• Journal of the Korean Applied Science and Technology
• /
• v.2 no.2
• /
• pp.63-67
• /
• 1985

AOM and lamp tests were carried out with soybean, corn, palm oil and beef tallow without the addition of antioxidant. The evaluation of rancidity for the stability was determined by changes of peroxide value and acid value, and the correlation between the stability and the composition of fats and oils was examined. The results obtained were as follows. 1. In the AOM test, POV began to rise in the order of corn oil, soybean oil, beef tallow and palm oil. However, the time required to reach POV 100 in beef tallow was faster than other fats and oils. It was found that there was a good correlation between POV and content of tocophrol. 2. In the lamp test by light of main wavelength 253.7nm, beef tallow was stabler than soybean and corn oil. It was because the absorption of light into beef tallow was much smaller than others, since beef tallow was fats. Palm oil was very stable in all the samples during AOM and lamp test.

• ETRI Journal
• /
• v.23 no.3
• /
• pp.97-105
• /
• 2001

$1.6\;{\mu}m$ emission originated from $Pr^{3+}:\;(^3F_3,\;^3F_4)\;{\longrightarrow}\;^3H_4$ transition in $Pr^{3+}-\;and\;Pr^{3+}/Er^{3+}$-doped selenide glasses was investigated under an optical pump of a conventional 1480 nm laser diode. The measured peak wavelength and fullwidth at half-maximum of the fluorescent emission are ~1650nm and 120nm, respectively. A moderate lifetime of the thermally coupled upper manifolds of ${\sim}212{\pm}10{\mu}s$ together with a high stimulated emission cross-section of ${\sim}(3{\pm}1){\times}10^{-20}\;cm^2$ promises to be useful for $1.6{\mu}m$ band fiber-optic amplifiers that can be pumped with an existing high-power 1480 nm laser diode. Codoping $Er^{3+}$ enhances the emission intensity by way of a nonradiative $Er^{3+}:\;^4I_{13/2}\;{\longrightarrow}\;Pr^{3+}:\;(^3F_3,\;^3F_4)$ energy transfer. The Dexter model based on the spectral overlap between donor emission and acceptor absorption describes well the energy transfer from $Er^{3+}$ to $Pr^{3+}$ in these glasses. Also discussed in this paper are major transmission loss mechanisms of a selenide glass optical fiber.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.1
• /
• pp.169-174
• /
• 2011

The synthesis of new pyrazolyl and cyclopropyl derivatives of purpurin-18 methyl ester and purpurin-18-N-butylimide 1a, 1b, 2a, 2b and 8 is described. The new compounds were characterized by NMR, UV-vis spectroscopy and mass spectrometry. UV-vis spectra of the new compounds showed long wavelength absorption of ranges 692 - 708 nm ($\lambda_{max}$). Photodynamic effects of the chlorin derivatives 1a, 1b, 2a and 2b were investigated by WST-1 assay in A549 cells, and showed good photodynamic activities with high photocytotoxicity and low cytotoxicity in the dark. In comparison between pyrazolyl and cyclopropyl derivatives, purpurin-18 methyl ester compounds 1a and 1b showed comparable photocytotoxicity result of the cell viabilities, otherwise, pyrazolyl derivative of purpurin-18-N-butylimide 2a showed better cell viabilities than those of cyclopropyl derivative 2b. And cyclopropyl derivative of purpurin-18-N-butylimide 2b showed higher dark cytotoxicity than that of others.

• Journal of the Korean Ceramic Society
• /
• v.55 no.5
• /
• pp.510-514
• /
• 2018

Colloidal semiconductor quantum dots (QDs), because of the novel optical and electrical properties that stem from their three-dimensional confinement, have attracted great interest for their potential applications in such fields as bio-imaging, display, and opto-electronics. However, many semiconductors that can be exploited for QD applications contain toxic elements. Herein, we synthesized non-toxic ZnTe/ZnSe (core/shell) type-II QDs by pyrolysis method. Because of the unique type-II character of these QDs, their emission can range over an extended wavelength regime, showing photoluminescence (PL) from 450 nm to 580 nm. By optimizing the ZnSe shell growth condition, resulting ZnTe/ZnSe type-II QDs shows PL quantum yield up to ~ 25% with 35 nm PL bandwidth. Using a simple two step cation exchange reaction, we also fabricated ZnTe/ZnSe type-II QDs with absorption extended over the whole visible region. The visible-light sensitized heavy metal free ZnTe/ZnSe type-II QDs can be relevant for opto-electronic applications such as displays, light emitting diodes, and bio-imaging probes.

