• 한국대기환경학회지
• /
• 제24권5호
• /
• pp.562-573
• /
• 2008

Concentrations of volatile organic compounds (VOCs) measured from the local industrial sources in Wanju industrial complex during June $2007{\sim}January$ 2008. The samples were collected from the primary sources (6 emission points) in 4 major factories in Wanju industrial complex as well as two general sources in Wanju County to elucidate the abundances of speciated VOCs and their spacial and temporal distributions depending on source bases. Industrial sources are as follows; fabricated metal manufacture, motor vehicle manufacture, rubber and plastic manufacture, and chemical manufacture factories. Two general source samples were collected from gasoline gas station and dry cleaning shop in urban area. In order to understand the near source influence at receptor, samples from the two receptor sites (one is at center of the industrial complex and the other site is at distance residential area downwind from the center) were collected with sample canister, and analyzed by using GC/MSD. The concentrations from different sources were compared and discussed. The mass contributions of the speciated VOCs to total VOCs measured from industrial sources and ambient ai r at two receptors were presented and discussed.

• 인지과학
• /
• 제16권3호
• /
• pp.199-211
• /
• 2005

사람들이 무엇을 왜 두려워하는지를 알고자 대학생, 과학기술 분야의 전문가, 그리고 환경단체에 근무하는 직원들을 대상으로 30 개 항목들에 대한 위험을 평가하도록 하였다. Slovic과 그 동료들(1978, 1984, 1987)이 밝혔던 두려움과 지식의 두 위험지각 차원을 검토하면서 생태학적 태도가 다른 세 사회 집단 간의 위험 지각의 차이를 살펴보고자 하였다. 본 연구는 Slovic 등이 발견하였던 것과 동일한 두 심리적 차원을 찾아내었다. 지각된 위험 강도와 사회적 이익을 비롯한 여러 심리적 특성들에서 그 생태학적 태도가 차이 있을 것으로 생각되는 세 사회 집단이 뚜렷한 차이를 보였다. 본 연구의 결과를 Slovic 등의 결과와 비교하였고, 원자력 등과 관련해서 집단들 간의 차이와 그 결과를 논의하였다.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2000년도 추계학술대회논문집A
• /
• pp.135-140
• /
• 2000

The characteristics of mechanical behavior were estimated for Ti-6Al-4V alloy with four kinds of microstructure prepared with heat treatments. For this study, impact test, tensile test and fatigue crack growth test were performed, and then compared mechanical properties on the four microstructures. Furthermore, for quantitative evaluation, fractal dimensions of crack pass were obtained using the box counting method. The main results obtained are summarized as follows. (1) The microstructures exhibited equiaxed microstructure, bimodal-microstructure and lamellar microstructure by heat treatment. (2) The impact absorbed energy and elongation is superior in the bimodal-microstructure, and the hardness and tensile strength are superior in the lamellar microstructure. (3) The fatigue crack growth rate is similar to all microstructures in the low ${\Delta}K$ region. The fatigue crack growth rate of equiaxed microstructure is fastest, and that of lamellar microstructure is lowest in the high ${\Delta}K$ region. (4) The fractal dimension D of lamellar microstructure is higher then that of the equiaxed microstructure and bimodal microstructure.

• Transactions on Electrical and Electronic Materials
• /
• 제6권1호
• /
• pp.18-21
• /
• 2005

Monolayers of lipids on a water surface have attracted much interest as models of biological membranes, but also as precursors of multilayer systems promising many technical applications. Until now, many methodologies have been developed in order to gain a better understanding of the relationship between the structure and function of the monolayers. Maxwell displacement current (MDC) measurement has been employed to study the dielectric property of Langmuirfilms. MDC flowing across monolayers is analyzed using a rod-like molecular model. A linear relationship between the monolayer compression speed a and the molecular area Am. Compression speed a was about 30, 40, and 50 mm/min. Langmuir-Blodgett(LB) layers of Arachidic acid deposited by LB method were deposited onto slide glass as Y-type film. The structure of manufactured device is Aul Arachidic acid! AI, the number of accumulated layers are $9{\sim}21$. Also, we then examined of the Metal-Insulator-Metal(MIM) device by means of I-V. The I-V characteristics of the device are measured from -3 to+3 V. The insulation property of a thin film is better as the distance between electrodes is larger.

• Current Photovoltaic Research
• /
• 제2권2호
• /
• pp.41-47
• /
• 2014

Extensive investigation on silicon based thin film reveals a wide range of film characteristics, from low optical gap to high optical gap, from amorphous to micro-crystalline silicon etc. Fabrication of single junction, tandem and triple junction solar cell with suitable materials, indicate that fabrication of solar cell of a relatively moderate efficiency is possible with a better light induced stability. Due to these investigations, various competing materials like wide band gap silicon carbide and silicon oxide, low band gap micro-crystalline silicon and silicon germanium etc were also prepared and applied to the solar cells. Such a multi-junction solar cell can be a technologically promising photo-voltaic device, as the external quantum efficiency of such a cell covers a wider spectral range.

