flexion-extension, the muscle activity of the ES, BF, and the RF increased. There was a greater increase in muscle activity of the ES and the BF during extension compared to flexion (p<0.05). Conclusions: If it is difficult to wear a baby carrier blanket due to lumbar pain, it is recommended to lower the wearing height of the baby carrier to the pelvic level so that the external load can be transferred to the lower extremity. In addition, it appears to be necessary to hold the baby and distribute the load onto the waist through proper body control when performing flexion-extension movements of the trunk. More objective and scientific research that includes various daily tasks and evaluation methods are needed.