• Proceedings of the KIEE Conference
• /
• 2000.07c
• /
• pp.1649-1651
• /
• 2000

Optical properties of $Cd_{1-x}Zn_{x}S$ films deposited by :chemical bath deposition(CBD), which is a very attractive method for low-cost and large-area solar cells, are presented, Especially, in order to control more effectively the zinc component of the films, zinc acetate, which used as the zinc source, mixed in reaction solution after preheating and the pH of the reaction solution decreased with increasing the concentration of zinc acetate. The films prepared after preheating and pH control had larger zinc component and higher optical band gap. As the more zinc substituted for Cd in the films, the optical transmittance improved, while the absorption edge shifts to a shorter wavelength and the optical band gap increased. The photo conductivity of the films was larger than the dark conductivity, while the ratio of those increased with increasing the mole ratio of zinc acetate.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.1
• /
• pp.56-63
• /
• 2013

IGZO thin films have been prepared by RF magnetron sputtering. The structural, electrical and optical properties of the IGZO thin films have been investigated as a function of deposition condition. XRD analysis of IGZO thin films showed a typical crystallographic orientation with c-axis perpendicular regardless of deposition conditions. The carrier mobility, carrier concentration and resistivity of the IGZO films sputtered at 200 W, 1mTorr and $300^{\circ}C$ were $28.5cm^2/V{\cdot}sec$, $2.6{\times}10^{20}cm^3$, $8.8{\times}10^{-4}{\Omega}{\cdot}cm$ respectively. The optical transmittance were higher than 80% at visible region regardless of the deposition conditions under the experiments above, and specifically higher than 90% at wave length over 500 nm. The absorption edge was shifted to shorter wavelength with increase of carrier concentration.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.2
• /
• pp.99-103
• /
• 2008

To improve efficiency of solar cells, it is important to make a light trapping structure to reduce surface reflectance for increasing absorption of sun light within the solar cells. One of the promising methods that can reduce surface reflectance is isotropic texturing with acid solution based on hydrofluoric acid(HF), nitric acid($HNO_3$), and organic additives. Anisotropic texturing with alkali solution is not suitable for multicrystalline silicon wafers because of its different grain orientation. Isotropic texturing with acid solution can uniformly etch multicrystalline silicon wafers unrelated with grain orientation, so we can get low surface reflectance. In this paper, the acid texturing solution is made up of only HF and $HNO_3$ for easy controlling the concentration and low cost compared to acid solution with organic additives. $HNO_3$ concentration and dipping time were varied to find the condition of minimum surface reflectance. Textured surfaces were observed Scanning Electron Microscope(SEM) and surface reflectance were measured. The best result of arithmetic mean(wavelength from 400 nm to 1000 nm) reflectance with acid texturing is 4.64 % less than alkali texturing.

• KSBB Journal
• /
• v.13 no.2
• /
• pp.220-222
• /
• 1998

Three microbial consortia were screened for their ability to degrade phenolic resin, resole as a sole carbon source. These microbial consortia were derived from soil samples collected from a phenolic resin manufacturing plant site. Among the consortia, the test consortium, designated as MS2, displayed approximately 70% degradation of the substrate, 100 mg of resole per liter, within the fist twelve days of incubation but the degradation was inhibited. During the incubation period, pH was decreased from 7.0 to 2.7, and the resole degradation became inhibited under the conditions. UV-scans of spent culture showed that the wavelength of maximum absorption was 261 nm for resole.

• ETRI Journal
• /
• v.36 no.4
• /
• pp.654-661
• /
• 2014

We develop accurate finite-difference time-domain (FDTD) modeling of polymer bulk heterojunction solar cells containing Ag nanoparticles between the hole-transporting layer and the transparent conducting oxide-coated glass substrate in the wavelength range of 300 nm to 800 nm. The Drude dispersion modeling technique is used to model the frequency dispersion behavior of Ag nanoparticles, the hole-transporting layer, and indium tin oxide. The perfectly matched layer boundary condition is used for the top and bottom regions of the computational domain, and the periodic boundary condition is used for the lateral regions of the same domain. The developed FDTD modeling is employed to investigate the effect of geometrical parameters of Ag nanospheres on electromagnetic fields in devices. Although negative plasmonic effects are observed in the considered device, absorption enhancement can be achieved when favorable geometrical parameters are obtained.

• ETRI Journal
• /
• v.35 no.4
• /
• pp.587-593
• /
• 2013

We demonstrate semitransparent organic photovoltaics (OPVs) based on thin metal electrodes and polymer photoactive layers consisting of poly(3-hexylthiophene) and [6,6]-phenyl $C_{61}$ butyric acid methyl ester. The power conversion efficiency of a semitransparent OPV device comprising a 15-nm silver (Ag) rear electrode is 1.98% under AM 1.5-G illumination through the indium-tin-oxide side of the front anode at 100 $mW/cm^2$ with 15.6% average transmittance of the entire cell in the visible wavelength range. As its thickness increases, a thin Ag electrode mainly influences the enhancement of the short circuit current density and fill factor. Its relatively low absorption intensity makes a Ag thin film a viable option for semitransparent electrodes compatible with organic layers.