• Journal of Plant Biotechnology
• /
• 제43권1호
• /
• pp.119-124
• /
• 2016

Anthocyanin accumulation and plant growth were examined in petunia (NT and $T_2$ transgenic plants) by determining the effects of different sources of light and varying light/dark cycles. Red light significantly enhanced anthocyanin content of B-peru+mPAP1; however, it had a negative effect on anthocyanin production in RsMYB1 plants. In general, white light was found to be reasonable for anthocyanin accumulation in all plants. In case of light/dark cycles, application of seven days of light:14 days of dark significantly enhanced anthocyanin content. We found that anthocyanin content detected in transgenic plants expressing anthocyanin regulatory transcription factor genes (B-peru+mPAP1 or RsMYB1) was higher than that in NT plants in all treatments. Plant growth was also influenced by the different light sources and dark/light cycles. Taken together, our results suggest that light source and light/dark cycle play an important role in anthocyanin production and plant growth. The choice of the optimal conditions is also important for anthocyanin production and plant growth depending on NT or transgenic plants carrying anthocyanin regulatory transcription factors.

• 한국대기환경학회지
• /
• 제15권2호
• /
• pp.191-199
• /
• 1999

This study evaluated the availability as an alternative adsorbent which is cheaper and more efficient than CuO/${\gamma}$-$Al_2O_3$ which have been studing vigorously to remove $SO_2$. Five adsorbents (CuO/${\gamma}$-$Al_2O_3$, Iron ore, Slag, LD slag, $Fe_2O_3$) was employed in a fixed bed reactor. $SO_2$ breakthrough curves were obtained as a function of temperature, initial gas velocity and particle size. Saturation capacities calculated by the numerical integration of breakthrough curves of $SO_2$ increased with increasing reaction temperature. $SO_2$ breakthrough curve equation of $Fe_2O_3$ for this system can be expressed as Kr=3,914,000 exp(-37,329.86/RT). By means of the breakthrough curve, the influence of bed height on breakthrough time was also estimated.

• 대한영양사협회학술지
• /
• 제23권4호
• /
• pp.363-373
• /
• 2017

This study examined the characteristics of the foodservice menu items offered at senior welfare centers to provide information on Korean senior menu development. A total of 514 lunch menu items were collected from 27 senior welfare centers in April, July, October and January. The most frequently served staple foods, soups, and side dishes were multi-grain rice, seaweed soup, Bulgogi, Kimchi, and liquid yogurt. The proportions of carbohydrate, protein, and lipids of total energy serving of senior welfare centers were 59.8%: 16.7%: and 22.8%, respectively. The nutrients served at less than 40% of the Recommended Nutrient Intake (RNI) and Adequate Intake (AI) of Dietary Reference Intakes for Koreans (KDRIs) were chloride (1.0%), vitamin D (1.3%), biotin (1.7%), magnessium (4.5%), Iodine (7.5%), pantothenic acid (8.0%), vitamin E (12.5%), vitamin $B_6$ (20.0~21.4%), vitamin K (21.1~24.3%), and water (35.7~39.7%). The nutrients served in excess of the daily intake goal and RNI were iron (98.9~127.1%), sodium (104.9%), and copper (1,100.0%).

• 전기화학회지
• /
• 제7권4호
• /
• pp.201-205
• /
• 2004

본 연구에서는 Pt-Ru 촉매를 $H_2PtCI_6$ 및 $RuCl_3$ 용액을 화학적 환원에 의해 전도성 고분자인 폴리피롤을 중합시킨 Nafion 막위에 직접 침적시켰다 EDS 분석 결과 Pt 및 Ru 촉매는 Ppy/Nafion 표면에 주로 분포하는 것을 알 수 있었다. 또한 폴리피롤이 중합된 Nanon 위에 침적시킨 Pt-Ru 촉매의 메탄올에 대한 전기화학적 산화특성을 CV로 평가하였다. 메탄을 산화 개시 전위는 Ru촉매에 사용이 증가함에 따라 음전위 방향으로 전이되었다. 따라서 폴리피롤이 중합된 Nafion표면에 Pt-Ru촉매를 직접 함침할 수 있었고. 메탄올 산화 특성을 나타내는 전극을 제작할 수 있었다.

• 조명전기설비학회논문지
• /
• 제24권5호
• /
• pp.16-28
• /
• 2010

본 논문은 AIPI 및 ANN에 의한 SynRM 드라이브의 최대토크 제어를 제시한다. 본 논문은 인버터의 정격 전압과 전류의 한계 조건을 고려하여 전 속도영역에서 최대토크제어를 제시한다. 속도에 따라 각 제어모드에서 최대토크를 발생하기 위한 최적의 전류값을 계산하고. 계산된 최적전류를 이용하여 최대토크 제어를 수행한다. 제시된 최대토크 제어 알고리즘은 AIPI와 ANN 제어기와 함께 SynRM 드라이브에 적용하여 동작특성을 분석하고 그 타당성을 제시한다.