• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.8
• /
• pp.34-45
• /
• 1994

We studied threshold voltages and I-V characteristics. considering short channel effect of the fully depleted thin film n-channel SOI MOSFET. We presented a charge sharing model when the back surface of short channel shows accumulation depletion and inversion state respectively. A degree of charge sharing can be compared according to each of back-surface conditions. Mobility is not assumed as constant and besides bulk mobility both the mobility defined by acoustic phonon scattering and the mobility by surface roughness scattering are taken into consideration. I-V characteristics is then implemented by the mobility including vertical and parallel electric field. kThe validity of the model is proved with the 2-dimensional device simulation (MEDICI) and experimental results. The threshold voltage and charge sharing region controlled by source or drain reduced with increasing back gate voltage. The mobility is dependent upon scattering effect and electric field. so it has a strong influence on I-V characteristics.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.1
• /
• pp.371-375
• /
• 2005

In this paper, the resonance characteristics of ZnO-based FBAR devices are compared. Several FBAR device samples were fabricated by using three different annealing methods while one sample remained non-annealed as a reference for comparison. Resonance characteristics could be significantly improved by both Bragg reflector-annealing and/or post-annealing steps. Especially, the use of two-step annealings resulted in most desirable resonance characteristic improvement compared with the Bragg reflector-annealing or post-annealing step alone.

• Proceedings of the KIEE Conference
• /
• 2006.07c
• /
• pp.1478-1479
• /
• 2006

AE(Acoustic Emission) 검출기법을 이용한 새로운 방식의 변압기 on-line 진단 장비의 개발을 소개한다. 금번에 개발된 변압기 진단 장비(AMiD)는 다년간에 걸친 프로젝트 수행과 실 현장측정 결과를 토대로 축적된 경험과 기술력을 바탕으로 설계, 제작되었다. 본 장비는 국내 전력용 변압기의 운전 환경에 적합하며, 각 변압기의 운전 환경과 운전 조건에 따라 유동적으로 적용될 수 있다. 본문에서는 장비의 기본적인 사양 및 기술적 특징에 대해서 설명한다.

• Proceedings of the KIEE Conference
• /
• 2005.07c
• /
• pp.1865-1867
• /
• 2005

Film bulk acoustic resonator (FBAR) devices which adopt an air-gap type (metai/AlN/metal/air/substrate) configuration are fabricated by a novel process. The newly fabricated resonator doesn't employ any supporting layer below it. FBAR devices with the air-gap type are also fabricated using the conventional method. The frequency response characteristics of all the devices fabricated are measured and compared, in terms of the kinds of top and bottom electrode materials. The results show that the better device performance of FBAR devices can be achieved by employing the proposed process.

• Journal of information and communication convergence engineering
• /
• v.3 no.1
• /
• pp.23-27
• /
• 2005

In this paper, the effects of various annealing conditions on the resonance characteristics of ZnO-based FBAR devices are compared. Several FBAR device samples were fabricated by using three different annealing methods while one sample remained non-annealed as a reference for comparison. Return loss ($S_11$) could be significantly improved by both Bragg reflector-annealing and/or post-annealing. Especially, the use of the combined annealings resulted in most desirable resonance improvement compared with the Bragg reflector-annealing or post-annealing method alone.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2002.04b
• /
• pp.1239-1242
• /
• 2002

In this paper, the implementation of MAI(multiple access interference)-cancelled SSMA(spread spectrum multiple access) system using orthogonal carriers was presented. Employing the pseudo periodic spreading codes and orthogonal carriers frequency offset, proposed system have the features no MAI during a certain local time-duration. Spreading signals designed by pseudo periodic method and repetition, have zero correlation duration(ZCD) by orthogonal frequency shift method. The SSMA modem has been designed and implemented using surface-acoustic-wave(SAW) device as the matched filter of receiver. The effects of frequency offset on stability have been evaluated using computer simulation.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.309-310
• /
• 2007

Spacecrafts such as most of commercial satellites that are operating in the geostationary orbit can be subjected to intense irradiation by charged particles. The surface made of dielectric materials can therefore become probable sites for damaging electrostatic discharges. Thanks to a specially equipped chamber, the spatial environment can be reproduced experimentally in the laboratory. In this paper, the behavior of high energy electrons injected in polymers such as PolyMethylMetaAcrylate (PMMA) and Kapton is studied. Results obtained by surface potential technique, pulse-electro acoustic device and a cell based on the split Faraday cup system are analyzed and discussed.

• Proceedings of the KIEE Conference
• /
• 2003.11c
• /
• pp.910-915
• /
• 2003

This paper describes the design of a 2-phase stepping motor driver using CPLD(Complex Programmable Logic Device). The driver IC such as L297 (SGS-Thomson Microelectronics), which is mostly used has some problems in PWM control because of the switching noise of power MOSFETs. It causes current ripple and acoustic noise. To improve theses characteristics, we proposed a new current control method that the output PWM frequency is almost constant using a digital filter. Also we proposed constant current method for 1-2 phase(half step) excitation. The proposed method is implemented with CPLD(Xilinx, XC9572-PC44). Experimental results show the effectiveness of the proposed method.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.1990-1991
• /
• 2007

Spacecrafts such as most of commercial satellites that are operating in the geostationary orbit can be subjected to intense irradiation by charged particles. The surface made of dielectric materials can therefore become probable sites for damaging electrostatic discharges. Thanks to a specially equipped chamber, the spatial environment can be reproduced experimentally in the laboratory. In this paper, the behavior of high energy electrons injected in polymers such as PolyMethylMetaAcrylate (PMMA) and Kapton is studied. Results obtained by surface potential technique, pulse-electro acoustic device and a cell based on the split Faraday cup system are analyzed and discussed.

• Proceedings of the KSPS conference
• /
• 2005.11a
• /
• pp.17-20
• /
• 2005

The purpose of this project is to develop a device that can automatically measure pronunciation of English speech produced by Korean learners of English. Pronunciation proficiency will be measured largely in two areas; suprasegmental and segmental areas. In suprasegmental area, intonation and word stress will be traced and compared with those of native speakers by way of statistical methods using tilt parameters. Durations of phones are also examined to measure speakers' naturalness of their pronunciations. In doing so, statistical duration modelling from a large speech database using CART will be considered. For segmental measurement of pronunciation, acoustic probability of a phone, which is a byproduct when doing the forced alignment, will be a basis of scoring pronunciation accuracy of a phone. The final score will be a feedback to the learners to improve their pronunciation.